Having problems with your Maytag MDB7100AWB Dishwasher ?

Maytag MDB4000AWA dishwasher keeps stopping. If you push in the door it often starts again


Answers :

Door switch out of ajustment
\015\012it's a small micro switch that bends from time to time and all you do is bend it back
Repair Help & Product Troubleshooting for Maytag MDB7100AWB Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Maytag MDB4000AWA dishwasher keeps stopping. If you push in the door it often starts again


Door switch out of ajustment \015\012it's a small micro switch that bends from time to time and all you do is bend it back ... Maytag MDB7100AWB Dishwasher

GE PDW7300 dishwasher - must slam the door shut to get a light on the panel and when the START button is pressed, it looks like the dishwasher is cycling thru a wash, but there is no water. When I press the START cycle again, it seems like it thinks its pumping the water out for a few minutes, then the light will go off. If I start it again and push really hard against the door, I can hear the water go on. But if I stop pushing the door, the water stops. The dishwasher was installed in 2001, but


... GE 24 in. Profile PDW7300G Built-in Dishwasher

Hello, I have a built in Viking dishwasher and lately it does not work unless I keep pushing the door closed.Then it starts and when I leave the door it stops without finishing the whole cycle. What can i do to fix this? Thanks


It sounds like one of two things: Inside the door are simple micro switches on the latch assembly it could be that one of these is not making a good contact or is misaligned. Secondly the latch on the top of the dishwasher could be loose meaning that ... Viking DFUD042 Built-in Dishwasher

Dishwasher stops during cycle. Have to push on door to start again.


Have someone replace your bad door switch ... Maytag MDB9600A Jetclean II Built-in Dishwasher

I have a Kenmore Elite Dishwasher Model 665.172824000. We think it stopped part way throught the dry cycle. The green "Clean" light has been flashing since in 7 flash cycles non stop. I tried pushing the Cancel button, it starts the drain pump then stops and we are back to where we started. I tried to start a new wash cycle but when I close the door and push the start button it just give 3 quick red flashes and then nothing but the green clean light flashing again. I shut the breaker off fo


So sorry but the partsdirect site for sears locked down my computer. Check where the drain hose connects to your pump and see if there is a small device the hose connects to that has 2 wires going to it. If it does unplug the wires, turn power off, w ... Dishwashers

Our dishwasher came with our house. Brand new. It is 2 yrs old now, warranty gone. The problem is when you shut the door the machine starts running immediately and keeps running and running and running. You can push the stop button, delay button and it still runs. Also, doesn't clean. model# FDB1050REC4


... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

My Frigidaire Dishwasher FDB1050RES2 gets stuck in a rinse cycle. The light on the front will be lit "clean" but the bottom of the washer is full of water. Opening the door does not turn off the "clean" light. For me to get it to run, I have to unplug it, plug it back in, push the start button until the ?washing? light comes on. I then push the start button once more and the dishwasher will begin to drain. I open the door as soon as I hear the water stop draining into the sink drain. This


By the descrition you are giving you will need to replace the main control board.Part number 154568401.you may also need to check the float switch.The part will run about 110.00 dollars from a local parts store ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

The Simpson Silencio 850 door does not shut properly and the dishwasher stops operating,but once you push hard on the door,the dishwasher starts again. There are no leaks ,but the door must have a sensor registering the correct pre-load force against the door seal , which in turn,allows the machine to operate. My machine does not work until you push hard against the closed door. What is the problem please?


