Having problems with your McCulloch FH180A Electric Pressure Washer ?

I need a 7022-140a02 power switch for a McCullouh high pressure washer FH180B. Every were I have tried to order, I am told the part is not available anymore. This is a maintenance part in the McCullouh parts manual. I thought parts were available for 10 years, they are still selling this pressure washer;


Answers :

I need a 7022-140a02 power switch for a McCullouh high pressure washer FH180B.
Repair Help & Product Troubleshooting for McCulloch FH180A Electric Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I need a 7022-140a02 power switch for a McCullouh high pressure washer FH180B. Every were I have tried to order, I am told the part is not available anymore. This is a maintenance part in the McCullouh parts manual. I thought parts were available for 10 years, they are still selling this pressure washer;


I need a 7022-140a02 power switch for a McCullouh high pressure washer FH180B. ... McCulloch FH180A Electric Pressure Washer

We are looking for the following part model number : LD2040WH, for an LG Dishwasher purchased in South Africa. Part number - 4681ED1003C. This part is not available in the UK, however would you be able to assist us with a website, which might have this part?


Http://www.repairclinic.com/SmartSearch/smartsearch.aspx ... LG Dishwashers

Hi I have a maytag dishwasher and a maytag fridge my fridge has been nothing but problems it has flooded my house twice in the past 9 years, the part on the inside are braking that hold the shelves in place and my dishwasher is on a recall that i just found out today. IT has a part called vent inlet that is cracked and the part is no longer available,so is part can i use it with out it in and I need to have a repair person in to fix what ever the problem is that has caused house fires I have no


... Kitchen and Much More Dishwashers

Where would I find availability of parts in QLD Australia to suit a pressure cleaner 3200 psi coupled to a Briggs & Stratton motor pressure washer number 020225-0 part required chemical injection kit FIG E on general assembly part number 192914GS


Wayne, Any Pressure Washer dealer should be able to sell you what is called a "Down Stream Injector". What you need to know is the flow rate. Like, at low pressure, see how many Gallons/Liters Per Minute actually comes out the wand. That i ... Briggs & Stratton Pressure Washers

I have a pressure washer which ran out of oil in the drive section and damage the bearings and swash plate there seem to be no parts available can these parts be sourced.


If the manufatgurer doesnt have them, you may be out of luck.\015\012\015\012If you ran it without oil ... you are pretty much stuck. On the other hand ... You could build yourself a go cart. ... Pressure Washers

The door would not shut. We checked all around and nothing was blocking the door from shutting. We determined the latch on the door was not releasing. I forced the door shut. The touchpad works...lights come on but unit will not operate. The release handle on the front just wiggles back and forth without effect. Lowes says it is one of three parts...none returnable. Any thoughts on what part and whether this is something average consumer can self fix? Thanks.


Hi,\015\012 Lowes is right regarding the parts needed.\015\012\015\012First check the strike part is ok - that's on the body of the machine not the door.\015\012\015\012Unplug the machine.\015\012\015\012Remo ... Whirlpool DU1055XTS Built-in Dishwasher

Hello, we have a Frigidaire dishwasher Model# FDB1250REC2. There was all kinds of junk down in the lower filter area and when I tried to remove the parts they all came out together and then fell apart. I need to see how the parts go back together, because I thought I had them in there correctly, but when I opened up the dishwasher after running it the water sprayer was laying on the heating element. Could you please help me get it back together right? Thank you


I am having the same problem...were you able to fix it? ... Frigidaire Dishwashers

Got a Frigidaire model FDB750RCS0. Now it was running for a couple of min then I hear a clicking sound. Thought it might be something hitting the propeller. I opened the door and nothing. Closed it and now it wont even work. Thought the breaker got tripped but not even that. Now when I had it set back to the cancel part, the Clean Light comes on very dim where as before it use to be bright. Any solutions?


... Frigidaire 24 in. FDB750RC Slim-Line Built-In Dishwasher

I just bought a used Kenmore portable dishwasher with Model #587 1749581. I'd like to find an owner's manual and parts list for this...in particular the hose adapters to fit onto a kitchen faucet. Can't seem to find such. Do you know how old this dishwasher is and if parts are available?


You should be able to go to the Kenmore web sit and down load a manual. If there is a manual you can get it on line. Try google put the model number right in the search. ... Dishwashers

I need a part for the upper rack, are individual parts available?


Hi,\012That is not that hard to fix and you can easily buy the parts yourself online...Here is a tip that will help you with the online buying...How to Buy ... Samsung DMR78AHS Builtin Dishwasher

I am trying to locate an upper rack for an old KitchenAid dishwasher, Model KDS21, I thought I had found it with part number PS402141 which I found on Partselect.com, but they said it was discontinued. My next try was with repairclinic.com and they also said it was discontinued and suggested part number 9741982, That is how I found you.


... Maytag MDB3100 Dishwasher

I am looking for a replacement for a Maytag dishwasher, model WU 484 timer. The part number is 902476. The part is no longer available, according to the Maytag website. Do you have any suggestions?


Check out the ReAR COUNTER web site , also the wreckers . ... Maytag Dishwasher Accessories

KENMORE MODEL # 363.16222100 Hello - my dishwasher (model# above) is currently filled with H20 and will not drain/work. When the knob to select the dishwasher cycle to begin is turned, it just 'clicks' and does not engage the washing cycle. When I tried to just let it run the cycle as is to 'restart', it had an electrical odor to it., Currently the knob is at the 'Rinse & Hold-(Heated Dry Off)' part of the cycle and all dishes have been removed. I would appreciate any assistance available. Thank


Either the motor is locked up or the control failed. You will need a service visit. If it is over 10 years old, I would buy new. ... Dishwashers

Will not go on ...all cycle lights light up put start will not activate. have unplugged to reset...to no avail...motor part was replaced 11/11/08 . machine is only 2 years old and only used in summer months about 2 times a week. what a disappointemnt!!


