Having problems with your Maytag MDB6650A Built-in Dishwasher ?
Does not seem to be getting power
\015 The dishes were not getting clean. I discovered the discharge housing was broken. Still had power after I disassembled it. While waiting on the parts the inside filled with some water and now it does not have any power. I have checked the breaker box.\015
The most common reason for a dishwasher to go dark like this is the door latch. From the wiring diagram, there appears to be two door switches on the unit, which must both be closed for the dishwasher to have any power. They are probably both in the actual door latch. Recommend that you confirm the latch is "latching " properly ... or manually close both switches and see if the DW lights up!
Good Luck! Please update me with what you find, OK?
Good Luck! Please update me with what you find, OK?
Repair Help & Product Troubleshooting for Maytag MDB6650A Built-in Dishwasher
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
My Hotpoint diswasher suddenly stopped working last night. It seems like it has no power to it, as the motor or pump does not seem to come on at all. Obviously when I get home from work, I will check the obvious first - making sure it has power to it, connections are secure etc. (I had a wire break before) If it does have power, I would assume checking the door switch and timer is next. Any suggestions, and any suggestions for checking the door switch and timer??
Sounds like your on the right track. I would use an ohmeter to check the resistance of the door switch by placing the meter probes on each side of the switch. Test while opened and closed position. Same with timer ... Hotpoint Dishwashers
Kudc10fxss4 I have a KitchenAid KUDC10FXSS4 w/o any power. Circuit breaker is on, and it's getting power. But there are no lights on the display. I called a parts place to see if I could order a thermal cut off fuse. But the representative stated there is no fuse listed for this model. Any ideas on what would be causing a loss of power? Seems odd/wrong to me that there wouldn't be a fuse. If there is a fuse, would it be located in the door (the control is built into the door, such
... KitchenAid Dishwashers
I have a jenn air dishwasher modle JDB7900AWW that the heating coil gets no power. The coil and thermostat seem fine, no power geting to them. Everything else works just no heat.
... Jenn-Air 24 in. JDB2100AW Dishwasher
No Power Hi. My dishwasher wont start. I loaded it and cannot get any lights to light up on it. There is no power to it at all it seems. I tried flipping the breaker but there is still nothing. The door locks, so that shouldnt be the issue. Is there a way to reset the machine? What should I do?
I have the exact same problem with my Kenmore Type 575-0. It was working one daym it went into dry storage for a year and then when I took it out of storage it would not work. Ive already tested the thermal fuse and there is nothing wrong with that. ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher
I have a Bosch Dishwasher about 10 years old, model SHV4803UC/U07. Yesterday it stopped working along with no lights on the selector buttons. I have reset the circuit breaker ( which did seem to not be off at any rate). It seem not to be getting any power if it's not the circuit breaker what else could cause this?
... Bosch Dishwashers
I'm not getting any water into the dishwasher, not on wash or rinse. The float float is working feely and I can hear it click when manually pushed. I don't seem to be getting any power to the valve that controls the water.
Hi pull the wires off the inlet valve under the dishwasher. Then set the dishwasher for a cycle and test the wires with a volt meter while the unit is supposed to be filling. If you are getting 120v the valve is either blocked or bad, you will have t ... GE Dishwashers
No power to kenmore dishwasher control panel no lights on and flipped breaker still does not seem to get power
... Kenmore 24 in. 16032 Built-in Dishwasher
I have a Honda xr2600 power washer. When I tried using it, water was squirting from the top of the gun. I took it apart to find that there are o-rings on top of some kind of washer---looks like a lock washer but it's made of cardboard??? Two of these washers were broken. I can get the o-rings but I can't seem to find the washers. I tried getting the manual for this model on line with no luck. Any assistance will be greatly appreciated.
The washers that you describe are made of teflon and are split to facilitate installation and/or allow expansion as they wear. These washers are actually seals and at times are used together with orings to seal high pressure. You should ... Honda Pressure Washers
I have a D3100 that continues to pump out. None of the controls seem to do anything, the only way i could get it to stop was to turn of the power point.It does not reset as when i turned on the power point again it started pumping again.
The flood switch has turned on at the base. This means either the switch is faulty or water has leaked into the base of the housing. ... Asko Dishwashers
I have a Kitchenaid KUDIO1DL white dishwasher which is a few years old now but has worked great since I bought it. Today it has the lean light flashing and will not turn on. there is power, and the drain button seems to work, but I can not get the cycles to come on. When I press the start button, I just get two dash lines and then the unit turns off. Thanks
... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher
My Kenmore Ultra Wash Dishwasher model 17731 stopped working mid wash I checked the power cord and it is fine but the unit doesn't seem to be getting power. Is there a fuse in this thing? Any advice would be welcome.
... Kenmore Dishwashers
Wash cycle stopped with water in the bottom. Seems like there is no power. Can't get lights on cycles buttons to turn on. Power button does nothing. Checked circuit breakers. All are on. Lights and outlets around dishwasher area are working.
