Having problems with your Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher ?

How do I disconnect the electrical wire plugs from the door handle in order to replace the handle? The plugs won't pull straight off and so I am wondering if there is any piece of equipment needed to disengage the plugs from the prongs.


Answers :

First shut off the power to the dish washer. The plugs are just verry hard to pull off. You may brake the switch on the old handle but if you have the right new part it should have new switches on it. Just pull hard side to side wiggle off.
Repair Help & Product Troubleshooting for Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do I disconnect the electrical wire plugs from the door handle in order to replace the handle? The plugs won't pull straight off and so I am wondering if there is any piece of equipment needed to disengage the plugs from the prongs.


First shut off the power to the dish washer. The plugs are just verry hard to pull off. You may brake the switch on the old handle but if you have the right new part it should have new switches on it. Just pull hard side to side wiggle off. ... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

Need to know how replace a 3 prong plug on my dishwasher model # fdb1050rem0 frigidaire dishwasher the wires on dishwasher are white,black,red wires on 3 prong are green an 2 white wires


On libnk below tells you how to change the plug. Step 8\015\012\015\012http://manuals.frigidaire.com/prodinfo_pdf/Kinston/15442730 ... Frigidaire Dishwashers

The heater element does not stop when the cycle machine is finish. I need to off plug the electrical wire. Some told me that my control board was broken. Is it possible because they told me that the piece was discontinue. The dish washing machine has been bought in 2003! What can I do


\015\012\015\012\015\012Hello, \015\012 \015\012Welcome to FixYa. \015\012 \015\012Beased on the description you posted..."The heater element does not stop when the cycle machine is finish. I ne ... Asko D1776 Stainless Steel Built-in Dishwasher

I have a ge dish washer model gsm1800jbb and the handle latch (WD13X10030) had to be replaced...well it took a while to get it in and now we are not sure how to wire the wires. There are 2 white and 2 black and 6 different prongs so I am not sure which way to plug them in to make it work properly. It worked fine before it got stuck closed and wouldn't open, that's why we ordered the whole assembly. The way I have it wired it sounds like its working...water goes in and drains put but the


... GE Spacemaker 18" Built In Dishwasher - GSM1800JBB

Dishwasher latch How do i disconnect the wires going to the switches on both sides of the handle? I tried pulling them apart but no luck . Do I need to pull harder? Squeeze the prongs and then squeeze?


Everything you want to know about your Maytag Dishwasher is in this Service Technicians Manual.http://www.servicematters.com/maytag_library/docs/16021814.pdf ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

How do i use a 3 prong plug for frigidaire dishwasher instead of hardwiring


Hello - I understand that you want to know if you can use a 3 prong plug instead of hardwiring the dishwasher, however may you please provide me the model number so I can assist you better in pinpointing you the information? ... Frigidaire Dishwashers

Need to replace the (110) plug on a dish washer


Any hardware store has a replacement.\015\012You can do it. ... Kenmore Dishwashers

Knife handle and blade need to be put back together


... Dansk 06201 Classique Stainless-steel Dinner Knife

It won't start. It has to be in the handle. What needs to be replaced or repaired? I know its getting electricity. Is there are relay switch that might need replacing. I know it is in the handle area.


Their is a lever switch, that can fail, please rate/vote this response ... Maytag 24 in. MDB3700 Built-in Dishwasher

I HAVE A CEAN MACHINE 1210 COLEMAN POWERMATE MODEL # pwo701210 MY PROBLEM IS THE SPRAYER HOSE TO THE PUMP DICONNECTED FROM THE PRESSURE OF THE MACHINE I FOUND 2 PARTS A SPRING AND A LIL BRASS PIECE THAT CAME FROM INSIDE THE ADAPTER NEED TO KNOW IF THERES ANY OTHER PIECES MISSING MAYBE A LITTLE DIAGRAM WOULD HELP SO I WILL KNOW WHAT I NEED PLZ HELP !!!!


Need a repair manual where can I find it ... Pressure Washers

I need to clear out broken glass from the gray pan underneath where the water drains to, but I need to take the twirling water sprayer off first to get to the next piece that looks like it is bolted down, and I cannot see how to remove the twirling sprayer part. The piece in the center of it does not appear to be a screw off part, so I am at a standstill.


Hold the twirling sprayer part and unscrew the big round nut part just above it, then you will see a 3/8 nut,remove it and sprayer arm will come off ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Need part for a Miele g841sc-i dishwasher. The part needed holds the upper spray arm in place. Not the piece on the spray arm, the white piece that you can unscrew from the top of the tub.


Hello mikesrepair,Try THIS website. They have parts for most white goods. Hope that helps. Should you have any further questions, please feel free to\015\012post th ... Dishwashers

I do need the igniter for the burnner / my igniter i think it is the wrong one , it is too shot and the spray of oil do not fire/ i think the 'plugs' is little short to ignite on the spray , comes on and off / but i have sparks all times, only dos not get fire , do i need longer plugs !!!do go under the noze of spray!!


