Having problems with your Maytag MDB7100AWB Dishwasher ?

Upper water wand does not rotate ? maytag dishwasher How can we solve this problem?


Answers :

Remove the wand and clean it out as well as the water inlet hose that attaches to it. Make sure you have good water pressure or it will not turn.
Repair Help & Product Troubleshooting for Maytag MDB7100AWB Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Upper water wand does not rotate ? maytag dishwasher How can we solve this problem?


Remove the wand and clean it out as well as the water inlet hose that attaches to it. Make sure you have good water pressure or it will not turn. ... Maytag MDB7100AWB Dishwasher

My LG dishwasher upper rack has stopped cleaning. The uppermost arm is seemingly getting no water at all and the arm on the underside of the upper rack is getting some water, but not enough to turn it. I have already disassembled and cleaned all the way down to the diverter assembly and it has not fixed the problem. I think this is a problem with a the (?) diverter pump or perhaps a sensor that sends water to the upper arms. I am trying to figure out how to further diagnose the problems. The


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... LG LDF6810 Built-in Dishwasher

I have a Husky pressure washer with a Honda 2600psi engine. Problem is, no water will come from the pressure hose. I connected the water w/out the pressure hose and water flows thru strongly. I then connected the pressure hose w/out the wand and water flowed thru the hose fine. When I connect the wand and pull the trigger, nothing. I have replaced the wand and that was not the problem. Please help.


Check the quick disconnect to the wand these are spring operated and can get stuck ... Pressure Washers

We are getting a grit on the dishes on the top rack. We have done many things to solve the problem. Running tang crystles, runing CLR through it, taking it apart to check for blockages, checking the impeller on the pump, blowing comprssed air through it, scrubbing the inside many times. The funny thing is it only happens about every third wash cycle or so. The upper spray arm is free with no obstruction. The dishes on the bottom rack are clean. We use Electosol and jet dry. Our water is softened


Hello John\015\012\015\012Thanks for all the detail. It's far more than I usually get to start with, but please could you also answer the following quick questions:\015\012\015\012- Are the particles hard and gritty or is it f ... Asko Dishwashers

I have a craftsman 4.5hp quantum xte pressure washer 1800psi/4.5hp/2.0gpm mod 580.761800. I have to start the washer before I turn the water on and just today started with if I let go of the trigger on the wand the washer stalls. Can you advise as to what the problem is and how to solve? Thanks ****


The pressure relief valve(bypass) is most likely stuck or clogged. take the relief valve off and check for broken or jammed parts..there should be a bypass hose that goes around the pressure valve ... Briggs & Stratton Pressure Washers

Hi there, Ok, i think i'mHi there, Ok, i think i'm getting close to solving this problem. I have an LG dishwasher- Model # LDS 5811ST. I have stripped it down and clean all hoses etc. It is running fine through all the cycles. The only problem is that it has no water pressure. In other words water is pumping into the More Hi there, Ok, i think i'm getting close to solving this problem. I have an LG dishwasher- Model # LDS 5811ST. I have stripped it down and clean all hoses etc. It is running fi


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. In\015\012this case you’ll need to check the water inlet valve. Disconnect the power\015\012source to dis ... Dishwashers

No water delivered,or "spinning" of upper spray arm.Serviced @n year ago & worked very briefly. Spray arms & filter cleaned. Using a hose as water source to test.....spray arm isn't blocked. The problem appears to be water isn't being delivered to upper spray arms. What could cause this & how can I correct? Thanks for your time & response. Sincerely, Lee Ballard


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for\015\012using FixYa. If the dishwasher is not filling then it is w ... Avanti DW18 Built-in Dishwasher

Hi there, Ok, i think i'm getting close to solving this problem. I have an LG dishwasher- Model # LDS 5811ST. I have stripped it down and clean all hoses etc. It is running fine through all the cycles. The only problem is that it has no water pressure. In other words water is pumping into the dishwasher but it's like there is no pressure behind it to force it through the holes in the propellers so it's just kind of dumping water out as opposed to having any forced pressure. Hope this makes se


