Having problems with your Neff Dishwashers ?

The washer still has water in it , It has stopped , there is a red light next to the tap svmbol on the controls ( don't think I've seen that lit before )


Answers :

Are you please able to provide the model number of the dishwasher.
\015\012
\015\012Also please confirm which cycle was it on and how far into the cycle did it stop. For example was it still swishing the water around in wash cycle or draining water out.
Repair Help & Product Troubleshooting for Neff Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The washer still has water in it , It has stopped , there is a red light next to the tap svmbol on the controls ( don't think I've seen that lit before )


Are you please able to provide the model number of the dishwasher. \015\012\015\012Also please confirm which cycle was it on and how far into the cycle did it stop. For example was it still swishing the water around in wash cycle or drain ... Neff Dishwashers

Model # KUDSO1DLSS1 Kitchenais dishwasher - had a burnt electric smell coming from the area of the touch pad (not the vent). Did "some" research and decided to replace the control board - smell went away - ran 3-4 cycles over a few days and then - no lights - tried a new control board (thinking the old defective) - nothing - replaced the thermal fuse - nothing - what next????


... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

My frigidaire dishwasher FDB1502RGC4 will not run a cycle. it will fill and drain the water but will not run a wash cycle. all the lights on the control panel lightup when they should. so i dont think it is a fuse. and there is not much i can see after i opened the front door, the control module and the console assembly. could it be one of these.


Having the same problem with mine, just replaced the discharge pump last week because it went out, worked a couple days now this. still have not figured out the problem ... Frigidaire FDB1502RGC Built-in Dishwasher

Control Panel On the control panel there is a light right next to the "Heated Dry" button that is on. It looks like a "3". It's lit up - and never has been before, and I can't get the dishwasher to start. How do I make it go away?????


I did not use your service to fix my problem - I found the answer on Maytag.com. But you charged me anyway - so I would like that money refunded. ... Maytag 24 in. MDB9750AW Dishwasher

I have a KitchenAid dishwasher model#KUDC25CH.The problem that I am having is the touchpad control panel all of a sudden is lit up like a Christmas tree. Just about every red indicater light is lit. The DW will run but I dont know what kind of wash it is performing or at what stage the cylce is in. I have tried canceling the cycle,I have tried child lock/unlock,I have cut the power to the unit for a few minutes hoping the computer panel would reset itself. I am affraid to run the unit in fear th


... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

I have a dish washer matsui model mf2w/a and the timer seems to be sticking causing the machine not to wash correctly, the machine carries on doing the same thing until i manually move the timer control knob on to the next setting , do you think the timer isfaulty or another component .


If your Matsui MF2W/A timer stops earlier in its cycle, turn off the water and unplug the machine. Pull it out and put it on its back. Remove the base panel. Remove the anti-flooding interlock. Unplug the two cables feeding the heater element ... Dishwashers

Hi! I dont have a User Manual for my dishwasher HJA8630 (Lamona). I cant get it to run- despite the fact all lights are lit on the control panel in the door. Can someone advise pleae?! Thanks, Lauren


... Dishwashers

I have a 6th sense dishwasher purchased new October 2004. It has been working properly and then has just stopped the next time I tried to use it - it will not turn on no matter what buttons I push - no response. I have checked the power out let with another appliance and that works so it is not the power supply from the power point. I can only think it must be a fuse or the controller. Can you please advise best course of action? Thanks Helen


I rang the appliance man to fix the problem.\015\012\015\012Thanks anyway Helen ... Westinghouse Dishwashers

Asko d3250 i think dont have water presure because he take the water inside and then star the cycle and drain the water but i think the blades dont run i lisent a smal noise of water


First I would check the water line from the sink that is hooked up to the dishwasher.You may have a screen that plugged up.Also, if you have little pressure at your sink faucet, then you should check your house's water system. ... Asko 24 in. D3250 Built-in Dishwasher

I have a mdd8000aws dishwasher. After a power outage (2 days) the power came back on, and the bottom drawer no longer works. It still make the chiming noise when the drawer is opened, but the control panel is not fully lit up and the washer will not start in any mode. The lights seem to flicker for a short moment and then they all stay very lightly lit up. Is this just a bad control panel or is there some other circuit that needs replaced? BTW, the top drawer works perfectly.


... Maytag MDD8000AWS Builtin Dishwasher

Frigidaire dishwasher Rylee, the circuit breaker is fine. There is no fuse on the dishwasher according to the owners manual, the parts manual and the wiring diagram. There is no timer selector switch on this model. While I changed the control circuit board, the only other thing I can think it would be is the control panel with the buttons on it. What do you think


Hi Todd,As a rule:\015\012\015\012Black Smoke = Unburnt Fuel, incomplete combustion, bad mix\015\012Blue Smoke = Burning Oil\015\012White Smoke = Water Va ... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher

Control panel will not light up, the dishwasher was running and now it has stopped mid cycle and will not do anything. I just replaced the control panel (black plastic with buttons, not control circuitry). was running the diswasher and it seemed to be working fine, then stopped. water is standing in tub, I checked the float, I don't think the float is the problem. There is power to the outlet, no tripped breakers. But control panel will not light up.


