Having problems with your Maytag MDB5100A Dishwasher ?

Water is not enter dishwasher

\015 Water is not entering dishwasher\015

Answers :

The problem is most likely the water inlet valve. This is a solenoid\015\012that opens when there is power to it. It is a common problem on\015\012dishwashers and washing machines.
\015\012
\015\012They are not very expensive and are usually fairly easy to replace.
\015\012
\015\012If you need more help, post a comment.
\015\012
\015\012Thanks,
\015\012
\015\012Tim
Repair Help & Product Troubleshooting for Maytag MDB5100A Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

No water will enter the dishwasher, There is no problem with the water supply or the supply line. The water flows from the supply line to the dishwasher connector but does not enter the dishwasher.


The water-inlet valve lets water enter the machine. Make sure it's not clogged. There is a screen on the inside of the valve, this sometimes gets clogged up with debris. Check to see if you get power to valve when unit is put into operation ... KitchenAid Dishwashers

Water seems to be leaking into the dishwasher at the end of the cycle the water appears to be clean, so I am wondering about a seal of some kind on the hot water line leaking or whatever. It is a Bosch Dishwasher SHU series 3200 My problem is the same. Water leaks in to bottom of dishwasher over about a 2-3 day period. The dishwasher runs fine. It does not ever run over. The water seems to stop entering the dishwasher after it reaches a certain level.


You have a bad water valve. When the unit is off, the valve should seal and the water should not flow. Something has gotten in the valve and is keeping the needle up or the diaphram in the valve has deteriorated. replace the water valve and you wil ... Dishwashers

Kenmore dishwasher My Kenmore dishwasher model 630.16302401 is not successfully completing wash cycle. When I hit "normal" and turn it on, water enters the d/w, and the sprayers (both top and bottom), spray water. Approx. 10 mins. later, the water is drained. At that point, it appears that water never again enters the d/w to complete the wash cycle. In fact, the soap in the dispenser does get released, and the door opens. However, the soap will just run down the inside of the door and pool on th


... Maytag Dishwashers

Loud humming when the water enters the dishwasher. The copper pipe vibrates. The dishwasher is approximately 11 years old. Problem slowly getting worse over time. I tried to tie down the copper pipe in the basement to no avail. When I closed the right angle stop valve and reopened, the problem got much worse and won't go away even if I grab the pipe. Only happens when water enters the dishwasher.


The fill valve solenoid has gone bad.u need to chg the fill valve assly.it is very easy to chge ad it is mounted on lhs bottom corner of the unit behind the toe panel. ... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

Zanussi DW908 dishwasher will not fill with water, when filled manually completes cycle untill fill time again. when filled continues on until water needed again. Only cold supply to machine. Water coming to valve, removed valve and freed it up as it was stuck, water flows through the valve when disconected from the dishwasher at filler pipe which leads up the side of washing chamber. When all connected up water will not enter the dishwasher. I,m beaten as I cannot access this area without maj


\012\012Hi,\012Here\012is a tip that will help you to find out why water will not come into\012the dishwasher... Dishwasher Trouble ... Zanussi Dishwashers

We just hooked up our old built in GE dishwasher and the water is shooting out the left side of the unit where the black water hose enters the tub. Shouldn't the water be entering into the wash arm? The hose isn't clogged. It attaches to a white plastic piece that is part of the unit itself. The water is entering both the tub but also shooting out of 2 slits approx 1 1/2" each. located right below where u attach the hose.. Any help would be greatly appreciated!


... GE GSD5130 Dishwasher

Whirlpool dishwasher DU945PWPQ2 four year old machine - never used. Water lines are attached properly and are clear. When dishwasher is turned on the wash cycle light turns on. cycle completes but water does not enter the machine.Water does not enter the machine.


... Dishwashers

Water temperature difference?? Does the brada dishwasher have a heatng element to heat the water if temperature of water not hot enough. If not, then the water entering the dishwasher is the issue. Th


... Dishwashers

My dishwasher is only 2 years old. My small coffee shop is in an area where we have large quantities of lime. At this point in time the repair people have been out two times and this is not fixed. There appears to be no water being pumped into the dishwasher where it will be heated prior to washing. Also the temp gauge is not working all the time. With no water entering, the small amount of water in there is rising in temperature quickly if the gauge is working. The technician that have be


... Champion Dishwashers

I have frigidaire dishwasher,starts cycle,can hear water entering dishwasher,checked level of water,does not get to 1",machine starts washing by the sound of motor, but dishes are not clean,water drains machine turns of,cycle complete.what do you think.


Depending on your dishwasher, it fills either by a timer or by a water probe or float. I will assume its a timer as a probe or float wouldnt exhibit this behaviour. I would say you have a restriction in your water supply line. Check your valves, an ... Frigidaire Dishwashers

Do these 'portable' dishwashers 'heat' water prior to washing? i have customer complaining bout the dishes not coming clean..yet the water entering the dishwasher is cold, does not appear to heat water prior to washing.


Most dishwashers require a minimum 120 degree inlet water temp. The heating element will boost this up during the main wash cycle to aprox 140. Do not hook a dishwasher up to inlet water temps above 150. ... GE Hotpoint HDA3500N Dishwasher

No water my kenmore ultra wash was unused for two weeks during a renovation and once hooked back up does not allow water to enter the dishwasher. The hose has been checked and runs freely. The dishwasher runs thorugh the cycles but not with any water. Thoughts?


