Having problems with your Maytag Dishwashers ?

Dishwasher model dwu7300 I am having trouble with the door handle. This is the third time that it has to be replaced. This last one only lasted 6 weeks. HELP!!


Answers :

Repair Help & Product Troubleshooting for Maytag Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher model dwu7300 I am having trouble with the door handle. This is the third time that it has to be replaced. This last one only lasted 6 weeks. HELP!!


... Maytag Dishwashers

Error 03 -"Wash pump not operating" and sometimes Error 12 "drain valve is running when it should be off". About one third of time runs normally. Other times only E03 or E 12 after E03 and restart attempts(pwr off/on). Pwr off 1 min before restart attemps. Last 45 uses eventually does run to finish. Local tech unable to replicate problem in one $100 service call.


... Electrolux Dishwashers

During power scrub cycle which is the one we use most of the time the dishwasher stays at one minute fot a long time. the dishes come out clean and it finally does finish cycle just dont know why it takes so long on last minute of cycle for so long


It's just heating the water more ... Bosch 24 in. SHU43 Built-in Dishwasher

We have run our dish washer several times, however, the dishes are not getting cleaned. We first ran it on "normal wash." The second and third time we ran it on "pots and pans." Not only are the dishes not getting cleaned, but the soap is hardly getting dissolved. We use liquid dish soap too. I noticed this last time, at the end of the wash, the soap was getting built up on the front-right (when facing the machine) and had turned into a solid clump; almost like plaster. I don't have a manual so


First idea goto your local home depot they make a product called AFFRESH for front load washing machines and dishwashers run this tablet inside your dishwasher with no dishes on the inside on the hotest setting this usually takes out all build up wit ... Dishwashers

I used the "rinse only" cycle on the dishwasher a little while ago. I've never used this cycle before. After dinner I tried to start the dishwasher, but no other buttons on the panel respond except the last one I used, which is the rinse only cycle. I push and push, I tried pushing and holding, nothing works, I get no lights no anything. I've been using the "light wash" cycle for a long time and I normally just push the start button and the last cycle used starts automatically, so I wasn't a


Try un-plugging the dishwasher (check for cord under the sink) or turn off the breaker to it to re-set the control board. If this does not resolve your issue you may have a defective key panel. ... Dishwashers

*Beeping* thing Hobart SR-24 Dishwasher Beeps at me. Has beeped on startup since service tech was here last month...thought he fixed something we didnt even know was broken.....but now the thing beeps mulitple times a day...sometimes mulitple times in one cycle. What does it want?


... Hobart SR24-H Built-in Dishwasher

I have a KitchenAid but model # KUDI24SEWH1. Can not find it on your list although another model without the last letters 'WH1' is on it. Anyway, my nephew ordered the parts he said needed to be replaced. One was the top water feed tube and bearing which he had no problem replacing when the part came in. But, he is having a very difficult time opening up the front door to replace the soap dispenser. Removed the 6 screw (three on each side) and the two at the top of the door but that is as far


You don't Use the WH2 just the first 6 letters and numbers.\015\012Jim ... KitchenAid KUDI24SE Built-in Dishwasher

My Bosch dishwasher does not start. Instead it just ticks. I am not aware of any timer that it has. We have let it tick all night. One time in the last 20 attempts to start it (by closing the door) it did start but not since. Model number SHX46B. It is about 5 years old.


Hi.It is possible that the timer board is responsible, timer board however is an expensive part and fails rarely.Before replacing control, if there is no water coming in check:Door lockInlet hose at the back ... Dishwashers

My Kithchen aid diswasher on its last use started smoking and then flames shot out of the side. I am I wasting my time calling a repair person and should I just look at getting a new one. My Kitchenaid dishwasher is 7yrs old


I would just replace the dishwasher. ... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

Honda CU2400 1-MHC has been sitting in my parents garage for about 2 years. It was used once or twice. It looks new. I tried to start it and it wouldn't. I drained the gas and put new premium gas in it and it started but it won't stay running and the pressure is not what it should be. It doesn't clean as well as the electric one I used last time. So, my problem is, it won't stay running and when it is running it doesn't have enough pressure. Any ideas???


After sitting that long, I'd guess the carburetor linkages etc., are partially seized and the governor is not operating as it should to allow proper RPM's when under load. Real good chance carburetor is gummed up good too. I'd get carb serviced, but ... Pressure Washers

My dishwasher made some really grindy, crunchy sounds the last time it worked. I unscrewed the float and checked for debris in it, nothing there. When I got that off, there was a circular black fan-type thing under it(the motor??), that spins around and seems to be held in place with only one screw. I tried to access underneath that, and it doesn't want to do anything but spin around. How do I remove that to check underneath?? I don't want to break it. I put it all back together and tried run


One of the most common question that I get on a dishwasher repair is "how does that motor and pump impellor screw come out?"Inside many dishwasher pump assemblies is a screw that goes through the upper impellor and screws direct ... Whirlpool 24 in. DU930PWP Built-in Dishwasher

How do i get electrolux to give me a new dishwasher given that the old one is a dud and can burn my house down? I don't just want a 'fix' like last time


Unless a tech can condem your unit, and it is less than a year, you will not have much to stand on. Can you discribe a little bit more on what problem the D\\W is giving you. ... Dishwashers

Programme very erratic lenght of times. Put it on programme and there are no 2 days the same 200 mins one day, 175 the next then 100 then still going at 5.30am after switching on at 10.30pm. It has been an absolutely fantastic machine until last week. Machine is a SE25A091 purchased 10/01/2004 any suggestions what it could be. Thanks Wendy Harvey


... Siemens 24 in. SE25A091 Hi-Line Free-standing Dishwasher

I purchased my KARCHER G2500VH last summer. I used it one time for about an hour. I tried to start it today, seems like its not getting gas. I checked the gasline to make sure gas was flowing. I removed the sparkplug, poured a little gas into the engine through the plug hole. Replaced the plug, pulled the rope and it started for about two seconds. I also poured fresh gas in tank. Cannot get to start.