I have a kitchenaid dishwasher model # KUDC10FXBL1 I went to start it and none of the buttons were working. I have checked the breaker and the wiring and everything seems to be in order. ... KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

My Whirlpool Gold Quiet Partner III dishwasher will not start. I have installed a replacement control board that worked for awhile. When it quit I put the old control board back and it worked for awhile with a portion of the lights on the control panel lighting up. After switching control boards back and forth, it will not work at all now. It will run through the diagnostic program (Normal, Heated Dry, Normal, Heated Dry) but after that the start button plus other buttons are not lit so it will


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Hi ive got a karcher k.3150 ive only had it 2 months and ive gone to use it the 3rd time and the detergent is not coming out of the container and ive done all checks-blockages etc and dont know why its not releasing the detergent?...the clear pipe is not sucking the detergent up when the machine is on and the lance is set to mix


This seems strange, as it is under warranty you can take it back or contact them about the situation. It depends were you purchased the machine but if it is a manufacturers fault they will fix/replace it. ... Karcher Pressure Washers

MDB6709AWW1 Poor Quality Control Panel Our dish washer is 2 years old this month and the control panel broke!!! My service technician told me that he has seen DOZENS of new Maytag dishwasher control service panels break and is convinced it is a design flaw. When I called Maytag the customer service rep had the NERVE to tell me "that because the house is near the beach, I must get a lot of power outages and power surges, that is why the control panel broke." I told her I wasn't born yesterday


... Maytag Dishwashers

Power is off to the control panel on my Whirlpool GU2400. This happened once before and there is a code the service man used to get it started again. I want to use that code so that I dont have to h


... Whirlpool GU2400XTPS Built-in Dishwasher

Dishwasher Normally, after the dishwasher cleans the load, it displays green light next to clean. Once the door is opened, the light goes off an dishwasher is ready for next load. But from few days, after opening the dishwasher door, the clean light does not go off, it remains lit. Dishwasher doe snot reset for next cycle. So, I have to go in the basement and trip the main power to dishwasher. That resets the dishwasher. This needs to be done before each cycle. Not sure how to resolve the issue.


Make sure that you do not open the door during the wash cycle. Wait until all the cycles \015\012are complete before opening the door. Especially don't open the door \015\012during the drying cycle. ... Dishwashers

When I press the start/resume control, the dish washer start/resume light blinks 2 to 3 times, then turns-off. then the dish washer beeps several times; however, the dish washer does not start. when turned the breaker switch off and on, and then I press the start/resume control, the dish washer go through a normal wash cycle. The next day when I press the start/resume control, the same thing happens. 2 to 3 blinking lights followed by beeping for several seconds. Dish washer does not start


... KitchenAid KUDC10IXSS Builtin Dishwasher

I have a KitchenAid dishwasher model KUDC10IXWH1 that has no control power. I have already verified that there is 120V at the control board. The unit kept the lights on after the cleaning cycle was done and I couldn't shut them off. I reset the electrical breaker and now nothing works, but the board has power. Please give any advice you might have. I was thinking of replacing the board, but I'm not sure if it is the board or the front control panel. Any way to tell?


... KitchenAid 24-in Built-In Dishwasher White ENERGY STAR KUDC10IXWH

Maytag model MDB5600AWB replaced faulty control panel started and lit up like it is supposed to do started wash with glisten cleaner and when I tried to cancel drying cycle panel or board would not respond, waited till unit was finished and control panel blinked and went dark , bad control board?


... Maytag 24 in. MDB5651A Built-in Dishwasher

Our dishwasher was taking in water, circulating it but not heating it up or moving through the cycle. My husband took the control panel off and there were some scorch marks on it so we got a new one. He replaced the control panel and the dishwasher went fine for one night. It heated up and washed everything perfectly. The next day when we put it on it was back to square one plus the lights on the control panel are now not working. Just wondered if anyone has any idea what we could do or are


Yes it's time to visit the dump ... Siemens 24 in. SE64A630GB Built-In Dishwasher

I have a bosch shu312uc with a few issues 1. takes forever to count down (pretty sure its a control module) 2. dishes dont clean - smells terrible like bad water (could this be a result of the control module??) i checked to see if the trap was clogged, it didnt appear to be. any suggestions??


Hello Cliff, The first thing which comes to mind when I read your post is 1) your on the right trac, and 2) this is a very common occurance with B/S/H ( Bosch, Thermador, Gaggenau ) manufactured dishwashers, a failed solder on the control board, spec ... Bosch 24 in. SHU53 Built-in Dishwasher

I think I am finding small pieces of the wrap from the tablets in the small holes in the spray arms, one wont move anymore??? This is about 10 yr old maytag machine. I tried to clean out the spray arms but dont really know what I am doing. Bought a new diswasher, dont want to use the tablets if they will clog up the works. please advise.


Just prime the sink before you start the dish washer ... Maytag Jetclean II MDB8551A Dishwasher

Not draining Hey I have a whirlpool(model # DUB50DWGB1) and Ive hooked it up and it wont drain. Ive taken the filter off and checked the bottom hose and it drains. I think that it is the pump is not pumping up to the gargbage disposal. If the gargbag disposal is not hooked up, would that be my problem? Thanks for any help taht you can give


Hi and welcome to Fixya, \015\012 \015\012I'd suggest you are correct in your suspicsion of the disposer being a likely problem. \015\012 \015\012Start by checking the drain spout of the dispose ... Whirlpool Dishwashers

I have a GU1500XTLB1, type-575-0 Whirlpool Gold dishwasher. For the last couple of weeks I've been getting the control lock on. I got the manual out, I hold the air dry button and it clears. My problem is now when I turn the machine on dosen't matter which cycle I hit (pots and pans, normal, or quick wash) it runs for about 5 minutes and it goes into a mode with the timer having lines going horizontal with the air dry button lit up and rinse button lit up. It sounds like it starts the cycle


Hi,There are Few Tricks to Reset this. Follow the below Tricks :-1. Try holding down heated dry key for 5 secs. I believe that is the control lock/unlock button on your model. IF not, look for the lock symbol and follow same i ... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0513 seconds