Having problems with your LG LDF6810ST Stainless Steel Built-in Dishwasher ?

Le indication, stopps shortley after cycle starts


Answers :

LE indicates a problem with the wash motor. I've replaced mine twice now. Check to see if something has the pump locked up first.
\015\012
\015\012Motor can be replaced by turning unit on its side. Motor is on the bottom. First take off pump impeller from inside the dishwaser (left hand thread on screw). Turn unit on its side and remove cover. Motor is the one in the center of unit. LG part# 4681ED1004A. This motor can be ordered from repairclinic.com.
Repair Help & Product Troubleshooting for LG LDF6810ST Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Le indication, stopps shortley after cycle starts


LE indicates a problem with the wash motor. I've replaced mine twice now. Check to see if something has the pump locked up first.\015\012\015\012Motor can be replaced by turning unit on its side. Motor is on the bottom. First take off pum ... LG LDF6810ST Stainless Steel Built-in Dishwasher

Model KUDS30FXSSO, Unit attempts to start. Blue light on the front of the door comes on indicating the cycle is starting. Pump runs a few seconds as normal. Then the maching sounds like it trying to start the next step three or four times. The blue light goes out. The washing cycle then switches to cancel/drain, ( I opened the door to see which control lights were on.) runs the drain pump then stops. The green light on the front panel does not come on indicating the cycle was completed.


... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

Kenmore model 5871526 When wash cycle is selected and start button is pressed, the wash cycle indicator, heated dry indicator and the Washing cycle indicator lights flash continuously - but the dishwasher does not start


... Kenmore Dishwashers

Hello. I have a Kitchen Aide KUDG255HWH1 that will not start from a cold state. The "Energy Saver Dry" and "Normal" indicator light/ switches failed to operate about 1 month ago and since then I have needed to use the "High Temp Wash" and Soak & Scrub" cycles to get the unit to run. Now these two indicator kight will illuninate but the unit will not start when I depress the "On" soft switch. When I depress the cancel switch the unit starts with what sounds like a pre-start cycle. Pleas


Hi\015\012\015\012\015\012\015\012\015\012\015\012Thanks for using FixYa. To reset the dishwasher switch\015\012off the dishwasher from the power socket and mains for five minutes and then\015\012switch it back on. If still the issu ... KitchenAid Dishwashers

Kenmore dishwasher model# 110753613 - Lights are on to indicate cycle settings but won't start. It is supposed to start when door is closed but but it doesn't start nor does the cycle knob move through the cycles..


... Kenmore 15939 Built-in Dishwasher

After interrupting a wash cycle by opening the door, the "start" button indicator will not light when the start button is depressed. (Neither will the "delayed start" indicator work.) The dishwasher will not resume any operation. All other control indicators light when selected. Removing and restoring power to the unit does not clear the problem. The unit is a Jenn-Air model JDB1100AWB.


It is possible that by opening the door mid cycle, the door switch mechanism has got disengaged. Refer item 11 in ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

Hi, The machine will not complete a cycle. I think it may have started when the power was turned off at the mains during a cycle. Symptoms are : - You can turn machine on, select a program, press start button, close door, machine appears to begin cycle as normal, water seems to load, then 2 minutes later drains, and 1 minute or so after that the machine beeps 3 times to indicate cycle is finished. Dishwasher tablet door never opens, dishes not cleaned. Have tried : - cleaning filters; - turn


It is likely the dishwasher is locked in some diagnostic program.\015\012If you provide the dishwasher model no. then I can try to find out the keys you need to press to get it out from it. ... Whirlpool Dishwashers

I have whirlpool Dish washer model GU 120 ES (bought in 2001). When we start the dish washer cycle the unit starts for a minute, then the "start indicator" light flashes. As indicated in the instructions, we press the "start button" for five (5) seconds, at this time the washer clears the water out and stops. If you can assist this would be greatly appreciated. Thanks Jeff


I called the service tech.... ... Whirlpool Dishwashers

We have a Bosch SHE44C02UC/46 that suddenly won't start. I pushed the on/off button to start the dishes cleaning on the 'Power Scrub Plus' cycle and the display lights up with a 125 min. indication for the cleaning time, but the dishwasher never starts. It just sits there completely silent and never begins the cleaning. The dishwasher has worked perfectly up to, and including, the last cleaning cycle (3 days ago) for the last 4 years. Suddenly, today, nothing. Zip. Zilch. Nada. I don't get i


Hi.Re:" I\\'m sure it has to be something simple." A: yes, probably a fault, simple as that.To start there is a recall concerning this model. ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

My CANDY DFI 45 dishwasher won't start it's cycle. I select the cycle, close the door and it does a two tone bleep and nothing happens? I did notice the indication LED to add more salt had come on, I have added the salt and the LED has gone out. Still not starting the cycle. Any help would be greatly appreciated!


... Dishwashers

Maytag model MDB4651AWW3 recently the lights for normal cycle do not light and wouldnt start unless you got lucky. Now it wont start all together and when start is pressed you can faintly see light on the start and wash indicators. Please Help!


