Having problems with your Meiko FV 40.2 Dishwasher ?

Some of our glassware has been cracking. We are wondering if it has anything to do with the water temp. Four of our Meiko machines (all are FV 40.2G) range from 183-187 degrees, is this typical and ok or is it too high?


Answers :

Repair Help & Product Troubleshooting for Meiko FV 40.2 Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dead spot? We just moved into a house and the built-in frigidaire oven, model no: CFEB27S2AS1 bakes on only the low heats, 0 - 250 and high heats, 450 - max but does not heat (red indicater light not come on nor any heat) at mid-range. Is there something I am not doing, or does it need to be "rebooted", and if so how do I get to the power plug/switch as it is embedded in the wall?


Hello\015\012\015\012You said, We just moved into a house and the built-in frigidaire oven, model no:\015\012CFEB27S2AS1 bakes on only the low heats, 0 - 250 and high heats, 450 -\015\012max but does not heat (red indicator light not come ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Some of our glassware has been cracking. We are wondering if it has anything to do with the water temp. Four of our Meiko machines (all are FV 40.2G) range from 183-187 degrees, is this typical and ok or is it too high?


... Meiko FV 40.2 Dishwasher

Miele dishwasher optima G 2420. during instalation and test for water hardness display shows 'P' then '1' then '0'. is this a water hardness of '1' or of '10'


... Miele Optima G2470SCSF Dishwasher

I have a Kenmore elite ultrawash HE dishwasher Model 665.13129K700 , serial # FU3801153 , Stock # 13129K , Type 586-0. My normal wash red light flashed constantly and will not allow me to reset the control panel. I disconnect power for 1 hour then it allowed me to run 1 cycle. Upon completion the normal wash red light started flashing again. I tried to toggle between high temp wash and heated dry but no other button will work since normal wash is flashing. I again disconnected power but this tim


Hi,Push push thishi temp wash / heated dry hi temp wash / heated dry hi temp wash / heated dryIf this does not reset the control then you will need to replace the control board.Let me know,if needed fur ... Dishwashers

Hi, Our Miele G611SC plus is making a high pitched noise for about 1 minute when (I think) it is on the rinse cycle. When it then changes to the next cycle, the high pitched noise stops. We got the unit new about 4 years ago. Thanks, Berni


Hey Berni,\012\012I've been having the same problem for quite sometime with my Touchtronic G 892 SC. It goes away if I open up the cabinet under the sink and wiggle the water inlet hose where it's connected to the dishwasher's "backflow" water ... Miele 18 in. G611SC Plus Slim-Line Free-Standing Dishwasher

Replaced control board 447325 in bosch SHU66C05UC/23; FD860300407. What code to select 0,1,2,3,4?


... Dishwashers

How do I fix a pressure washer that will not build up pressure quickly and when it does reach high pressure, the pressure quickly drops to a lower pressure (more typical of the pressure found in a garden hose)


It can be the inlet filter where your garden hose connects is clogged, so check that first. Also make sure that the hose is connected tightly and not pulling in air both at the inlet and outlet. Remove the spay nozzle and use a pin to make sure it is ... Karcher G3025OH Pressure Washer

I am having issues with my dishwasher where it appears to be working but does not clean. Hot water does enter the unit and drains properly but is not cleaning. Muck is still on the door, the arms are wet. Also, normal cycle with no extra features selected (i.e. High Heat, etc.) takes over 1 hour and 20 minutes. Sounds appear to be normal, draining, filling, etc. Thanks!


No\015\012 you need not wash the dishes but just cleaning of the debris and then \015\012putting it in the dishwasher for proper cleaning will help you to \015\012prevent the drain from getting blocked.\015\012\015\012 ... Dishwashers

On new maytag dishwashers what is the range of height adjustment? They are all listed at 34 1/2" high but there must be some adjustment plus or minus!


Hi, W/D here.They all have adjustable feet that can adjust the height up by about 2", or so. Check your manual.The rear feet have a linkage to the front of the machine.Best regards, --W/D-- ... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

I have a model FDB2310LCC2 dishwasher and it won't turn on. The column cycle lights washing cleaning drying and sanitizing are all blinking simultaneously along with the "high temp wash" light. I de-energized the circuit breaker for approx. 1 minute then re-energized and no difference is noted. Any ideas?


This may be a problem with the door interlock switches. You will need to shut off power to the dishwasher, unscrew the control panel and remove the wires to the door switch ( make note of where the wires go on the switches) and check the switches wit ... Dishwashers

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

Bosch dishwasher SGS45EO2GB/45 does not complete washing cycle. It stays at 1 min left with pump running. I have reset the machine twice at which stage the pump empties the machine and the display shows 0 mins. However, have tried it agin and same problem. Any ideas, please?


... Dishwashers

DHB standup dishwashing machine, temp and high temp over heating,not working in proper temp range. only happens in the morning when after fist fill, will continue to overheat for about a half hour to 45 mins then machine usally begins to run normally at propper temps.looking for a cause.


