Having problems with your Maytag 24 in. MDB6601AWS Stainless Steel Dishwasher ?

How do you get the top panel off the dishwasher to replace the handle


Answers :

Repair Help & Product Troubleshooting for Maytag 24 in. MDB6601AWS Stainless Steel Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How do you get the top panel off the dishwasher to replace the handle


... Maytag 24 in. MDB6601AWS Stainless Steel Dishwasher

Need to replace the latch assembly on Maytag dishwasher model # MDB5600AWW. How do I gain access to the area where I need to replace the part? I removed the 5 screws at the top, but can't seem to get the upper front panel off. I'm afraid of pulling on it to hard.


Remove all the screws on the inner door panel and lift it up it will be easyer ... Dishwashers

We have a bosch integrated dishwasher with a broken handle. We can't get the cover off to replace it! There are no visible screws on door front and I am unsure about unscrewing the metal panel door in case I damage further. Please help!


I am not sure how to fix your broken handle issue but if you are ever looking to change the look of your appliances like I was then you should check out www.applianceart.com. ... Neff 24 in. S5443X2 Built-in Dishwasher

My Maytag dishwasher Model#MDB4650AWW, Serial #10725477EN has a problem with the door latch It appears the spring on the handle is broken. How do you get the top Panel off to check and see if this is the problem? Or is there another problem?


The door latch is item 5 on this diagram. You will have to remove the screws as marked on the panel dia ... Maytag Dishwashers

An electrical panel breaker switch was replaced after the microwave and dishwasher both lost power. The microwave works after replacing the main panel breaker. However the dishwasher will not show any power. Checked the internal circuit board, no burned areas, cannot find an internal GFI reset, what can I do to get power restored to the main control panel or even the unit itself? Rick C


1)check any fuse in the circut board.(blown off)\015\0122)check any loose connection of neutral (or)phase wire to the machine(or)in the switch. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I just purchased a G.E. dishwasher with a black front panel that is glossy. My daughter used a mister clean sponge to clean it and is now full of scratches, is there anything I can use on it to get them out without having to replace the panel. I also have a G.E. frig with a different finish on it, it has a rough texture it never marks or shows finger prints best refrigerate I have ever owned, and was wondering if I could get that finish on the dishwasher door panel.


Once paint is scratched it is scratched. There are cheap and inexpensive ways to cover that panel with a glossy black, or even stainless or white, or whatever. Go to www.applianceart.com, they have a ton of options to help your dishwasher getting b ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

I have a Kenmore Elite Dishwasher Model 665.13773K600. It seems to have no power to the touch pad (top) control panel. I have already checked the circuit breaker and the power to the dishwasher. A friend said that it may perhaps be the thermo fuse cut out that needs to be replaced. 1) Is this true? 2) How can I remove the 1" thick control panel touch pad after removing the six screws- it seems to be stuck, and I don't want to break the plastic touchpad.


... Kenmore Dishwashers

Hi, I have the Bosch Logixx Dishwasher . BOSCH SGS0922gb /06 .. aged about 6 years old .... When I press the on/off button 'on' the led display only shows the 'not started' message. When I press the on/off button 'off' the led display lights up momentarily with 'start' etc just before I have fully released the button. I have tried a new switch and the same happens so not that. ALSO i can sometimes see S1....> on the top panel and get the machine to show on the top panel the close door


... Dishwashers

Whirlpool DU6000XR Dishwasher. How do you get the bottom panel off to get to the underneath? It seems there are screws on the top of the panel but the door is in the way.


You should be able to still reach it with a screw driver ... Dishwashers

Thermal fuse Dishwasher konked out mid-cycle and now no power to control pad. We've already had the thermal fuse replaced once (machine is only 2 years old!) and this appears to be the same issue. I tried to open the front and I think I can see where it is but not sure how to get it out and replace it AGAIN. I wasn't able to get the inside panel completely apart from the front of the unit so I was somewhat limited. I'd rather save the service charge if I can and there's n


Http://www.partselect.com/MultiModels.aspx?ModelNum=KUDS35FXSS&SearchTerm=fuse&RefineSearch=0Maybe this link will help ... KitchenAid KUDS35FXSS Dishwasher

Bosch Dishwasher I have a stainless steel Bosch dishwasher, I made the "mistake" to try to see if I could fix the jammed handle from the door. Unfortunately, (did not realize the top panel comes off without opening the entire door). I removed the screws from the door frame (Inside panel), and the door springs/latched got loose. I would like to put it back together, but I dont have any diagrams on the door to make sure all parts are in place to put the door back together. I have been havin


Hi ED,\015\012\015\012It sounds like a real problem here. If the springs are still in one piece, my best guess is to to remove the springs from the door. Then attach the springs to the dishwasher body first, then reattach the spring to the door. Not ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Blanco BFDWC65X dishwasher. Has broken handle. Have been informed that the handle cannot be replaced and that the whole front electronic panel needs to be replaced. Is this correct? Can you recommend a repairman in Brisbane?


Hello. Generally the handle can be replaced or repaired with epoxy. Call the local appliance stores as they have lists of local repair persons. Try to get one familiar with your dishwasher. J. ... Dishwashers

The rollers of the top shelf of my ASKO dishwasher are worn out and catching and likely need replacement. Can I get the spare parts and replace them myself? If not, where can I get ASKO service in Toronto, Canada?


