Having problems with your Maytag PDB3600A Built-in Dishwasher ?

I have a leak coming from my injector. It appears that the water is coming out to fast for the injector to drain into the tub. Any ideas on how to fix it. the gasket looks good.


Answers :

Repair Help & Product Troubleshooting for Maytag PDB3600A Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a leak coming from my injector. It appears that the water is coming out to fast for the injector to drain into the tub. Any ideas on how to fix it. the gasket looks good.


... Maytag PDB3600A Built-in Dishwasher

Kenmore model#587(Frigidaire) leaks under door. New install. Had machine for a year plus before install. took off front panel- can see water squirting past lower door gasket as wash arms rotate. cause is water running down door during wash cycle piles up in the channels molded into the lower left & right side of the wash tub and pushes out the sides of the lower gasket. looks like a design issue- called SEARS, they just want to sell me a new gasket! go figure. any ideas on a fix?


It does sound like an inner door seal ,however If you get upset at Sears and complain they may help you as they say the squeaky hinge gets the oil..And with Sears the more you squeak the better your chances of results ...Good Luck ... Dishwashers

Code F2 I just replaced the door switch on an inoperable DD-602. My top drawer was working fine, but my bottom one has been offline for a while (door switch failed and I never got around to fixing it since I had the top). Well, my top finally failed too so I replaced both switches. Looks like everything is good on the top, but my bottom is erroring with an F2 code now. Kindof makes a thumping noise as it starts the cycle -- maybe 3-5 short thumps and then a 10 second delay, repeats. Any ideas? C


F2= \015\012The motor has not\015\012been sensed rotating\015\012\003 Foreign object has jammed the rotor\015\012\003 The rotor has failed\015\012\003 The hall sensor has failed\015\012\003 The electronic controller has ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

We have a Sears Ultra Wash III dishwasher, model 665.1677993, bought in October, 1995. It is not filling with enough water to get the dishes clean. I took the water valve out and looked at it and it seems okay. It doesn't look like the valve is opening all the way - just my guess. A small stream of water comes out with good pressure, but it is a small stream. I can't find any screens or filters in the water line coming in. The fill cycle lasts only about a minute. Is that adequate? Steve


There should be another letter after the p in your model number. If it's just a B then there are no parts available for that model. Typically a dishwasher will fill for 90 seconds or more. One minute or less sounds like you have a control board is ... Whirlpool GU2400XTP Built-in Dishwasher

Dishwasher I am getting a run around with getting my LG dishwasher fixed properly. We had a tech more than once come in and look at our dishwasher. It has not been fixed and never dried the dishes properly. It is now leaking and going to a "del" level when we attempt to wash the dishes. It is also leaking on our fairly new tiled floor and under our new kitchen cabinet. Your tech stated the dishwasher was not installed properly. The installation dept , Francine stated it is not their problem


Not sure what you mean by a "del" level, but as far a drying issues:\015\012\015\012LG chose to use a very energy efficient drying method which relies on the residual heat of the dishes to help dry them rather than many manufacturer ... LG LDF6810 Built-in Dishwasher

Hi, We have a Frigidaire dishwasher machine 1500 series with fully electronic control. It is a new unit, has been installed nearly 4 months ago. The other day, when I went to take the dishes out of it, I notice that the rubber gasket that seals the door had come off somehow. Along with it I saw, sitting on the bottom, two pieces that looked like part of the seal, but I didn't know where they came from. I put the rubber gasket back on, but now the pieces and now the dishwasher will leak when runn


... Frigidaire Dishwashers

I have a Maytag MDB7600AWB dish washer. I have a door leak, dripping from the right side. I can not see anything that would allow it. It seems like it could be coming from the inside of the door. Also, there is heat and condensation on at the top of the door, above the leak. It could be that steam is coming from the top right and dripping down the door. Could you give me some idea about fixing the problem.