It is possible that the control panel might be bad. Remove the inner panel on the dishwasher. Then inspect the ribbon connector and make sure it is fully seated into the the panel and control board. Carefully inspect the ribbon connector for any shor ... Frigidaire 24 in. PLD3465REC Stainless Steel Built-in Dishwasher

Cannot find manual for conia dishwasher wqp12-9213 in order to check for correct maintenance of parts


R u in australia. conia went bust about 1 year ago. if u r in australia please reply back and i will try to help u. ... Dishwashers

GE GHDA485N 10CS Dishwasher that has standing water in the bottom after the cycle completes. I pulled it out and reconnected power and ran a rinse cycle. I could see that water was pumping out the clear drain pipe but there was still about an inch of standing water in the bottom. Any thoughts as to what part has failed. Does the system use a water level switch or a timed drain cycle to determine when the water has pumped out. If it is a timed cycle could a slow drain cause the problem. Thank you


... GE Dishwashers

I have an indesit Dw9S dishwasher. Water is leaking from the base of the unit. It seems to be a problem with the seal and plastic ring inside the base of the filter holder inside the dishwasher. Can you please advise if this seal is available as a spare part and if it is a difficult task to fit. Thank you for your assistance Graham Neilands


... Dishwashers

Water leak have the Ge triton dishwasher (Model # GSD5320D02BB, bought it n 2001) and currently have very small amount of water leaking out of the door during a run cycle. I did check levels when running and that seems to be fine......meaning the dishwasher is level and not an over-flow problem. My next thought is maybe it is a faulty door gasket. So my question is, where is the door gasket located and how do I replace it? (and where do I order this part from?). Looked for diagrams to follow and


They are in the bottom left and right of the door opening. GE likes to use L-shaped, molded and ribbed seals on most of their models - hopefully also on yours. Typically these can be removed by hand and easily replaced without taking anything apart. ... GE Tritonr XL GSD6260JCC Dishwasher

We have a +11 year old Bosch SHU3006/UC/U06 that never leaves the wash cycle. We had to stop it during our last test run at 3 hours. Chat advise is suggesting a water temperature problem (I origionall thought the timer), suggesting that the cycle will not advance until it hits a set temperature (170 degrees). We checked and noticed that the water in the machine was only around 90 degrees during a wash cycle. We do not have exploded views or parts drawings, nor electrical schematics. I wou


Check continuity of the heating element to see if it is broken/open.\015\012\015\012The dishwasher prefers that the incoming water (water heater) be 120 degrees (F) ... Bosch SHU3036UC Dishwasher

LG Model LD-14AW2 - loud bang and door dropped open as if a door hinge or spring snapped. Are both sides of door normally supported. Are parts available to repair. Where do I get a manual. Colin


Hello- Parts are available locally at app. parts store. Need complete model #. Usually have to pull out unit to install. Replace both sides. There will be a spring, sometimes with a cord to pull door up. Either part can break, so get both. Not easy, ... LG Dishwashers

Looking for info on our churches dishwasher - Toledo Kitchen Machines. Model # TDA27. I can describe it as a single cycle dishwasher. Wondering what type of detergent to use and if there is a manual available. There is a small seal leak between the motor and the pump, other than that everything works. ( this has not been used in 10+ years).I am now in charge of bldg maintenance and am trying to get everything in working order. Any help is appreciated. I am guessing the circa is mid to late 60's


Dishwasher Repair Guide: How To Fix a Dishwasher - ACME HOW TO.com\015\012\015\012\015\012\015\012 ... Dishwashers

I have a leaky gate valve shaft seal that I want to replace myself (part # WD8X181). It only leaks when in the drain cycle. Repair manuals are not available for this model. How much disassembly is involved to replace this seal? Do I need to gain access to the shaft from inside the housing pump assembly (drain sump)?


... GE Dishwashers

Myy kitchenaid dishwasher model kudi01flss doesn't start even though the lights on the panel light up so I opened up the door to look at the latch and found a broken plastic piece that appears to be part of the latch. Could this be why the machine doesn't start. The funny this is the door still seems to snap closed even with this broken piece but what I'm thinking is that this piece activates some sort of electrical connection that turns the machine on when the door is closed. Any thoughts on th


... KitchenAid KUDC25CH Dishwasher

There are two hoses coming from my Bosch SHE45M06UC dishwasher. One is obviously the drain coming from the back of the unit, and the other is attached to the side looped and not connected to anything. I went online to the Bosch website for a installation manual and it describes this hose as a air venting hose. Does the end attach anywhere or does it just hang loose on the unit. My husband detached it from its original position and thought it was part of the water line. HELP!


Many people realize the dishwasher connects to a little hose on the sink, it is called an air gap. However, many people wonder " The air gap is there to prevent the water from being siphoned out of the dishwasher. When water flows through the drain ... Bosch Dishwashers

Telmann Dishwasher TEL 12DWM. Dishwasher started to make weird wooshing start-stopping sounds at the beginning of the wash cycle so I stopped it. Since then the lights are on but wont go regardless of where the switch is set to. Have pulled the pump off and the inlet pipes and blown to remove any blockage but still no luck. Cant get into the water jet part due to connectors that require specfic tools to remove and replace. Any thoughts?? thanks in advance, Michael


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0638 seconds