Having problems with your Maytag 24 in. MDB9750AW Dishwasher ?

Maytag Quiet Series 300 Contol Lock Light On does not turn off by holding heated-dry button for 3 seconds as manual states.

\015 Control Lock Light is On and will not turn off by holding the heated dry button for 3 seconds as manual states. Also tried turning power off, via circuit board, for various lengths of time (up to 30 minutes) hoping for a reset, but it did not.\012\012Is there an alternative way to turn the control lock off, or a way to reset the controls to original condition? Thanks\015

Answers :

Repair Help & Product Troubleshooting for Maytag 24 in. MDB9750AW Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Maytag Quiet Series 300 Contol Lock Light On does not turn off by holding heated-dry button for 3 seconds as manual states.


... Maytag 24 in. MDB9750AW Dishwasher

Dishwasher: Kenmore ultra wash sensor quiet guard plus. I'm in a rental so I don't have the manual or model number. A few days ago it just wouldn't start the wash cycle. When you press normal wash then start the no heat dry and lock lights flash every other second or so but nothing happens. I can hit the cancel button and it will make sounds like its trying to drain, and after about 5 minutes stops. I've done the heated wash/ no heat dry sequence to try to reset but no luck. Also tried turn


... Kenmore Dishwashers

Electronic controls the dishwasher will not turn on. press and hold the heated dry button for 5 seconds and the machine came back to normal. now even that is not getting the machine back to normal. the normal button and start buttons flash but machine does not function. i have the front electronic panel off and do have a volt meter to test if you could run me thru the proper procedures.


First thing to check is the door latch switches, and hte strike plate(metal tab protruding from the top of tub assy in which the door closes into, if bent up to high the door will not be recognizedas being closed. you can use a small screw driver nad ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

I have a Kenmore dishwasher model 66574362K2. It has worked fine until tonight. I opened the door before the end of a cycle, closed the door, and pushed the cancel drain button. There was still water in the bottom but the dishes were basicly finished. Now I can not seem to get the dishwasher to come back on. The lock button seems to be on and it usually is not on. The manual says to push and hold the button for 4 seconds to turn it off. I did that. But now it is flashing between the Heate


Can you press the drain button to drain the water, then shut the unit off and restart??? I have exhausted all my resources to help, thought this may work. ... Kenmore Dishwashers

Lock wont turn off . i hold the heated dry button for more than 3 seconds and it still wont turn off. tried resetting with breaker swicth No luck


I would be more likely to believe that it is the locking solenoid.You say the light is faint, which leads me to believe that there is a high amperage draw from this locking mechanism. Remember, the locking solenoid should definitely affte ... Dishwashers

Have a kenmore ultra wash dishwasher model #15779, the lock button is lit at all times, we can't figure out how to turn it off, have tried holding the no heat dry button for the required 4 seconds doesn't work???


... Kenmore Dishwashers

KitchenAid Dishwasher I have a KitchenAid Model KUDS25SH Serial FKO531820 "CHILD LOCK" Light Stays on I have tried what is suggested in the manual of holding the ENERGY SAVER DRY button in for 4 seconds, it did not work, I have turned off the power to the washer, that did not work, any suggestions for this guy who is tired of doing dishes? Thank you. Nick


Nick,\015\012It sounds like you have tried all the normal things for this. It is possible that you have a stuck key on the panel. Try pressing all the buttons several times to see if they may be stuck. It may just pop it loose. If that does ... KitchenAid 24 in. KUDP01DL Built-in Dishwasher

Our dishwasher's lock indicator won't turn off, even after holding down the heated dry button for 3 seconds. We also tried disconnecting the power for 5 minutes and it would not reset. What part do I need? The model number is mdbh965aww.


Try holding the button down for longer say 5 seconds. When you push the button and hold it the little green light should blink. I would disconnect the power for longer..try 20 minutes. If that does not work then remove the inner panel and disconnect ... Maytag Dishwashers

The washing, heated dry, and normal wash light just flash. I have unplugged and plugged it back in several time, i tried restting it by holding down the Rinse only button for 15 seconds. I pressed the high temp ater, heated dry, high temp water, heated dry buttons to try to reset. I also ran the hot water line that feeds the dishwasher until the water was hot. Nothing has helped. The machine is18 months old and therefor no longer under warranty.


Please provide the make and model number of the dishwasher.\015\012do you hear pumps running? what was the last cycle it was at when the flashing started. was there water left at the base of the dishwasher from the cycle that stopped? ... Dishwashers

My accusense light keeps coming on and blinks continuously. I tried the heat-dry, normal sequence and it would reset to 2 minutes. After the 2 minutes cycle, the accusensor blinking would begin again. Then I tried holding the heat-dry button in for 5-seconds. This looked like it worked so we set a normal cycle without heat-dry. Äll looked good, but a few minutes in, the normal light was off, the accusensor was blinking again and the heated-dry was on again! Is the unit possessed? Other id


... Whirlpool GU2400XTP Built-in Dishwasher

My dishwasher won't start. The Heat Dry button is lit up and the Washing light is blinking. Some websites recommended holding down the Heat Dry button for 5-7 seconds, but that didn't work for me.


