Having problems with your Northstar Pressure Washer 3000 PSI ?

Engine will run for 1 minute then shut off with a cloud of white smoke out the exhaust. i remove and cleaned carb. float is free not binding no improvement


Answers :

This symptom can indicate several problems, white smoke is usually indicating water in the system, as this is air cooled honda motor, therefore it is not coolant, check oil and check if there is water present in oil sump or in fuel tank.

Water from fuel tank can be easy drained, with fuel, replace then as well fuel filter and clean again carby. add about an ounce of methylated spirit adn fill gas to full, start engine and check if problem still present.

If this did not solved the problem, check oil for presence of water.
Water can seep to oil sump through trans, and as water pump is located directly on the shaft, simmer bearings may load water under pressure to the crancase. If necessary, repalce bearings and seals.

Please let me know if this was correct advice, or you did find other reason for that white smoke.

Oil is usually burning bluish, fuel not fully burned is black.

Hope that this will be just condensation in the tank.
Repair Help & Product Troubleshooting for Northstar Pressure Washer 3000 PSI

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Engine will run for 1 minute then shut off with a cloud of white smoke out the exhaust. i remove and cleaned carb. float is free not binding no improvement


This symptom can indicate several problems, white smoke is usually indicating water in the system, as this is air cooled honda motor, therefore it is not coolant, check oil and check if there is water present in oil sump or in fuel tank.W ... Northstar Pressure Washer 3000 PSI

Honda GX 240 on woodsplitter stopped running. Tries to fire a couple of times each pull but dies. Found debris in gas tank. Cleaned out the tank and hose to carb. Cleaned out the sediment cup. Cleaned out the rust and debris from the bottom of the float bowl. sounds like debris in carb jets? Is it worthwhile taking the carb apart and cleaning it, or just order a new carb?


Install a new plug, and make sure your gas mixture is not to rich, And you air cleaner is clean ... Honda 8 HP Engine

Carb hunts at wot and at idle, it will backfire if your not running the trigger. exhaust pipe turns red. seems to be lean. carb is clean with a new kit, fresh gas, and spark plug. if i add some choke it runs better. all the jets are clean. carb was disassembled and soaked in engine tuner.


It sounds like it is running really hot. Did you check the air filter and oil level. If not these it could be the muffler. ... Porter Cable Pressure Washers

Hi, I have a 10yr old Neff s5543 built-in dishwasher, it is has been working fine but recently has stopped fully draining. I have removed it from the housing and checked all pipe work is unblocked and not kinked, have also blown back down drain tube to free any blockages from drain pipe, have also removed pump cover and checked around impellor for any foreign bodies etc. Everything seems clean and free. I ran a complete heavy cycle (empty dishwasher) and allowed drain pipe to drain into a


Hello there and thank you for choosing fixyaOk there are acouple of things that can be checked on this along with what you have already checkedDrain solenoid\015\012 \015\012 \015\012 \015\ ... Neff 24 in. S5543X2 Built-in Dishwasher

Won't Drain I've removed and cleaned lower arm and drain in right corner. How hard to remove the upper spray arm? no parts to remove first? What's the float for in the left corner? ted


I think you need to clean the filter under the lower sprayer...I had to do that once and worked like a charm afterwords. ... Maytag MDB7100AWB Dishwasher

I have a Honda 5.5 hp pressure washer and it wont keep running I bought it off craigs list they said the last time it ran was almost a year ago I took off the carb and sprayed carb cleaner threwout but didn make a difference I cant seem to see any jets juist the float needle and that was clean if I pour gas in the carb it will run for a for about 5 seconds and but wont stay even if I choike it. does anyone have a answer


Try soaking the carb for 15 minutes in gasoline. If you have a plugged port just sparying may not be enough to clean it ... Honda 2500 PSI Gas Pressure Washer

I have a Bosch dishwasher model no. SHU66C05UC that does not drain properly. After checking for a clear drain tube and finding no problem. I removed the left side panel and found that the red float was not rising in the tube. If I pull up the trigger device to engage the pump switch the machine drains. What causes the float to stay down and what is required to free it? Thanks for any help.


