Having problems with your Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher ?

While installing maytag dishwasher mdbh949awb, a wire became unplugged under the machine; noticed it dangling down after all water, drain etc. were connected. It's a brown wire; 2 strand; it has a white plastic plug/connector on the end. Any proposed solutions, short of removing the machine and starting over, would be greatly appreciated Thanks.


Answers :

Repair Help & Product Troubleshooting for Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

While installing maytag dishwasher mdbh949awb, a wire became unplugged under the machine; noticed it dangling down after all water, drain etc. were connected. It's a brown wire; 2 strand; it has a white plastic plug/connector on the end. Any proposed solutions, short of removing the machine and starting over, would be greatly appreciated Thanks.


... Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher

My LG 24 in LDS 5811 ww quite working in the middle of a cycle. I have power to the machine, but no lights come on, nothing works. I turned off the power and removed the front pannel. The large brown wire and large orange wire that are plugged into the back of the control panel start to smoke. So does the large black wire and the large white wire. Any ideas, is this the heater or is the panel bad?


The unit will need a new Wire harness, Pump/motor assy, Main Pcb and inner door liner.\015\012Contact LG @ 1800 243-0000 they may help you out. ... LG 24 in. LDS 5811 Built-in Dishwasher

The drain hose is off and i can't find out where it is supposed to connect. There is a white plastic piece on the end of it that looks like it broke off and I can.t find the spot it came out of ...The machine is a built in Kenmore Ultdra wash 11. #1565590 could you tell me where it is located on the machine/


... Kenmore 24 in. 15654 Built-in Dishwasher

I'm installing an electrolux dishwasher, the first thing I'm going to do is the electric wire. I know I have to attach the black white and green (ground wire).I've done this before with my Maytag and it was a breeze. When I open the elec. box on the electrolux dishwasher the black white and green wires go into the box from the Dishwasher and then THROUGH THE BOX AND THEN BACK INTO THE DISHWASHER>>>>>THERE IS NO END........... In the Maytag I just opened the box on the dishwasher and the ends of


There should be a complete wire connection already there ready to be plugged in. If not, typically at the back of the unit there should be a black plastic box that when opened will indicate 3 terminals. live - neutral - and earth. Looks to m ... Electrolux Dishwashers

I am installing a Kenmore dishwasher model 13743. I have direct wired the washer?s terminal box wires to the wall power via a BX wire and the washer doesn?t respond. None of the panel buttons are active. With a multimeter, I find that there is voltage on the wall wires and on the dishwasher end of the BX cable wires that hard wired to the wall current. Even though, when I connect the dishwasher?s terminal box wires to the BX wires as directed in the Installation Instructions (white to white,


Next step to check the door switch...the door must close and the switches on the door must close to send power to the control...let me know ... Dishwashers

HI. Trying to install a LDF6920ST Dishwasher. Question about the wiring. The wires coming out of the machine are Black, Green with a yellowish stripe and White (the white one has a label attached to it with a "N" on it). The plug wires are 3 side-by-side. They are gray, green and gray. Which wires do I connect with which wires?.


... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

I am replacing the drain hose on my LG Dishwasher LDS5811BB. The new hose they gave me has an additional piece connected onto the hose. I don't know what it is or what it is for. The original drain hose was composed soley of a gray hose with the to end connectectors. This new hose is similar with an additional white, hard plastic, U-shaped hose with a black hose extending off the end of the U-shaped end. Is this an air gap extension, and if so, what do I connect it to or can I cap it off?


... Dishwashers

Hello. Have a Neff S5457 that is not working properly. It sounds as though it's working but on getting the crockery out, it is obsvious that it isn't. Have checked all the filters in the machine that are easily checked and all are OK. On taking all the filters out, I can see some philips screwheads in the 'sump' of the machine. Wouldit useful to remove these and see what's under the white plastic covers down there? Are there any other areas that I can check or test? I also wonder if the pump is


Clean the nosels of the arm's, check if the tetergent is pumped (if you have an automatic detergent dispenser) check whit dishwasher unpluget!!! you can check and the pump but be carreful how you put it back. also you can check and the hoses to be cl ... Neff 24 in. S5457X0GB Built-in Dishwasher

Dishwasher kenmore ultra wash dishwasher moved unit out and the wires to the selonoid became dicconected. one is brown and one is brown and white no marking on where the go please help


THANKS ANY WAY FIXED IT ON MY OWN ... Kenmore Dishwashers

We have a Hobart dish washer in our bar area and when it sits over night there is a pool of water on the floor in the morning. When we open the door and look at the upper right corner in the rear of the machine we have a steady flow of water running down the rear wall. When looking at thge machine where the black 1 inch water hose comes up from the floor there is a plastic T in the line with an electric wire the goes into the side of the T. I am guessing tha that is a sensor valve that is suppos


The model is most likley a lx18,lx30,lx40.The fill solenoid valve is stuck open.Remove the 2 screws on the bottom front where the pressure gauge is.Turn the circuit breaker off.When you remove the cover you will see a bronze valve with a red hose goi ... Hobart Dishwashers

DS603 Fisher & Paykel U1 error code ..(see our previous errors we've listed) we have now pulled out the yellow water valve that goes up behind the front panel and at the other end by removing the drawer and plastic protector thingy - we checked that there were no bedris or calcium buildup in the valves ends and filters and replaced it all. So we put it all back to gether as we could not see what would cause this error, only to find that it worked - water came into the machine but about 4 mins in


This product is total ****.\015\012Pull it out, call whoever sold the **** to you\015\012and tell the to come get it and shove it up their ***.\015\012Then buy a Bosch and live a happy life.\015\012The design is moronic. The machine is like the old\ ... Fisher and Paykel 23 in. DS603H W Built-in Dishwasher

Bosch dishwasher white wire connection in machine terminal box got hot and melted the wire nut.