Water will flow out of your inlet pressure. The pump takes from your machine to spray. The same water is circulated during wash!Hence try the method I have informed you. If it is a micro controller problem you have to contact the service ... Dishwashers

Hi there, Ok, i think i'm getting close to solving this problem. I have an LG dishwasher- Model # LDS 5811ST. I have stripped it down and clean all hoses etc. It is running fine through all the cycles. The only problem is that it has no water pressure. In other words water is pumping into the dishwasher but it's like there is no pressure behind it to force it through the holes in the propellers so it's just kind of dumping water out as opposed to having any forced pressure. Hope this makes se


Try adding some more water to the machine after it has done the fill cycle do not over fill it. if there is no change in the performance the you need to replace the main wash motor.\015\012if there is achange the you need to change the fill val ... Dishwashers

I have a zr2700 pressure washer. As soon as it is started, water pumps through very forcefully. Pressing and releasing the triger on the wand does not control the water. Do I need a new wand or is there a problem with the pump


... Pressure Washers

Kitchenaid dishwasher model# KUDK031TWHO seems to allow water into bottom of dishwasher but will not shoot the water over the dishes in order to clean them. Not sure if there is a simple solution to this problem or is this problem only solved with the replacement of the pump/motor


You put the bottom basket in reverse. Turn it arround, and align the centre pipe to the pressure nozzel.\015\012Vitally ... Dishwashers

The upper rack side rail is loose where it attaches to the side wall of the dishwasher. It allows the upper rack to wobble. When the dishwasher is turned on, the force of the water pushes the rack forward so it detaches from the water supply and the arm does not rotate. The arm and connection are all clear and the arm is able to rotate, so those problems are not a factor. The wheels are in good condition. The left rail is a little loose; the right one is very loose. There must be a way t


Hello melinda.... Here is a link to searspartsdirect.com ... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

Weak water pressure particularly in the upper spinning water arm. Never a good cleaning machine again in the upper half of the dishwasher. My other kitchenaid never had this problem...


Hi,This sounds like debris got into the sump area of the pump. I have created a set of instructions on how to clean out. If you are up for it, follow the link below and let me know if it helped. ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

How do you stop the water not draining. I ran the DD603 last night and this morning found the drawer still containing the rinse water. Obviously everything was wet. I do NOT want to call out an engineer. They are hopeless and do not solve the problem, merely get the machine operational again without solving the root cause.


If the water doesn't drain from your dishwasher, check these:\015\012\015\012Drain line/air gap--A clog in this part is the usual\015\012reason that a dishwasher doesn't drain. Remove the drain line to clear\015\012any debr ... Fisher and Paykel Dishwashers

My Kenmore ultra wash dishwasher fills with a little bit of water but does not spray water and does not proceed through the wash cycle. Any advice? We had problems yesterday with blinking lights and not able to get anything to work except the drain. then we followed a sequence of pushing buttons and it solved the first problem.


The spray arm rotates based on the water pressure coming out of them. If no water pressure, then no rotation. You probably have a clog on the intake hose. You can pull out the dishwasher, tip it forward so you can get to the bottom and then rem ... Kenmore Dishwashers

Kenmore dishwasher Food particles left on dishes and inside of dishwasher. All functions appear to be working normally. Water pressure OK, drain OK, water temp OK, Etc. Operating dishwasher though a normal cycle without dishes solves the problem for one load, then back to problem. Dishwasher is about 5 yrs old and worked perfectly for 4 yrs. Any advice would be greatly appreciated. Bruce


... Kenmore 17822 Free-standing Dishwasher

Recently installed a GE Merlin RO Drinking Water System. Flow of waste concentrate through the air gap faucet down the drain is considerably faster than the purified water. Adding a booster pump did not solve the problem. Neither of the local service provider listed for my area are willing to prvide help. Any ideas on what to do next? (It's not a dishwasher but water sytems was not listed as a category) Waste water should be stronger than purified water. This system needs at least 60psi to