Water in the base. ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

Model gc190 will only run with choke applied,removed float bowl cover and found gummy **** in it removed jet and blew out with carb cleaner and comperssed air still no good


... Honda Pressure Washers

I have a Miele G896 dishwasher. Drain light on. Washer won't work. Water clogged in drain area. Trying to remove triple filter system to clean it per owner"s manual, but handle stuck. Tried pressing down, turning both directions, technical taps to free handle, but no luck. How do you get triple filter system out to clean it?


... Miele 24 in. G656SCi Plus SS Built-in Dishwasher

Honda GC190 no start. Unit has been sitting for 2 years. Drained old gas, cleaned the carb. No go. New plug gapped to 0.030in. Still nothing. spark seems good. Cleaned the fuel strainer and there IS a bit of vacuum at the fuel pump when cranking. Poured a dab of gas into combustion chamber.. Still won't "talk to me" AT ALL. Removed valve cover and checked the valves.. within specs and nothing sticking or hanging up. Timing belt and cam looks good. Took a peak at the coil.. air gap in specs. 1ohm


... Karcher 2500 PSI Pressure Washer

Ge model # gsc3200j01ww dishwasher. when the door latch is closed, nothing happens. motor does not start. if the timer is advanced to the next part of the cycle, water will spray into unit until float valve is triggered. water will not pump out, motor does not start. bailed out water, checked for stuck float valve-ok. removed drain screens and filters, cleaned. no motor, drain, or start. what parts should i check? always rinsed dishes before putting in washer. unit is portable or undercounter


... GE 25 in. GSC3200J Built-in Dishwasher

Carburator is gummed up I can remove the carburator but after that im lost I removed the screw from the bottom of the cup drained the old gas shot some carb cleaner in there opened the gas line put the screw back in numerous times wont start regapped the spark plug and cleaned it won't start only has been used about five hours my buddy didn,t run the old gas out of it two years ago before winter it's a type 5 manual choke/fixed throttle


... Karcher 2500 PSI Pressure Washer

I have a troy built pressure washer leaking gas from the air filter i looked around for advice and hurd bang against the carb and it will realease the float valve i did it and it worked but should i clean out the fuel in the filter area or the filter will it harm it as it is or should it be okay? the filter was soaked in gas dry now and when it happened the gas flowed from the air intake (behind the filter) if i need to clean out in there how do it do it and if i need a new filter


Definetly replace the paper filter and yes Lowes will carry them.if it does not leak now, I would leave it alone or you will be installing a nine dollar kit.The briggs kit # is 294260 is you choose to do it anyway ... Coleman Powermate DuraBuilt 1400 PSI Pressure Washer

Water problem Hi, I have a Jenn air DW 711 that does not get water. I checked the following: Water line: I unhooked the water line and it is clear & free flowing. Float: The float moves up and down as it should. Filter: The filter inside the tub is clean. The motor runs and will drain any water in the tub I put a bucket of water in the tub and the dishwasher immediately drains no matter which setting I choose. Any ideas? Thanks, Steve


Many dishwashers will drain at the beginning of any cycle. \015\012If the water does not fill after the pump-out cycle, then the problem is either the fill valve or the float switch. You should be able to hear the float switch click as you rais ... Dishwashers

The machine has suddenly stopped cleaning properly. I put a cleaner through every few weeks and the inside is clean. I have blown through the pipes and they seem to be ok. I have removed the arms and filter and all seem to be free of debris. Not sure what else to check. Are there any filters behind or underneath the machine?


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Neff 24 in. S4443 Built-in Dishwasher

SHX46B I have a 4 year old Dishwasher that filled up with clean water on it's own and leaked on the floor. There appears to ba a float switch switch on the very bottom of the unit that runs the pump if this happens. It won't stop until I remove the water caught in the plastic base on the very bottom of the unit. Drain is clear and this machine has worked fine until now. I'm thinking it may be a bad or leaky fill valve but how can I check?


