Having problems with your Maytag 24 in. MDB4000 Built-in Dishwasher ?

Can I add vinegar to the detergent dispenser or the tub of the Maytag 4000 series(450) in order to prevent dye leakage of red laundry ? I just want to make sure it will not damage any components.


Answers :

Repair Help & Product Troubleshooting for Maytag 24 in. MDB4000 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Can I add vinegar to the detergent dispenser or the tub of the Maytag 4000 series(450) in order to prevent dye leakage of red laundry ? I just want to make sure it will not damage any components.


... Maytag 24 in. MDB4000 Built-in Dishwasher

I wanted to heat up a cup of tea. As I've done many times before, I pressed Time, then 1:20 seconds, then I pressed Auto Start, but fear I may have touched the button below it, which says Start in small red print. The oven wouldn't switch on, and I noticed a small green u-shaped mark had appeared at the base of the 1: I pressed Clear, and repeated my movements, making sure this time that I pressed Auto Start. Again, nothing happened. I've cleared the touchpad several times, but the oven won't


... Danby 22 in. DDW399 Free-standing Dishwasher

I need the diagram for the door pulley system so I can make sure I am hooking it up right. The original door chord/pulley assembly broke. I ordered new parts, Now I want to make sure I am putting it back together the right way. The edge of the screw- on floor panel is pushing the plastic hook off of the door hook when you shut the dishwasher door.


... KitchenAid Dishwashers

I have a Maytag dishwasher, model #MDB4100AQ. Is it possible to replace the door panel on this dishwasher? I see the relevant part number (99002109) in various online parts stores, but before I order it I want to make sure this is a do-it-yourself job. I can't see any screws or other hardware that's holding the panel in place.


You may not have to deal with the screws. Check out ApplianceArt.com to see if they might have a solution to fit your needs. I know they have stainlesss options, but also colors and designs. ... Maytag Dishwasher

I have a SHU8805UC/14 BOSCH DW and need to replace the inner door panel. I ordered the part, but there are no instructions on how to replace the door panel. I want to make sure I do it correctly, so


Go on line with Bosh company and look up dishwashers giving your model. Request technical assistance to install the panel... ... Bosch Dishwashers

I have a kenmore dishwasher ultra wash quiet guard deluxe and broke a cup in the dishwasher. I want to make sure to get anything big that made it through the top filter. How do I get the bottom spray bar and filter off to check


... Dishwashers

The problem is with the recirculating pump not the drain pump. I would like to know the details of how to dissemble the impeller and make sure it turns freely without potentially damaging the grinder assembly that I have access to at the moment. Thanks in advance, Rick


... Kenmore 24 in. 16539 Built-in Dishwasher

Need to disconnect power from GE 530 dishwasher. It's not draining and I want to get to the drain hose to make sure it's clear


... GE 24 In BuiltIn Tall Tub Dishwasher GLD4406RWW Firewall

Dishwasher making a loud buzz when the impeller starts. Tappan Cheapest. Is it easy to open the impeller area and check for debris or damage? Looking for schematic to decide whether to call tech or get a new one or do home repair. It is in a rent house and I don't want to spend to much time...or money.


Is it the renters machine .This maynot be your reponseablity.If so Get a Portiable machine kenmore is good. ... Dishwashers

The red intake/drain light comes on. I have removed the filter and drain however, this does not seem to make a difference. The machine works very intermittently so I am not sure what the problem is. Please help!


... Miele 24 in. Novotronic G842 Plus Built-in Dishwasher

Bosch DW model SHU53A05UC/17 was working fine until yesterday evening. Went to turn it on and now get nothing. No lights, no power zip. It's on its own 20amp circuit. Checked the fuse and it's not blown. Flip the breaker on/off a few times anyway to make sure. I was installing a floor and used my miter saw on the sump pump circuit (diff from the DW circuit). It blew the fuse a few times. Any chance, on a diff circuit, it spiked and damaged a board in the DW? What part (part #) would


... Dishwashers

I need the dimensions of my maytag 24 inch 18 yr old builtin WU284 dishwasher. I was planning on replacing it, and I wanted to make sure the new one would fit into the opening.


... Dishwashers

Hi there, I have a Whirlpool GC1000 garbage disposal. I've tried hitting the red reset button and checked to make sure there's nothing clogging the sink, but the disposal still won't come on when I flip the switch. Is there anything else I can do? Thanks!


... Whirlpool Dishwashers

My question is this: once the flood activation switch (F1 error code) has been activated due to water in the tray, will the switch self-set once the lower board area has dried sufficiently, or does it require a board replacement? I have found (I think), and will be correcting the leak, but wanted to make sure the water sensor is healthy or not.


