Having problems with your Northstar Gas Powered Wet Steam & Hot Water Pressure Washer 3000 PSI ?

Heater will not lite - Northstar Gas Powered Wet Steam & Hot Water Pressure Washer 3000 PSI


Answers :

Donnie I have same problem, did you get it resolved?
Repair Help & Product Troubleshooting for Northstar Gas Powered Wet Steam & Hot Water Pressure Washer 3000 PSI

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Heater will not lite - Northstar Gas Powered Wet Steam & Hot Water Pressure Washer 3000 PSI


Donnie I have same problem, did you get it resolved? ... Northstar Gas Powered Wet Steam & Hot Water Pressure Washer 3000 PSI

Northstar Hot Water Pressure Washer (model #157322) While using the pressure washer the safety relief valve activated venting steam and hot water from it... I immediately shut it down and let it cool down. After it was cool, I turned on the water supply again and the relief valve was still spewing water from it. My neighbor said it was probably the "unloader" valve was stuck or damaged. I called around my area and it seems as though no one services my pressure washer.. Is there a manu


... Pressure Washers

Heats for a few then shuts off - Northstar Electric Wet Steam & Hot Water Pressure Washer 2000 Psi, 1.5 Gpm, 120 Volt


... Northstar Electric Wet Steam & Hot Water Pressure Washer 2000 Psi, 1.5 Gpm, 120 Volt

I have a Karcher G2600 OR Pressure Washer, 2600 psi, 2.5 gpm. PN 1.194 506 0. gas engine works fine and water flows fine but pump is not adding pressure to stream. Checked and cleaned inlet water filter.


... Pressure Washers

Hotshot over heating - PressurePro Pressure-Pro Hot Shot Series 4000 PSI Hot Water Pressure Washer


There r three devices which can cause overheating.1)-thermastat(stuck in close circuit2)-pressure switch and or flow switch stuck in close circuit. 3)-fuel solenoid stuck open located at fuel pump ... PressurePro Pressure-Pro Hot Shot Series 4000 PSI Hot Water Pressure Washer

Brand new Northstar hot water pressure washer, 2000 psi, electric and Diesel fired burner. The burner will not come on??? It works ok as a cold water unit but the burner will not fire even with the Heat switch on and fuel in tank?? What could cuse this?


... Northstar Wet Steam & Hot Water Pressure Washer with Honda Engine 3000 Psi, 4 Gpm

I have a northern 3000 psi hot water pressure washer everything works but the burner will not fire up to heat the water


If it gettin diseal to nozel it ur photocel r thermostat ... Northstar Gas Powered Wet Steam & Hot Water Pressure Washer 3000 PSI

Won't pump out water - Cam Spray ST Series 3000 PSI Hot Water Natural Gas Pressure Washer


... Cam Spray ST Series 3000 PSI Hot Water Natural Gas Pressure Washer

Does it hurt a pressure washer to run hot water thought it went they hook up the water for outside to hook it to the hot water i did not no it and i hook it to the pressure washer


Most pressure washers have packings that can sustain a temperature of 140 degrees although it as strongly not recommended since the pump head heats up when in bypass mode(triggergun closed)best rule for pressure washer is never leave the trigger clos ... Karcher 2500 PSI Pressure Washer

North star 4000 psi 7gpm hot water pressure washer coil replacement


... Pressure Washers

The Hom Model No. 308653045 gas-operated cold-water pressure washer has a spring-loaded control on it and I am assuming that this control regulates the output pressure of the water from the pump . . . for example, 1500 psi to 2700 psi. Is it correct to assume that this control regulates the output pressure of the pump. If the control is a pressure regulator, how does one use it and, EVEN MORE IMPORTANT, can one under-adjust or over-adjust the control to a point where THE CONTROL OR THE PUM


... Homelite Pressure Washers

I have the Coleman powermate 2400 PSI pressure washer and on initial start it sprays and has great pressure. But once I release the spray handle it will not spray again, not even one drop of water. I have verified water pressure, bought 3/4 hose, and also changed the spray handle with no help. Pressure washer was bought new at Lowes, but did not use for first three years of ownership, should have tested it. Thanks for any help on this. Ted Miller


Sounds like the valve in the handle is sticking closed. May have a broken spring, or maybe a part is stuck..\015\012I say take it apart, and the answer will present itself.. Play with it with nozzle out too... Maybe something is stuck after st ... Coleman Pressure Washers

