Having problems with your Mi T M Mitm 3500 Psi Hotcold Portable Gas Pressure Washer ?

No spark at electrodes

\015 The burner was working last week. we have no spark at electrodes right now. Bypassed switch for burner still no spark. where should I go from here?\015

Answers :

Repair Help & Product Troubleshooting for Mi T M Mitm 3500 Psi Hotcold Portable Gas Pressure Washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

11 hp honda pressure washer engine won't start. No spark at the pkug, bought a new coil and still no spark. This sysem only has a coil off the fly wheel and the spark plug. I even changed spark plug. Use the unit the other day, shut it down and on restart it won't start. Also, I disconnected the kill switch and the il lvel sensor so nothing was going to ground.


If you replaced the coil,check the wire and boot,check with meter for continuity.could be loose connection to spark plug ... Honda Pressure Washer PSI 3000

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

Washer won't start tried everything , I could think of changed spark plug tried new gas , Two things that bother me are . if i take out the spark plug and put my thumb over the spark plug hole theres no pressure and the wire that comes from the coil to shut off the pw it has continunity from the coil to the pin that sticks up to shut off the pw but it also has continuity from the coil to all parts of motor.


... Pressure Washers

No spark we had a gas leakand it ran down to the coil and flywheel. The engine quit and wouldn 't restart. no spark. I replaced the coil and still no spark. the insulation on the magnet appears to be good .I need help please.


Here are a few pointers from a former pressure pump tech. Usually no spark is caused by the low oil safety system or spark plug wire shorted. This system will prevent the engine from starting if the oil is dirty or contaminated with gas. Try disconn ... Pressure Washers

Troy built pressure washer won't start. It has a Honda 160 CVG motor. I used it for about a year and then it stopped working. I've replaced fuel and spark plug. Spark plug is soaked every


... Karcher 2500 PSI Pressure Washer

Hi my scorpion squirt pressure washer won't start spark but no fuel at spark plug fuel is going into the carby


... Pressure Washers

Got spark, no fire. Dipped plug in gas. Not ENOUGH spark?


Ok lets assume for a moment that it does not even fire with gas inserted into the spark plug hole. Given that we have to assume there may not be any compression. Have you tested the compression? \015\012\015\012Just for girns lets do s ... Briggs & Stratton 020324 3700 PSI Pro Series Pressure Washer

I have a Troy Built 2500 PSI pressure washer with Honda 160 CVG motor. It won't start. I've replaced the gas and spark plug. Every time I pull the spark plug out it's soaked. Not sure


... Pressure Washers

Hard starting 6hp Briggs and Stratton power washer engine. I poured a teaspoon of gas into the cylinder; reinserted the spark plug and with one pull in ran fine. This is a choke start engine and it may take 12 to 15 pulls to start on a cold engine. The unit is clean. The air cleaner is new. The spark plug is new. The unit is 2 years old with very little use.


Hello. I have this same machine. Go to the auto parts store and get an aerosol can of starter fluid. Have a helper squirt some into the air intake while you start it. Then continue to squirt a little starter fluid as it runs for the first two mi ... Campbell Hausfeld Pressure Washers

I have proplem start the engine i check the spark from the coil to sparkply and i find out no spark so i order the coil and i steal have a problem , the kill switch is working ok. Thanks for any help Demetrios


Have you put a new sparkplug in. Also check that the oil level is full. If still no go, check the spacing between the coil and flywheel. ... Honda 8 HP Engine

Won't start I have checked the spark plug and I have good saprk. I have checked the fuel sysstem and the primer bulb injects fuel. I have removed the head and cjecked for engine damage and all cycle correctly. Vaves opne on time piston shows no dmagae. side walls are smooth and not damaged. This engine was working fine but the pressure washer needed some O rings replaced. I have tried to start it with and without the pump attahced. Evrything on the engine looks fine. I removed the spark plug and


... Briggs & Stratton Briggs Stratton 2550 Psigaspressure Washer

Ignitor keeps sparking - Stoves Belling Gas Cooker Spark Ingniter Unit C00241367


... Stoves Belling Gas Cooker Spark Ingniter Unit C00241367

HOW DO I FIX MY HUSKY MODEL HU80520 PRESSURE WASHER, IT WONT STAY RUNNING AFTER REPLACING THE SPARK PLUG? WHAT IS THE RIGHT SPARK PLUG FOR THIS UNIT?


... Pressure Washers

Wont start acts like no spark but is getting spark


Same problem happened to me after starting it on the 1st pull used it \012and put it away for months.The carb.has a single jet which is a very \012small hole that gets gummed up when its not ran for awhile due to the \012Ethanol that they put in gas. ... Karcher G3025OH Pressure Washer

I have an Excell VR2500 pressure washer with B & S 6.5 HP engine. It was running fine, but then stalled out and now will not start. Has clean gas and full oil. I pulled the spark plug it is producing a sufficient spark when starter cord is pulled. Any ideas what might be causing the problem? Please help.


The key things to check are the spark plug, the air filter, the fuel. If those are all new and in good shape then you probably have gum in the carburator. Get a can of starter fluid and a helper. One person squirt the starter fluid into the air in ... Briggs & Stratton Pressure Washers

I have a mid 60's 6 hp Tecumseh engine on a Troybilt tiller. I used it to till my front yard and it ran fine. I let a friend use and it quit on him after a few minutes. It will not start. It has spark at the spark plug. I have thoroughly cleaned the carburetor by taking it apart, soaking it in cleaner, blowing out all holes and passages. I made sure the tiny holes in the power valve at the bottom of the fuel bowl are open. I have taken this carburetor apart five or six times over the years an


... Karcher 2500 PSI Pressure Washer

Not getting spark


Check for low oil some models have a low oil shut off ... Pressure Washers

Have a genarac pressure washer when trying to start the engine catches half way through the pull with spark plug out it cranks fine


... Briggs & Stratton Power Products 1539 Pressure Washer

Honda gc160 engine on 2500 psi washer, no spark?


No spark from the plug? you have to change the plug. ... Karcher 2500 PSI Pressure Washer

Cant get to spark plug on troy bilt 2700 pressure washer


... Pressure Washers

Spark plug gap for Briggs and Stratton 6.0 HP


... Craftsman 2500 PSI Briggs & Stratton Powered Pressure Washer

675 series spark plug gap settings


... Karcher Pressure Washers

Dishwasher bang and sparks


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0170 seconds