Having problems with your Maytag MDB9600A Jetclean II Built-in Dishwasher ?

Water isn't coming in to my dishwater

\015 I have a maytag jetclean dishwasher it is turning on but the water\015

Answers :

The problem is most likely the water inlet valve. This is a solenoid\015\012that opens when there is power to it. It is a common problem on\015\012dishwashers and washing machines.
\015\012
\015\012They are not very expensive and are usually fairly easy to replace.
\015\012
\015\012If you need more help, post a comment.
\015\012
\015\012Thanks,
\015\012
\015\012Tim
Repair Help & Product Troubleshooting for Maytag MDB9600A Jetclean II Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

It appears to finish it's cycle, as far as the dishes are clean - however there is clean water that has pooled on the bottom. you can hear the water fresh coming in - the pump comes on for a few minutes, drains some of the water and shuts off - the pump comes on again - drains some of the water and turns off. I turned the water going into the dishwater off - the pump ran for a few minutes - drained some of the water and then just sits there with the red power light on - there is still the same


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Bosch 23 in. SHU3302UC Built-in Dishwasher

My Whirlpool Gold Series 980 dishwater no longer fills up with enough water to drive the washing arms, so the dishes do not come out clean. I cleaned the filter on the water intake valve (which was really clogged) and it still did the same thing. Replaced the inlet valve and still no change. The water does not reach the level of the overfill float switch, so that’s not it. Its been working fine for 4-5 years, what else could it be? Thank you.


I hve provided u with all details .read it carefully .it has all the resolutions for all possibilities ... Whirlpool Dishwashers

Water is coming from between door and front bottom panel by the looks of it when running, seems to be on the rinse but will have to check again . but I have wood floors and the water isnt doing it any good we have checked all over inside to see what is wrong


... Kenmore 16769 Dishwasher

Dishes come out dirty and soap scum on them. I think the rinse cycle isnt working. Hot water is good. I have a culligan water softener. Changes PPM from 600 to 400


Hi,Check your heating element.. Dishwasher ... GE Dishwashers

Frigidaire Dish Washer. no water is coming into it. Shut off valve under sink is open,float switch isnt stuck. should I shut water off and remove inlet valve?


Verify that water is getting to the valve and verify that 110 volts is getting to the valve. If either one is missing then you know what the problem is. If you have both then replace the valve. ... Dishwashers

Water in the dish washer is not getting hot, any ideas? i do have hot water coming from the sink, but none out of the dishwater, just cold.


Hello, welcome to Fixya.\015\012\015\012The problem you're describing is unfortunately a common one with B/S/H/ built dishwasher's. That includes Bosch, Thermador, Siemens, and Gaggenau.\015\012\015\012Here`s the most likely reason why it has detecte ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

Dishwater Check Water Light comes on


You can have a failing water valve., sometimes the solenoids in the water get stuck, creating a restriction ... Dishwashers

Water isn't coming in to my dishwater


The problem is most likely the water inlet valve. This is a solenoid\015\012that opens when there is power to it. It is a common problem on\015\012dishwashers and washing machines.\015\012\015\012They are not very expensive and are usua ... Maytag MDB9600A Jetclean II Built-in Dishwasher

Ok i need help i have a Hobart C44A and it is not rinsing at all could this be the final rinse solonoid valve all the machine does is alarm out cause of no rinse. I checked in side to make sure that it isnt our controler and there is no rinse water coming out of the jets. I know that the actuator is working properly to tell it when to rinse or do i have a bigger problem


... Dishwashers

Hi i hace a haier dishwasher dw12 pfe2u ive plumbed it all lights come on wen try to put wash on it just flashes and beeps. when filling my salt container up its all cum out bottom of dishwasher . dishwasher isnt filling up wiv water all pipes have been checked


... Dishwashers

Neff s4840x0gb/06 no water coming into dishwater programme stuck on interrupted


... Neff Dishwashers

Water won't come into dishwater


Make sure your brass line or braided line is hooked up with no kinks or pinches, Then make sure water to valve is turned on. ... Whirlpool 24 in. DU920PW Built-In Dishwasher

When the washer drains it comes out of the, what i thought was just the vent, on top of the sink next to the fouset knob. isnt the water supposed to drain into the existing drain for the garbage dissposal under the sink. we just bought this house with this problem. not sure of the model but figured that the drain would be the same concept.


... Kenmore 16529 Built-in Dishwasher

Belling IDW604 Error E4 coming on machine, I have drained all the water from the machine and switched it off and back on again at the wall and it still isnt working. Can you please help????????


I found the solution myself. Underneath the machine, there is a plate. \015\012On the plate, there is a float and a\015\012 microswitch, when the water leaks onto the bottom plate it raises the \015\012float and activates the microswith which shuts d ... Belling 24 in. IDW603 Built-in Dishwasher

Our 8 yr old kenmore dishwasher model 665 isnt letting water come through to start wash?


