Having problems with your Maytag MDB7100AWB Dishwasher ?

Unit will not start lights turn on - Maytag MDB7100AWB Dishwasher


Answers :

Check the door magnetic switch or microswitch, also you can check if tha water is at the right level in your washer, check if you had close the door.
Repair Help & Product Troubleshooting for Maytag MDB7100AWB Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Unit will not start lights turn on - Maytag MDB7100AWB Dishwasher


Check the door magnetic switch or microswitch, also you can check if tha water is at the right level in your washer, check if you had close the door. ... Maytag MDB7100AWB Dishwasher

Maytag MDBtt60awb will not start. Power definitely at dishwasher as panel lights are on, however "start" button does nothing. Dishwasher is less than 2 years old. The panel buttons eventually turn off. I've cycled the power to the unit with no response. The door is definitely latched. Unit ran fine a few days ago.


Most likely you have a bad motor when replacing the motor ihave found it is cheaper to get the pump with the motor attached where as they charge you more money for just the motor or the pump seprately try allbrands appliance parts they seem to be che ... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

My Maytag dishwasher goes for long stretches when it won't turn on even though I push the proper buttons. The buttons won't light either. It turns on by itself after a couple of weeks of sitting idle. Some of the lights may blink on the start panel while the dishwasher doesn't work, but only on occasion will it fully operate. I have turned off the power and turned it back on, hoping to reset the computer part of the dishwasher. It didn't work.


The Control Touch Panels like to fail on may brands - especially Maytag. They are sensitive to humidity - and a lot have the vents out the front - right by the control panel.Please reply using "continue with this expert ... Maytag Dishwashers

Maytag mdb9150 dishwasher stopped at some point last night--found it this morning with flashing lights--I think "clean" and "heated dry", not sure.  I used "drain/off" to make sure there was mechanical noise--there was, so I don't think the machine is dead.  Purchased on 2001 with 5 year warranty, so out of luck there.  I tried turning off the electricity to the unit for a few hours; nothing improved.  When you start it (or think you have!) it makes noises for about a minute that sound promising


Check pump and solonoids click/work, if no mechanical noise, could be the circuit board, but they can be expensive. :(\015\012if the solenoids click, and allows water in, then the pump might be jammed, with grit, clean and reinstall... good luc ... Maytag 24 in. MDB9150A Built-in Dishwasher

KUDU03STSS2 The dishwasher won't start and you cannot select a cycle. Hiting cancel twice will turn a small steady light on in the time window were the spining light normally is before a cycle starts, at which time closing the door will drain the dishwasher. Tried using the reset combos: hot wash, heat dry, hot wash, heat dry - all lights came on but nothing reset. Also tried same sequence doubling the heat dry. Unpluged for ten minutes, still nothing. Can select rinse, but unit does not start,


... KitchenAid Dishwashers

Maytag MDBH965AWQ I have a Maytag dishwasher model number MDBH965AWQ. A few weeks ago the clean and sanitized lights would not go off after the door had been left open for over 30 seconds. Then last week, the diswasher would shut off in mid cycle and all lights would turn off with water still in the dishwasher. Today, I noticed that I am able to open the dishwasher door while the dishwasher is running and it will continue to run like the door was never opened. Now it is starting to trip the brea


2 items in need of testing are the door switch - and the main controller board/timer unit.CLIC ... Maytag 24 in. MDBH965AW Built-in Dishwasher

We have a Maytag built-in dishwasher Quiet Series model MDB8551AWB. When we press the Start, the lights light up, but after a few minutes all lights turn off. We've unplugged and plugged it back in. I've tried to repeat the 'start up' multiple times and sometimes it sounds like the motor is going to begin but then it pauses and stops. All lights turn off. No odd noises or grinds.


... Maytag MDB8851AWS 24 in. Built-in Dishwasher

I have a LG LD-14AW2 dishwasher, today I set it to run and came in and although the lights were still lit up the tome was not moving, I turned the unit off and waited a while then turned it back on. The power turns on and I set the type of wash but when I press start it beeps twice and won't start. Can you help, I have had nothing but trouble with this dishwasher since it was installed!


V\\:* {behavior:url(#default#VML);}\015\012o\\:* {behavior:url(#default#VML);}\015\012w\\:* {behavior:url(#default#VML);}\015\012.shape {behavior:url(#default#VML);}\015\012\015\012\015\012 \015\012 Normal\015\012 0\015\012 \015\012 \015\012 fal ... Dishwashers

Our dishwasher seems to have stopped working over night. The power button comes on and the unit beeps to acknowledge start, but then there is only a very light hum & the unit does not start. No water comes through the unit and it just hangs at the light hum. We have not turned off any water but just checking if there is a simple solution? Adam Hdw100sst


Suspect pump.on start the pump will activate to remove condense water from drying the last load.if the pump does not start then the next step of adding water to start wash cycle will not happen.ensure pump is not blocked ... Dishwashers

My Maytag MDB7609awb2 dishwasher has a glitch When I try to turn it on the heavy and light was lights go on but won't start the normal wash light won't go on at all until I keep pushing the off and on for a while, then suddenly the normal button works and start will start the machine, then is washes without any problem.


... Maytag 24 in. MDBH955AW Built-in Dishwasher

I have a 4 year old Maytag MDBH945AWW and the panel lights come on and I can select cycles... but the dishwasher wont start. I tried holding the start cancel button, tried turning the breaker off for a couple of hours, took the inner panel off the door and checked the latch, but its still wont start. Any other suggestions? If it needs a new control panel its probably better to just get a new similar dishwasher for $300, correct?


