Having problems with your Neff 24 in. S5456 Built-in Dishwasher ?

The top arm will not rotate.Have checked to make sure that no holes blocked and arm rotates freely.Bottom arm works ok


Answers :

Check the transfer pipe that takes water to the top arm, it could be cracked, loose, kinked or blocked. Try back pressurising it from the top rotating arm attachment pipe. This will give you an indication where a leak could be or blow out a blockage.
Repair Help & Product Troubleshooting for Neff 24 in. S5456 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The top arm will not rotate.Have checked to make sure that no holes blocked and arm rotates freely.Bottom arm works ok


Check the transfer pipe that takes water to the top arm, it could be cracked, loose, kinked or blocked. Try back pressurising it from the top rotating arm attachment pipe. This will give you an indication where a leak could be or blow out a blockag ... Neff 24 in. S5456 Built-in Dishwasher

I have a De Dietrich DV640JE1 built in 45cm Dishwasher, working fine for over 3 years. After replacing the connection under the sink to fix a leak it has stopped working. But I dont think this is related. I run a cycle and it fills water in the bottom of the machine, it drains it out in the end but the 2 arms are not rotating and no water comes out. I checked the arms and they are not blocked. A faint clunking sound can be heard at some part of the cycle. I did also run a cycle with the dr


Hello Benny,\015\012\015\012It's highly unlikely that replacing the connection under the sink is related to this problem.\015\012\015\012From the symptoms you describe, it's almost certain that the circulation pump motor has f ... Dishwashers

Maytag MDB5000AWW started making noise when cleaning. Bottom arm working , but water isn't pumping with much force. No water coming out of top hole (removed arm to make sure there is no obstructions. Checked down to the impeller (didn't remove), and didn;t see any blockages, etc.


HI\015\012Motor malfunctions usually call for service by a professional. There are three main causes of motor failure: lack of lubrication, a defective motor switch, or worn or frozen bearings. A humming sound can be related to a burned-out mot ... Maytag Dishwashers

Figidare dishwasher Upper arm not rotating, no water coming from top hole to fill upper arm.Lower arm rotates shoot water up cleaned filter screens. Check ball seems ok by pump, is there a location it (ck ball) should be? My upper arm is not rotating, things are coming out crusty, and it's definitely not getting water to the upper arm. My check ball seems to be plugging the tube the water goes up in.


It seems other posts were correct - The upper arm doesn't spin all the time. Once I learned that, and let the dishwasher cycle through, I saw that the upper arm does spin. So, there wasn't a problem with the upper arm afterall. That doesn't solve ... Dishwashers

Figidare dishwasher Upper arm not rotating, no water coming from top hole to fill upper arm.Lower arm rotates shoot water up cleaned filter screens. Check ball seems ok by pump, is there a location it (ck ball) should be?


Read on another site that if the dishwasher is not near being perfectly level, this can happen.  The check ball moves back and forth allowing water to get to the upper arm sometimes and the lower arm at other times.  The upper arm does not ... Frigidaire 24 in. FDB435RFR Built-in Dishwasher

Do4esnt clean My Bosch SHX33a05 dishwasher has a problem. It fills and drains well but nothing gets clean. It appears as if the arms are not rotating but the inside is wet when I look inside. I have put a bit on catsup on the inside door and even that is on at the end of the cycle. I have opend and clodes the door multiple times during the cycle and bot arms appear to not be rotating. Nothing is blocking them. I have clean the microfilter, the drain screen and open up the impeller to make sure t


... Integra SHX33 Dishwasher

My deceased parents have a GE dishwasher (don't know the model number - can't find it on the machine and can't find the paper work) that stops working shortly you start it and displays a message on the front panel that says "Blocked wash arm - check for wash arm obstruction - restart". We restart it and get the same message shorty thereafter. This happens when the washer is COMPLETELY EMPTY, even when we remove the bottom rack. It first started after several month of inactivity. We'll just t


Could be false sensor input, could be that the arm is not turning, I am not sure how old your machine is, but age could play a part if the arm is "in fact", not turning. If you are not mechanically inclined, I would suggest that a qualified repairma ... Dishwashers

I have a Bosch SHX98M dishwasher and the top arm will not rotate. I can see water coming out of the holes when open during a cycle and I have made sure there are no obstruction for the arm or anything stuck in the arm feed line. I just had a technician here who was at a loss and did not think the pump was bad since alot of water is being pushed around inside. The bottom arm works fine.


