Having problems with your Maytag Dishwashers ?

I have a maytag dishwasher model MDB8600AWQ that suddenly stoped working, no power lights on panel. I have had multiple problems with this unit with a complete service approxinamtely 1 year ago and had no problems until there just seems like there is no power to the unit. It is used infrequently and has been wwll maintained. Is there an easy solution or should I just give up on this unit.


Answers :

Please refer to the diagrams on this site.
\015\012
\015\012If the mains power to the dishwasher is still ok, ie, no circuit breaker trips, then you will have to check if the power is coming to the door switch. If yes, then the control circuit board has a fault and will need to be replaced.
\015\012
\015\012If there is no power to the door switch then you will have to trace the wire to the terminal block where the mains cable enters the dishwasher to check if a fuse is blown.
\015\012
\015\012The control panel of the dishwasher is live so take care to switch off the power when working on it.
\015\012
\015\012Hope this helps.
Repair Help & Product Troubleshooting for Maytag Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a maytag dishwasher model MDB8600AWQ that suddenly stoped working, no power lights on panel. I have had multiple problems with this unit with a complete service approxinamtely 1 year ago and had no problems until there just seems like there is no power to the unit. It is used infrequently and has been wwll maintained. Is there an easy solution or should I just give up on this unit.


Please refer to the diagrams on this site. \015\012\015\012If the ... Maytag Dishwashers

Dishwasher does not seem to have power. I have a Kitchen Aid, under counter unit, 9 years old, model KUDS01I. I used it 2 nights ago with no problem. When I push a button, nothing happens, no lights show, etc. It is plugged into the lower half of a duplex socket with disposal plugged into the top. Disposal works, so the problem seems to be with the dishwasher. That also eliminates any issues related to breakers or ground fault indicators, etc. Is there a reset button on the dishwasher? Is there


... KitchenAid Dishwashers

Have GE Monogram ZBD6880 dishwasher. Ran unit and unloaded. Went to use the next day, and none of the buttons to select and start will work- it is as if the unit has no power. I confirmed that there is power to the unit. Is there a way to reset, seems like it might be something simple.


... GE Monogram® ZBD6880NSS Stainless Steel Dishwasher

I am trying to clean my block paving using my pressure washer Karcher 3.99, which I used successfully last summer, however, it is not cleaning well. I have used the high power nozzle but the power seems inefficient to get the dirt out of the paving. Please can you advvise what you think the problem may be. Many thanks. Sue Thompson


Hello Sue, you don't say where in the world you live, but if you are attempting to clean dirt and algae off pavers, you need to add a solution to the water jet via the inbuilt attachment. Mix a fairly mild solution of bleach and detergent, pus a dash ... Karcher Pressure Washers

FDW60 Hello, I have a Hotpoint FDW60 dishwasher. It seems to have the usual quality issues but the actual problem is different to most I see on here. The machine has only been used about 20 times, but yesterday the following happened, I loaded and selected intencive program, when I pressed start the machine made a shriek/chipping sound, it seemed to run for about 5 seconds then stopped with the power and prewash lights flashing erraticly for about 3 seconds then was totaly dead, no power light o


Tom,\015\012If your dishwasher is still under warranty, best thing will be to contact Hotpoint's service center for repair the problem. ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

The "clean light" on our Kitchenaid KUDIO1FLSS flashes 7 times and I cannot clear the problem to allow the unit to operate. Is there a sequence, using the control buttons, to permit the unit to run a system check? I disconnected the power for 30 minutes but that did not solve the problem.


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Hi. I had f1 appear on my Gisher and Paykel dishwasher. Unplugged from wall. Few days later dried using a hairdryer. Took cover off pcb board and dried in there as well. There was water on bottom of cabinet so understand the F1. Problem is now, I put cover back on pcb board and tried to power up but it is dead? Any sensor.microswitch on PCB cover, or anything i may have missed? No power at all to unit? Any assistance greatly appreciated. PS - Wall socket finer as powers other appliances.