... Dishwashers

Matag MDBH940AWS dishwasher: Push start and light comes on but dw doesn't start - push again and light goes out but pump starts running but no water enters, push again , it shuts off ;; past problem never addresses is delay feature stopped working , no lights come on when delay buttons are pushed, so... control head in door replacement in order? Thanks , [email protected]


... Maytag 24 in. MDBH940AWS Built-in Dishwasher

I HAVE A WHIRLPOOL DISHWASHER AND THE LED LIGHT FOR CLEAN KEEPS FLASHING AND IF I PUSH THE CANCEL BUTTON IT PUTS IT IN TO A DRAIN CYCLE THEN THE LIGHT KEEPS FLASHING I CAN SELECT ANY CYLCE I WANT BUT WHEN I PUSH THE START BUTTON ITS LED FLASHES SEVERAL TIMES AND THEN STOPS AND THE CLEAN LED LIGHT STARTS FLASHING AGAIN


Check out it there is a water leak to the bottom housing. Usually this happens when there is a leak activated the flood sensor causing LED light turned on. Dry out the leak then leave it unplug for 24 hours so the sensor dry out by itself. Make sure ... Whirlpool Dishwashers

Hi i recently started to have issue with my dishwasher. The issue is that the washer stops in the middle of the washing cycle. More specific, once i start, it stops about 20 second latter. Once i push the door of the washer it start to work again for another few seconds any ideas?


There is some mechanical problem.Check water flow. Free rotation of spray arms. Refer user guide. ... Dishwashers

Asko 1585 Dishwasher. Lately the washer has not been completing it's cycle without going into the all lights flashing mode. Usually just opening the door, closing then pushing start gets it going again. Yesterday this happened and it was restarted as described, then it go stuck in what appeared to be a drain mode - all lights flashing, drain motor running. It was in this mode for several hours and could not be stopped by any means. Pushing buttons or opening the door had no effect. Even c


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa. You are right it is related to a bad control board. The\015\012control board has gone faulty and needs a replacement. Please check this recall\015\012information--- ... Asko 24 in. 1585 Built-in Dishwasher

Bosch dishwasher I have a month old Bosch dishwasher. It was stopped mid cycle. I drained the water at the bottom, but the active light keeps flashing, and when I press the start,reset button, then turn it off, it does the same thing when I turn it back on. active light keeps flashing and the wash light is on. It won't even lock the door. How do I fix this because there is no Bosch dealers here to help with the problem.


... Hotpoint 23 in. BF41 Built-in Dishwasher

I have an LG dishwasher Model LD-O5AW2 Benchtop. IT has been going perfectly until now. I push the button in and then the start button, when the wash cycle has finnished it wont empty until I push the stop button off and then on again. Then it empties and goes to rinse but wont come out of the rinse cycle, just keeps rinsing, until I turn it off and on again.Up until now its been a great little dishwasher. JOAN


... LG Dishwashers

Dishwasher model# FGHD2433KBI. washer was purchesed mid July, used 4 times. I just put in some dirty dish's and closed the door. A couple minutes later the washer turned on. No lights were on. After a few minutes I pushed the cancel button. Nothing happened. I opened the door and it sounded like a sucking sound and the pump stopped. No water in unit. I closed the door it started again. I cut the power at the circut box. Waited a few minutes and turned power back on. Power failure light came on.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

KitchenAid KUDI10FL dishwasher- The door spring system broke and I repaired it, but now all of the sudden the dishwasher will not start. The door may have been dropped a couple of time before the spring system was repaired, but it did not hit the floor, just a hard sudden stop. All of the cycle setting lights come on when they are pressed except for the start button. Just before the start button stopped working the dishwasher started by itself or started several hours after cycle selection had b


Hi- It is possible that the door latch is not completely engaging. If the door dropped the hinges may have bent a little thus preventing a good contact with door switch. Try pressing and holding the door shut, hard, and pressing start. If that wor ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

My dishwasher 'start" button won't kick in. The machine seems to think it isn't locked - light wont activate, but the door IS locked. I select the cycle and option, but when i push start, it won't stay, The "clean" button keeps flashing. This is 5 years old


Hi,How many Blinks are there?Is it 7 Clean Light Blinks?Let me know, so that we could proceed.Hope i helped you.Thanks for using ' Fixya ' and have a nice day!! ... Kenmore 24 in. 17032 Built-in Dishwasher

Continuous alarm after a power failure an alarm started going off in the door of the dishwasher. the push button panel is not functioning. I opened the door panel and found an electronic control circuit board. It is this board that is making the noise. I unplugged the black and white pair of wires on the lower right side of the board and the noise stopped. this must supply power to board. Anyone know what this problem is?