... Dishwashers

My GE dishwasher, model # gsd2230f00ww won't drain. The spray arm is working and i hear the motor. Checked both ends of drain hoses, very clean. took sum cover off, clean. checked float, fine. What could be the problem? solenoid? I turn the dial on the washer and the solenoid does nothing, should it make a noise to actuate the drainage? please help! Thank you


... GE Nautilus 24" Built-in Dishwasher

Danby DDW396W-2 Spray arm won't turn have checked pump, appears to work, spray arm is clean, drain hole clear, lines clear, HELP


I have had a similar problem numerous times, a couple of which required\015\012manoeuvreing it into a place I could work on it, and a laborious\015\012removal of the covers. Each time, up until this current incident, the\015\012solution that worked, ... Danby 22 in. DDW396 Free-standing Dishwasher

GE Quietpower 2 spray arms not rotating. Sounds like pump is working and water is moving inside but arms are still in same position when I check to see if they've moved. Of course the dishes don't get clean. What's up with this?


... GE 24 in. GLD5560LSS Stainless Steel Built-in Dishwasher

After a regular dishwashing cycle, our dishes and glasses are not getting clean. They are left with a white film. We have checked and all holes in the spray arms are open. We have tried a rinse agent, too. The upper arm gets blocked when we spin it when open ... probably not spinning well in the cycle. any ideas to fix it would be great!


Hi Please check if something is blocked near the top spray arm, also make sure that all holes are open. Use a sharp metal pin to clean the holes on the top spray arm. Make sure the water pressure i ... KitchenAid KUDR24SE Built-in Dishwasher

I have a Whirlpool Dishwasher DU1345XTVB about 5 years old. It functions perfectly but is not cleaning the dishes well particularly the top rack. The arms spin, soap dispenser works, cycles properly--just doesn't get the food off. I checked the arms to see if the are blocked but don't appear to be as the dishes get wet. Thanks


There are a few things to do. The water temperature is a big contributor, in dishes not getting clean. Another is the type of detergent being used. Liquid dishwasher detergent with water softeners and a drying agent will help loosen food too. If ... Dishwashers

Bosch 9925 - water comes in and drains - but not enough pressure to make water comes out of rotating arm more than about 6 inches. Do I need a new pump? I cleaned all holes and filters. How do i access the pump - through the inside of the machine? Thanks. LDS


DO YOU HAVE AN ISSUE WITH HARD WATER IF SO TAKE 1 GALLON OF VINEGAR START MACHINE LET MACHINE DRAIN THEN WHEN IT STOPS DRAINING OPEN DOOR AND FILL WITH VINEGAR THIS WILL PUT ADIQUATE AMOUNT OF LIQUID IN MACHINE TO RUNDON262-893-4840 ... Bosch Dishwashers

My kitchenaid dishwasher kudl03fvss0 is leaving disher dirty, specks of debre are allover the dishes, and the door is has debrie on it. seems like the dishes are either not getting sprayed well i have checked to make sure nothing is blocking the spray arms on the top and bottom and i use a rinse aid any ideas?


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... Dishwashers

I have an asko D3450 dishwasher. Washer makes buzzing/humming noise at start of cycle and then randomly through cycle. I checked the sump and pump appears to be clean and impeller spins freely. The cycle seems to work ok. Water is pumping out ok. If you open the door to stop the cycle, the buzzing will continue for a few minutes then stop. If the cycle is restart, the buzzing starts again. The vibrations seem to originate from under the lower spin arm.


