Having problems with your Midea dish washer ?

Midea dish washer not running

the unit starts and takes water but will not run after taking water in.

Answers :

Repair Help & Product Troubleshooting for Midea dish washer

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

GE Dish Washer GSD 2800 DO3 runs a partial cycle...(even empty) and then beep and gives a message on control panel "washer arm blocked". Even ran without dish rack in washer still got the message. Push reset button and washer starts back runs a couple minutes and then stops and then beep and gives the same message on control panel "washer arm blocked" again. There is "NOTHING BLOCKING" the washer arm!


The rotating arm has a magnet in it to let the controls know if it is turning. Yours is not turning so \012\012\012\012check the jets for blockages... you might have to remove the arm to clean them properly ... Dishwashers

While the rinse cycle was running in a dish washer i heard a loud pop. the dish washer quit running. what would cause this?


OK, this is usually a thing called an Electrolytic Capacitor, these can go off like "Little Bombs". When this happens, usually, it represents a far greater "Fault" is actually involved. than just that, symptom. usually it is on the "Main Controller" ... Dishwashers

I have kelvinator dish washer in Bahrain. The sale agent J.A Zayani suddenly stopped its sale and workshop. The dish washer produces a high blasting sound while running though perform its cycle correctly. We are scared to use it. No one in Bahrain accept its repair as the agent has abodoned its operation. Did you fix anothe ragebt in Bahrain. Please advise what is this bang sound appearing once or twice during operation. Is it safe to run it. How to reapir it. Thanks in advance for your assist


... Kelvinator Dishwashers

My dish washer isn't cleaning the dishes well. There are little particals inside of every cup and on dishes after it is done. I just emptied and and now I'm running it with bleach. But before I started it I looked at the drain hose under the sink. The drain hose had water in it. The drain hose is going uphill from the dishwasher to the sink so I don't know if this is normal to have some water in the drain hose when the washer completes since it's not would have to pump uphill to get to the garba


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher

My GE Potscruber dish washer is leaking water underneath in the middle. Water is dripping from around the metal sim running across the middle of the dish washer. What should I do next and is it fixable?


You will have to get a flashlight and a phillips head screwdriver. Remove the lower front panel of the dishwasher and carefully check the drain hose for a leak. You may end up replacing the hose that runs from the base of the dishwasher into the ga ... GE Dishwashers

Dishes are still dirty. I have used every kind of dishwasher aide, half loaded it and dishes are still dirty, I let the water run until very hot before starting the washer. The washer says you don't have to rinse but I do and they still come out dirty. Also black nasty stuff comes up from my garbage disposer.


Suggest the problem may be a plumbing issue - likely substantially blocked drain system, so the dirty wash water cannot properly pump out but rather remains in the dishwasher.\015\012\015\012Suggest getting a plumber in to "snake" out you ... Dishwashers

Dish washer runs all cycles but no water entering dish washer


Make sure you check that the water is turned on to the dishwasher.Check for a kinked or squished fill hose. If all else fails its most likely you need a new fill valve for your dish washer. ... Maytag Dishwashers

Frigidaire dishwasher won't end cycle - will run on and on for hours. Sometimes it cycles through, usually it just endlessly washes and rinses. I have to CANCEL the cycle, which causes the dishwasher to empty and run a few RINSE ONLY cycles (which are consistent, cycle time wise) to rinse the soap off of the dishes. Also, the door for the soap seems to stick - how long into the cycle before the soap door should open? Also, does opening the washer during it's cycle (to add more dishes) change or


I would say the resettable thermostat has failed. There is a thermostat which senses the water temperature, and when it fails, it causes the dishwasher to run constant. Replace the thermostat underneath the dishwasher and that should cure problem. P ... Frigidaire 24 in. FDBB540 Built-in Dishwasher

AFTER RUNNING MY DISH WASHER I OPENED THE DOOR THERE WAS ST HALF IN OF WATER IN THE BOTTOM SO I WAS GOING TO WASH AGAIN BUT HAD NO LIGHTS ON CONTROL PANEL HAD POWER TO THE DISH WASHER BUT NOTHING WOULD LIGHT UP? DONT HAVE 10 WASHES WITH THIS UNIT .? MODEL #655-13443K900


Hi Bennie, Try http://www.manualowl.com for free PDF for troubleshooting the issue you are having. I hope this helps. ... Kenmore Dishwashers

My dishwasher is fairly new, lately it has not been cleaning the dishes on the top rack very well. Food still on dishes, mostly on left side of washer. When the washer is running, it seems to start and stop numerous times. My dishwasher is a Maytag.


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Maytag Dishwasher

Dish washer does not drain after the cycle is complete. The last few months when the dishwasher is done their would be a small amount of water left in the bottom. It didnt create any problems but would smell after a few days. So we would just run the drain cycle and it would empty. Well i got home to and the wife said the it was really full. The water was dirty and when you run the drain cycle it didnt drain. She said the dishes were clean. So i cleaned the vent, and filled the sink with


Check drain hose and drain pump.End of drain hose must be in same level with machine.Try it. ... KitchenAid KUDR01TJ Dishwasher

Dishes not clean after running. Dishes and glasses have a white residue on them after drying. Water is turned on and seems to ok. When I open the washer after the wash cycle starts there are several inches of water in the washer and the jets seem to be functioning. Thanks for your advise.