Wait.................. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

AEG Favorit - model F86050UM The dishwasher was disconnected and moved whilst new timber flooring was being laid. On reconnection it was evident there was some water in the base of the unit, this was removed by tipping the unit over to drain. Now there is no power display on the door.Power outlet checked OK. Your assistance would be appreciated in this seemingly simple problem. Murray


What has happened is that you have tripped the overflow/anti flood device switch when you upended the machine. You most likely need to empty out the salt container, and to reset the antiflood give the machine a few sideways tips and try to shake fre ... AEG Dishwashers

Have a bosch dishwasher model shu3032uc-14 doesn't clean very well it seems top spinner doesn't always turn, had service look at it and couldn.t find problem recommended to use a water softner, other people have same unit and do not use a softner and theirs works great what else should i look for thank you


... Maytag Dishwashers

I have a Karcher K3.91M pressure washer that pulsates when the trigger is released (off). It works fine when turned on, pressure seems OK. Before this started the unit would just turn off until I again wanted to use it. Is it a problem ? Correctable? All connections seem tight & I see no leakage.


... Karcher K 5.85 M Electric Pressure Washer

Hello, My Kenmore elite dishwasher model 665.17282.400 seems to have a problem. The CLEAN light is flashing and can't do anything else with it. Do you know what thew problem is, or how to reset it. I tried cotting off the power to the unit but to no avail. Please help ASAP


Try pressing the heated wash then heated dry one after the other about 5 times. this should reset the unit.\015\012\015\012\015\012--------\015\012in some machines there is "Hi temp scrub " and "air dry" so press this ... Kenmore 24 in. 17282 Built-in Dishwasher

Rinse Aid dispenser seems to use a lot of product. Could almost need to be refilled daily. Is there somewhere or somehow to determine where an internal leak may be or to check that the rinse aid door is leaking or is not the problem. This seemed to happen very suddenly. This unit is approx. 6-7 years old. The rinse aid settings have not been changed.


Turn the settings down. the amountof rise aid dispenced. ... Whirlpool 24 in. GU1500XT - Multiple Color Built-in Dishwasher

Describe your whirlpool du948pwpq Problem: I have a whirlpool du948pwpq dishwasher in a tenant's unit. They said the delay start button is no longer working. Also, they cannot "de-select" the heated dry option. It seems to be an issue with the electronics of the control panel. I've already tried to "unlock" the buttons - no change. I also powered off the unit in hopes of re-setting - no change. Does anyone have any other suggestions? I am hesitant to call a service person (it's out of warrant


... Whirlpool 24 in. DU948PWPQ Built-in Dishwasher

I have a kenmore elite smart ultra wash that used to be pretty quiet then got noisier and now it cycled thru very slowly but did not clean anything. the door for the detergent opened and the tablet dissolved but i dont think any water was used. both swing arms seem to be free and spin. water is going to the unit and it definitly has power.


Do u have hard water is so go to your local hardware and get that solution for it to remove hardwater stains and run it threw your system..it could be cloging up.. ... Kenmore Dishwashers

Humming noise i have a GE nautilus GSD2200 model which has not been used more than 4 years that is giving me trouble.  it's making a loud humming noise (the noise comes and goes, comes and goes) which seems to be coming from the motor area at the bottom of the unit.  I stopped it in the middle of the cycle, but the water seems to be stagnant at the bottom.  any suggestion on fixing the problem myself?


I have seen this SOOOOO many times in my 35+ years in the appliance repair industry.......it is very typical....here you are this is an answer I provided someone with the exact problem not to long ago..............This is a t ... GE Nautilus 24" Built-in Dishwasher

WP DW Mod # GU1200XTLS0: this unit filled with water and just stopped running. I have power to the unit. The control panel does not light up at all. Its wierd that I have power to the board and all the wires seem to have power! No burnt spots and no burnt smell on the board.Hmmm! Door latch and switches all check ok. Oddly it seems like the line power to DW goes all the way thru the unit and back through the nutural wire. Could the motor windings be burnt out?


