Having problems with your Miele Dishwashers ?

Getting a F51 message - Miele Dishwashers


Answers :

F51
\012

Heater pressure switch
\012

The program is interrupted and the drain pump is operated. The display
\012

shows Technical fault F51. Call Service Department. The buzzer is
\012

activated for 2 minutes.
\012

Background information:
\012

Start position:
\012

One second after the program start, heater relay K1/1 is activated. This
\012

enables a check as to whether the contacts on heater pressure switch B1/13
\012

have closed on switching steps 21/22 or 11/12.
\012

Cause:
\012

Heater relay defective; contact open.
\012

Remedy:
\012

Replace the heater relay.
\012

Cause:
\012

Heater relay solenoid defective.
\012

Remedy:
\012

Replace the heater relay.
\012

Cause:
\012

Connection from heater relay to electronic module open-circuited.
\012

Remedy:
\012

1. Check plug connections.
\012

2. Check the connection wires for continuity.
\012

Cause:
\012

Heater pressure switch open- or short-circuited.
\012

Remedy:
\012

Replace the heater pressure switch.
\012

Cause:
\012

Connection from heater pressure switch to electronic open-circuited.
\012

Remedy:
\012

1. Check plug connections.
\012

2. Check the connection wires for continuity.
\012

Cause:
\012

Foreign objects in heater pressure switch.
\012

Remedy:
\012

Replace the heater pressure switch
\012

if you have any further questions message me back and please remember to rank this opinion it allows me to help people in similar situations in the future Thanks again Rick

Repair Help & Product Troubleshooting for Miele Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Getting a F51 message - Miele Dishwashers


F51\012Heater pressure switch\012The program is interrupted and the drain pump is operated. The display\012shows Technical fault F51. Call Service Department. ... Miele Dishwashers

Did you get my message about my Miele dishwasher? I don't think I sent it. I am getting suds in the bottom of the dishwasher. Then sometimes all the cycle lights come on when the load is finished.


Hi \015\012\015\012 \015\012\015\012Suds left in the bottom of the\015\012dishwasher tub would indicate:\015\012\015\012Using too much detergent, using\015\012wrong kind of detergen ... Miele Incognito G818SCVi Built-in Dishwasher

My Miele Dishwasher (Excella Series G 2630 SCi) fails to fill. I get the message "Water inlet - Open the stopcock". I checked the water inlet filter and looked for hose kinks to no avail. I even checked the non-return valve. When I start the dishwasher I can hear a low hum (Not the pump) for a few second before the error message displays.


... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

We have a miele dishwasher and are getting a technical fault 68 error message. We have turned the dishwasher on and off and this did not fix the problem.


Peace friend,\015\012ngfam1 at your service\015\012\015\012Unfortunately I am not there hands on for you !\015\012You will need a good service tech.TO DIAGNOSE THIS ELECTRONIC PROBLEM!\015\012How old is the appliance? ... Miele Dishwashers

Getting a F14 message, what does it mean? - Miele Optima G2420SCi Stainless Steel Builtin Dishwasher


... Miele Optima G2420SCi Stainless Steel Builtin Dishwasher

I have a Delonghi dishwasher, it's a stand alone, like a washing machine. The water inlet is connected to the hot water tap, normally used for a washing machine. When we first started using the dishwasher, we kept getting the E4 error message, we reduced the water inlet pressure by turning down the tap, that worked for a while. Just a while ago, we started getting the E4 error message again, not sure we can turn down the tap any further without cutting the water off completely. Do you have a


The E4 error message could be because the water pressure is too low rather than too high. Can you let me know the exact model number of your dishwasher and I should be able to tell you more.\015\012\015\012Regards,\015\012BElectric ... Dishwashers

I have an Electrolux EWDW6505G Dishwasher. Had started a cycle, then opened the door midcycle when water was in the tub -- and accidently pressed "cancel." When I try to start a new cycle now, I was getting an "Error 01" message. After trying to get out of it, I'm now getting a "water serv" message. How can I reset?


... Electrolux EWDW6505GS Fully Integrated Dishwasher with 9 Wash Cycles, Nylon Racks, Wave-Touch Contro... 24 in. Built-in Dishwasher

Miele dishwasher fault code f51


... Miele Dishwashers

Where can I get Miele dishwasher parts? - Miele G892SC SS Dishwasher


Hi,you will have to purchase spare parts from Miele directly or from a miele authorised dealer. you cannot purchase spare parts any other way.if you look at www.mi ... Miele G892SC SS Dishwasher

"drain" message on miele futura dishwasher - Miele 24 in. G665 Built-in Dishwasher


... Miele 24 in. G665 Built-in Dishwasher

Miele dishwasher error f51 what is it please - Miele Premier-Plus Built-in Dishwasher


... Miele Premier-Plus Built-in Dishwasher

Miele dishwasher Hi I hope you can help. While we were away my daughter used fairy liqid in the dishwasher, and we did three washes to get rid of the suds and put the dishwasher through a cleaning cycle with a dishwasher cleaner. 'Inlet/ dreain is lit up and after the wash there is some residual water in the bottom. Is it mendable, please.?


