Having problems with your Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher ?

Computer board has a diod that has shorted out

\015 I have power to the junction box where power comes in, but no lights or power for operation. I noticed where a diod has shorted and burned a hole in the board. Can this main controll board be replaced?\015

Answers :

Hi,
    If you look both side back and front of the board the part board number written there. But if you want to find the component value, then you should have a service manual. From there you can get the specific part number and then get it to the company or have vale then can buy from market.
Hi,
\015\012
\015\012The answer is yes that can be replaced ( the diode & the Board both) provided we are talking about a non-branded ~ Assembled Machine & provided you know the part number, & the Model & Make of the machine ....
\015\012
\015\012You may find the parts on E-Bay.
\015\012
\015\012Thanks
\015\012
\015\012Fame !
\015\012
Repair Help & Product Troubleshooting for Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Computer board has a diod that has shorted out


Hi,    If you look both side back and front of the board the part board number written there. But if you want to find the component value, then you should have a service manual. From there you can get the specific part number and then ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

In December 2010, I purchased an Electrolux range, microwave and dishwaser for my kitchen. Already I have had to replace the computer boards on my all three appliances. Last night, I load the dishwasher and go to turn on and the computer board is dead again. What is the problem and would you advise that I return all 3 appliances for a refund?


... Electrolux EWDW6505GS Fully Integrated Dishwasher with 9 Wash Cycles, Nylon Racks, Wave-Touch Contro... 24 in. Built-in Dishwasher

Re:communication board I have an electrician doing repair work since there were two burnt out areas on the communication board or control unit. We have a replacement board and it came with some listed diodes that indicated which component it corresponded to but it does not list all of them. There are several diodes/relays,etc that are burnt out but do not know what component it corresponds to. Where can I get a diagram showing the entire communication board with a complete listing of the entire


We have the same problem, but we can't find the diagram on site\015\012http://www.samswebsite.com/ . Is any other links? Thanks in advance ... Asko 24 in. 1585 Built-in Dishwasher

LG - LDF7811ST Dishwasher will not turn on at all. I have replaced the main PCB board and checked all wires for shorts. The PCB board does have 120Vac to the board. I have also checked the latch and it does close the switch when the dishwasher is closed. I think it may be the main switch/power button board but can't seem to find the part number or alternate part numbers that can be used.


Hi. The likely culprit will be the power switch. The part number for this switch is 5020ED3011A.NOTE_ Make sure there's power getting to the dishwasher. Check for a tripped circuit breaker or a blown fuse. Check the wall socket for po ... Dishwashers

Good Afternoon We have a Kleenmaid DW8 dishwasher. At the beginning of the cycle, it will pump out the water, sit idle for a short time and then show the end light, without washing or any further action. A technician came to visit and had a brief look. A follow up call came from his company stating that the circuit board had a crack in it. It would require a new circuit board ($650), the dishwasher to be taken to the workshop and repaired ($150). Upon further investigation, the circuit board had


... Dishwashers

I'm working with a kitchenaid D/W model N0. KUDS01FKSS1: I repired a broken wire that shorted out near the main board, after repairing the wire the cycle selector board "light wash cycle" was not working, after the customer used the D/W the "clean light starting flashing 7 times then pauses repeately, after instaling the selector board, I entered the diagnoptics code all lights came on and then I cancelled, the D/W started working, when the cycle finish the light will come back and D/W will no


... KitchenAid Dishwashers

I have a KitchenAid drawer dishwasher model kudd01dppa and it has a mind of its own starting and stopping in the middle of the night/day and chiming all different beeps and sounds like its computer is glitching out. We had a service person out and they changed the main computer board and it seemed to fix it for a few days then started again. They gave up. They also tried some sort of reset or reboot but nothing has fixed this intermitten but long term problem. Any ideas?


"it seemed to fix it for a few days then started again" (sic) OK, well if this is so, then in my experience you are getting some, sort of Power Bourne Spike, Surge, or Transient, problem. If there is nothing else it can possibly be. Use a Pow ... Dishwashers

On our Hobart Dishwaher, Model AM15T, S/N-23-1000-664 won't start with message wrench & P2. The Thermistor is not open or shorted with resistance reading of 64 Kilo-ohms. I suspect that the Relay Board P/N- 892934-2F is not good. I installed the New spare board P/N 892934-1 Rev.F, but no display at all. Is this the correct PCB? Also the Thermistor is on one assembly with float switc. The new spare we had is only a Thermistor P/N F370609. I also checked the 3- Thermostat on the Tank and they are


... Hobart Dishwashers

I have the above dishwasher shv57c03uc just less than 5 years old. The door latch does not engage solidly. when i pust start button left side lights on indicator right does not come on and i have to push on button twice for washer to come on. When it does come on the cycle is real short and it does not complete a full cycle. I an asuming the circuit board is defective!! does this sound right? if so how can i replace the board?where can i get troubleshoooting instructions?


Hi\015\012\015\012You are right it is the ... Bosch 24 in. SHV57C03UC Built-in Dishwasher

We have an ariston LS 620A dishwasher. For the last year every few months the dishwasher seems to cause a short in our electrical box causing all the power to go out in our house. It is only when the dishwasher is on that this occurs. We turn the power back on and everything, tv computer etc starts then turn the dishwasher on and everything shorts out again. We have had an electrician in who said that there was no electrical problem and that it was the dishwasher. After 2 months or so the dishw


The problem seems to be water seepage into the electrical contact.If the heater has lost its insulation this problem could accur( element to body )Disconnect the heater and give a try without any load and soap. If itperf ... Ariston Technologies Dishwashers

Describe your Amana DWA73A Problem There has been a short on the board behind the switches. Can the board be replaced and is it worth it?


