Having problems with your Miele Optima G2470SCVi Built-in Dishwasher ?
Intake/drain light on
\015 When we try to run the dishwasher, it starts beeping and the intake/drain light goes on. please help! thank you!\015
Please check the INLET water pressure, remove the inlet and check. Now if there is pressure make sure that when the power is pressed there is a pre wash cycle to start the machine. If not there is fault in the program controller , please check the door switch and the panel board.
Repair Help & Product Troubleshooting for Miele Optima G2470SCVi Built-in Dishwasher
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
I have a Whirlpool Quiet Partner 3 GU2200XTSB3 dishwasher that starts but wont complete a full wash cycle. I went to diag mode and the follow light sequence appeared: Normal light and washing light came on, then switched to Rinse only and drying then back to normal light washing this sequence repeated 3 times then no lights then Light and heated dry followed by the normal light flashing repeatedly for an long period of time then switched to Light and heated dry then all lights went out I was t
... Whirlpool GU2200XTSB GU2200XTSQ 24 in Builtin Dishwasher
I have a kenmore DW model 16019. The clean Light stays on the light does not turn off. I have tried to disconnect and have taken the motort apart to make sure everything is clean. What Can I do to solve this problem? 1. Does the washer work at all? No it does not work 2. Does it display any codes or flashing lights other than the CLEAN LIGHT being lit? no other lights are on except for the green blinking light 3. Is the light solid or blinking? blinking Green light 4. Entire model # is necessary
Thanks for re-posting with all the info!!The model # is 665.16019403The cleaning light blinking is a fault code listed in the tech. service sheet, its usually a faulty heating circuit.The sheet can be found behind the ki ... Kenmore Dishwashers
Lights on Dishwasher light up but nothing happens. When I reset power it lights up the high temp and sanitize button light up and LED displays PF. After I open the door they stop flashing. the far left five buttons light up when I push them and a corresponding number displays on the LED screen. the only lights that do not come on are the Delay button and power button. Don't know if they are working or just don't light up. No matter what lights up the unit does not turn on....:( ? help can't fin
Pf is power failure\015\012 your loosing voltage to the unit \015\012it may just be the door switch or it could be in the control\015\012 try starting the unit but keep your hand on the unit pushing the door in place,, its not a g ... Electrolux 24 in. EDW5500DSS Stainless Steel Built-in Dishwasher
I have a whirlpool in counter dishwasher model # DU915PWPQ0 serial #FS2536586. The problem i have is the light cycle, green light is constantly blinking. When another button is pressed the heavy and normal cycle lights start blinking and the light cycle, light is illumanated constantly. I have left the power off for 24hrs and when turned on the light blinks again. it will not start any cycles.
Hi Mike...As I said..it flashes 4 times (not 5) 4 times then stops and starts flahung 4 times again. Also, the float is free moving in the tub,\015\012\015\012Any other suggstions??\015\012\015\012Thanks\015\012Dave ... Whirlpool 24 in. ADP5962 Free-standing Dishwasher
TEKA Dishwasher TDW 59.2 FI Error lights Light 1 = off Light 2 = on Light 3 = off Light 4 = on Light 5 = flashing
Normal light flashing on and off. Pressed cancel, now both normal light and cancel light are flashing. Dishwasher won't start. Can't shut lights off. Tried disconnecting power. Lights still flashing.
Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. To resolve this you will have to\015\012reset the console. Do this by closing the door and press t ... Dishwashers
The three lights for Pots & Pans, Normal Wash, Econo Wash are all flashing. When I hold the start button down for four seconds, just the Normal light is on. However, once I close the door, all three lights are on again, and the dishwasher does not start. We have tried unpugging it and then plugging it in again. It worked once then went back to all three light flashing. Before this, only the Normal Wash and Econo Wash lights were flashing.
Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012I can't seem to access any previous post dialog that may have taken place but I'd like to help if you can fill me in on whats taken place to this point.\015\012\015\012The scenario you describe i ... Viking DFB450 Dishwasher
Model Ariston AFA370X - This query is for my daughter who is currently house sitting and can't find any manual for the machine. When switching the dishwasher on there are two red lights next to the on switch. One light indicates salt but it's the other light that is coming on with 2 stars above it and she doesn't know what this light indicates. She has used the machine once before and everything seemed fine but this time this light keeps coming up and the machine will not start. Please a
Kenwood Elite Dishwasher Mod#665.13779 K600 "Normal Wash " light blinks continuously with NO washer action. No other wash modes light up when pressed. Washer does not do anything. However, a couple of times I got it to make a noise as if it was draining, but then nothing happens. Push "Cancel" and it blinks in unison with Normal Wash light. Open door and close it, "Cancel" light goes out and Normal Wash light continues to blink. Have tried various combination of buttons to try to "Reset"
... Kenmore Dishwashers
My Miele G641 displays the Salt PC light even after filling it with salt. I have to cycle the main power switch 3 or 4 times before the Start light will come on. Then when I press the Start button it momentarily pumps out water and then stops. Sometimes the Start light stays on and I can get it to give the pump another brief spurt, but often the Salt/PC light comes on again and the Start light goes out. I then have to re-set the power switch. How do I tell if the logic board is fried?
Hi.This is not a PC, when logic board is fried the machine does not start at all rather than doing weird thing.The logic board is not fried, in the worst case the salt sensor is jammed. Try first pouring a couple of litres of hot wa ... Miele 24 in. Novotronic G641 Plus Built-In Dishwasher
My Bosch dishwasher stopped the other day for no reason, the bottom still has water in it, I just tried to start a full wash again and all that happens is the red light below the brush symbol lights up, then after a couple of minutes the red light below the tap symbol lights up, also the red light below the drying symbol is also lit, but nothing happens after that? Any ideas?