Check the wiring in the units junction box. Its located at the bottom right corner. You will likely find melted connectors. If so, you need to cut the wires back and replace these connectors. Make sure you turn the power off before doing any of this ... Bosch 24 in. SHX46A05UC Built-In Dishwasher
Dishwasher is just less than 1 year old. it doesn't respond to attempts to turn on. I turned off the power at the box and back on after 10 minutes. it worked. then the same problem returned. now it wont turn on at all. I checked all the connections I could and they seem fine. I know it is getting power. My guess is that something is wrong with the computer system. any ideas?
Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. This issue can be either due to a faulty door latch or\015\012door lock switch which is not engaging its ... Maytag 24 in. MDBH950AW Built-in Dishwasher
I am trying to clean my block paving using my pressure washer Karcher 3.99, which I used successfully last summer, however, it is not cleaning well. I have used the high power nozzle but the power seems inefficient to get the dirt out of the paving. Please can you advvise what you think the problem may be. Many thanks. Sue Thompson
Hello Sue, you don't say where in the world you live, but if you are attempting to clean dirt and algae off pavers, you need to add a solution to the water jet via the inbuilt attachment. Mix a fairly mild solution of bleach and detergent, pus a dash ... Karcher Pressure Washers
Dishes just are not getting clean its seems like water is not getting distributed. It is a GE quiet power 3.
You may not have enough water entering the dishwasher and need to have the water valve replaced. Try adding a quart of water during the wash cycle to see if it makes a difference. ... GE 24 in. GLD5860LSS Stainless Still Built-in Dishwasher
Honda gas powered pressure washer--runs great and I get pressure throughout the system but nothing comes out of the wand itself. There seems to be no clog throughout the system . I have cleaned all parts. When the unit isn't started I can get flow throughout the system
... Pressure Washers
Does not seem to be getting power
The most common reason for a dishwasher to go dark like this is the door latch. From the wiring diagram, there appears to be two door switches on the unit, which must both be closed for the dishwasher to have any power. They are probably both in th ... Maytag MDB6650A Built-in Dishwasher
I have a JDB1090AWS about 3 years old. We noticed a smell and found cutting boards and plastic cups melted. Machine was off. Had to turn off the breaker. Checked both leads to element & have power even with machine off. Not sure if it could be the limiting thermostat; I assume that is to shut the heat down when it gets too hot. Element is on though when it shouldn't be to begin with. I did have to tighten the water supply. Had some water underneath, but all wires seemed dry. Any tests I should t
The heat element can only get so hot.It's timed so it doesn't exceed a period of on, exposing dishwasher contents to continuous high temps.Watch the timer and take note how long it broils your cookware.Good luck. ... Dishwashers
Whirlpool dishwasher adp 4500 . on start up green power light pulses and machine seems to struggle to get going sometimes it will happen again mid cycle
Check the start capicater on the motor ... Whirlpool Dishwashers
My dishwasher seems to not be getting any power and no lights are lighting up. It is still plugged in and I already tried resetting breaker. Any suggestions?
HI. Make sure there's power getting to the dishwasher. Check for a tripped circuit breaker or a blown fuse. Check the wall socket for power. Sometimes the power cord disconnects at the dishwasher (inside the junction box, behind the bottom kick panel ... Kenmore 24 in. 16032 Built-in Dishwasher
I have a GE Quiet Power 3 that has completly died. I cannot get a light to come on or anything to beep when pressing buttons. I checked the circuit breaker and outlet and they are both working fine. I tried pressing and holding the reset button on the front control panel and nothing. It seems to have just died at 2 years old. Anyone have a solution? GE wants $80 just to look at it.
A dead set simply means a cut off of power supply. Open the back cover of your dishwasher . Locate the area where the AC cord is located and look for the plastic fuse holder which is usually installed in one of the AC cord line open it and replace t ... Dishwashers
All the sudden, our Bosch dishwasher model SHU66C won't come on, like it's not getting power. The circuit seems fine, didn't trip off or anything. The dishwasher has been working great and is farily new. Any thoughts?
... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher
Water won't drain and dishwasher won't start. Breaker and GFI's are functioning. Power does not seem to be getting to the dishwasher.
... KitchenAid 24 in. KUDS25SH Built-in Dishwasher
Seems like the washer is not getting power. The cord has a big plug with two buttons with little lights. Lights do not go on. I think they did at on point. Is the plug toast or is there some trick or could it be another issue?
The lights are gcfi circuit interupter indicators you should be able to push them in to reset them if they dont check where you are plugging them in to see if that is causing the problem. ... McCulloch FH160G Pressure Washer
We just installed a new Kenmore Elite #13123K dishwasher. It has power and water but does not run. The lights light up and all but it does not seem to be getting any water.
Is the water inlet valve open? ... Kenmore 24 in. 15173 Stainless Steel Built-in Dishwasher