HiIf you have already tried leaving it unplugged for a while then the issue is with the control board that has gone bad and should be replaced to solve this issue. You can also try to blow some compressed air on the electronic control and ... Maytag 24 in. MDB4651A Built-in Dishwasher

I have a Whirlpool ADG937 dishwasher (9 years old) which will not complete a 65c wash cycle. It starts Ok and runs for a long time but then continually bleeps, when I open the door the programme indicator light is on the rinse cycle. If I reset the programme to 65c it may do the same or occasionally it will finish the cycle. I have tried salt top-up, descaling and filter cleaning all to no avail. Is the programmer faulty (can I bypass it?)or should I replace the washer?


... Whirlpool Dishwashers

Clean light blinks 7 times pauses 1 second and repeats. will not work. the light above the clean cycle indicator blinks 7 times. I can not run the dishwasher, When I press start the light above the start button blinks and will not start


Hi there,\012Well first of all you reset this by pressing - High Temp Wash, Heated Dry, High Temp Wash, Heated Dry, High Temp Wash.If you don't have a heated dry then use "air dry"This sequence help you to reseting the e ... Whirlpool GU2400XTP Built-in Dishwasher

Machine starts fills Ok but when it clicks on to start the wash pump, nothing happens, I can hear a faint hum. When cancelling wash and starting new wash it pumps out ok too. After rinse cycle it indicates a completed wash, but no water has been pumped through washer arms.


Sounds like your main circulation pump is not working, if it is humming when it is supposed to start, sounds like it is getiing power, so probably not the control circuits, can you measure voltage to pump?if you are getting 120 there, probably pu ... Asko D1876 Dishwasher

Door indicator light does not come on when door closed and wash cycle will not start


... Kenmore 24 in. 15932 Built-in Dishwasher

Teka DW6 55 FI giving alarm signal and first 4 of led light indicators blinking as soon as I selecting any washing cycle and closing door (which should start cycle)


... Dishwashers

Bosch she44c wash cycle time keeps extending. Once averaged about 130 minutes, now starts at about 150 minutes indicated. Seems to hang up at 1 or 2 minutes before cycle end, then keep running for as much as 4 hours. Water is hot, filters are clean.


We have had the same problem, except the water was not getting hot either. After a ton of research there was an issue that kept popping up. There was a massive recall on many of the model and serial #s. According to the recall there was a fire risk f ... Bosch Dishwashers

When I start the cycle the lights on the panel turn off as if to indicate the power is off, but the dishwasher is still running with no water being dispersed. I let the cycle run through, but the dishwasher is still filthy afterwards. (not cleaning at all) What colud be the problem?


... Magic Chef DU6500 Dishwasher

I have a Miele Incognito Dishwasher (G 858 SCVI PLUS) that starts a cycle, goes for maybe 45 seconds, then stops. The large indicator begins flashing and the Salt/Intake indicator flashes/holds solid/flashes. This has been and intermittant issue with this Miele. I have been walked through troubleshooting sessions with the official Miele support - a handful over the last 5 years - that end up with a reset . Its always time consuming as they have mediocre to poor customer service - 8-5 ET o


... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

I have a F&P dishwasher model DW60CDX1 (around 5 years old) which we cannot start a cycle. The dishwasher turns on (power button and all programme indicators light up) but when you press a programme button nothing happens - the lights don't change. We have switched the power off at the powerpoint and on again a few times but this has not rectified the problem. It was playing up before this in that sometimes the programme would not start when a button was pressed but I just closed the door mor


The micro switch in the door which senses the door closing has probably failled. This is accessible once the inner door cover is removed. Switch should be under $10 from electrical store. Or buy through appliance manufacturer. ... Fisher and Paykel Dishwashers

My GU 120 stops mid cycle and the indicator light starts blinking a humming whirring sound preceeds the ctcle stop nad light blinking. Pressing the button for 5 seconds causes the flashing light to extinguish but the sound continues untill the unit stops. It does not complete the full cycle. Your help would be appreciated. Tony


... Whirlpool Dishwashers

I have a Whirlpool Gold Quit Partner III, model GU1100XTLB1. When I run the normal cycle it functions well until near the end. At that time the unit stops and the pots&pans indicator light blinks. If I hold the cancel button in the unit drains then refills and the light starts to link again. I don't know how to reset this unit because I only have air dry. If I leave the power off for a day I can get the unit to reset. If not, it just fills back up with water and the pots&pans starts blinking aga


... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Non-starting unit The dishwasher will not start, reacting as if the door is not closed. The right side of the control panel (air dry, sani rinse, hi-temp scrub) allow selection i.e. the indicator light comes on. However, none of the cycle selection buttons on the left will engage.


... Kenmore 24 in. 16934 Built-in Dishwasher

Whirlpool APD5550 Dishwasher, cycle does not start, green light on start button flashes 6 times, pauses, flashes 6 times etc. can you please give me some indication what the problem may be. Thanks


... Dishwashers

I have an indesit dvg 622 kix dishwasher and about 30 seconds after starting a programme the 1st indicator light starts flashing and the machine sounds like it is going through a emptying cycle what could the problem be


... Indesit Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1343 seconds