Having problems with your Neff 24 in. S5443X2 Built-in Dishwasher ?

Dishwasher just hums, faintly, when I turn it on.

\015 When I turn it on, it just hums faintly. The arm does not move. No water fills. If I turn the dial to various locations, it hums at most places. At several locations, it will start to fill with water. But the rotating arm never moves. It does not seem to want to pump out any water, only fill. But it does not fill at the start of the cycle. I have had it for 10-15 years and it has worked well with no service.\015

Answers :

Motor is locked up.. if you let it hum faintly for a couple min it will cut out most likely.. thats the thermal trip built into the motor.. the motor assm needs to be replaced..
Repair Help & Product Troubleshooting for Neff 24 in. S5443X2 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Amana Dishwasher dishwasher will fill with water, then will proceed to just hum through the wash cycle, no water is pumping through the turning blades. It will stay humming until you turn it off by hand ( dial will stop mid way through cycle)


Sounds like something is jamming your wash inpeller start at the washer arm and go down till you get to the wash impeller and see whats sticking it like broken glass small peice of bone toothpick etc ... Dishwashers

The dishwasher makes a humming sound when turned on. No matter what cycle it is turned to, it continues the humming sound and does nothing else. I thought I could reset it by unplugging it, but as soon as it is turned on again, it continues the humming sound.


... Miele G848I Dishwasher

Maytag DWU6402AAB dishwasher hums but motor does not run. I've taken the inside apart down to the disk-shaped impeller. It turns freely so the pump and motor are not stuck. When control knob is turned motor hums at the places where it normally should run. The water valve & heating coil seem to be operationg normally. i assume the next step is to test the motor &/or motor relay. Is this correct and how do I do that?


... Dishwashers

I HAVE A BOSCH SHU5305 DISHWASHER THAT WHEN IT IS TURNED ON IT WILL NOT DRAW WATER FOR THE WASH. IT JUST SITS THERE AND HUMS. HAD A BIT OF WATER FROM THE SINK BACK UP IN THE DISHWASHER AND SPILL OVER ONTO THE FLOOR YESTERDAY. I CLEANED THE DISHWASHER FILTER WHICH WAS COMPLETELY CLOGGED. I THINK THE DISHWASHER WORKED FINE PRIOR TO THIS INCIDENT BUT THIS COULD ALL BE COINCIDENCE. I DON'T KNOW IF I HAVE A PLUMMING PROBLEM OR A WASHER PROBLEM. THE SINK WATER WORKS FINE. I CHECKED THE ON/OFF WATER VA


If the solenoid valve is humming and calling for water, you probably have a plugged screen in the valve, some you can get to and clean, some you have to replace. ... Dishwashers

Dishwasher was making a loud hum. I turned it off and started it this morning. Seemed to be working fine, but after about 5 minutes it started making the same loud hum. The first time it seemed to be between cycles with no water, this time there water moving as normal except for the loud hum.


... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

Disposal plugged up and water backed up into dishwasher. Cleared disposal and dishwasher drain line. Checked around sump but dishwasher won't pump out. Sounds like pump is trying to run. I can blow air through the drain hose from the disposal and get bubbles in the water. Turned off breaker for 1 min. then tried reset. Can hear pump humming.


The pump is humming because its still trying to get all the water out of the unit. Deinstall the dishwasher and pull the entire dishwasher out from under your cabinet. Next step would be to disconnect the drain line from the drain pump and check to ... Dishwashers

I have an avanti dw 18 dishwasher . the problem i am having is the when i turn the on button on the motor goes on however no water fills up. The motor is only humming. But; when i press down the float from inside the machine the water fills up and the machine starts to work. after the water drains again the motor continues to run and hum and the dial does not move. when i manually move the dial nothing seems to change . the motor continues to only hum. Even when the dial is in the stop position


... Avanti Dishwashers

I just installed a new Kitchenaid dishwasher (Model KUDE60FVSS3). After filling with soap, closing the door and starting the machine, it fills with water, waits a couple of minutes and then I can hear low humming noices coming from down below. After opening the door it appears that neither spray arm has turned as if to wash. This dishwasher was purchased new a few years ago and kept in storage as our basement was being finished. This dishwasher has never completed one cycle. Any and all inf


If you have a garbage disposal, there is a plug in the dishwasher that has to be removed for the washer to drain. ... KitchenAid KUDE60FVSS 24 in Builtin Dishwasher

Gianni dishwasher, turns on, but dial control doesn't cycle thru, just has humming sound


... Dishwashers

My Kenmore 363 dishwasher has not been used in quite a while and will only hum when turned on, no water. what can I do to get it working again.


Hello There\015\012\015\012If your dishwasher was working perfectly before this incident and all that has happened is no use, then the problem is with the motor. It's most likely some gunk/dirt has dried up over time and is preventing th ... Kenmore Dishwashers

Dishwasher just hums, faintly, when I turn it on.