... Champion 26 in. D-HBC Free-Standing Dishwasher

I have an Arthur Martin ASF 2655 and the timer continues to turn from 0 to 1 to 2...... how do i reinitialise it


... Electrolux EWDW6505GS Fully Integrated Dishwasher with 9 Wash Cycles, Nylon Racks, Wave-Touch Contro... 24 in. Built-in Dishwasher

The count down timer gets to 1 stays there a long time, then resets to 23 or so, gets to 0 in about 3 hours or so. What do I need to replace? Thanks for your help.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012Based on your description I'd say the issue is with the control. Bosch has had a history of this exact problem I'm about to lay out for you and this is the fi ... Bosch 24 in. SHU43 Built-in Dishwasher

Honda GC 160 Engine, I had the carb replaced about 1 year ago, now its doing the same thing. At first it wouldnt start at all, I cleaned the carb, then it started would speed up and die. I then took the carb off and cleaned the jets, now it starts with the choke in the closed position only, at high speed it sputters and dies, but will I run it at med speed it runs but will die with tiller has a load, also when you put the choke to open it always dies. I dumped all the gas, and checked the fuel


This really sounds like a carb problem, good to hear that you are taking the carb all the way off and soaking it, this is the best way to clean a carb. I don't think it would be the fuel pump, they either work or they don't. I would check the governe ... Karcher 2500 PSI Pressure Washer

Comet 2700 psi pump lost high pressure after 1 hr of use.


... Comet BXD2527 Pressure Washer Pump

Kenmore dishwasher 665.13843K601 ser. FU4806977 STOCK 13843K TYPE 575-0 Tried to turn it on won't start/ run/ perform any functions The following buttons light up but will not perform functions; Smart wash and heated dry also lights up like it should, pots and pans, normal, fast wash, high temp, sani rinse The following buttons do not perform functions or light up Quick rinse, Turbo ZOne, Delay Hrs., Cancel/Drain, Start/Resume I killed the power to it for 1 minute for reset but d


The touch pad is not working. Pull the front kick plate from font/bottom of machine and there is a 'TECH SHEET'. This has a complete diagnostic sequence for you to go through and verify the functions for you. ... Dishwashers

I have a Bosch dish washer model SHX 43 M 0 ZUC / 48 FD 8709 00169 The dish washer is about 1 1/4 years old and was installed by a plumber as part of a Home Depot kitchen remodel. The problem is draining. The quick wash does not drain at the end of the wash. The regular wash sometimes drain and sometimes does not. The auto wash does drain. The lack of draining does not cause problems with the regular wash cycle. I checked the drain hose re the instruction manual and it is correctly installed.


Usually a brush with a flexible shaft will do the trick...\015\012\015\012Like this venturi tube cleaner (available where gas grills are sold)\015\012\015\012 ... Bosch Dishwashers

KitchenAid Superba Whisper Ultima Quiet: Inside the door ia a blue knob with numbers ranging from 1 thru 6. What is this feature?


... KitchenAid Dishwashers

Hello. I have a Kitchen Aide KUDG255HWH1 that will not start from a cold state. The "Energy Saver Dry" and "Normal" indicator light/ switches failed to operate about 1 month ago and since then I have needed to use the "High Temp Wash" and Soak & Scrub" cycles to get the unit to run. Now these two indicator kight will illuninate but the unit will not start when I depress the "On" soft switch. When I depress the cancel switch the unit starts with what sounds like a pre-start cycle. Pleas


Hi\015\012\015\012\015\012\015\012\015\012\015\012Thanks for using FixYa. To reset the dishwasher switch\015\012off the dishwasher from the power socket and mains for five minutes and then\015\012switch it back on. If still the issu ... KitchenAid Dishwashers

KitchenAid KUDP01DLBS2 dishwasher. Runs for a very long time on any cycle; time does not seem to advance. (takes 2.5 hours or more for normal cycle. "sensing soak", "water heating" lights on for a long time, even though it appears that water is not being heated. Checked incoming water temp, is hot. Did not do this when new, something has changed. Typical cycle was 1 hr 10 min. before.


Sounds like the heater inside the dishwasher is not working. The machine is trying to get the water up to a preset temperature, probably in the neighborhood of 140 degrees. That is one of the things that it is sensing.After the machine fi ... Dishwashers

My kleenmaid dishwasher super silent model system DW5 doesnt appear to be heating the water on any cycle so it is not washing properly and leaving the powder etc on the glasses up the top particularly and also it does not go completely to the end of the cycle by itself(any cycle).Or completing the drying cycle. I have to switch to 0 cycle to make it complete the clicking to start again. What is the gauge on the inside of the dishwasher on the left that can be adjusted from 1-5 is this a heat


Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012\015\012\015\012Service manual, generic, use this to troubleshoot and repair.\015\012\015\012 ... Dishwashers

Whirlpool quiet partner 1 is extremely loud. I high pitch whine while washing. I took it apart and there is nothing clogging the system. any ideas?


I have the same problem. Same dishwasher with the exact problem. Took it apart...nothing clogged...maybe motor is going out on it. Still cleans the dishes though. \015\012\015\012Any thoughts anyone? ... Dishwashers

When I press the start button, Bosch dishwasher (model SHY56A 05UC) just keep running the motor pumping the water out of dishwasher, irrespective of: 1) the wash cycle it is on, 2) whether the door is closed or open, 3) whether I cancel drain cycle, as told by Bosch Cust Svc in following steps: - "Cancel Drain" by pressing 'Quick Wash' and 'Regular Wash' buttons together for a minute until it shows 0* - Shut power off for a minute and wait for a minute - Restart on Quick Cycle. Paid


What is happenig i believe and has happened to me 2 times is that the water level float that is on the left side of dishwasher is stuck.\015\012\015\012Either remove side panel and flick lever or pull dishwasher out and tap lower portion ... Bosch SHY56A02 / SHY56A06 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0477 seconds