Hi If you are noticing that the dishes are not clean, then there are a few things to check for. Check the soap powder if it's kept in a dry environment. Also try replacing the powder with something like a gel or liqu ... Bosch SHU9925UC Built-in Dishwasher

Dirty Dishes After running the dish washer a layer of food is often times spread over the dishes. It appears as though the dishes went through the cleaning cycle and then were rinsed with dirty water? Thanks for the help


It cleans poorly\015\012\015\012If your dishwasher is cleaning poorly, check these:Water-inlet valve ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

We have run our dish washer several times, however, the dishes are not getting cleaned. We first ran it on "normal wash." The second and third time we ran it on "pots and pans." Not only are the dishes not getting cleaned, but the soap is hardly getting dissolved. We use liquid dish soap too. I noticed this last time, at the end of the wash, the soap was getting built up on the front-right (when facing the machine) and had turned into a solid clump; almost like plaster. I don't have a manual so


First idea goto your local home depot they make a product called AFFRESH for front load washing machines and dishwashers run this tablet inside your dishwasher with no dishes on the inside on the hotest setting this usually takes out all build up wit ... Dishwashers

I have a kenmore elite dishwashe and it isn't or is almost a year old. yesterday i did a load of dishes and it didn't clean them....at all. so i put a differant detergent in the washer and heard it fill but then let it run the dishes are hot like they went throught he cycle but the dishes weren't clean. what could be the cause of this?


When you say they are not clean do you mean they have a white film on them? if so it is your water actually and not your dishwasher. there is a product designed specifically for this problem. it filters the water going into your dishwasher. ... Tappan 18 in. MDR251RE Built-in Dishwasher

I have a Bosch dishwasher, stainless steel front- with buttons on the inside top( same as display, and the washing cycle won't start. Water seems to be running into the washer, as I can hear it, but the cycle never starts. Recently, I had clogged garbage disposer issue that has been resolved. The dish washer drains into the disposer, and I had free standing water left behind in the washer for 2days during this time.. Could this be the issue? Can you help me figure out this problem? Thanks!!


... Bosch 23 in. SHU 8805 Built-in Dishwasher

Some of the dishes on the top & bottom are not coming clean. Is there a filter that gets plugged? I am not cramming dishes in & I run the hot water to really hot before I start the washer. I also rinse the dishes before putting them in. HELP!


It sounds like water supply problem hose may not feed enought water ... Kenmore 24 in. 15079 Built-in Dishwasher

The top rack dishes do not get cleaned. I have run the vinegar rinse. The bottom rack dishes get cleaned. It doesn't even look like the top rack dishes get wet. I ran the washer without the top rack in and I think water was coming down from the top. What can I do?


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Dishwashers

Dishes bottom rack are marginally clean. upper rack is never clean anymore. The dish washer cycles through NORMAL and Dries dishes OK. Motor is running, and rinsing can be heard as well as washing cycles. Water temperature is HOT. Different detergents (liquid and powder) were used. Frigidaire model FDbb2040FB1


Just fixed my Frigidaire. The outboard o-ring on the main pump became distorted and stretched. Check your local hardware store as Frigidaire wants $17.50 + shipping. Good luck ... Dishwashers

Dishwasher does not get enough water. Dishes are always dirty after running dish washer. The center part where the water is suppose to spray out of doesnt even pop up to allow water to spray dishes thru out.


Check your water inlet screens, and the pump for blockage of some sort or no pump operation condition ... GE Nautilus 24" Built-in Dishwasher

Dish washer runs and drains water only. I turn it on and you can here the drain pump running. But it just keeps trying to drain ut won't go into the fill cycle


It sounds like the re-lay switch on the pump is stuck and therefore only pumping inthe one direction.some pumps come with re-lay switch built-in and orthers with it seprate less hassel not built -in.P ... Dishwashers

A few days ago the dish washer was running fine, maybe a single wash every day. Then, out of no were the logic seems to have left the machine. If you pressed the "normal cycle" button it would blink for about 30 to 45 seconds then the front panel would go blank. All LED lights would turn off, like it finished doing the diskes, never running a single cycle. I unplugged the machine to let all circuits reset, that worked for two days, two washes in that time. Today I'm back to a machine that will n


Your control panel is faulty and will have to be replaced. This is the main brain of the machine. Normally when a cycle doesn't start the timer is bad, but when your control panel doesn't do anything, then it is faulty. ... Dishwashers

Dish washer starts and runs thru cycle but does not clean top row of dishes its as if no water gets to them


Hi,\012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried in vainto clean the things... \012Bought new spray arms online and installed them inminutes...now the thing works ... Dishwashers

The dish washer will not fill. It starts to , but the float switch apears to be stuck. It runs thru all of the cycles, there is not enough water to wash the dishes.


... Kenmore 24 in. 17669 Free-standing Dishwasher

Washer makes a grinding noise while running in the wash cycle. I've confirmed the rotors in the unit are not hitting anything inside the tube. The noise seems to be coming from the drive mechanism underneath. The washer continues to clean the dishes in spite of the noises, but the noises are a bother.


You will likely have to remove the pump motor from underneath to solve your problem. Try removing the lower spray arm assembly down to the deck and check the pump impeller for noises. Make sure to note the position and placement of all parts removed. ... GE 24 in. Profile PDW7800 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1262 seconds