HI,Check for the following troubleshooting steps:Some leaking around-under-from the door on dishwashers can be traced back to a split in the spray arm. If the lower spray arm develops a split in it, the spray arm can turn too ... Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher

I have a bosch shv99a13uc dishwasher i need a manual I am not sure how well it works my understanding is the water dosent come up to pressure i am assuming a good clean out will be a good start, so am looking for pump removal instructions or advice :)


... Dishwashers

Model WDB212RBMO (1994) is leaking where the water comes into a plastic piece on the side. It connects through to the inside.The piece is molded to the unit and has a hole in the side that looks like it was designed that way. No idea why. But this is where the water comes out while it's filling the tub.


... Westinghouse Dishwashers

I NEED HELP CLEANING OUT MY FILTER ON MY HOTPOINT DISHWASHER..... WHEN WE GO TO RUN IT THE WATER STAY'S IN THE BOTTOM AND WILL NOT DRAIN OUT SO PLEASE HELP ME FIX MY PROBLEM CUZ I CANNOT AFFORD RIGHT NOW SOMEONE COMING OUT TO LOOK AT IT SO IF I CAN FIX IT MYSELF THAT WOULD BE GREAT AND WITH YOUR ALL'S HELP IF YOU WILL THANKS ALICIA


I f you have warranty on this please call them, you have a defective\015\012D/W.Unless there is no charge for repairs ,don't spend a dollar on what\015\012is going to be a on going problem ahead.To explain how to fix this is\015\012what the manufactu ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have got a problem with my circuit board on my homark dw45bi any ideas where i can get a new one or fix the old one there is power going into 1 side and coming out of it but not going into the other side any ideas???


... Dishwashers

8hp honda engine on log splitter. costantly stalls as governor opens throttle to maintain rpm. engine starts to stumble then stalls. When revved with throttle acts similar. somewhat better when hot, somewhat better at half choke. have pulled carb and checked bowl, float, pulled main jet checked, blew carb out but no better. No dirt or gum in carb, looked new. all gaskets looked good. engine has low hours.


... Honda 8 HP Engine

Bosch Dishwasher Cycles will not stop running. They keep starting over. Help please!! Our 2 year old dishwasher will not stop running. It gets to the end of the cycle and starts over again. Plus, the cycles seem to have gotten longer. We called the Bosch repair number and they want $150 in cash to come out and look at it. Then they will come out and fix it!!!! Unbelievable!!!


Carry out a reset.\015\012This should reset the board back to factory settings,\015\012Deep Diver ... Bosch 24 in. SHU5305UC Built-in Dishwasher

Water flow I have had my dishwasher off for over a year because of a leaking shutoff valve(nobody wanted to fix it) .My son finally fixed it, and i ran a clean cycle before washing actual dishes. Everythign worked fine until I realized it was leaking all over the floor. I looked in and the water was not stopping coming in after it finished.


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012chkq356 ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

My whirlpool adp4601 isn't cleaning properly! The full cycle looks and sounds complete, but looks as if the 'blades' aren't turning as items on the outside of trays are coming out dirty. Any ideas??


... Dishwashers

My accusense light keeps coming on and blinks continuously. I tried the heat-dry, normal sequence and it would reset to 2 minutes. After the 2 minutes cycle, the accusensor blinking would begin again. Then I tried holding the heat-dry button in for 5-seconds. This looked like it worked so we set a normal cycle without heat-dry. Äll looked good, but a few minutes in, the normal light was off, the accusensor was blinking again and the heated-dry was on again! Is the unit possessed? Other id


... Whirlpool GU2400XTP Built-in Dishwasher

Have k3.99 electric. have water flowing through coming out nozzle but has no pressure. Powwer is there. Have no idea where to look or what needs to happen ?