Discount Parts\015\012Major Appliance \015\012& Consumer Electronic Parts.\015\012\015\012TOLL FREE 1-(888)-338-3790\015\0128:00AM - 12:00 MIDNIGHT\015\0127- DAYS ... Asko Dishwashers

GE Potscrubber 650 Dishwasher, 13 years old. We want to take the front lower panel off to move the motor fan by hand, as you described for glideston'es post, but we can't figure out how to get the panel off. A repairman told us to remove the three screws at the top of the lower panel -- but they are too close to the upper door panel. The space between the two panels is not big enough to fit a screwdriver or any other tool we can think of. How do we remove the lower panel?


Homeowner with this model:\012I believe you would need to take the door loose by removing the screw on each side of the door near the bottom on the outside. \012\012I would recommend removing the unit whole instead. That way you don't n ... GE Dishwashers

Amana dishwasher, model adb2200aws, ser #, 26650464e. history: quit running, no lights, nothing. replaced the door switch, ran for three days, replaced the switches on both sides of door switch, ran three days, quit. replaced the circuit panel , ran one time, quit. not lights, nothing. when I take it apart sometimes, that is take off inside cover on door, it might run or not. seems like the current isn't getting in as no lights will come one.


I have the same problem with mine as well but I found out that if you take a space heater to it and warm the control panel up for about 5 minutes, everything works great. This model of dishwasher seems to be problematic in any environment under 70-75 ... Amana Dishwashers

I am replacing the front panel on my Whirlpool dishwasher. It is a Quiet Partner III. The model #GU2455XTSS2. I need to know how to get the old front panel off? Then how to install the new panel?


Here's where you can download the service manual for whirlpool dishwasher:http://www.servicematters.com/narso/tech_ref_eng/europe/service_manuals/dish/8542%20955%2010310.pdfhope this helps. ... Dishwashers

I have a dd24dctb6 Fisher Paykel dishwasher and the handle on the top drawer came off on one side. I can get a handle kit but don't know how to disassemble the existing handle. Is there a repair manual somewhere? thanks


... Fisher and Paykel DD24DCTB6 Builtin Dishwasher

I have a frigidaire dishwasher model FDBC45BAB0. It has a black door (full door, not panel). I would like to either replace entire door panel w/stainless. Or get a stainless panel just for the front. Any ideas? Thanx


Hello! Here is a website that offers a selection of stainless door covers........www.kitchensource.com/kau/frigodw.htmGuru...................saailer ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

We have a 2003 KitchenAid KUDI01IL Dishwasher that will not start . We had problems with the top rack dishes getting clean and we replaced the chopper. The dishwasher worked fine for one cycle, but now will not start. The buttons have lights except for the high temp scrub light. The dishwasher will drain when cancel is hit but that is it.


... KitchenAid 24 in. KUDI01IL - Multiple Color Free-Standing Dishwasher

The latch on my maytag dishwasher dwu9962 has to be pushed real hard to get it started. this just happened about a month ago. we bought the dishwasher in 1999. how does the latch work? i am now putting a plastic ruler between the latch and the bottom of the top panel to hold it. dave mahadevan


... Maytag DWU9962 Dishwasher

My Maytag Dishwasher MDBH750AWW will not turn on. Pressing the key pad on the top front does not activate the controls. I traced the wiring and found it is active in the door latch assembly, which I recently replaced. Question: 1) If I purchase a new Control Panel exterior white key pad, which is linked to the interior Control Board, should that solve the problem? Or,2) if I purchase a new exterior Control Panel finger touch pad, and an interior Control Board, will that solve the proble


... Dishwashers

I got this dishwasher from a friend that had mice chew the hoses and i was told that it worked perfect before the mice chewed it. I replaced the drain and fill hoses plus the power cord. when i put everything back together and power on I get F1 on the top drawer and the rotor rotates and the heater plate turns on. The botton drawer does nothing with no display. I checked all the wires with a meter and found good continuity thru every pin. I replaced the main filter board. I even switched the


Did the F1 error in the top drawer disappear after you replaced the mains filter board? ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

I have a maytag dishwasher mdb5600awb. it is about 5 years old. it does not clean anything on the top shelf for the most part. i took everything apart and found nothing that was clogged. we tried a rinse agent and that didnt help. for 460 dollars i expected more out of this. i also had the motor replaced 3 years ago. can someone give me an idea why i cant get my dishwasher to wash dishes?


Replace the dock at the back if it is missing a piece. That solved my problem with the top rack not getting clean. ... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

How can I shut off the water supply to the dishwasher? It fills slowly with water from the top (while not running), and then water spills out over the kitchen floor. By pressing the 'Drain' button, the water will drain out, but I have to get to it before it floods. It takes about 4 hours for it to get to the overflow stage. It is a Jennair model, about 9 years old. We have a lot of limescale, it is probably time to replace it, but for the moment my main concern is to stop the leak. Thank you for


Most water supply lines are attached to the hot water supply under the kitchen sink. If not it may be accessible from the basement somewhere under where the dishwasher is located. Regarding the issue with the dishwasher, the inlet water v ... Sears 24 in. 14181 Built-in Dishwasher

The control panel on my Maytag MDBH970AW is unresponsive, and the latch is stuck in the "open" position (the plastic piece stays pushed in to the handle and won't come down). I've checked that the unit is getting power from the house. Last time I had this exact problem (when it was under warranty), they had to replace the control panel, the latch, and it seemed like most of the door. What should I do?


... Maytag 24 in. MDBH970AWS Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2299 seconds