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

The dishwasher cycles down to 1min and then keeps trying to empty. It never does get there though. Water is still in the sump. Emptied this out once and it started ok again. Removed side cleaned out the sticky float switch. This was full of gunk. Noticed rear tank was partially blocked. Is this anything? Which is the outlet solenoid


... Neff 24 in. S5457X0GB Built-in Dishwasher

I ran a load of laundry in whirlpoo[ duet ht, model ghw9400pl4, error code p-09 was indicated. water was overflowing from door, and water was continuing to fill the tub. I turned off the faucets, unplugged & restarted in drain mode it hummed but would not drain. I turned the faucets back on and retried to drain but it would only hum. I manually removed the water by losening pump filter. There was no debree in filter except for a little bit of hair. The pump & vain was free & clean, and I co


It is your mixer value that is malfunctioning. ... Whirlpool Dishwashers

Bosch Exxcel Diswasher SGS43E08GB/43. Top spray bar won't spin. All arms, spray holes, ducts, filters, etc are clean and free from obstructions. Water comes out of the holes on the top bar but it won't spin. Water pressure inside the machine with all the bars and ducts removed seems good. Bottom bar works fine. Any ideas please?


Try starting the washer, then opening to door and checking the water level in the bottom of the machine, as far as I know, there should be enough water there to disolve the tablet when it sits in the bottom. if not that much, bung in a few cupfulls a ... Bosch 24 in. SGS47E02 Exxcel Free-standing Dishwasher

Engine does not start. I ran it about two weeks ago and it worked fine. I took the spark plug out and it was dry. I made sure there was gas in it. I tried some starting fluid by spraying into air intake and it start running for a short time until the starting fluid ran out. I removed the carb bowl and there was gas in it. However the inside of the bowl and the float had brown deposits and looks like rust. So I think the main jet has been clogged up with a particle. How do I clear it? Where do I


Try cleaning the carb with gumout spray and a little compressed air, be careful to reassemble the float and needle valve exactly as you found it. ... Northstar Pressure Washer 3000 PSI

My fisher paykel DD603 fills with water at the start of the cycle and stops with the following error code and a beeping noise: - error U1 spanner symbol - crossed out faucet symbol. The water level is high enough that the spray arm is floating in the water. I am able to drain the water by entering the hardware diagnostics mode and running the motor in the drain direction. By removing the filter plate and examining the impellers I am not able to see visible damage. All filters are clean. The


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. You are spot on as error U1\015\012indicates that the dishwasher has twice tried to fill with the required amou ... Dishwashers

I have an FDS252RBS2 Frigidaire dishwasher. It's about four years old, and has always worked well. Now, no water appears to be entering. The dishes are dry and dirty at the end of the wash cycle. I removed the tower and the float, and both were clean. Is this a total disaster, or can it be fixed?


... Frigidaire Dishwashers

Honda gc160 when I first pull it. It wants to start. Then dies in 1/2 second. I have put a new fuel punp, plug, and coil on it and opened the carb at float. cleaned it there. it will not do anything after the first pull untill 15 min latter, then it does the same thing ?


... Pressure Washers

My valve needle broke of while removing the float in the carburetor and now half of it is stuck in there how can i remove it?


Try using a air nozzle. If the needle is stuck up in there then a good blast of air should take care of it. ... Pressure Washers

We recieved a dishwasher that had tons of lime and scale. well i remove that mostly by hand by taking the bottom part and disassemblying it and soaking it in CLR and slowly removing the calcium lime and whatever else there was. but i am kind of a thorough person and the bar =on the back of the dish wash needs to be removed and the back of it cleaned and probably soaked also if not replaced but i will just clean it for right now if i can. HOW do you remove it? I need a step by step on how to remo


Instead of going through all that effort, and still not being able to get to everything, just use a product called "Dishwasher Magic". It is a dishwasher cleaner and disinfectant, and cleans limescale and rust out of the dishwasher by just running i ... Maytag 24 in. MDB4600A Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1239 seconds