... Karcher K2.26 Electric Power Washer

There is soap left at the end of a cycle from the dispenser. It is trailing down the door and standing in a puddle at the bottom of the dishwasher. The soap that is not in the trap door seems to wash away, but not the soap that comes out once the trap door pops for the main wash. Any ideas on how to fix this or what could be causing the problem?


Try different detergent types--liquid instead of powder, capsules instead of liquid. Don't put large dishes near the door that might block spray. Check the spray holes in the spray arms for blocking. ... GE 25 in. Nautilus GSC3400J Free-standing Dishwasher

My wife opened door during cycle. When she closed door it would no longer run. Looking at problems and recomendations on similar models, I replaced the board. Did not fix the problem. I have checked the fuse and the door switches for continuity and all seem ok. The only lights on the panel that come on are: under cycle- Pots & Pans, Light. Under Options - Heated dry. No other lights work and the dishwasher does not operate.


Hi,\015\012\015\012First off, sorry to hear that you replaced the control board for nothing..in hindsight. So if I understand what you're saying is this, You cannot select any cycles and the unit won't start...because the start button is ... Dishwashers

Asko 1375 unit will not wash drains and fills ok  motor at back of unit runs well. Suspect impeller   Does motor have to come off for impeller replacement?? My 1375 is leaking a bit, looks like the seal which was mentioned in the impeller repair case,may be the problem? The other problem I noted was a clogged screen at the bottom of the dishwasher which is on the suction side of the pump, the screen had calcium buildup etc. I cleaned it off with vinigar and reran the dishwasher seemed ot fix th


Do you mean to say that the washer does not go into the wash cycle at all, or washes poorly?An answer to both can be found HERE.This article ... Asko 1375 Dishwasher

My Kitchenaid KUDS01FLSS3 dishwasher is making an unusually loud whirring noise when it is in the wash mode. I am fairly mechanically adept, I like to get some ideas on what to look at so I can fix it and quiet it down.


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Dishlex 450 Hello, I have a dishlex global 450 and on the screen panel it is flashing NF do you have any idea on how to fix this problem. I understand this means no fill, the water is coming into the side of the dishwasher but not actually entering. Regards Helpless lady!!! Who is sick of washing dishes!


Hello,I had this problem and reset the dishwasher to solve. Turn off dishwasher for at least 20 seconds, turn on while pressing eco button and wait for about 30 seconds. Should hear beeps. ... Frigidaire 24 in. FDB126RB Built-in Dishwasher

Kenmore 16359 this ca12. i saw your solution and thanks but i have a question before i change the console. the machine was working fine and we went on vacation and when we came back that is when the light was blinking. could that have caused it or does the consoles just go out? i would like to know so when i repair it i don't break it again. i looked at the possibile fixes prior found the console but not clear if the circuit board comes with because the circuit board in no longer availible. is i


'Membrane buttons' as they are so called, just go bad. The circuit board is not part of the switches. circuit board not available? Chances are this part has a substitution that is available. Many models of this type have consolidated to 1 or 2 standa ... Kenmore 24 in. 16539 Built-in Dishwasher

HI THERE WE HAVE UST BOUGHT A SECOND HAND LG DISHWASHER AND IT DIDN'T COME WITH A TOP OR LID AND IT DOESN'T LOOK GOOD. WE WERE WONDERING IF WE COULD PURCHASE EITHER A SECOND HAND ONE OR NEW ON? THANKS HOPE YOU CAM HELP US. SYLVIA


Sylvia I am just guessing but I believe this is an under counter dishwasher and if that's the case it does not have a top you will have to mount it under the counter top ... Dishwashers

Dishes come out cloudy especially the glasses. Small amount of water remains in unit at end of cycle (which we drain each time before commencing cycle). We have had repair person here twice to clean unit and look over and he cannot seem to fix the problem.


The problem is from hard water. there is a new product out just for this problem. its called the dishwasher filtration system. it filters the hard minerals out of your water before they enter the dishwasher. it has a money back guarantee and works am ... Kenmore Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0885 seconds