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Have a kitchenaid dishwasher KUDS25SHWH1 - the child-lock light came on and will not go off. It is a light and no button to push and hold except all of the select buttons for the type of wash you want, no air dry button. How do I get this light off?? The Child Lock light has come on by it's self and I cannot get it to turn off. I have never used this feature before. I have tried to hold the Energy Saver button for several seconds but the Child Lock light will not shut off. The dishwasher is loc


Unplug the unit for 15 minutes then plug it back in. This should reset all your computer system and make everything work again ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

I have a GU1500XTLB1, type-575-0 Whirlpool Gold dishwasher. For the last couple of weeks I've been getting the control lock on. I got the manual out, I hold the air dry button and it clears. My problem is now when I turn the machine on dosen't matter which cycle I hit (pots and pans, normal, or quick wash) it runs for about 5 minutes and it goes into a mode with the timer having lines going horizontal with the air dry button lit up and rinse button lit up. It sounds like it starts the cycle


Hi,There are Few Tricks to Reset this. Follow the below Tricks :-1. Try holding down heated dry key for 5 secs. I believe that is the control lock/unlock button on your model. IF not, look for the lock symbol and follow same i ... Whirlpool Dishwashers

I have a built-in Kenmore UltraWash ~ Model 665.15819990. The problems we are experiencing is lately when we press "Normal Wash", the "Lock On" will flash on and off, and then "No Heat Dry" comes on & off and nothing works. We have tried pressing and holding the "No Heat Dry" button for 5 seconds and sometimes this clears everything. However, more recently, nothing is working. Suggestions?


... Dishwashers

I have a new Frigidaire FDB1050RE diswasher. I ran it for the first time set on normal wash and pressing both the Hi-temp wash and heat dry button. This cycle is supposed to take a total of 89 minutes to complete including the drying cycle. After 89 minutes it was still in the wash cycle so I cancelled it to preserve sanity. In the instruction manual it states that the water temperature must be above 120°F. Our building's water heating unit is set at 110°F. Why there is a lower temperature


It should still work pretty well but you probably can't use the high temp wash because it will take too long for the dishwasher to heat up the water enough to satisfy the high temp washer thermostat. If the thermostat's calibrated closing temperature ... Frigidaire Dishwashers

Lock Light After a power failure the lock button turned on with power restored. After holding the Air Dry Button for 4 seconds, the lock will not turn off. How can this be resolved?


... Kenmore 15322 / 15324 / 15329 Built-in Dishwasher

I have a kennmore dishwasher model 665.15772990 and the "Lock On" button will not turn off. (I have held NO HEAT DRY button for 4 seconds) The lock on button will not go out and dishwasher will not work. Can I reset the computer?


... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher

Child Lock light glows without pressing Energy Saver Dry button for four seconds. Cannot turn off by pressing Engery Saver Dry button for four seconds. Turning off main power and turning back on doesn't solve problem. But turning off main power for extented period, over night, and turning back on does fix proble for a very short period but Child Lock does come back on by itself. Is replacing the Console Assembly the only fix? Is there some button sequence to disable Child Lock altogher?


The mini manual for this dishwasher is located behind the kick plate. The mini-manual reveals that the child lock (called a control lock in the manual) can be disengaged by pressing and holding the air dry button for four seconds.or ene ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

I have and kenmore model # 66517779990 were the lock light is on and the control buttons won't work or start the the dishwasher the manuel says to hold the dry with not heat button for 4 seconds and that will reset it i tried that but it did not work


... Kenmore Dishwashers

Pdw 9200 jo3ww dishwasher- The start button doesn't work. The arrow keys work and the heated dry button works. I tried turning the power off for 30 seconds and it still doesn't work any ideas?


... GE PDW9200N Built-in Dishwasher

Kenmore ultrawash 665 15819992 lists holding air dry button down for 4 seconds for lock turn off. IT DOES NOT WORK. This causes both button lights to flash (still no washing).


... Kenmore 24 in. 15689 Built-in Dishwasher

I have a Frigidaire Gallery Series dishwasher (model. GLD3450RDB0) that always displays the "lock" icon under the no heat dry button. I am able to get rid of it by holding the button for 3 seconds, but I am still unable to select anything or get the dishwasher to start afterwards. As soon as I close the door, the unit locks again! What can I do?


Have you tried unplugging the dishwasher for a while then .. Trying it again.. If the problem still persists have a cleaning done to the control board and touch pad inside and if still the problem persists then i doubt whether the problem is that the ... Dishwashers

Control panel is locked. no buttons work when pushed. door panel says to push and hold ''heat dry'' button for 4 seconds to clear. nothing happens. this is on kenmore ultra wash dishwasher


Try unplugging the machine and wait 5 minutes. Plug it back in, the problem should clear. ... Dishwashers

I have a Whirlpool Energy Star dishwasher (no clue what the model is). Door will not latch. Inside of door says to press and hold ''Heated Dry'' 5 seconds to lock control and repeat to unlock. This is not helping. We rent and do not have a manual. Please help.


Happened to me today. After much head scratching I found that the screw attaching the unit to the underside of the kitchen counter had loosened and was preventing the door from closing all the way. I tightened the screw and was back in business. ... Dishwashers

Hi I have a Jenair JDB1090AWS Dishwasher, that seems to be in locked mode (flashes 5 times when I press the start buttom). I tried holding the Heated Dry down for 3 seconds like it says in the manual but nothing happens. I even cut power to the dishwasher for > 30sec, still no joy. The dishwasher is still locked. How do I unlock it? Chuck Olson


Hello Chuck,. When these appliances work like they are supposed to they are great....... that being said lets see if we can unlock your dishwasher.\015\012\015\012Since the heated dry button doesn't unlock it, lets try the energy saver ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1092 seconds