... Bosch Dishwashers

I have a JDB1090AWS about 3 years old. We noticed a smell and found cutting boards and plastic cups melted. Machine was off. Had to turn off the breaker. Checked both leads to element & have power even with machine off. Not sure if it could be the limiting thermostat; I assume that is to shut the heat down when it gets too hot. Element is on though when it shouldn't be to begin with. I did have to tighten the water supply. Had some water underneath, but all wires seemed dry. Any tests I should t


The heat element can only get so hot.It's timed so it doesn't exceed a period of on, exposing dishwasher contents to continuous high temps.Watch the timer and take note how long it broils your cookware.Good luck. ... Dishwashers

Most plastic ware like plastic glasses and some of the other dishes but not all come out with a hard to remove white coating no matter how much rinse agent I use. I use Cascade Complete powder for soap and Cascade Crystal Clear rinse agent what Bosch recommends the exact amount according to the owners manual. This problem started about a month ago, before that the machine worked well.


... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

There is a double brown wire and a single brown wire.


... Asko 24 in. 1585 Built-in Dishwasher

My wiring is Blue, Green, Yellow, Orange, Brown, White, Black and purple how do i hook that up to a Honwywell RTH7600D


... Dishwashers

White wire connecting heating element burnt plastic covering.


... Frigidaire FDB1502RGS Built-in Dishwasher

A piece fell off on the dishwasher and I don't know where to reconnect it. Looks like a white plastic tube with a suction cup at the end.


... KitchenAid KUDP01DLBL Split-Control Console, Dishwasher 4 Cycles, 4 Options, Whisper Quiet® Plus, Sm... Air Conditioner

Dishwasher is 16 months old. Recently, it won't get tea stains from spoons or cups and there is a white film on plastics. I have run unit once with vinegar. I tried using less detergent and no change (Cascade Complete). (Neighbors using same detergnet on different machine with no problems so it's not the water.) I always select High water temp and air dry on normanl wash. My hunch is that the motor is going bad and therefore it is not pushing the water with enough force.


Hello, there are a few thinks to check on the dishwasher. Circulation, drainage - no backflow back into tub, and water temp. If all three are good, then you have hard water. \015\0121. circulation - These MDB models are very good with water circul ... Maytag MDBH985AWB / MDBH985AWS 24 in. Built-in Dishwasher

Dishwasher leaves on heavy film (white) on plastics and discolor silverware. If I soak them in vinegar they come clean. Dishwasher is about 10 years old but has always worked well before. We use Cascade and always put JetDry in machine.


... Dishwashers

Component failure Actually a Kuppersbusch IGV 645.2 Dishwasher There is a plastic conduit which takes water from the base of the machine to the upper spray arm. This now comes adrift from its connection at the base (behind the lower spray arm) on every cycle, resulting in poor or incomplete washing. It can be replaced easily and seems firmly inserted when done but is always adrift again by the end of the next cycle. Anyone any ideas?


Put a bead of silicone on the tube connection and let it set up good before running. If the tube is in good shape and only comes loose this should be an easy fix. ... Whirlpool GU2400XTP Built-in Dishwasher

What does the small white plastic tube attached to the drain hose and wiring harness accomplish? I have been having an F1 problem with both draws, have just found this tube in the top drawer harness (beneath the drawer)severed; could this be contributing to the problem?


It is most definately a cause of leaking. Its function is to hold the hoses and wiring together to swing behind the drawer when it closes. If it has snapped the hoses get caught between the lid and the drawer and cannot seal properly. The new replace ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Water is leaking out of my 7 year old Kenmore built-in dishwasher at bottom right by what I think is the solenoid valve (2 wires going into white plastic fixture then into dishwasher)...how do I fix this?


Hi,\012That is not that hard to fix and you can easily buy the parts yourself online...Here is a tip that will help you with the online buying...How to Buy ... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

Just will not start like it has no power to it. Checked breaker box and made sure everything was plugged in under machine. There was one white wire that was not slid on in front. Plugged it back on ,still does not start


A voltmeter is very handy with a problem like this. If you have proof of power available at the junction box under the machine, then the next likely place to look is within the latch mechanism inside the door. There is usually a microswitch which act ... Admiral Dishwashers

Burning smell from our Dishwasher. I opened it up and found a little square brown thing attached to the motor - It has a terminal at one end that a white with a coloured stripe cable attaches to via a slip on terminal and 2 terminals to slot the little unit directly into the motor. Anyway, this little unit has obviously burnt out and this is the problem. Except my problem is that I dont know what this little unit is, so dont know what to ask for at the spare parts centre. Can anyone identify


... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0654 seconds