Having problems with your LG LDS4821ST Stainless Steel 24 in. Built-in Dishwasher ?

Leaking from the dryer vent on base of door during wash cycle. I know I have water coming down through the dryer vent in the door. I guess it works like a thermostat in a car and opens when it gets hot, but it leaks cold. Can I get that part?


Answers :

Before try to repair, gather the model and serial number from the unit and contact LG support line. There was a recall on early versions of the (energy saving) condensing drying cycle and specifically most of the components in the door.

If the problem is what I described above, this is not a warranty issue but a product defect/recall. Be firm with them, be polite and do not take no for an answer, asking to be "escalated to the phone guy's supervisor:"

Good Luck!
Repair Help & Product Troubleshooting for LG LDS4821ST Stainless Steel 24 in. Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Leaking from the dryer vent on base of door during wash cycle. I know I have water coming down through the dryer vent in the door. I guess it works like a thermostat in a car and opens when it gets hot, but it leaks cold. Can I get that part?


Before try to repair, gather the model and serial number from the unit and contact LG support line. There was a recall on early versions of the (energy saving) condensing drying cycle and specifically most of the components in the door.I ... LG LDS4821ST Stainless Steel 24 in. Built-in Dishwasher

I have the Fridgeadair Dishwasher FDB1502RGS model. It worked fine for several months but now it does not clean or rinse the dishes properly. It does not get hot any more. It used to be that when you open the door after washing is done it was hot and steam would come out. Now it is cold when you open the door. Please advise what the problem might be.


... Frigidaire FDB1502RGS Built-in Dishwasher

I have a Blanco Dishwasher Model BFDWC65X. It appears that the thermostat may be faulty as the water gets extremely hot on cycle 3 which is supposed to operate at 45 degrees centigrade. When I open the door mid-cycle, clouds of steam emerge and the whole dishwasher smells hot - almost a burning smell. I have found an online source for a replacement thermostat, but would like to know how difficult a job it will be to replace the thermostat. Also where can I find a manual that details where the th


... Dishwashers

Kenmore dishwasher. The upper rack is not getting clean. Even very light residue remains. And, detergent is left in door at end of cycle. The bottom is filling up, so I don't think it's the intake valve. Also, all the blade openings appear clear. I am noticing that hot water is not filling the dishwasher when I first run the cycle. Even if I have hot water running in the sink, the dishwasher fills with cold or warm water. So, I think this is the problem. What should I do? Thank you in advance!


I find it odd that the dishwasher is filling with cold water if the water is hot at the sink. It sounds like the dishwasher is connected to the cold water line rather than the hot. Check under your sink; if you've got standard plumbing, the dishwas ... Dishwashers

Indesit idl 535, washing on usual cycle but not heating and dishes not being cleand properly? Disolves tablet and goes through full wash cycle as usual but doesnt wash dishes properly and the dryer isn't working as it normally is hot when you open the door, but it is just cold. water draining as normal too.


Your problem is very clear, you need to replace the wash tank heating element. ... Indesit 24 in. IDL500 Built-In Dishwasher

The air dryer vent on the door is filling up with water and squeaking during operation. When I open the door water comes out of the vent and then it operates OK until next used. How do I open the vent, is there a seal to be replaced or what, thanks Carol


... Miele 24 in. G646SC Plus Free-Standing Dishwasher

When my dishwasher completes its cycle, there is powdered detergent left in the dispenser and the dishes aren't as clean as they use to be. This started happening after I ran a HI TEMP WASH with a SANI RINSE cycle. I'm thinking that either the detergent dispenser door is opening late or the water is not getting hot enough. To check the dispenser door, I left the door open and just poured powder into the dispenser compartment. This did not improve the cleaning.


Hi\015\012 \015\012Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doesn't allo ... Kenmore 16372 / 16374 / 16379 Built-in Dishwasher

Kenmore 665.16529000 When we put the dial to pots and pans the diswasher fills up and cycles through, when the dials moves to normal wash, it fills up and cycles through again. When the dial gets to light wsh we can hear the motor running but nothing is happening, but the soap door opens soon after. The heating light comes on and the inside of the dishwasher gets so hot that it has melted our big plastic tumbler cups on the top rack and makes the counter top extremely hot to the touch. The dial


... Dishwashers

My dishwasher has stopped cleaning plates properly. It makes everything wet but at the end of the cycle the detergent block is half dissolved at the bottom. I have just run a cycle and opened the door during this. The bottom is full of soap suds and water and the top spray bar is dripping water after I open the door but when I close and then reopen a few secs later the top spray bar has definetly not rotated. The water is also not hot, this dishwasher is a cold fed only machine so I guess the el


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Zanussi 18 in. ZSF4123 Slim-Line Free-standing Dishwasher

My Kenmore series 70 dryer heats up but takes 3 times on 70 minutes to dry the clothes. After every 70 minute period when i check the clothes i open the dryer and it is like a steam room. It is getting really hot but the clothes aren't getting dry?


Check your dryer venting for obstruction.  Take the vent hose off and run the machine,  If it works with the venting disconnected, It is between your wall and the outside of the house.  If it still has the same problem it is somewhere ... Dishwashers

My Omega Eurolux Dishwasher (mode: DW211P/1) won't stop cycling, It sems to get stuck during the wash cycle and continues for hours, until I turn it off. If I turn the dial to rinse it rinses fine. It doesn't seem to heat the water at all, there is no steam when I open the door. I have put a new heating element in, but this doesn't seem to be heating up at all. When I open the door mid wash cycle the element is cold to touch.


