Having problems with your McCulloch FH160G Pressure Washer ?

Same thing>connector broke between inlet hose and body of pump

\015 Obviously made of cheap plastic material, and the earlier solution to same problem yielded only dealer locations....unable to order parts from McCullockpower.com\015

Answers :

Junk it.
Repair Help & Product Troubleshooting for McCulloch FH160G Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Same thing>connector broke between inlet hose and body of pump


Junk it. ... McCulloch FH160G Pressure Washer

GE Dishwasher model PDW8200J03BB stopped draining. Removed the drain pump, checked with Voltmeter and there is resistance on ohms X10 of about 3. The flap is in place so water isn't shooting back into the sump inlet. Replaced the sump inlet about 6 months ago because it was deteriorated due to hard water. Pump worked fine after that. Checked drain hoses and air gap. Was able to blow water through. Pump only trickles water out at air gap. Does the pump need replaced?


Clear the line from the air gap to the drain,, if the rest is clear the only thing it can be is the propellers on the pump, i which case you will need to change the pump ... GE 25 in. Profile PDW8200J Built-in Dishwasher

No pressure, the inlet filter is clean, all hoses and connections are tight, oil levels are correct, hose size to pump is correct with no kinks. Has the pump gone?


In this case it sounds as though either your unloader valve has failed, the water seals have failed or the check valves in the pump need replaced. Unfortunately there are no tests that can be done on this unit to verify which component has failed bec ... Karcher 4000 PSI 36 GPM Gas Pressure Washer G 4000 OH

Vulcan Dishlex Executive 14-10 Dishwasher leaking onto floor from right hand side when it was filling at start of cycle. Husband has checked the following: both pumps (main and waste) hoses, solenoid switch (inlet). Where can we find the float/level valve? Could this be the problem? What else to check? This is the second time it's happened - I don't use it that much. The previous time my husband replaced the inlet and outlet hoses. What is the proper level for water fill - never above the


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If you have water leaks around the base of your dishwasher,\015\012you may be using a detergent that is ... Dishwashers

I have a Coleman pressure washer model PWO952750. The connection to the pump for the hose sprayer broke off at the pump. Looking at a parts list I believe I need a Manifold kid. Am I correct ?


... Coleman Pressure Washers

DD601ver2 Top draw wont drain properly.Leaves about 2 inchs of water(clean). Occaisionally u3 code shows.Have tried eveything i can think of. HP is correct Drain hose and filter to pump are both clear. No blockages. Have swapped motors from bottom to top and makes no difference. Have swapped inlet hoses around and no difference. Have run diagnostic and when in drain mode P2 it drains very slowly - takes 1 minute 42 seconds to drain 2 litres of water. Bottom draw takes just 30 seconds to do the s


Check for restriction in sump. ie remove rotor, push pipe cleaner or similar from filter sump into rotor sump ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My Miele Dishwasher (Excella Series G 2630 SCi) fails to fill. I get the message "Water inlet - Open the stopcock". I checked the water inlet filter and looked for hose kinks to no avail. I even checked the non-return valve. When I start the dishwasher I can hear a low hum (Not the pump) for a few second before the error message displays.


... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

Water leaks from underneath the unit. Water only leaks when the pump cuts on (pressurizes). It leaks down on to the hose connecting to the water inlet valve on the right hand side of the unit when looking at the door of the unit. When the unit is full of water and the motor / pump is not running the unit does not leak. This unit is a Maytag jetclean dishwasher Model DWU9200BAB about 12 years old


Please change the 'o'rings of drain line and the inlet and also check the drain hose and the inlet if there are any holes in it ... Dishwashers

ASKO D3432 At start up, drain pump works fine to remove water. Inlet valve kicks in and it fills with water, then it shuts off and gives a fault message. "Water Inlet Fault". There are no "kinks" in the water hose and I can see water fill the side "reservoir".


... Asko 24 in. D3432XL Dishwasher

Dd601 ver2 Top draw wont drain properly.Leaves about 2 inchs of water(clean). Occaisionally u3 code shows.Have tried eveything i can think of. HP is correct Drain hose and filter to pump are both clear. No blockages. Have swapped motors from bottom to top and makes no difference. Have swapped inlet hoses around and no difference. Have run diagnostic and when in drain mode P2 it drains very slowly - takes 1 minute 42 seconds to drain 2 litres of water. Bottom draw takes just 30 seconds to do the


I had the problem with the top draw not draining properly and the dishwasher showing the U3 fault code on my DD601 v.1, I did'nt have a copy of the dishwasher manual so it took the following steps, this is best done out side to save on messing your k ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Lg dishwasher model LD-2163SH problem code IE meaning water is not supplied. I have checked that the valve is open and water line has sufficient pressure. Inlet hose is also not kinked and pump for drain is functioning normal. Pl suggest solution urgently? manoj


... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

Parts Where can I get replacement parts for McCulloch 1600 psi jet washer? The adapter at the bottom going from the hose to the body is broke.


Go to McCullochpower.com and under power equipt click on pressure washer follow the links till you get to page about ordering parts and you will need your exact model number but the parts can be ordered online or there is a link to find a dealer near ... McCulloch FH160G Pressure Washer

HELLO. my siemens dishwasher SE50T590EU/01 is not runing,it starts and makes a noise like its draining that lasts for 5sec and pump is working for about 1 min than stops.i have cleand the filter inside the tub and also cheked the filter on inlet hose with the two solinoids any advice??? thanks.