One of two things could be your problen. 1 Check where the water enters into the dishwater, It is more than likely a blue plastic water valve. This valve has a small screen in it right after the end of the water line connection to prevent pieces o ... Dishwashers

Water comes out the dishwater drain vent at the top of the sink.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is ... Dishwashers

No water is coming thru the water valve to fill the dishwasher. The water is turned on. I had a Kenmore portable dishwasher and we just converted it to a built-in. The electricity is on and the water line installed. When I turn on the dishwasher, it comes on ok but no water is coming into the machine.


Most probable cause a faulty intake solenoid. OK start simple and go from there.If your have power and light etc come on then we know you are good for power. I'll assume that is OK. If\012you are not getting any li ... Dishwashers

Hi my L G dish washer is coming up with E1 . It comes on after about 2 min it takes water into the washer then it hummes for about 30 seconds then comes up with E1 and pumps water back out. I have checked the hoses which don't appear to be leaking -I read somewhere in your answers about this problem that it could be the Water Level in Drum lowering, this means there is a leak on one of the pipes. More likely it is the Circulation Pump, which is responsible for pushing the water to the Spray


Hello aderry -\015\012\015\012\015\012I'm a bit short of time as I'm on my way out to a service call, but I've uploaded the service manual to Rapidshare for you to download. \015\012\015\012\015\012Rapidshare download inst ... LG Dishwashers

I have a Frigidaire dishwasher and there is not any water coming out of the top wash arm. There is good water pressure coming out of the lower washarm. I pulled out the dishwasher and can see the water going to the top washarm through the tube and it goes up very slowly. I took out the "check ball" below the lower washarm and it worked good. I put the "check ball" back in and ran the machine on "Upper Rack" and it still does not have any water coming out of the upper washarm. It doesn't seem lik


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Please check that there is no gunk or mold\015\012behind the filter screen and under the cover at the bottom. N ... Frigidaire PLDB998A Built-in Dishwasher

Miele dishwasher model# g868 could be 4 or u at end, customer complained water not coming into d/w ,when i got there water was coming in.for a few minutes then stopped filling ,drains fine, customer had not operated machine for a few days.i disconected the safety valve hose from under sink to see if water comes through does not when advancing cycle by hand, washes ok when water came in, thanks, Murray


... Dishwashers

Model FDB4315LFC2 Serial TH80658596 It is only 20 months old but Does not load with water. I have checked water line into white valve and water is flowing, but it does not come into the dishwasher. If I manually put water in the bottom of the dishwasher it works fine through the cycle until it is time to pump in more water. There is a sound but no water comes through the valve.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. As you have already checked the water line for clogs/obstructions and the water is flowing but wont fill ... Frigidaire Dishwashers

Display shows no water coming in but hear water coming in on side replaced intake valve but still showing no water coming display still fllashing


\015\012Hi\015\012You would need to check for air gap on the dishwasher, it may be\015\012clogged. It prevents dishwasher from draining, sometimes the drain flow is\015\012restricted due to gunk. Cleaning or bypas ... Miele G 2670 SCVi 24 in Builtin Dishwasher

I have a Dishlex Global 500 dishwasher (DX500lWW*b). Woke up the other night to find water all over my kitchen floor. The hot water hose connector to the hot water tap split (bursted). The dishwater was not in operation at the time but I can only assume when the hose bursted the dishwater came on to alert me? the code on the dishwater is displaying ''oF'' - which means Incorrect fill level of fill time. I have consequently had the hose connector repaired but the display still has the code ''oF''


I found this\015\012\015\012"Hi - answer I was given by Electrolux Help was: pull machine out from under bench onto old towel, tip GENTLY onto left hand side (your left as you face the front of the machine) after it has drained, stand up ... Dishwashers

My Whirlpool Dishwasher ADP931 has stopped working. It stopped in the middle of the cycle with 2 to 3 inches of water on the floor of the compartment. I mopped out the water and tried to restart the dishwasher. The green "on" light now comes on when I press the start button. but nothing happens (no motor comes on,no water enters).Repeating the above action several times does not help the washer to restart even though the other function lights will come on when the knob is turned. saturn1914


Hi,Whenever you see such symptoms, Time for you to investigate it properly. Check the below guide :-\015\012\015\012\015\012\015\012\015\012Power from the house\015\012\015\012Is\015\012there power getting to the dishwa ... Dishwashers

Asko D3530 water inlet fault code, water valve is on, water comes in but after water comes in for a couple of minutes we get a (inlet water fault code) check power at circulating pump no 120v unit will not run reset system it will drain and start cycle again with same result


Hello,\015\012\015\012It is common for these valves to "appear" to be ok, meaning they begin to allow water into the unit, but then one of the two coils or plungers inside fail, or are clogged with mineral deposit from the water or other ... Asko 24 in. D3530FI Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1402 seconds