... Dishwashers

Quit working during wash cycle, about 6 liters of water left in bottom, looks like it quit during rinse cycle. There is power to the door switch and door switch works shutting off power when door is opened. However the control panel does not respond to any push button. I have had a problem in the past with moisture from the door vent getting into the control panel area causing the push buttons to become eratic.


The capacitors in the control panel could be bad or have burnt out. Do check all connnections and if necessary, check the continuity of the power to and from the control panel with an ohm/voltmeter. ... Dishwashers

Smeg integrated dishwasher.when you set it sounds as if working but continues to go on for ages.when you open door it is stuck on glass wash. if you open during wash water is cold where previously was hot.


... Smeg DWI614 Built-in Dishwasher

We have the same problem. At first, we were getting a horrible detergent film on everything. We thought that was because the detergent cup wasn't opening or the water was too hard or not hot enough. We kicked up the rinse agent as high as possible, switched to a liquid detergent, and only placed shorter items towards the door. The cup still wouldn't open consistently and our dishes still needed to be re-cleaned. We stopped closing the cup. No change. Why would liquid detergent leave a powder fil


You dont need a new dishwasher. it is your water that is causing the film and residue. go to www.dishwasherfilter.com. they have an awesome product that is affordable and g ... Dishwashers

Water spills out of the dryer vent when i open the d/w door after a cycle. Why is this and what can I do? If I have to remove the door, specifically, what screws do i remove? Thank you. Maureen


Hello,\015\012\015\012welcome to Fixya. \015\012\015\012The issue is likely just the blower and housing drain hose blocked with "dirt" from time & use.\015\012\015\012First things first...**turn off th ... Miele G892SC SS Dishwasher

Diswasher TYP NBKH, SERVICE 8546 892 10010 Problem: For all programs except rinse and charge 1/2 for all programs. Pre-rinse and rinse for 50 Bio, 60 and 70 OK. Downloading water to wash causes multiple knocking (on the left side dishwashers) and simultaneous blinking light (relais?). Opening doors and adding water (different amounts - from 0.5 to 2 l) brings the normal work of dishwasher back. Rinse with cold water after washing OK. Final cleaning with hot water causes knocking again. After r


... Dishwashers

Water comes out of the dryer vent when opening the door after wash cycle is done.


... Miele 24 in. G865 Built-in Dishwasher

Candy cs455m the dial goes through one cycle but it stops when it gets into another cycle and there seems to be no heat because when we stop the cycle and open the door the plates are cold and the water has not been dried off


\015\012\015\012\015\012Welcome to fixya.\015\012\015\012I'm Huuum at your service.\015\012\015\012You said, The dial goes through one cycle but it stops when it gets into another\015\012cycle and there seems to be ... Candy 17 in. CS455 Built-in Dishwasher

Bosch logixx dishwasher sounds like its running continuously & will go through entire program but does not fill or wash. Filled it with hot water manually to try for air locks & it does drain out. Then continues to attempt to drain even while door is opened. My amateur guess is that its a float switch but can I get at it from the inside or from the back? If thats what it is. Hope you can help,thanks.John


... Bosch 24 in. SGS09L12 Logixx Free-standing Dishwasher

Frigidaire dishwasher Mod# GLD4050RHS overheats, melting plasic contents, and venting steam upon opening door hot enough to burn my face. Did so when new, numerous service calls eventually leading to part# 5304467317, 154642901, 154467702, 5304467317 154543602 replaced. Satisfactory service 13 months and now melted another load. Suggestions? Fear fire hazard.


... Frigidaire GLD4050RHS Builtin Dishwasher

Our KitchenAid Superba model KUDS01DJss0 ( about 7 years old and has always worked fine) I think is not heating . . the dishes come out wet and don't seem very clean if they had especially if they have a small a bit of something like peanut butter on them when loaded ( so lately I've been dong a pre-wash by hand). Unit doesn't seem to get very "hot" during the wash/dry and steam does not billow out when I open the door soon after the cycle completes like it used to. It does feel warm to the


Hello. The new heating element will come with a new control board. There are no tricks to the change actually, the easiest way to change the heating element is to unhook the plumbing, electrical, and drain hose then pull it out and get to the back ... Dishwashers

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

Dishwasher I have a whirlpool dishwasher that does not appear to be getting hot water. The washer water is cold initially and only seems to get warm once the heater in the base of the machine heats it. The hot water supply line does not get hot so I presume no water is being supplied. Is the water supposed to be hot at the start. If yes could this be caused be a faulty inlet valve and if so how can I check. The dishes are dirty especially on the top rack. Thanks for your help. David


Gendos is on track with his question. I have the same dishwasher and it doesn't get enough hot water to clean the dishes and runs for hours because the heating element wasn't designed to heat water, just maintain it. The only solution we have found ... Whirlpool GU2400XTP Built-in Dishwasher

I have a mitsubishi cp 9800 dw a erra that work great a error came up that stated after fixing error open and close door. I tryed to open door and it won't open. How can i get the door to open?


... Dishwashers

FDW60 Fault Hi, I have exactly the same problem. My dishwasher starts and washes ok but appears to get very hot during the drying phase and then the two lights fast and eco flash warning of a heater problem. I suspect either the heater, thermostat or control PCB. As the rest of the cycle seems of and the water gets hot then I'm assuming the heater and thermostat are OK. When the dishwasher attempts to dry is when the problem starts. Did anyone find out what there fault was? Thanks


Hold down the start key and you will re- set the D/W. Please Rate This !!! Thank YOU !!! ... Hotpoint 24 in. FDW60 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1004 seconds