Having problems with your LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher ?

Vent cover on bottom of door has broken off

\015 The vent cover has broken off, letting moist air hit the floor making the floor wet\015

Answers :

Repair Help & Product Troubleshooting for LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Vent cover on bottom of door has broken off


... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

Vent cover on bottom of door has broken off


... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

Model # PLD2850RDC2 has a leak at the bottom of the door. i have replaced the gasket in the vent. Had to remove door cover and seal at bottom of door. Had difficulty replacing bottom seal. How do I replace seal correctly? It is still leaking. Could it be something else?


The side baffels are bad. look on each side on the bottom in the corners and that is were their at just pull them out and get new ones ... Dishwashers

Maytag model mdbtt70aww. After the end cycle. open the door and found detergent tab on the bottom and the main wash cover is opened. Maytag diswasher model MDBTT70AWW. Put dishes and so forth in the dishwasher. Put detergent tab and jet-dry rinse agent in the pre-wash section. and close the cover. Start wash cycle after done over door and found the detergent tab on the bottom new the heater. The cover to the main wash is opened. Dishes are are clean. Wish someone would tell me


... Dishwashers

Door leak I have a small leak between the bottom of the dishwasher door the lower service panel on the dishwashere. I did replace the seal on the inside bottom of the door along with the other parts that come with the door seal. Could there be a gasket leak around the detergent dispenser or the vent at the top of the inside of the door. I did not check the water lever as was mentioned in a previous question on water level, but the float does move up and down quite freely. Any suggestions as to w


I had my dishwasher leaking alot at the bottom of the doo,r and found out that the steam vent was very cloged with gunk. After taking the vent cover off on the inside of the door and cleaning, then putting the vent cover back on NO MORE leaking. Th ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Maytag dishwasher MDBTT50AWS Door Latch broken. Screws hold the top. The bottom appears to fit into ''plastic teeth'' . Are the teeth supposed to have top and bottom or just bottom teeth. It appears mine has broken teeth on bottom. Is so, do I need to replace control panel to hold latch at bottom.


... Dishwashers

Quit working during wash cycle, about 6 liters of water left in bottom, looks like it quit during rinse cycle. There is power to the door switch and door switch works shutting off power when door is opened. However the control panel does not respond to any push button. I have had a problem in the past with moisture from the door vent getting into the control panel area causing the push buttons to become eratic.


The capacitors in the control panel could be bad or have burnt out. Do check all connnections and if necessary, check the continuity of the power to and from the control panel with an ohm/voltmeter. ... Dishwashers

We have had an LG 7810 dishwasher since 2007. There is a film always left in the bottom of the dishwasher (large area, covers most of the bottom, not just near the drain) and a moldy sludge that builds at the bottom where the door seals. We can clean it out manually, but I don't think you should have to wash the inside of your dishwasher.


When you are done doing your dishes are they hot? do you see steam comeing out the dishwasher?\015\012if no you have a bad heater\015\012try heated dry are they dry at the end? not including plastic they never dry and the tops of cups. ... Dishwashers

The wooden door on my built in stoves dishwasher has become disconnected at the bottom clips. I removed the door cover and the clips dont look right, how is this door supposed to be fixed?


... Stoves 27 in. DW60 Built-in Dishwasher

The detergent dispenser [Main Wash] door doesn't stay closed. It seems like there is something wrong with the latch, but we can't what. We've cleaned it, but don't know what else to try. There don't seem to be pieces missing or broken. But no matter what, when we put in the detergent [we use the cubes] the door always just pops open and the detergent ends up falling to the bottom on the dishwasher. The dishes are still getting relatively clean, but we want to solve the problem with the door


... Frigidaire FDB1200RG 24 in. Built-in Dishwasher

Drying cycle vents at bottom of door causing a slip hazard


Call the manfacturer and give them give them make model and year of machine.If problem they may be aware of it and should be able to help you ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

I have a Maytag MDB4800AWB and it leaks at bottom left side between the two panels, is there a seal I can replace,and if so, how do I do it? Also according to the warranty Maytag covers leaks of door


... Maytag Dishwashers

LDF9810ST/01 steam release vent leaking water on left bottom door


... Dishwashers

I have a Whirlpool DUL300XTLQ3 Queit Partner III. The cleaning blades stopped moving-started it-waited awhile-opened it-the blades were in the same position. Took the bottom blade+filter cover off. Then I held down the metal piece on the case and switched on the micro switch on the door to see it running with the door open. The water shot straight up about 4-5" that's it. This does not seem to be enough pressure for the water to get all the way up to the top spinner. Am I looking at a new pump


If there is not enough water, the dishes would not get cleaned. Thiscould be caused by a partially closed water shut-off valve (locatedunder the sink), or a faulty dishwasher water valve (located at thebottom of the dishwasher, behind the kick panel, ... Whirlpool Dishwashers

We have a leak around the door. It looks like it is around the bottom of the door. We can not find any reason for this. We have checked seals and everything else we can think off at no avaiel. Model 15919. We have found pieces of black stuff on the floor like maybe a protective cover that is deteriorateing . Other then that, everything else is fine. Thanks Dan


... Kenmore 15919 Built-in Dishwasher

When dishwasher is running, it leaks water from the lowr right corner of the door. It looks like a water guard is on the inside of the door and part of it is broken off at the bottom right corner.