... Dishwashers

Water stopped pumping so ordered new pump. Upon removing the old I discovered it had a few straws twisted up into the pump. Removed and reinstalled pump and it sounds great and throws water all over with force. PROBLEM: Now there is ZERO water coming through top tube to spray arm. Pulled pump back off and noticed what seems to be a "white diverter ball" that moves a little in front of the inlet for the upper water tube. Any guidance to where the ball should be prior to installing the pump


... Kenmore 15529 Built-in Dishwasher

I also have a dishwasher (AEG Favorit), and it does not heat the water anymore. It worked fine for last 3 years, and all sudden, it only washes dishes with cold water. Could you please help to solve this problem? The hot water line is fine and I do have the hot water to the sink next to the dishwasher. Thank you in advance for your help.


... AEG 23 in. Favorit 44070IW Built-in Dishwasher

Water stopped pumping so ordered new pump. Upon removing the old I discovered it had a few straws twisted up into the pump. Removed and reinstalled pump and it sounds great and throws water all over with force. PROBLEM: Now there is ZERO water coming through top tube to spray arm. Pulled pump back off and noticed what seems to be a "white diverter ball" that moves a little in front of the inlet for the upper water tube. Any guidance to where the ball should be prior to installing the pump or i


... Kenmore 15529 Built-in Dishwasher

Model: Whirlpool ADP 4501/5 (4 years old) Problem: Dishwasher won't start wash cycle. Green light flashes 11 times. After adding a bucket of water to the dishwasher it runs normally. Checked the inlet valve and it appears to be fine. Filled the salt container and it solved the problem for a while but having the same problem again. Any suggestions would be appreciated.


... Dishwashers

I have an LG ldf7811st dishwasher. My bottom arm spins with water, my middle arm does not spin but does have water coming out, and my top arm doesn't spin or have water. I have just finished taking apart the arms, the supply to the upper arms, the filters and the impeller. I cleaned everything and nothing really seemed clogged. I have tested it since and it still has the same problem. I know that they aren't spinning because i placed them in a certain position before i ran the test run. They


I'm thinking like you're thinking, that it's something affecting the water pressure, but you've done everything in the upper section, so the problem must be from below, unless you have a leak somewhere you haven't noticed and are losing pressure beca ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

My kenmore 665 dishwasher will not pump water to the lower and upper spinner arms. The pump entry screen assy seems to have one tear in it and is dirty. However water does come out if I take off the lower arm assy. Is this a sign that the pump is bad and is not pumping enough water to move the arms or is there another problem?


The pump is probably defective (low pressure). Enough to spin the bottom but not the top. ... Kenmore Dishwashers

EDW5500DSS wont completely drain water Okay so now that my dishwasher runs, when it finishes a cycle it has a nice puddle of water at the bottom that never drains completely out. I am assuming its a relay or something because I looked for a floating switch (did not find), I can hear a pump sound as if it wants to pump the remaining water out, but, it doesn't. I really want to solve this problem soon so I can order the new door seal and needed part together. Checked the line out and of course i


The srainer over the pump could be clogged not letting the water drain quick enough. Be sure the screen is cleane out. I believe you would have already checked and cleaned this. I believe it is the impeller on the pump that pumps the water that is ei ... Dishwashers

Dishwasher, nautilus, doesn't spray water out the top arm? I'm haivng to wash dishes 2 times, and still no better results. I've tried opening the door fast during a water cycle to see which is the problem - can only figure it is the upper arm, the lower arm seems to have water coming out, can't tell if the tower raises completely up.


The jets on the arms can sometimes get blocked with food bits that have got past the filter. This reduces the water flow and rotation of the arms.The arms are easy to remove without tools (they are intended to be removed by the user). ... GE Nautilus 24" Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1525 seconds