What you need to do is read for continuity and power across the door latch switch. (2 white wires) AND 2 Black wires Both wires must read continuty at the control panel connectors to the power source terminals for the unit to start. Since the co ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

For my Kudi01dl model dishwasher, the rinse light is on, but the unit will not respond to any buttons being pressed and won't turn on. When I press any buttons, two horizontal lines show in the front, but go off as soon as I let go of the button. Is there a ways to reset the unit? Everything was functioning fine the last time I used it. I use it about once a day. The problem started when I heard sounds coming from the unit, very loud motor sounds. The door was closed but I had not turned


... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

Dishwasher model# FGHD2433KBI. washer was purchesed mid July, used 4 times. I just put in some dirty dish's and closed the door. A couple minutes later the washer turned on. No lights were on. After a few minutes I pushed the cancel button. Nothing happened. I opened the door and it sounded like a sucking sound and the pump stopped. No water in unit. I closed the door it started again. I cut the power at the circut box. Waited a few minutes and turned power back on. Power failure light came on.


... Frigidaire 24 in. PLD2850 Built-in Dishwasher

I have a 1 year old maytag dishwasher and it has the touch buttons on top of the door . When you touch the buttons to turn it on, nothing happens. It will light up the type of wash you want e.g. heavy,light...., but it won't start when pressed. It will cancel when pushed, but can't get it to start. HELP!!!


... Maytag Dishwashers

I have a miele model G2470 SCVI under cabinet dishwasher it worked great until i ran out of cascade and starting using a liquid brand (Sun Light Oxi Action) we dont use the system on a regular basis so when i turned the unit on and attempted to use it , it started up filling and then sounded like it was running, the alarm tone came on with all the lights blinking a code F14 was flashing on the left side display.


... Miele Dishwashers

Start button flashes 2hr, but will not start the dishwasher, when touched. Also, lights on top of the door are not always functioning. I phoned Maytag and customer service had me turn off the circuit breaker for 5 minutes. This did not change the dishwasher. I think that the door latch is not snapping into position, when I open the door.


... Maytag 24 in. MDB7601A Free-Standing Dishwasher

Stupid dishwasher! have a maytag model MDB5100MWQ and it was working fine then poooof it the lights go on and it sprays water and thats it, the soap door doesnt open, the indicator lights turn on but nothing happens, then about 20 min later the rinse only light and clean light start blinking what the heck is going on with this damn theig thanks :) brittany


Can you tell me if it drains at all? it sounds to me with the model that it may be the drain pump indicating its clogged. When you open it up is it filled with water? sitting in there idle as in its not draining or siphoning out.let me kn ... Dishwashers

SHE4AM15UC/05 dishwasher will not start When I turn on light for regular wash lights up but will not start after I push start button. When I turned it on the rinse agent light was on, I added some and that light is no longer on but after several tries it will no start. Electricity went out yesterday but dishwasher was no on when it went out..


... Bosch SHE4AM15SS Stainless Steel 24 in. Dishwasher

I have a Kitchenaid KUDIO1DL white dishwasher which is a few years old now but has worked great since I bought it. Today it has the lean light flashing and will not turn on. there is power, and the drain button seems to work, but I can not get the cycles to come on. When I press the start button, I just get two dash lines and then the unit turns off. Thanks


... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

Maytag Dishwasher MDB6600AWB turns on by itself and will not turn off. The lights blink even with the door open and the only way to stop this is to unplug the unit


... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

Maytag dishwasher mde8600aww I just replaced dishwasher handle and switch assembly and turned power on at breaker and lights blink independantly like its in diagnostic mode. customer said it started doing this last night? I have no tech sheet or manual 4 this. Help


Hi\015\012\015\012\015\012Thanks for using FixYa. The model no# mde8600aww for your Maytag seems to be a model no# for a Dryer instead of a Dishwasher. However, from what you have described it seems it is the control pa ... Dishwashers

Maytag Quiet Series 100 series: When wash cycle starts, water gets filled in, dishwasher attempts thrice to start but then it gives up and all lights turn off.


... Dishwashers

We lost power as our dishwasher was running. When power was restored it seems to be stuck in the drain cycle. We have tried turning the unit off and back on and also holding the start button for 5 seconds.The 4 lefthand lights blink on and off and the right hand lights are steady. It is a model D1996.


Try to unplug it or turn off the circuit at the electric box.............wait ten minutes or so and plug it in and try again..................the program needs to be reset in that manner sometimes....... ... Dishwashers

Dishwasher (Model # SHU6806UC), unit is about 8 years old, very light use, less than once a month, and no previous problems. Turned on unit and after about 10 minutes, I found water on floor coming from dishwasher. Turned unit off and turned off water shut-off valve. Removed dishwasher from cabinet. Found mice had chewed a hole in water discharge hose under unit, inspected all hoses, and found another hole chewed in the 13" flex hose in the front of the unit. Also found the float chewed to alm


Hi,\015\012 Check the valve is open where the supply gets its water from the sink supply.There is a garden hose type swivel adapter after the valve, Close the valve tightly and then unscrew that hose coupling and see if the hose is full of w ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

I have a KitchenAid dishwasher, model KUDP02FR. The "normal" cycle light is flashing. When I push "cancel" or "resume/start", they start flashing as well, but the dishwasher won't start. I turned off the power and turned it back on. The "normal" light still flashes, but when I press "resume" it all starts over again. Any ideas? I can't find this in the troubleshooting guide I have. Thanks.


Hi\015\012\015\012Thanks for using FixYa. To\015\012resolve this you will have to reset the console. Do this by closing the door\015\012and press these buttons in sequence...\015\012\015\012 ... KitchenAid KUDI01TBK Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1831 seconds