Having problems with your Northstar Pressure Washer 3000 PSI ?

Motor starts on first pull. Runs for one minute. Shuts itself off. By passed swich. Still doies it. Please help. We have tried all we can. Al Christenson 507-390-2724 -5


Answers :

Hello. Insufficient fuel supply, drain all fuel, disconnect and clean/replace fuel line and fuel filter. check fuel valve for blockage and clean. check as well tank for presence of rust, if any, clean it out as well.

if this did do not help, you have gunk in the carburator. Get a can of aerosol carb cleaner and spray it into the air intake as the engine runs. THis should clear up the problem but if not, the carb. will have to be disassembed and cleaned. J.
Repair Help & Product Troubleshooting for Northstar Pressure Washer 3000 PSI

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch dishwasher SGS45EO2GB/45 does not complete washing cycle. It stays at 1 min left with pump running. I have reset the machine twice at which stage the pump empties the machine and the display shows 0 mins. However, have tried it agin and same problem. Any ideas, please?


... Dishwashers

My Bosch SHU5316UC won't finish cycle. When I turn it on it resets to 13 minutes and goes down to 1 but stays at one and never finishes. Except on rinse and hold where it goes to 1 and stays there. It would run all night if I let it. How do I reset adn try to fix it. I tried to hold POWER SCRUB and REGULAR WASH as suggested by manual and no luck. Any help?


Hello, welcome to FixYa. ... Bosch SHU5316UC Dishwasher

I have F&P DD603 with problem with bottom draw. Once a programme is selected and door is closed, the dishwasher beeps three times then tries to start itys cycle. It then starts but stops every 1-2 minutes (like pause botton has been pressed). If you press start again it starts for 1-2 mins then stops again. I have tried turning off the power and totally cleaned out the dishwasher but no change? Any suggestions?


Hi \015\012When you pull out the drawer, pay attention to the bottom near the bottom front panel, you will see a little tab. this tab is at both sides of the drawer, press these tabs in and pull the drawer fur ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have an electrolux wt30 m/n LS6 dishwasher, trying to find a wiring schematic so I can try and rewire it to operate on 220v 1 phase, presently it's wired for 220V/3 trying to find a site that may offer a parts and repair manual w/ schematic would appreciate some help in resolving this problem


... Electrolux Dishwashers

DISHWASHERHD98E I stopped my dishwasher a minute before the cycle had finished. Now when i try to start it up again the 1 minute number comes up but gets stuck on this so that the 1 minute does not end (fan can be heard working) and I am unable to reset the programme. What can i do to overcome the problem.


You have probably flooded the base of the machine and it now is in flood mode take side panel off and have a look and drain water away common fault ... Hoover 24 in. HD98E Built-in Dishwasher

My Candy CDI 2012 beeps loudly when I try to programme it in 1,2,3,4 or 5. It will not commence any of the programmes. I have tried every button, but the inactivity, apart from the beeping, continues. Any solution?


... Dishwashers

GE GLD6360L15SS. Dishwasher stopped mid cycle and the Start / Reset button is flashing. The washer will not restart. Tried unplugging for 1 min and flipping breaker for 1 min. No change.


... GE 24 in. GLD6360LSS Stainless Steel Built-in Dishwasher

Hi, our new home us the KUDP02CR Built-in and we have two issues: 1) dishes on top and bottom are coming out dirty; unless we scrub very food particle of dishes and cutlery they just won't come out clean. Either food is baked on or cutlery/glasses/plates have a cloudy residue 2) the soap dispenser doesn't always open; we've tried cleaning it ourselves but to no avail. Sometimes it opens, sometimes it leaks out the liquid and other times it's still shut . Any help would be great. We've tried


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... KitchenAid 24 in. KUDP02CR Built-in Dishwasher

Soap has collected and hardened inside dishwasher and comes off and flakes on the dishes. I have tried cleaning with a few cycles of 1 cup vinegar (no dishes) and making sure the water is the hottest. I also tried Dishwasher Magic which did not help at all. Can I use Lime Away? Is that safe? Or will that poison me with the next cycle of dishes? Is there another solution? Thanks, Missi Walkyourbike


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Kenmore 24 in. 16039 Built-in Dishwasher

I have a Sears Kenmore Elite Ultra dishwasher 665.1315 model. For the last 3 weeks, it keeps having the clean light blinking 6 times pause then 1 blink and pause and repeats cycle again. I have turned off the breaker...I have reset by pressing the heated dry and normal wash until all lights are flashing. It then completes some type of cycle and looks ok. When I opened the door, steam came out and all was hot inside. However, once I try any new wash cycle, it seems to wash but after 1-2 hours and


Call sears service and tell them you need service there is a service flash and will be no charge ... Kenmore 24 in. 15932 Built-in Dishwasher

Disposal plugged up and water backed up into dishwasher. Cleared disposal and dishwasher drain line. Checked around sump but dishwasher won't pump out. Sounds like pump is trying to run. I can blow air through the drain hose from the disposal and get bubbles in the water. Turned off breaker for 1 min. then tried reset. Can hear pump humming.