Hi\015\012\015\012\015\012Thanks for using FixYa. You are right, F1\015\012error means that the flood switch has been activated. You’ll need to res ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Dishwasher makes a humming sound, but does not flow water to jets


... Kenmore 16973 Stainless Steel Dishwasher

Maytag mdb9150 dishwasher stopped at some point last night--found it this morning with flashing lights--I think "clean" and "heated dry", not sure.  I used "drain/off" to make sure there was mechanical noise--there was, so I don't think the machine is dead.  Purchased on 2001 with 5 year warranty, so out of luck there.  I tried turning off the electricity to the unit for a few hours; nothing improved.  When you start it (or think you have!) it makes noises for about a minute that sound promising


Check pump and solonoids click/work, if no mechanical noise, could be the circuit board, but they can be expensive. :(\015\012if the solenoids click, and allows water in, then the pump might be jammed, with grit, clean and reinstall... good luc ... Maytag 24 in. MDB9150A Built-in Dishwasher

I have a built-in Bosch dishwasher SHU 4302 UC. It no longer drains the water out at the end of all the cycles. I have tried everything mentioned in the booklet (make sure water is hot, use the jet-dry stuff, make sure outflow hose doesn't allow water back in). I have to siphon out at least a good bucketful of water. (Also, only the regular wash cycle works, which is fine with me.)


The problem is a solenoid on the bottom of the unit. It is a small black cylinder next to the pump. It operates the valve that changes to the drain cycle. You can probably order one from Bosch ... Bosch 24 in. SHU43 Built-in Dishwasher

My 5-year old Bosch dishwasher leaves a somewhat fine grit on dishes? especially obvious on the inside of glasses. I use only Cascade detergent, use a rinse aid, don't overfill the machine, and always make sure that the filter at the bottom of the dishwasher is clean. I also make sure that the spinner is able to move freely. But, after all of that, I sometimes get very clean dishes; even more often, not. I see no rhyme or reason. I am presently looking at an entire load that has gone through


I have the same problem with mine!! It's 6 years old, and I'm running loads of dishes through twice. Even that doesn't help! And I rinse the dishes too, so I have no idea where all these "crumbs" are coming from. Will check back for updates. Hope to ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

I have a neff dishwasher that is maybe 5 years old. im pretty sure there is nothing wrong with it as it was working perfectly fine before i had a plumbing problem a few days ago. after the plumbing problem was fixed the dishwasher doesnt seem to want to fill any longer. it sounds like it wants to work but its just not filling and going thru the cycle. does it just need to be reset or something? im not sure of the model number as ive misplaced the directions for it. could you please help? by the


Look for the connection from the valve to the inlet of diswasher. Check the hot water valve to be on. It is probably closed when anyone working on the plumping. Good luck. ... Neff 24 in. S5443X2 Built-in Dishwasher

My SHU 5305 UC has sporadically heating problems and runs forever. I left the door panel open to put gauges on the red wire (heating) and ran 4 cycles OK; the fifth times there was no heating current


... Bosch 24 in. SHU5305UC Built-in Dishwasher

Motor makes noise shortly after starting, makes normal sound level during main body of wash, then makes noise again during what I'm guessing is the rinse cycle. Not sure if it is a pump or motor problem. Slight electrical smell noticed after finishing the ''cancel/drain''. Water does not seem to be sprayed around washer during normal cycle, even though water has been in the washer.


Make sure the sprayer arm is turning freely, check for something stuck in the base of the sprayer arm (food or utinsel) preventing it from turning. ... Dishwashers

Hi, We have a Smeg ST 663 dishwasher that does work. However, sometimes when you want to use it and turn the power button on it beeps twice with the red light flashing and you can't get it to work or change the settings. Sometimes if we leave it for a while and try it again later it will work, but it is annoying as sometimes it won't want to work for ages and we really want our dishes cleaned! The dishwasher doesn't have many buttons on it (a power button, cycle selection button and 1/2 load


Hi,\015\012\015\012Turn machine on and press and hold the programme select button till the light goes out about 5-7 seconds see if this resets it if it does start a cycle and see what happens.Otherwise the pcb as its not responding to an ... Smeg Dishwashers

THe door suddenly won't shut all the way. I made sure there was nothing physically in the way--duh--then realize it has to do with the door itself. I made sure the inside of the latch (I guess that it would be called the feamle side) wasn't gunked up. The male side is free of gunk, dose not seem to be damaged. HELP!!!


Hi,\015\012\015\012Usually the only reason a dishwasher door will not close is if either someone has fallen on the door and stretched the door hinges which would then require a service call to replace them or if the unit is not level. if ... Dishwashers

I have a credaplan integrated dishwasher with no manual it came with the house so is about 15-20 years old. I want to put salt in it. I have found a compartment with an 's' on it but just want to be sure that this is the right place. I have never owned a dishwasher before. Thanks in advance for your help.


... Creda 24 in. DWI34 Built-in Dishwasher

How do you gain access to the Front Panel circut board? On a Jenn Air JDB8910AWW Dishwasher? If I want to check the soldering connections, I don't want to open up areas which would make more work for me. Thanks for your time .. Mark


The front panel control board is accessed by taking off the inside door panel that will release the control panel so you can get to the control board but do not try to solder connections on the board just replace the complete board ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0816 seconds