You can go through this link http://www.miele.co.uk/Resources/OperatingInstructions/G%201142.pdf it contains the operational manual t ... Miele Dishwashers

Miele G2670scvi re: miele G2670scvi diswasher Hi , I have experienced two years of continual problems with this dishwasher. I'm always getting the F11 drain fault. There are no clogs as I have been through the routine that Miele takes you through to assess clog at least one hundred times. Pump has already been replaced once. Please help.


... Miele Dishwashers

Put dishwasher cleaner in the rinse aid compartment on Miele G 851 dishwasher by accident. How do I get it out? Will it ruin my dishwasher?


Should not do any harm to your dishwasher.you can remove the front panel on the door then take out the soap dispenser and take it to the sink and empty it out or run water in it till it over flows itself and begins to clean out the soap could tak a l ... Dishwashers

I get an LE error message on my LG Dishwasher. I replaced the pump. Still get the LE error. Replaced the main control. Still get the LE. No blockage in the pump. What now?


When you receive the LE error code, unplug the machine for approximately 15 - 20 minutes. This will reset the microprocessor.Oversudsing is the main cause of LE error codes. Using non-HE detergents or too much detergent will cause stress ... Dishwashers

No matter which cycle selection in pushed, the dishwasher only starts up in the "normal" 93 min cycle. If I try other cycle options, and persist, I get an ER message and the cycle stops prior to the soap powder door opening and never completes the cycle. Only with turning off power for several minutes and receiving the PF message, and resetting ONE TIME that message can I then select any cycle, at which time the machine "defaults" to the "normal" full cycle. If I do not disturb that cycle, it wi


Looks like you are having a good deal of problems with the dishwasher.\015\012\015\012It will be helpful if you provide the make and model no. of the dishwasher.\015\012\015\012At this stage I can speculate the controller (ass ... Dishwashers

Miele dishwasher gets stuck in rinse cycle and


... Miele Dishwashers

IE message Getting an IE message on dishwasher. Water is coming into the tank and heating, but after about 5 minutes, it kicks into an IE error. We have checked the water inlet and the spray arms and everything appears okay. I have read the comments about checking the float, but how do you do this? Any other suggestions would be helpful.


My solution was, after LG sent me a second dishwasher that ALSO did not work, to demand a refund. Then I went and bought a KitchenAid~ it's awesome! ... LG LDF6810 Built-in Dishwasher

Miele Dishwasher G643SCVi- Get a whistling sound when the dishwasher starts. Lasts for 20 seconds, stops, and continues again for 20 seconds. It does this 3 or 4 times and then it is normal. I have not done anything at this point to fix the problem.


... Miele Dishwashers

I get a water outlet fault message on my asko d3531 dishwasher...water is filling at the bottom of the dishwasher and will not drain.


... Asko 24 in. D3530FI Built-in Dishwasher

I have a component in the bottom front part of the Miele G542 dishwasher that is leaking water. Its connected to the water IN line. Plumber came out, showed me that I need a dishwasher repair guy to replace the part. Who can I get to make a service call and repair this in San Jose CA.


\015\012Advantage Appliance Repair\015\012\015\012(408) 266-9560\015\012Highly recommended. ... Miele Dishwashers

I have a brand new Miele dishwasher which has worked grate since it was installed 2 weeks ago. It keeps shutting itself off & indicates an F13 fault. I looked in the manual, see that water is going in fine & pressure is good. It then says to clean water intake filter. How do I get to that ? I don't have a user maintenance manual. I'm on city water & doubt that the filter is clogged but My wife will kill me if I don't get it fixed today. Can anyone help. Glenn


On my Miele 1220 dishwasher, the inlet filter is inside the inlet hose connector, where it screws onto the water supply. To clean it:\015\012\015\0121. Turn off the stopcock.\015\0122. Unscrew the inlet hose.\015\0123. Remove the black rubber s ... Dishwashers

I have a Miele G 2470 scvi dishwasher. Machine displays F24 in display, lights flash, machine beeps and it won't run. Miele manuals seem to have no reference at all to error message displays. any thoughts?


... Miele Dishwashers

I have LG dishwasher model LD 14AW1 I get error the message HE about 15 minutes into the wash cycle then the dishwasher turns its self off


HE refers to HEATER ERRORThe water is not heatedor the temperature inthe Tub is overheatedto over 95¡Possible causes¥ The Circuit of Heater is troubled.¥ The Thermistor is troubled.¥ T ... LG 24 in. LD-12BW5 Free-standing Dishwasher

My G865 Miele dishwasher goes partway through the cycle then gets hung up and runs without advancing. We left it running when we left for vacation and it was still running when we came back. I'm assuming it is the timer mechanism. The dishwasher is ten years old but has been run only every other day or so. Is it worth fixing or is it better to replace?


It will cost alot to get repaired,10 years old you got money out of this one. ... Miele 24 in. G865 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1388 seconds