... Siemens 24 in. SE55A560 Built-in Dishwasher

I have a whirlpool gold model GU1500 diswasher. When the rinse cycle ends the water pumps out into the garbage disposal like it should, but then water backs-up from somewhere into the bottom of the dishwasher. The overfill protection drain seems OK...the water doesn't overflow. It doesn't have a air gap on the sink. The drain hose goes directly from the dishwasher to the inlet on the garbage disposal. It appears to be properly installed per the installation instructions. The washer is about 4 ye


Seems you answered your own question here. You need to make an air gap in the drain hose - take as much slack as possible and make a curve (upside down U) under you sink as high as you can go. Make sure you clip ot to back of the cabinet to stabili ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

Getting error code 1E I've replaced the sump pump, cleaned the screen at the water inlet, checked water flow from the hose. Continue to get the 1E once water has entered dishwasher and begins the wash cycle.


... LG 24 in. LDS 5811 Built-in Dishwasher

Hello, I just installed a GE profile dishwasher (pwd9280n00ss) into my kitchen. I connected a hose to the valve water inlet, I connected the drain tube from my garbage disposal to the check valve flapper and then the the drain pump asm. When the dishwasher finishes washing the dishes, all the water doesnt drain out. Any ideas how I can correct this?


... GE Dishwashers

Shu9925uc/14 bosch dishwasher leaves standing water in the bottom of the pump. The pump seems to be bad because it wont drain out the back hose. I have run the diswasher full cycle and put the drain hose into the sink to test. It wont drain at all now and I dont hear the pump. Perhaps unrelated: Pump seemed to stop working after the back hose disconnected itself from the back of the unit spilling water all over the floor. When I reconnected the unit to the wall the pump now seems to be disfunct


Hi Dishwasher not draining issue occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dish ... Bosch SHU9925UC Built-in Dishwasher

I have a CDA WC140 Integrated Dishwasher. Does anyone know the best way to access the drain pump and hose for inspection and possible pump replacement.


... Dishwashers

Does the LG Ld1452WFEN2 dishwasher need a pressure reducer on the inlet hose or is it incorporated in the hose


... LG 24 in. LDS 5811 Built-in Dishwasher

Cat pump 3200 psi problem- plz help! I hook up the hose and no water will come out of the pump out let with or with out the hose the pressure waser hose hooked up!


... Caterpillar Cat Pump Pressure Washer Pump 3SP30G11

I have a Comet BXD 2525 G pressure washer pump which is giving me some problem. (Maybe) I hook the water up to pump and the pressure hose up to the pump, turn on the water and the water sprays out of the water connection at the pump. I check the hose to see if it was clog ok and the next was a the water connection ok. It's like the water is not going int the pump. When i start the pressure up the water come out of gun but no pump running like it should. The next thing i was going to look at i


The water inlet needs a gasket like all hose connections. If its gone the pump may be starving for water. ... Comet Pressure Washers

Attempting to install asko d1706 dishwasher. Bought used, had no hoses with it. when trying to connect water inlet hose, unable to connect without leaking. Finally got a connection on there that has it slowed down to a drip. does the inlet valve need to be replaced or is there a special inlet hose that we don't have?


Yes there are actual dishwasher supply hoses you can purchase at most hardware stores.... if you do have the correct hose may try to put some teflon tape on connection so that leak stops....\012good luck to you ... Asko Dishwashers

Had the Northstar 3000 psi Pressure Washer for 2 months and it started leaking oil from the pump during use. Took it to Northern and they are replacing the pump under warranty but said it was likely because I was using quick connects on my garden hose coupling and that was restricting the water flow making the pump overheat. They said never to use quick connects on the garden hose unless the opening is at least 5/8". Does anyone make such a quick connect? I hate having to screw the garden hose o


It is easy to check if your hose and quick connects are supplying enough water to the pump. Your pressure washer gallon per minuite requirements are printed on the machine and also on the pressure tips in GPM. Your post indicates 2.5 gpm but check yo ... Northstar Pressure Washer 3000 PSI

I just had a Haus slimline dishwasher delivered and have tried to set it up. I have followed the instructions to the letter but the water inlet hose keeps leaking out water when you move the dishwasher into place after attaching the hoses. I have tried the manufacturer's hose they provided and two spare i have in my cupboard. I even went out and bought some 3/4" washers and added extra washers to the inlet hose, but it still leaks. What is wrong?


It is possible the dishwasher inlet is set for low water pressure.\015\012\015\012Check the water pressure setting matches your inlet water pressure.\015\012It might help if you provide the model number of the dishwasher. ... Dishwashers

My hobart lxi pumps down after each wash cycle Already Tried: Cleaned all three water level probes Checked water inlet solenoid (all good) Checked inlet water pressure (all good) Checked drain pump which is supposed to pump out 3/4 of a gallon at the end of each wash cycle but it pumps 2-1/3 gallons then pops up the infamous wrench!


... Hobart 24 in. LXIH-3 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0928 seconds