... Bosch Dishwashers
Dishwasher will not start. Kitchenaid kudr25sh does not start. Light/china light and rinse only light do not light up. Energy saver does not light up. Start button will not light up.
... KitchenAid 24 in. KUDR25SH Built-in Dishwasher
My Maytag dishwasher model MDB600AWB, serial 18721619CN Quiet Series 300 will light up on the panel except for NORMAL WASH and START. It will not run. All other buttons work. It displayed the number 9 and the RINSE ONLY light came on after we got off the phone with Maytag. Initially nothing would light at all. We changed the fuse (it is NOT on a breaker) and it again didn't light. A few minutes later it did light the above mentioned buttons.
... Maytag Dishwashers
Have a kitchenaid dishwasher KUDS25SHWH1 - the child-lock light came on and will not go off. It is a light and no button to push and hold except all of the select buttons for the type of wash you want, no air dry button. How do I get this light off?? The Child Lock light has come on by it's self and I cannot get it to turn off. I have never used this feature before. I have tried to hold the Energy Saver button for several seconds but the Child Lock light will not shut off. The dishwasher is loc
Unplug the unit for 15 minutes then plug it back in. This should reset all your computer system and make everything work again ... KitchenAid 24 in. KUDS25 Built-in Dishwasher
Maytag dishwasher mdb7601 will not run- light doesn't come on and nothing happens when you push the buttons. Earlier it would work but if you pushed the light cycle button the longer cycle would light up and it would run. Then the time running light did not light up.
... Maytag MDB7100AWB Dishwasher
I have a Whirlpool ADF951, it has power to it and was working fine, the power light is on and the green light to the far right of the cycle lights is flashing, I can only get any response if I hold the start button in for about 10-15 seconds, The machine stops the light flashing and makes the noise like it is starting , that goes for about 20 secs then returns to the flashing light stage, any idea's please
Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the light flashes, pauses, and then repeats. When\015\012the dishwasher doesn't sense a water tempera ... Dishwashers
My Whirlpool Quiet Partner 111 dishwasher Model # GU2500XTPS7 control panel won't respond. There are 4 lights on, the normal wash light, heat/dry light, the lock light, and the start/resume light is blinking. I have held the heat/dry button for 5 sec. trying to unlock it and nothing happens.
Disconnect your circuit breaker for 20 minutes and then reset. It should reset your dishwasher. ... Whirlpool Dishwashers
My Kenmore 15652 dishwasher has the Pots/Pans light blinking. When I try to press cancel the quick rinse light also blinks, as well as the cancel light and the pots/pans light. When I release cancel the pots/pans light still blinks and the other two turn off. How do I reset dishwasher so it works normal?
... Kenmore 24 in. 15652 Built-in Dishwasher
Kenmore Ultra Wash Model 665 - 158* Front panel not working properly. Pressing Normal does not light that option. The only option that lights is "Quick Rinse", pressing this lights that option and also the "No Heat Dry" light. After a few seconds the lock light comes on. Looks to me that the "No Dry Heat" button is stuck on, which causes all the other things to happen Is there a way to fix this?
Hi, I have a KitchenAid Superba diswasher model #KUDSO1FLSS2 that has quit working. All the buttons seem to work and the lights light up as they should but when you hit the 'start' button the light that you selected for whichever cycle would flash once, then close the front door and dishwasher would start. The 'start' button was acting up and would have to press a few times before light would flash and then the dishwasher would work. Now everything lights up but start button does not work. Opene
Hi.Test the start button switch.The switch is tested by disconnecting power and reading Ohms, this will tell you if it does open and close the circuit.If the start button is part of the control assembly, then this kind o ... Dishwashers
I have a Eurotech Model EDW242C, I can't get the "on" light to turn green, the program light is green, and the start light is solid green but the "on" light stays red and the dishwasher will not start. My cell is 404-229
If the start light is red from start, and there is no water inside the machine , then it can be an inlet error.Trip first the circuit breaker to reset the appliance.Check the inlet hose and ensure there is pressure. ... EuroTech Dishwashers
I have a Frigidaire Model Number GLD4355RFS1 Serial Number TH80493988 Dishwasher. It quit working when the Rinsing Agent Low light came on. We filled the rinding Agen dispenser with hopes that it would come back on. The Rinsing Agent Low light went off but the unit never came back to life. When the room is totally dark, you can just barely see the lights in the LED display and other lights. It will not come back on. I tied turing the power off and the "PH" alert is displayed in t
... Frigidaire Dishwashers
Whirlpool GU2300 built in Dishwasher. It rather suddenly began shutting off in mid-cycle. If I cancel or open it, getting it to finish the cycle or even drain takes many tries.Once started, the cycle might take several hours with long pauses during the cycle. When it puases, none of the lights are on at all. If the cycle is disturbed, the normal wash light blinks, and if I hit cancel, the cancel light and the normal wash light blink.
... Whirlpool Dishwashers
Stupid dishwasher! have a maytag model MDB5100MWQ and it was working fine then poooof it the lights go on and it sprays water and thats it, the soap door doesnt open, the indicator lights turn on but nothing happens, then about 20 min later the rinse only light and clean light start blinking what the heck is going on with this damn theig thanks :) brittany
Can you tell me if it drains at all? it sounds to me with the model that it may be the drain pump indicating its clogged. When you open it up is it filled with water? sitting in there idle as in its not draining or siphoning out.let me kn ... Dishwashers
3 sec light on control panel blinks .. dishwasher wont star. None of the other control lights come on. I have reset the breaker in the main panel to attempt to reset any internal breakers with no results. When I attempt to set anuy of the options, the 3sec light blinks then returns to a solid light.
Go to maytag website they have all kinds of help there ... Maytag 24 in. MDBH950AWS Built-in Dishwasher