Two things to check. First see if anything is holding up the float inside the tub. Located on the bottom right if I remember correctly. I had a fork fall off the rack and do the exact same thing by getting lodged under the float. Second, if there ... Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173

When we turn on the dishwasher there is no water entering the appliance..then it cycles to drain the water and I reset it so the pump doesnt burnout...what could this possibly be and is there some troubleshooting I can do before I call a repairman..the dishwasher has a touchpad front...by the way..the water is turned on..


... Maytag Dishwasher

ASKO 1905 - Turn the dishwasher on and no water seems to be entering the d/washer. Water is turned on. Dishwasher gets very hot as no water is coming through the pipes.


... Asko Dishwashers

Seems my drain is plugged on my dishwasher it is the magic chef 4500b unit and i now have water all over my kitchen floor. i cant seem to find the product du4500b  so i entered the du2000 , either way there is water on my floor and about 4 inches of water in the bottom of the dishwasher


Ok there are several problems this can be caused from...1. there is usually a float device (I'm not sure about this model) that floats up and turns the water flow off when an appropriate amount of water is injected into the DW...sometimes these ... Magic Chef 24 in. DU2000 Built-in Dishwasher

My Whirlpool Dishwasher ADP931 has stopped working. It stopped in the middle of the cycle with 2 to 3 inches of water on the floor of the compartment. I mopped out the water and tried to restart the dishwasher. The green "on" light now comes on when I press the start button. but nothing happens (no motor comes on,no water enters).Repeating the above action several times does not help the washer to restart even though the other function lights will come on when the knob is turned. saturn1914


Hi,Whenever you see such symptoms, Time for you to investigate it properly. Check the below guide :-\015\012\015\012\015\012\015\012\015\012Power from the house\015\012\015\012Is\015\012there power getting to the dishwa ... Dishwashers

GE Triton XL Dishwasher won't start, Runs but won't allow the hot water to enter the dishwasher at the beginning of the wash cycle. Just hums with no hot water.


Check the float switch make sure it not stuck or may be full valve gone bad ... GE Dishwashers

I have a Gallery 900 series GLDB958AS dishwasher. The cycle status lights (just right of the "time remaining" status window) continually blink. None of the buttons on the front panel work and every 10 minutes or so the water pump starts up for about a minute then shuts off. No water enters the dishwasher. I tried turning the power off then on but there is no change. Every so often a random cycle light will blink or light up for a minute, then turns off.


It seems that there is error on the program controller unit. All you need to check if that if there is moisture build up on the panels thus causing the programs to go harewire.\015\012So remove the panel and disconnect the wires, check all lead ... Frigidaire 24 in. GLDB958A Energy Star® Built-in Dishwasher

We have a Whirlpool ADP962 Dishwasher that will not fill. I replaced the inlet hose as I thought the solenoid was faulty. It's gone a step further and now sounds like it fills (continuously) however it soon drains without any water entering the dishwashing compartment (this remains dry). I believe this issue was caused by running it through a cycle without the water mains turned on. Any ideas?


Hi.When you say inlet hose I think you are referring to the inlet valve, which has a built in solenoid. The inlet hose is only the rubber hose connected to valve and faucet.Rather than the hose the problem is likely overfill d ... Whirlpool 24 in. DP840D Free-standing Dishwasher

Viking dishwasher code says water line problem, but water enters the dishwasher 1st cycle then stops.


... Viking DFUD142 Built-in Dishwasher

Dishwasher leaks When we start the dishwasher we hear it try to start but no water enter the inside tub. If we hit the cancel button it shuts down and water starts spraying from underneath in the area where the main wate line hooks up.


Sound like the fill valve is not working. I woudl check the hoze for a clogged screen ,then replace the fill valve if no clogs found.  ... Kenmore Dishwashers

I have a Kirkland Signature dishwasher produced by GE. The dishwasher is leaking from the top of the tub, where the water enters into the top sprayer. Should the top water inlet hose be tight to the top of the wash tub, and if so what can I use to make it tight?


... Dishwashers

Dishwasher - Bosche - SHV43A03GB - When the main power switch is ON, even with the door open the pump/motor continues to run (ie. Stop-cycle does not operate). However, the wash-program itself does not run, even with the door closed (ie. No water entering the dishwasher, even though water supply is on and feed lines are clear - not kinked). It is like the program is 'stuck' and I cannot seem to get it to reset.


Your door switch is likely faulty and should be replaced. You can get them at partselect.com ... Dishwashers

Defy dishmaid dishwasher does not start wash cycle. Several attempts to reset dishwasher has been done. Machine has been unplugged for several days and switched on again and still does not work. The start/stop switch have been kept in for about 5 - 10 seconds to reset. When the machine is set to do washing, the water enters the machine and wash light shows green and machine remains like that with water inside the machine. The start/stop button is again pressed for 5 -10 seconds to drain the wate


... Dishwashers

No water When I start the dishwasher, the display shows 96 and starts to go down but there is never any water entering the machine and "HO" starts blinking. The dishwasher has been running fine up until today.


First swith the machine and the water supply off and then where the inlet hose is on the back of the machine remove the hose from the machine and look in the plastic part that the hose screws onto there should be a small sieve there this can be pulle ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1257 seconds