... Amana 24 in. DWA73A Built-in Dishwasher

My bosch sgs45 tripped the electrics out, now the machine washes the dishes, but does not get hot and stays washing on 1 indefinatley,i have checked the pipe under the kick board which was blocked,also the circuit board for shorts /dodgey solder joints all seem ok, any ideas


And have you checked the heater element for continuity? also check to where the wires are connected to the element as well sounds like a short to me Thanks Rick ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

ASKO D 1796 NEEDS COMPUTER BOARD


... Asko D1796FI Built-in Dishwasher

Global 300 KA dishlex dishwasher shorts out power board cuts out straight away


... Dishwashers

Lg dishwasher gives error code ee changed computer board but didnt help


Hello and welcome,\015\012Display Condition EE = Motor Error\015\012Possible Cause For Error Occurrence:\015\012Wiring connection is OK?The Impeller of Washing Pump islocked. ... LG Dishwashers

We have a n eight year old fully integrated asko dishwasher. Only the rinse cycle works, so I rinse many times - last rinse with detergent and then run the short program which does not wash, but will dry the dishes. The circuit board was replaced once before under warranty($500.00 labour) and I suspect that we may have to do the same again. Can we find this on the internet and do it ourselves; we have good electrical knowledge. Thank you in advance.


This is most likely an issue with the timer. Timers\015\012don't often fail. But if every other part of the dishwasher seems to be\015\012working properly and the timer knob seems to be stuck in one\015\012place--doing one function continuously--the ... Asko Dishwashers

Du1145xtpba quietpartner II starts then stops shortly into cycle and the normal wash light just blinks, if you hit cancel then both lights will flash when unplugging/reconnecting ribbon cable from control board it will complete 1 cycle and more often than not will do the same thing


... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

My dishwasher has no power. A service tech came a few months ago and replaced the mother board along with a fuse. Am I having a short and need to replace the fuse? If so,where and how would I do that?


... KitchenAid KUDM01TJBS Dishwasher

No water. replaced solenoid for inlet water motor runs but no water flow I think it's the control panel (touch button) is shorted out. Whats the cost of a new board.


You might have to call up GE service support to confirm. check this link:\012\012www.geappliances.com \012\012check also for spares, post your queries: ... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher

I have a Frigidaire GLD 3450 RDB0 dishwasher that begins the wash cycle then halts midway and shows 'ER' on the display. I replaced the computer board with no better results? Any suggestions.It is only 4 yrs old. Thank you,


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

I have a MDB6759AWS3 that is one year and two months old. This morning I went to the control panel to press the buttons and some would light up and others would not. I disassembled the inner panel and looked at the "computer like" flat ribbon that connects the control panel to the main circuit board and noticed that some of the wires in the flat ribbon had deteriorated. I put it back together and pressed the buttons and they flash very dimly for a few seconds and got the dishwasher working bu


You may want to check the warranty iif it is a maytag or whirlpool, some have a 5 year warranty on the control and board. If not you can go to www.searspartsdirect.com to l ... Dishwashers

Dishwasher cycles with timer, won't fill with water. Motor runs fine, drain and fill valves test fine, float switch tests fine too. Water pressure fine. I'm thinking the timer is bad and won't send a signal to the water valve to open. What do you think? The system here doesn't know what a GSD2030F00WW is, so I had to pic one with a computer board, mine is not that sophisticated.


Remove the toekick plate on the bottom of the dishwasher.Remove the wires from the water valve. Insert the leads from a volt meter into the water valve power wires.Turn the washer on. After the initial pump out cycle the timer sends power ... GE 24 in. GSD2030Z Built-in Dishwasher

I removed the top cover on the of my dishlex global 300 and a black wire became disconnected i don't know where it goes the wire is made of two one wire has what dots (short lines) and then a continuos line the two wires go into a slightly transparent cover which has a small round opening for it to be plugged into something the wire comes from the cercuit board that controls the start/stop and mode


The wire that came disconnected goes to the door switch. If the wires came out of the switch then you need to replace the hole switch. If you still have some wires coming out of the switch then you can just wire nut ... Dishwashers

The computer board is melting strong smell of burning plastic


Hello,Welcome to FixYa. \015\012 \015\012Based on your description ( specifically the smell ) I would suspect the control board is faulty. However, these faults are usually easy to identify and ... Asko D3122XL 24 in Builtin Dishwasher

Whirlpool dishwasher The dishwasher works off and on. Every few days it stops going on altogether...only the cancel button goes on and the the dishwasher's timer says 2 minutes. Sometimes the air dry button works,but none of the other buttons work. The problem has been when the repair person comes out, it all of a sudden starts to work and so he can't diagnose the problem. I spoke with someone who said it sounds like with the touch pad or computer control board is bad. You don't seem to list my


Hi there,\015\012\015\012your problem is intermittent and before you start replacing parts, i would recommend that you do these checks:\015\012\015\012unplug the dishwasher from the wall\015\012check the connection betwe ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0287 seconds