Hello , there should be a fuse located by or on the side of the board with 2 wires going to it , one from the latch and one from the board ,it does come off , use an ohm meter to check it , it should ohm out or have low resistance make sure to take t ... Whirlpool GU1200XTLS Stainless Steel Dishwasher

Maytag 6 yr old Dishwasher - Model LR111721 Standing water in bottom of unit. Front panel lights do not come on. Checked circuit breaker in basement & it is getting power. Last time we used it it seemed to make a bit more noise than ususal.


... Maytag Dishwashers

I have model 1380 and it has worked great. We recently moved and now want to use it, but it has been unused for over 3 years. Got it all hooked up and greased the o-rings and plugged it in and it will not start. I can't reset the GFCI as it does not seem to move or do anything. Any suggestions on what my problem may be and how do I correct it, short of buying another unit? Joe


... Campbell Hausfeld 1,350 Psi Electric Pressure Washer With Auto Detail Kit #PW1350

Dub750x leaks My Whirlpool Quiet Wash Plus Series Model DUB750XB-0 dishwasher produces a small puddle of water on tile floor in front of unit, but it doesn't seem to be coming from underneath it as tile/grout right in front of it aren't wet. This happens hours after the dishwasher has been run, usually at night, whether on Air Dry or Heat Dry setting. This began occurring recently after years of use without the problem. Sometimes it occurs more than once after washing/unloading. Coul


... Whirlpool Dishwashers

I have just bought a Kenwood KID60S10 dishwasher. I have used it a couple of times with no problem. However I realised it has been leaking from the water pipe at the back so pulled the unit out to tighten and readjust the pipe. However when I tried to run a cycle it won't after this to check if it was still leaking it won't. When I choose a programme non of the lights light up (except the power on/off light). I had left the washer out of the cavity to ensure the pipe wasn't leaking anymore. It i


... Dishwashers

[email protected] My problem: I have a GE Quietpower2 dishwasher. The normal wash and heated dry lights continiously blinks, the pump seems to be operating with no water present. I've tried turning the power off and using the reset button with no results. The lights blink even with the door open.


Hi,It sounds like the main control board has gone wacky....replace the control board.\012That is not that hard to fix and you can easily buy the partsyourself online...Here is a tip that will help you with the onli ... GE Dishwashers

GU1500XTLS3 Periodically won't start. Dishwasher has power because pressing cancel causes dishwasher to start draining (even though there is no water). Door switch works because opening door prevents starting drain cycle. No other button on control panel will work except for the 'air dry' / 'lockout' button. Turning off circuit breaker for 15-30 minutes and then turning circuit breaker back on seems to fix the problems but only for a couple uses and then it stops working again. Need ad


This could be the 'fill switch', which is the level sensor. Could be a plastic tube that exerts air pressure into the tube as it fills, make sure it's clear and open. The dishwasher has a sensor that monitors the door being closed too. Some use a hig ... Dishwashers

The control panel on my Maytag MDBH970AW is unresponsive, and the latch is stuck in the "open" position (the plastic piece stays pushed in to the handle and won't come down). I've checked that the unit is getting power from the house. Last time I had this exact problem (when it was under warranty), they had to replace the control panel, the latch, and it seemed like most of the door. What should I do?


... Maytag 24 in. MDBH970AWS Built-in Dishwasher

Hi, I have a Karcher K3 pressure washer. 18 months old, used maybe 6 hours total. For the past 3 hours of use the compressor/pump seems to cycle audibly but pressure at outlet hose seems constant, hence I did'nt worry. Now it does not start with switch on. I now hear a buzzing sound from the unit. The unit was last used 6 weeks ago. The unit was stored in the garage away from frost, it does not leak water so I don't think there is any frost damage, but just this buzz. Any suggestions would


... Karcher K3.68MR Electric Pressure Washer

I have a Baumatic BDW 45.1 slimline dishwasher, the unit will power on but I cannot select a program. I was able to place the unit in to reset mode once by holding down 'P' and power cycling the unit. This then allowed me to choose a program and complete a full wash cycle. Now I cannot repeat this steps and the unit remains with just power light on. There are no Error codes displayed at all. Could this be a problem with the front panel?


... Baumatic 18 in. BDW45.1 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1379 seconds