Dear Sir?madam, I bought a CV-240 4 MBC HONDA PRESSURE WASHER , 2400 PSI , 5.5HP, It is 4 stoke overhead, cam single cylinder , October, 2010 from NATIONAL HARDWARE SUPER CENTRE – GUYANA. I used this equipment sparingly during this year. I have 2 – 450 gallons plastic water tanks to supply the pressure with water. Recently, water is not coming out through the pressure hose. I talked to a technician, and he opened the water pump and there is some white plastic valve, one was broken and he repl


... Karcher 2500 PSI Pressure Washer

Hi ..I have an Excell gas pressure washer model no. Exwgv2121-3 with Faip 2100 psi 2 gpm vertical shaft pump..the problem is that there is water leaking from every weep hole at the bottom of the pump when running. Oddly enough,the pump still puts out significant pressure but less than it should due to the leaking water. What is the most likely cause of this?..is it the high pressure water seal(s)? If so,how do I repair it?


... Pressure Washers

Kenmore Elite Stainless Steel 24 inch tall Model 66577963K701. The heating element works for "heated dry" but not for "Hi Temperature" wash. It used to do so and when I opened the door a nice blast of steam would come out. My hot water tank is a great distance from the washer so we usually run the hot water tap in the sink for a bit until hot water comes... but the heating coil no longer kicks in on any of the cycles (Smart Wash / Normal Wash ). The high limit switch works and as I said, th


... Kenmore Dishwashers

Assembly plans for karcher 2400 psi pressure i recently had a problem, with my pressure washer. i was cleaning out my hose and took the hose assembly and brass fitting off. run water threw it thought i had cleand it out, put it back together and now when i hooked my water hose back up the water comes out of the despencer instead of the pressure wand. does eny one no what i need to do to revurse this?


... Honda Karcher G2400HH-R Pressure Washer

2-yr old troy-bilt pressure washer with honda gcv160 engine. seems to run well, but when trigger is pulled get full pressure for less than 5 seconds before reducing to house water pressure. when left running, looks a black plastic pressure relief valve starts blasting hot water. appreciate whatever insight you can give. Thx


It sounds like an air lock. Try this: With the machine off, connect the hose to the washer and let it run for several minutes to get all of the air out of the hose, and to purge any air out of the pump. Shut off the water, and connect the high pre ... Briggs & Stratton Pressure Washers

Sistema psi 1700 psi pressure washer low water pressure


... Psi Sistema GT11 1400 PSI Pressure Washer

We have a Pressure washer 2600 PSI it is hooked up to the water line and we have a bucket of mix of 50% bleach and 50% water there is no suction coming from the line into the washer to mix with the water Why?


You need a soap nozzle to lower the psi is call downstream injection. ... Electric Pressure Washers

I have a 2300 psi gas pressure washer, campbell hausfeld, runs fine but water comes out the nozzle like a hose , no high pressure. inlet filter is clean and when you pull the trigger on the nozzle water comes out like a hose but no pressure


If you no longer have High Pressure coming out while machine is running, it's a pump issue. ... Campbell Hausfeld PW2575 Pressure Washer

No water pressure - Simpson WB4200 Water Blaster 4200 Psi Cold Water Gas Powered Pressure Washer W/ Honda Engine


... Simpson WB4200 Water Blaster 4200 Psi Cold Water Gas Powered Pressure Washer W/ Honda Engine

I have a 3000 psi karcher pressure washer with honda engine, the problem is for a while the pressure would kick in and out, now only water hose pressure, the water supply is fine, what is the problem


Sounds like you need a seal and bladder rebuild < if you liver in a cold environmet for winters please dont forget to winterize your washres every year before winter ... Karcher G3025OH Pressure Washer

Two problems please: craftsman 2150psi briggs and stratton engine washer, will not start when hot. and secondly, i was washing with regular pressure, then noticed a pressure drop at the nozzle, then the unit shut down. no water leaks at the manifold. water supply was strong. any ideas?


Nozzle dirty, clean out with small diameter wire. ... Pressure Washers

Dewalt model #4200 psi pressure washer oil - Dewalt DXPW4240 - 4200 PSI Professional Gas-Cold Water Pressure


... Dewalt DXPW4240 - 4200 PSI Professional Gas-Cold Water Pressure

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1767 seconds