Having problems with your Maytag MDB9600A Jetclean II Built-in Dishwasher ?

Power not coming on

\015 I bought a new maytag dishwasher 2 yrs ago. After using it a couple of times the power stopped coming on. Miracously it started working again. Now I have the same problem - the panel simply shows no lights. I have checked the power supply - it is fine and I have tried connecting to a different supply without success.\015

Answers :

When a dishwasher appears to be dead, many times the door latch is to blame. On some models, that latch has a safety interlock switch directly controls the power, so that when the door is opened during a wash cycle, power is removed.

The problem is that the interlock switch can fail or get un-aligned, so the dishwasher does not get power.

Depending on your skill level, you can investigate the problem, using a phillips screw driver to open up the latch so you can see the interlock.
Good Luck!
Repair Help & Product Troubleshooting for Maytag MDB9600A Jetclean II Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

Lg dishwasher will not come on. power circuit has power. control panel wil not come on


... LG LDF7932ST Builtin Dishwasher

My Miele G641 displays the Salt PC light even after filling it with salt. I have to cycle the main power switch 3 or 4 times before the Start light will come on. Then when I press the Start button it momentarily pumps out water and then stops. Sometimes the Start light stays on and I can get it to give the pump another brief spurt, but often the Salt/PC light comes on again and the Start light goes out. I then have to re-set the power switch. How do I tell if the logic board is fried?


Hi.This is not a PC, when logic board is fried the machine does not start at all rather than doing weird thing.The logic board is not fried, in the worst case the salt sensor is jammed. Try first pouring a couple of litres of hot wa ... Miele 24 in. Novotronic G641 Plus Built-In Dishwasher

My kenmore dishwasher has no power. No lights come on - nothing. I checked the wiring running to the machine, and it has power. Just not coming on


... Kenmore 24 in. 16032 Built-in Dishwasher

My Kenmore Diswasher (Mod # 665.17842400) has crapped out again. Towards the end of a cycle, the power seems to have been lost. There is now water in the bottom, and the user interface won't come on. 2 months ago I replaced the user interface and the magical board it connects to to solve a start button problem. I checked the power coming to the washer and it is live.


There is a thermal fuse on the control board. It protects in a overheating problem or sometimes when there are to many appliances on the same circuit that creates a high amp draw, that melts the fuse not actually blowing it like a short. Check your d ... Kenmore Dishwashers

Kenmore Ultra Wash Model 665.15801891 (Serial FJ3403697). This is in the USA. Unit will not run. Two lights are lit on the display panel and do not go off - 'Drying' and the #2 on 'Delay Hours'.rn I have turned off the power at the breaker box hoping it would reset. Once power is turned back on the Lock light comes on. I can clear that by pressing 'No Heat Dry' for 4 seconds but then the 2 lights mentioned above come on and do not go off. Any suggestions? Can you tell how old the unit is by t


Plase confirm if your model has the same front panel as the one shown in this manual.\015\012In that case try this sequence to reset the dis ... Kenmore 15899 Built-in Dishwasher

Our AEG Favorit 50620 dishwasher won't start. When I push the power button, the power light comes on, but none of the other lights. Pushing the function buttons has no effect. The door is fully closed, and it was working perfectly before. I have tried turning it off and on, unplugging it etc. Nothing works. Interestingly, if you push more than one function button at the same time, some of the function lights come on, but then when you try to start the cycle it still won't work. Help!


... AEG 24 in. Favorit 40650 Free-Standing Dishwasher

I have a Maytag MDB5601AWB dishwasher. all the switches except the heated dry switch are not working. I did the unlock thing and still nothing . Do I need to replace the switch panel or is there something I should try? I tested for power and have 120 volts coming into the circut board and through the door switch Comments: Aug 22, 2009 - I tested the door swich and I have power on both poles when it is closed. there is 2 switches on the latch but the one with power to it powers up the circ


... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

No power. Dishwasher will not come on. I checked power to power switch. It has power to switch. Is there a fuse in dishwasher, or a reset anywhere. It is a Whilrpool model.


Yeah, there is a fuse just enderneith the panel on the control board itself. It's white in color, and snaps on and off of the board. Very easy to replace. I bet that's your problem. Good luck :) ... Dishwashers

Woke up this morning and the unit acts as if it has no power. no lights, no sounds, nothing. I checked the power and it has power. I checked the wire nuts in the box with the power coming in and they are fine...it is only 1 and a half years old...Please help.


... Haier ESD311 24 in. Built-in Dishwasher

No power to washer control board. When power comes


1)check any loose connection with neutal/phase wire.\015\0122)check incoming fuse. ... Bosch Dishwashers

Power washer 1500 (reset gfci power plug ) still wont come on


... Pressure Washers

I have a Frigidaire FDB956rbc0 model. When the start/cancel button is pushed nothing happens. There is power and other buttons cause lights above what is pressed come on. Delay wash works but when it starts the washing light flashes. I have run a test on the cycles by pushing start/cancel and power dry button during power failure mode. all cycle run properly. Any thoughts?