Send me a email at [email protected] I am an dealer for Northstar and many other brands of pressure washers. I need the model number off the machine if you have it. I can get you th ... Northstar Gas - Powered Wet Steam & Hot Water Pressure Washer 2700 Psi, 2.5 Gpm

SHE6AF06UC/03 upper wash arm came off. Have arm (d'uh) and round piece that goes thru it. Seems to be another piece that connects arm assembly to top of unit as that round piece can't snap into what is still there. Need exploded view diagram to determine what piece is missing ('cause can't find any other 'other' pieces in the unit). thx


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012If you follow this link below and save the file and then open it,( pdf about 5mb in size ) refer to page 21 it will illustrate how the upper arm ... Bosch Dishwashers

My pressure washer is not pressurizing the water. i took the bottom assembly off the pump and there are three spring loaded plastic pieces in there. underneath these springs is a mushroom shaped plastic piece. two of the three mushroom pieces were contorted and need to be replaced. how do i get them?


Craftsman 2200 psi pressure washer 580.752341 ... Pressure Washers

When the washer is fitted up ready to use the water comes through the handle ,i took the end piece off ,the water then comes through to where the end piece fitted on,when i looked through the end piece i can see straight through so it doesnt seem to be blocked with dirt ect


Check o rings washers ... McCulloch FH160G Pressure Washer

The door handle is broken which enables the opening of the door. Therefor we can't open the door and need to replace the handle but dont know how . The handle is situated inside the door and there are no screws around it to to take it apart. It is an Indiset DG5000 model. There are screws at the edges of the door.


I had a similar problem with a similar model.\015\012Insert a fine screwdriver into the small space immediately abive the handle. Press the inside end down firmly and the lock should release.\015\012I ran mine for about 3 weeks, this wa ... Dishwashers

My power button cover broke on the dishwasher and I figured out the part number I needed, but when I put it back together I got the wires crossed on the board and door switch. Now the control lights up , but the dishwasher will not run a cycle. THe question is does the plug on the door switch have to be a certain way, because there are three wires and you can connect the plug both ways. I did turn the plug, but it still does not run. Did I break the switch? Bosch SHU9956uc/14


The wires do have to be a certain way on the door. Otherwise a door open can tell the board that's it shut and vice versa. The easiest way to do it, is test the switch with an ohmmeter, place the meter on the switch, push button in and see if the rea ... Bosch SHU9956 Built-in Dishwasher

The lower shelf/drawer in the dishwasher has rusting pieces mostly at joins and also has upright pieces breaking off. Also a couple of small pieces have broken off the top shelf/drawer. I need to replace both shelves/drawers. how do i order replacement parts and at what cost. pat


Hi,\015\012\015\012you'd have to start by providing a make and model & serial number. Check out repairclinic.com, amresupply.com or searspartsdirect.com to name a few, but there are many more on-line appliance part vendors if you do a search with you ... Asko D1876 Dishwasher

Door handle needs replaceing I have new handle how do I do it? Do i go in though the frount or do i unscrew the back of the door?


\015\012\015\012you will have to unscrew the back of the door.\015\012\015\012Open the door to the dishwasher and remove the inner panel by turning out the stainless steel screws at the outer edge of ... Dishwashers

Blocked Rotors I often get little pieces of rice in my rotor arms and am wondering whether my filter may have a screen missing. At the bottom end of the removable tubular filter screen there is no mesh disc, and I was wondering whether there should be one there. If so how do I get one? Cheers Jim


Hello jameso1WelconeYou said, I often get little pieces of rice in my rotor arms and am wondering\015\012whether my filter may have a screen missing. At the bottom end of the\015\012removable tubular filter screen there is no mesh d ... Electrolux 24 in. EDW5505EPS Stainless Steel Built-in Dishwasher

We're having same problem with our whirlpool GOld quiet partner III. We moved into our house three years ago and no manueal was left. I am sure its a filter or plug but I can't seem to figure out how to get to the filter or plug. I can take off the arm but then nothing. Is there a manuel I can get or can someone explain exactly where the parts are that I need to check? Dishes have grit on them, white spots, just not clean at all. Thanks!


The problem is hard water. There is a new product out called the dishwasher filtration system. It filters the water before it enters your dishwasher. It works amazing and has a money back guarantee. You will love the ... Whirlpool GU2400XTP Built-in Dishwasher

Just looking for some advice on removing the drawer from my servis washing machine, sorry I dont know what model it is. I need to clean the powder drawer but cant find any way to remove it from the machine. There is no internal part marked push that i can see and im wondering if i need to unscrew the four screws around the drawer. Help please! Cheers


Send an email to this address asking for the user guide for your model \015\012\015\[email protected] ... Servis Dishwashers

When I plug in my dishwasher it trips my test fuse and none of my plug sockets work. Do I need a plumber or electrician?


Electrician. You have a short in the dishwasher which is an electrical problem. Is it tripping GFI outlet. If so the GFI is probably weak or overloaded. Try regular outlet not on the GFI circuit and see what happens. ... Dishwashers

Broken fitting The plastic curved piece that attaches the hose to the white fitting on the back of the dishwasher broke, and I need a replacement.  I have been to Home Depot and they don't have anything to fit it, and I was told to go back to the manufacturer for a replacement piece but have looked online and can't find anything that would allow me to order the part.  Help!??


You don't have to change that piece,just tie the hose (drain hose ) to something that is equal height,this prevents siphoning. Please Rate This ! ... Danby 22 in. DDW396 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0889 seconds