If the sound is a bussing - it is the capacitor mounted to the pump. It is failing.Shown here (big white cylinder on right of pic).. ... Asko 24 in. D3450 Dishwasher

The unit goes through its cycles but the top rack is not getting clean. The bottom spray wheel works, the middle and top spray arms are getting water but it seems not enough to make them rotate. The pump screens are clear and there seems to be enough water. Whats going on?


The problem is likely to be that the jets in the rotor arm are blocked.\012\012To check this, remove the arm (it is easy to do, as it is intended for the user to do this) and clean out all the holes. Try running water from you tap through ... Dishwashers

Noisey maytag We have a maytag quiet series 300 with the 3 racks. Just recently we have been hearing alot of noise from our dishwasher while it is in the washing and rinsing mode. We have checked the arms to make sure they are moving but doesn't seem to be a problem. Thought maybe there is a liquid that we could pour into the washer to run through it's cycle? Of course we know nothing about the inter works of a dishwasher.


Hi, i had the same problem twice and both time there was some plastic stuff in the shredder. Remove the screw in the middle and remove the cap and you will probably find some pieces near the blades. ... Maytag 24 in. MDB5651A Built-in Dishwasher

Have Fisher-Paykel DD603 double-drawer dishwasher. Top drawer motor making loud noise. )Bottom drawer fine.) Still seems to wash and definitely pumps water but sounds like a "motor with a broken belt." Checked filter and rotating spray arm - no problems. (Found a little broken glass in filter; could be very old.) Suggestions?


If glass has gotten past the screen and into the pump, you may have a pcs. logged in the pump housing.\015\012Best way to correct this, is to remove the pump inlet and outlet lines and flush out with a water hose.\015\012Keep ... Dishwashers

Our dinner plates hit the rotating arms of the jets. We have checked the manual and we are loading correctly. Just doesn't make sense.


Solution - there are 2 sets of rollers about 2 inches apart. You just click off the stoppers at the end of the sliding arms on the top shelf, take out the rack and put it back onto the higher set of rollers!!! ... Hoover Dishwashers

My Bosch classixx has started making a terrible squeaky noise during the cycle. And it isn't washing stuff as well. I have checked the spray arms and they are not blocked and they are able to turn.


Build up of calcium clean your hoses check your lines they maybe blocked sound like a high pitch squeak something is stopping it from getting water ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

My GE dishwasher model # GLD6560l0ss makes a horribly loud noise when started and continues through the whole wash cycle. I have checked to see if anything in blocking the arms or maybe it's not closed all the way but nothing is in the way? Any suggestions?


... GE 24 in. GLD6560LSS Stainless Steel Free-Standing Dishwasher

Motor making loud noise. checked filter and rotating arm - no problems. seems to wash dishes or at least have water in during cycle . . .


HiSeems the noise is from foriegn debris( ie.chicken bone of pistachio shell, toothpicks) getting into macerator/chopper assembly, wouldnt panic just yet, give it a fewloads to try to clear itself, a few screws leading down through the top of m ... Fisher and Paykel Dishwashers

Kuppersbusch IGV 645.0 built in dish washer has started to make its audable intermitent beep alarm, with start light flashing, have checked the (rubbish) instruction manual it suggests filters are blocked but they are not, turn it back on and it sounds as if its working but just keeps beeping, can you advise pleas?, The last time this happened I turned it off at the mains for three hours then turned it back on to find the alarm had cleared


... Kuppersbusch Dishwashers

Noisy dishwasher My Kitchenaid dishwasher has always been very quiet -- now, it's making a fairly loud grinding noise. It still works fine, water coming out, arms turning -- I'm just wondering if I should get it checked out. Thanks.


... KitchenAid 24 in. KUDP02CR Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1483 seconds