... Frigidaire Dishwashers

Opened door and unit did not have electrical power (lights did not come on either unit). Called serviceman. He stated there was no electricity to unit(s). Called electrican. He stated wiring to the dishwasher had power. Called serviceman again. He came out and dishwasher worked. He did nothing to it. I opened the door and the lights(buttons) came on. Unit worked for a few days and this morning, there was again, no power to the unit. What is likely wrong with this dishwasher?


... Fisher DD603B / DD603W / DD603H Dishwasher

I have G1023U CS Built - Under D/washwer and red light on drain keeps coming on. All dishes are wet but the tablet has not been released. Have reset more than once and also turned power switch for over an 3 hrs. When I tried another cycle you can hear a noise as if starting then the water coming through then the drain light comes on.


... Miele G2732SCIWHWH Dishwasher

It appears to finish it's cycle, as far as the dishes are clean - however there is clean water that has pooled on the bottom. you can hear the water fresh coming in - the pump comes on for a few minutes, drains some of the water and shuts off - the pump comes on again - drains some of the water and turns off. I turned the water going into the dishwater off - the pump ran for a few minutes - drained some of the water and then just sits there with the red power light on - there is still the same


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Bosch 23 in. SHU3302UC Built-in Dishwasher

After a power outage, that occured while the dishwasher was running, the lights come on and there is a high pitched noise. Then all the lights go off and the motor sounds like it is starting. However there is no water and the heating elemant comes on. The lights on the front; china/crystal, normal wash, clean and heated dry, all come on as if the computer is confused and trying to run them all simultaneously.


Sounds like the board was fried from a power surge ... GE Tritonr XL GSD6260JCC Dishwasher

My Hotpoint diswasher suddenly stopped working last night. It seems like it has no power to it, as the motor or pump does not seem to come on at all. Obviously when I get home from work, I will check the obvious first - making sure it has power to it, connections are secure etc. (I had a wire break before) If it does have power, I would assume checking the door switch and timer is next. Any suggestions, and any suggestions for checking the door switch and timer??


Sounds like your on the right track. I would use an ohmeter to check the resistance of the door switch by placing the meter probes on each side of the switch. Test while opened and closed position. Same with timer ... Hotpoint Dishwashers

No power dishwasher stop working in middle of cycle. water still in the bottom no power,lights nothing .there is power coming from panel


Check the thermal fuse located on electronic control 2 inch square fuse problalby no continuity through it, Replacemant comes with wires attached and instructions for installation ... KitchenAid KUDR01TJ Dishwasher

After a power outage, my GE monogram dishwasher beeps continually. The controls are not responsive. I've tried turning off the power to it (by the fuse box) but the noise resumes when the power comes back on.


Unfortunately, if you lost power as a result of a lightning storm or a power surge, there is a good chance that your dishwasher was exposed to a power surge that may have damaged the control circuitry. During these types of events, there is no way of ... GE Dishwashers

FRIGIDAIRE DISHWASHER HI! MY NAME IS MARK AND I AM HAVING PROBLEMS WITH MY FRIGIDAIRE MODEL # FDB710LCB0/SERIAL # TH51153536 DISHWAHER. THE PROBLEM: IT DOES NOT COME ON AT ALL LIKE THERE IS NO POWER TO IT. I HAVE CHECKED THE BREAKER AND THE ELECTRICAL CONNECTION AND THERE ARE NO PROBLEMS AT THOSE POINTS. ALTHOUGH FOR A BRIEF MOMENT LAST NIGHT IT DID COME ON AND THERE WAS A "HUMMING NOISE AT THE DRAIN PUMP LOCATION (IT SOUNDED REALLY BAD) THEN IT SHUT DOWN AGAIN AND NOW IT WON,T COME ON AT ALL. A


Check your door switches behind console, next i would ck the circuit board for power in/out. there a tech sheet behind front panel for further diag test points ... Dishwashers

Hi experts, My Indesit IDL530 dishwasher never seems to run on any of the 5 programmes. On pressing the power button, the red light comes on and on pressing the start/reset button, the light signalling washing comes on and not the one showing water intake. But even then nothing progresses and just a buzz with that wasing indicator on shows for a second and goe off. But today only the buzzer sounds when pressing down the start/reset button and no indicator comes on atll. Will be great if you coul


... Indesit Dishwashers

Siemens SE25M851 randomly looses power. power to the unit is fine ie fuses ok and constant power. if i give the unit a bit of a jiggle it some times comes back to life. any suggestions?


It could be the lid switch. See if "jiggling" the door handle pin points the problem. The door switch normally sits behind the door handle.\015\012\015\012If so, it is either a faulty door switch, or more likely a brocken piece of plastic ... Siemens Dishwashers

Hi, the power will not come on for my GE GLC56504vww dishwasher. It shut off mid-cycle and the wall outlet is fully powered. It has not worked since.


... GE Glc5604Vww 24" Tall Tub Convertible/ Portable Dishwasher

John- power stopped -rest the GFCI STILL POWER WON'T COME ON-KARCHER K2.26M NEW -USED ABOUT 15 MINUTES WHEN THIS HAPPENED


These small power washers are tricky. Keep working with it. It may just be waiting for u to squeeze the trigger to activate. Make sure you have the water connected and turned on. ... Karcher K2.26 Electric Power Washer
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0849 seconds