I posted this under "Ben's" problem as well, but I had the exact same problem. I know which black and white wires you're talking about. I don't know what causes this, but getting new parts did fix it. The black box that all those wires go into on ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

My GE Nautilus gsd2220F00BB keeps stopping. Everytime I push the door it starts but then stops right away. Any help on what the problem might be.


... GE Nautilus 24" Built-in Dishwasher

My ASKO 1805 Dishwasher started to smell weird and white smoke came from it. I turned it off, but after I turned it on again it just keeps pumping water in and out, I can't get in contact with it (None of the indicator lights are working and it is not reacting to any commands) In addition the safety feauture that is supposed to stop all operation the moment the door is opened is no longer working. (i.e. even with the door open it is still pumping water) Does it sound like an expensive repair? (


Hello,\015\012\015\012Welcome to FixYa. Based on your description ( specifically the white smoke and smell ) I would suspect the control board is faulty. \015\012\015\012If the unit does not stop when the door is open can be r ... Asko 24 in. 1805 Built-in Dishwasher

I have KitchenAid dishwasher KUDS01FLSSD. The sani-rinse butten keep flashing and not let me start the machine. Other buttens are not working. When I push the sani-rinse butten with cancel butten with door closed, it makes sound that water is drainning, but there isn't any water in it! I tried 'sani rinse' 'energy save dry' 'sani rinse' 'energy save dry.' didn't work. Sani Rinse keeps flashing. Help me!!!


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

I have a Frigidaire FBD1250REQ0 dishwasher, and the top rack keeps coming off the wheels on the right hand side. How do I fix this? Also, when we push the start button the washer does not aways start. We have to open and close the door and try again, usually several times. Is this fixable?


Hello,what this simply mean is that there has been a lost or pastier connection on the power distributor from the panel to the control unit .what you are to do to solve this problem is to unscrew the washer from the screws then trace the ... Frigidaire 24 in. FDB1250RE Built-in Dishwasher

Dishwasher keeps running I have a Bosche dishwasher and the water keeps running. As long as we run it and don't stop it, the pump will continue to drain about every 3 minutes. The water just keeps running though. If we open it to empty the dishes, the cycle will stop. But the water keeps running, filling the tub, and then overflows, flooding the kitchen and drains through our wood floors to the basement below. Our ASKO seems to have a similar problem. I started the dishwasher, and the water ke


Open up the door, get out the control unit. Pry open the unit's plastic case and look at the board. Burnt spot? If so, the heater circuit burnt out (happens a lot on Bosches) and the control is waiting for the water temp to rise, but of course it ... Bosch SHU43C05 Stainless Steel Built-in Dishwasher

DU943PWKSO DISHWASHER STOPPED WORKING, ELECTRICAL CURRENT TO PANEL...THE LOCK LIGHT COMES ON WHEN THE DOOR IS CLOSED AND LATCHED, BUT THE WASHER WON'T START WHEN ANY OF THE BUTTONS ARE PUSHED...THE LOCKED LIGHT JUST BLINKS A FEW TIMES AND THEN STAYS SOLID AGAIN. ANYTHING I CAN TRY?


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. This issue can be either due to a faulty door latch or\015\012door lock switch which is not engaging its ... Whirlpool DU943PWK - Multiple Color Built-in Dishwasher

Dishwasher starts fills up but then won't go onto the next cycle also when you go to open the door where it would normally stop the machine it keeps going


Please check the timer switch ... Zanussi 18 in. DCS12W Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2508 seconds