... Frigidaire FDB130RGS Built-in Dishwasher

Water is leaking from the door (bottom) and some got through the air vent at upper left corner!? I just repalced the heating element gaskets, so they are not to blame this time. door gasket?


... Frigidaire 24 in. PLD3460 Built-in Dishwasher

I have Frigidaire model FDB130RGS3. This seems like a pretty cheap dishwasher that is provided by my management company. This is third dishwasher I've had in this apartment. The others have all broken. Now this one, which is less than 6 months old, seems to have broken. It does not clean the dishes. I removed the round plastic cover in the base of the dishwasher and the bottom of the dishwasher (sorry don't know how else to describe this) is filled with dirty water. I drained the water and tried


Hi,\015\012\015\012the round plastic cover in the base should just push back on, but you need to make sure it is correctly rotated before doing so. It should look like this:\015\012\015\012\015\012 ... Frigidaire FDB130 Built-in Dishwasher

I have LG dishwasher for 2 years now. Working perfectly until one day one glass gets broken during washing cycle. Immideatly we get EO error. We check possible reason of error in the manual then decided to try to fix ourself. We open bottom cover and drain outcoming part. Immideatly we discover a piece of glass that was preventing a small plastic piece to rotate. We remove that piece of glass. Put back covers and machine. We connected it back to outlets and run it. All was working again !!! This


In order to fix problem we disconnected dishwasher, put it on one of side, opened bottom cover - the one that is outside of dishwasher. We find out the part that is\015\012connected to the drain horse. We take of 3 screw and open that part too ... LG Dishwashers

Dishwasher leak I have a General Electric Potscrubber Mobile Maid dishwasher (model GSC720?) that hasn't been used in some time, but appears to still work OK. It has a leak from the left hand vent opening in the bottom of the door when operating. The seal around the door appears intact and doesn't leak. Can you suggest a probable cause, and remedy? Thanks, Bob.


With dishwasher empty and disconnected, find the screws around the area of the "vent",you may need to open it from the bottom. There will be a hose that has either ruptured or just needs the clamp tightened with a screw driver. I think that the hose ... Dishwashers

When the dishwahser door is lowered to unload the bottom rack, I get a small puddle from the top, left side of the door. this is the area where there are vents for the steam that releases during the final stages of the dishwashwer. this puddle happens every single time regardless of how long or short of time after the dishwasher is complete. Is something not working correctly? Or is this just a bad design and condensation is buidling up and this puddle is the result? My wooden floor is taking a


Most dishwashers of this design have a small extractor fan built in if yours is one of these it may not be working if not try adjusting door latch a little tighter hope this helps ... Kenmore Dishwashers

BOSCH SGS6302GB I took the front door cover off my dishwasher and 2 clearish plastic grommits fell out from the bottom (each side) of the door. I cant see how they fit back in. Can you help me?


Hi nikkij\015\012\015\012 It is simple to put them back on. the plastic pices fit on the bottom of the hinges. there is a cut out where they fit in. when you look at the door at the bottom you will see the hinges and the cut outs, the ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

We have a bosch integrated dishwasher with a broken handle. We can't get the cover off to replace it! There are no visible screws on door front and I am unsure about unscrewing the metal panel door in case I damage further. Please help!


I am not sure how to fix your broken handle issue but if you are ever looking to change the look of your appliances like I was then you should check out www.applianceart.com. ... Neff 24 in. S5443X2 Built-in Dishwasher

My Brandt VF300 dishwasher is not draining properly. If I empty the residual water (by hand) I can still use it but the water still remains in the bottom at the end of each cycle. How can I fix this? It's driving me nuts! Also the door is not functioning properly something has broken that supports the weight of the door. It can only be shut completely or open completely! Is there a part that can be bought to fix this?


... Dishwashers

Whirlpool gold gu2500 dish washer leaks from behind door panel. After inspection it is splashing out vents in bottom of door and pan. unit does not do this all the time. it does it on every cycle and even when ran empty.


... Whirlpool GU2200XTSS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1128 seconds