Motor is locked up.. if you let it hum faintly for a couple min it will cut out most likely.. thats the thermal trip built into the motor.. the motor assm needs to be replaced.. ... Neff 24 in. S5443X2 Built-in Dishwasher

Dishwasher when turned to usual dial number hums enthusiastically but does nothing, no water, dial does not advance. If dial is advanced manually, some cold water is produced; dishwasher tablet is released but not dissovlved. All rotor arms and water intake areas are free of obstacles and blockage (as far as we can see). Any ideas?


Removed the filter and shopping for a replacement. An "in progress" report - not completely solved yet. ... Dishwashers

Our dishwasher seems to have stopped working over night. The power button comes on and the unit beeps to acknowledge start, but then there is only a very light hum & the unit does not start. No water comes through the unit and it just hangs at the light hum. We have not turned off any water but just checking if there is a simple solution? Adam Hdw100sst


Suspect pump.on start the pump will activate to remove condense water from drying the last load.if the pump does not start then the next step of adding water to start wash cycle will not happen.ensure pump is not blocked ... Dishwashers

Dishwasher GU1500 Whirlpool--motor just hums and blades do not turn. Dishwasher fills correctly and drains well.


This strongly indicates the motor capacitor - normally mounted on or close to the motor. easy to replace and a cheap part. also possible motor seized - disconnect from mains and see if motor turns by hand ... Dishwashers

I have a GE potscrubber portable dishwasher and when i connect the hose to the facet and plug in to the outlet and turn the dial to start the dishwasher up all i hear is a low humming sound. I tried truning the knob around a few times and still the same low himming sound.


I have this same problem with the same dishwasher. Did you ever find what was wrong with it? ... GE Dishwashers

CI am having a problem getting our Miele G575 dishwasher to run through a wash cycle. It definitely has power, the water is on and there is no water in the bottom of the dishwasher. When you turn the dial to start a cycle, it hums but doesn't fill with water and doesn't progress through any cycle. We have tried all positions of the dial and have had no luck? Any ideas??


You said it does not progress...meaning the dial does not eventually move? it may be waiting on a water level sensor to be tripped. The dishwasher is just not filling. The water valve solenoid may be stuck or defective. or a wire may have come of ... Dishwashers

I turn on the dishwasher and it just hums with no water spraying the dishes. I tried the sani wash cycle and it worked but just one time. Now every cycle is the same - turn it on and just the mild motor noise


... Miele 24 in. Novotronic G851SC Plus Built-In Dishwasher

After the dishwasher is finished running they cycle the machine is still humming - there is power on -- only way to turn it off is to turn off the circuit breaker


... Asko D1776 Stainless Steel Built-in Dishwasher

The dishwasher fills with water and heats the water but does nothing that requires the motor to turn. It turns easily with my finger rotating it, but not under its own power; no click, no hum no movement no nothing.


... Estate 24 in. TUD6700KQ / TUD6700KT / TUD6700KB Built-in Dishwasher

My dishwasher turns on but dosn't clean dishes.when I press the drain to turn off its makes a humming noise like its stuck


Your pump needs replaced due to bearing is wore out. ... Maytag 24 in. MDB6100A Built-in Dishwasher

Dishwasher won't drain nor will the lower arm rotate and spray. When turned to the ON position it just makes a clank noise (like a motor is trying to turn on) and hum for a short bit. Nothing afterwards. There is water standing in the basin.


I don't know if this is unusual or not. But, I found A solution. Thinking about what I said in the problem descriptor, I disconnected the power to the dishwasher. Got to messing around with the electric motor and found it was seized up...don't kno ... Hotpoint 24 in. HDA1000G Built-in Dishwasher

My Maytag jetclean dishwasher, (model#MDBD820AWW)when turned on just makes a humming sound, and no water enters the dishwasher.


HI. First, i recommend checking to make sure you are receiving water from the pluming. Check to see if the water shut-off valve (located under the sink) is open. If you get water to the dishwasher, but there is still no water inside during the fill c ... Dishwashers

When i turn my Viking dishwasher on the motor starts to run but no water comes out. It was humming along for several hours before i realized that nothing was really happening. I turned it of and then tried again but the same thing happened. It sound like a motor and/or pump working but no water enters the chamber. Thanks, Jonathan


It sounds like the Water Supply Solenoid is bad. I would change that and let all of us know what happens. ... Dishwashers

Dishwasher not cleaning. Dishwasher turns on, fills and then hums. If we hit cancel, it drains fine. No water sprays around inside.


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... KitchenAid KUDR01TJ Dishwasher

I have a Bosch shu43 dishwasher that just hums when turned on.The timer counts down but I can't hear water running through it. At different times in the cycle it will hum but no other sounds, it won't clean.


... Bosch 24 in. SHU43 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1753 seconds