The pump is humming because its still trying to get all the water out of the unit. Deinstall the dishwasher and pull the entire dishwasher out from under your cabinet. Next step would be to disconnect the drain line from the drain pump and check to ... Dishwashers

Miele dishwasher optima G 2420. during instalation and test for water hardness display shows 'P' then '1' then '0'. is this a water hardness of '1' or of '10'


... Miele Optima G2470SCSF Dishwasher

Kenmore elite dishwasher model #665.13942k010 is 1 yr old and stuck in rinse mode..tried combo button pushing....no lights or beeps....tried the breaker in off position....blue light keeps flashing rinseing with 3 bars.....appreciate the help Thanks Steve


... Kenmore Dishwashers

On my bosch shu66 diswasher the error code indicates a number 1, aqua sensor I think. There is a screw missing in the soap dispensor and it's been letting water into the door interior. could this be repaired by replacement of the screw and drying out the interior insulation and wiring The solution I tried didn't clear the error code on the panel. Is there a reset or do I need to replace the aqua sensor or ? The machine still won't start and displays a #1 on display. There is no water in the whi


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a Kenmore elite ultrawash HE dishwasher Model 665.13129K700 , serial # FU3801153 , Stock # 13129K , Type 586-0. My normal wash red light flashed constantly and will not allow me to reset the control panel. I disconnect power for 1 hour then it allowed me to run 1 cycle. Upon completion the normal wash red light started flashing again. I tried to toggle between high temp wash and heated dry but no other button will work since normal wash is flashing. I again disconnected power but this tim


Hi,Push push thishi temp wash / heated dry hi temp wash / heated dry hi temp wash / heated dryIf this does not reset the control then you will need to replace the control board.Let me know,if needed fur ... Dishwashers

Goes down to 1 minute and will never finish. If you turn it off and try to start over it starts at 13 minutes then goes down to 1 minute again and never turns off.


New control board. ... Bosch SHU5315UC Dishwasher

Machine doesnt start . when on button is pushed and regular wash button is pushed it goes to agent and cycle is at 0 flashing (both 0 and agent lites).have tried to shut it off and main switch and turned it on and off a few times. and still the same


Because the timer controls many operations, a faulty timer can cause many problems. The timer is a complex component, so you shouldn't attempt a do-it-yourself repair. Test the timer with a VOM set to the RX1 scale. To gain access to the timer, ... Bosch Dishwashers

I will continue to try to drain and does not stop. I reset it and use papertowels to remove watter from tray under pump I will start again but will eventually go back to the same situation of trying to drain but never getting lower than 1 minute left


Two possible areas of suspicion are the drain pump / drain filter that can be faulty or clogged resulting in lower pumping action in the said time . A good cleaning of the pump/ pump filters and drain filters can help to improve the drain pumpi ... Bosch 24 in. SHU6802UC / SHU6806UC Built-in Dishwasher

Hi, I have a Dewalt pressure washer 3100 psi. I want to know why the pressure washer works okay for 1 hour then it stop working completely. the oil is fine, the spark plugs are okay, and when I tried to start it again it does not work. Can you please tell me what could be the problem? This pressure washer is almost brand new I have used it for only like 30 hours for 2 years that I have it. I used it couple times lately but same problem it works for 1 hour then it does not work any. I will


There are two common issues that will cause what you are describing. What you need to do is run the machine until it dies as you are describing. Then pull the spark plug and check for spark. If you do not have spark you have a failing stater. It is v ... Dewalt DPH3100 Gas Pressure Washer

Hello I am trying to connect my GE GSD680 dishwasher to the drain hose but there seems to be 2 drain outlets. 1 large and 1 small. The small outlet seems to open when I depress the plunger. The larger outlet is capped with a rubber cover. Which one do I use? Thanks!


... GE 24 in. GSD2120C Built-in Dishwasher

Dishwasher lights keep flashing. 1 and 3. tried


... Dishwashers

Replaced control board 447325 in bosch SHU66C05UC/23; FD860300407. What code to select 0,1,2,3,4?


... Dishwashers

Maytag MDB7100AWS when drain button is pushed it tries to drain for 1 second and stops


... Dishwashers

Constant Failure Bought the unit along with other LG products to furnish new home. Problem 1: After first few loads, noticed that the dishes were always wet, the repairman came and said he would try replacing some kind of sensor and that we should run it on the "Sanitary" cycle. Have done this ever since, but should you have to run on sanitary to prevent your dishes from coming out soaking wet? Problem 2: Noticed the inside of the door on the adjacent cabinet was changing colour, found out throu


Problem #1 solution.  Make sure that you are using a rinse aid.  All dishwashers require a rinse aid to assist in drying the dishes.\015\012\015\012Problem #2 and #3 suggestion.  Possible that the door is either warped or not clo ... LG 24 in. LDS 5811 Built-in Dishwasher

My kenmore dishwasher will run part way thru the wash cycle, stop and the hi temp and heat dry lights will flash back and forth and not do anything else. When you open the washer it will have water in it that has not pumper out. It seems that the light wash cycle will work after trying the regular or heavy wash. The washer is 1 1/2 years old. model # 587.15259402


First cut power for ten minutes by unplugging power cord or tripping circuit breaker.If that does not work try the following reset.Press in succession:High temp-air dry-high temp-air dry - High temp-air dry-high te ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0665 seconds