Have tried to start our BlackMax 2700psi pressure washer, it is not getting gas to the carburetor, what to do? ... Pressure Washers

I have a Kitchen Aid dishwasher that ha had the processing board replaced twice in the last year. It is not functioning again so this will be the third time in 13 months. Any reasons why the board keeps failing?


Do you live in an area that has a lot of power outages? That could be one reason. Another reason is an area that has power surges. You can have an electrician add a surge protector to your electric fuse box that will help. Otherwise, if a good techni ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Our house had a power surge last year and since then our kitchenaid KUD102IRBL has had some issues. One is that the 4 hour delay stopped working all the time, and now a very loud noice comes out of it during the wash cycle. It does not clean well now. Would this be a pump and is it fixable?


Step 1, Open up the sump assembly/filter which is below the lower spray arm. It appears the the sump filter top is held down with just one screw.\015\012\015\012Remove everything you can, rinsing/cleaning any thing that needs it. ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Dishwasher Leak I found water on the floor in front of my dishwasher one morning so I removed the panel and ran the dishwasher to check for leaks and found none. I did check all the gaskets on the inside and they appeared okay. I again ran the dishwasher and had no leaks at that time, however, the last two mornings after I have found water in front of the dishwasher.


Hi,Here is a tip that I wrote about leaking dishwashers...There also is a link in there to another tip on how to buy parts online fo ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Hello, We have a combination oven and dishwasher. Last week I filled up the dishwasher and after about 5 minutes a blue spark came out at the bottom and it cut the electricity off. Once the electricity was restored we started it again and after a few minutes it just stopped after filling up with water. It blew a fuse again but only one fuse this time and now doesn't switch on anymore. We have emptied all the water from the dishwasher and checked the filter, etc and wonder what could have gone wr


Hi, I contacted the Rosieres web site in France and sent a message using the link Contact Us. Here is the reply;Dear xxxxx,we advice you to contact:TELE MENAGER VIDEO SERVICE21 rue georges Doublet0610 ... Dishwashers

It's a Karcher presure washer K2.54, one and a half years old. Was working fine last time but when turned on now there is very little pressure through the hose and the water seems to be filling up inside and spurting out through the vent on the front


This sounds like the seals may have been damaged inside the pump or that the water inlet/outlet could be damaged. If you take off the front cover (use a star bit screw driver) then run the pressure washer you will be able to see were it is leaking fr ... Karcher Pressure Washers

Our Kenmore dishwasher 665.1726 doesnt seem to be cleaning as well. LAst time this happened a serviceperson cleaned out a filter where food debris had clogged the water flow. We were able to take off the bottom wash arm but couldn't figure out how to get the filter off (there are 4 screws holding it in place and one is under the plastic arm that caries water to the sprayer.


I had the same problem!\015\012\015\012The arm WILL come off....you have to pull the screen off. ... Kenmore 24 in. 15689 Built-in Dishwasher

I have a Braun combimax 650--it is fairly new. It was working fine last time I used it, but this time, the dial that turns the machine on seems to be stuck. The little button for the pulse does work. I read the instructions, which said that this might happen when the machine overheats and to wait fifteen minutes, but it is definitely not an overheating problem and the last time I used it was weeks ago.I love this machine and now need to use it for quite a number of things--any help you can provi


... Braun K-650 CombiMax Foofs Processor FOR 110 VOLTS

I have an Asko w66 front load washing machine that will only wash one way with a 60 second time delay and washes the same way again instead of reversing. At no time will it wash the other way. At the first spin cycle the water is pumped out but the wash drum will not spin. The pump continues to pump and will not stop while the one way wash continues. The timer stops at this point with the one way wash and pump still pumping continuously.


... Asko Dishwashers

Blowing fuse... We've replaced the overheating fuse located in the control board area about 5 times. It has just blown again after using the dishwaser one time--before it would go about a month before blowing the fuse. It seems to get about a few minutes away from completing the wash cycle and does not complete the draining process. Help!! We don't know what to do next--replacing the fuse is costing about $15 each time, before you know it we could have bought a new one! Thanks for the help. Ti


Tim, this blown fuse issue was pretty common on this model. Whirlpool, which made this model came out with a fuse kit that included a terminal and heavier guage wire to eliminate this problem. It just splices right into the control board, easy job. T ... Kenmore 17024 Built-in Dishwasher

I just bought this pressure washer last yr. I tried to crank it for the first time 2 days ago since i cranked it last season. It took several times and it finally started. About 20 seconds later, it s


Gas only lasts for 30 days in small engines try fresh fuel but you might need to clean the carb out ... Honda Black Max 2600 PSI Pressure Washer

Siemens aquaVario I have a 2007 (?) Siemens Aquavario Automatic 3 in 1 dishwasser. One of the programs got stuck with 1 minute at the timer. It was running like this most likely for more then one hour over the normally scheduled time; we don't know for sure since we were out of the house. It produced some sort of 'sucking / blowing' sound and continued doing so after I opened and closed the door again. After the reset (pushing two buttons at the same time) the timer went back to zero but the sou


... Siemens Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0607 seconds