Having problems with your Northstar Pressure Washers ?

Cant put carb assembly back on correctly on powerwasher

\015 I have a North Star brand powerwasher 2400 psi at 2 gpm. I had to take off and clean the carb, now I can not figure out how to put the pin for the throttle back on correctly and can not find a diagram to simply look at.\015

Answers :

Repair Help & Product Troubleshooting for Northstar Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Cant put carb assembly back on correctly on powerwasher


... Northstar Pressure Washers

The maytag dishwasher model mdb7130AWB stoped cleaning correctly so we went from the arm assembly in bottom of dishwasher down to the cutter disc and we found a crack in the housing so i ordered that piece. the new part was designed a little different but we put it all back together the way it came off. but it started and ran maybe 1 minute and stopped. so i have pulled up the diagram and see some problems. in the current diagram. original there was no part 37, 17 19 and 3, alos the crew d


... Maytag MDB7130 Dishwasher

It sounded like something was jammed in the bottom of dishwasher. Took it apart, not sure if put it back together correctly because now it is not turning (bottom). Is there a diagram to look at on how to put back together correctly? Whirlpool Quiet Partner II Serial # FP1386450 Model # DU943PWKQO


Go to sears part sales web site adn look at parts breakdown. ... Dishwashers

Karcher 2400 pressure washer with honda engine. my problem is that i've installed a new rebuild kit in the pressure pump assembly, and now, when i reinstall the assembly back on the engine, i cant even pull start the engine over. its too tight! when i loosen back on the pump assembly, i'm able to pull the engine over. what have i installed wrong from the rebuild kit??


The pump is correctly oiled and lined up on the camshaft, correct? ... Karcher 2500 PSI Pressure Washer

Assembly plans for karcher 2400 psi pressure i recently had a problem, with my pressure washer. i was cleaning out my hose and took the hose assembly and brass fitting off. run water threw it thought i had cleand it out, put it back together and now when i hooked my water hose back up the water comes out of the despencer instead of the pressure wand. does eny one no what i need to do to revurse this?


... Honda Karcher G2400HH-R Pressure Washer

Soap door on my Whirlpool dishwasher model # DU810SWKU0 does not open.I had inner door off to check rinse agent problem.Is there something i did putting inner door back on? If I close soap door and turn timer knob on outside of door the soap door will open after I make two full turns of the knob.If this cant be fixed can I just put soap in the bottom tray that has no door or put soap in both trays and do not close the soap door? Thank You RH.


... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

I need to put the lower pieces of my dishwasher back correctly.


Try this website:\015\012 ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

I need to know how to put the pump assembly back


Go to the link provided below and under the heading "Browse Subcomponents" click on the "Pump and Motor Parts" link. I think that shows what you're looking for. Otherwise, check the other diagram links for your model on the same page.\015\012 ... Kenmore Dishwashers

I had a draining problem, clogged line, fixed. Does the small in line rubber valve under the dishwasher in the transition piece to the hose have any real need to go back? and which direction it is cupped slightly. Also are there any assembly instructions? I cant seem to get it back quite right, or a white washer has split. not sure which.


... Whirlpool 24" Built-In Dishwasher - Black-on-Black

I have a bosch dishwasher model number SGS0902GB/05. I use tablets instead of detergent. I put the tablet in the Dispenser and close the lid, noproblem. I then set the programme and shut the door, I usually set the programme to delay start so that it washes dishes in the small hours when all are in bed, however, when I have set the programme and close the door within a minute the dispenser assembly opens and the tablet falls into the dishwasher, I then try and put the tablet back in the dispe


Hello Andrew,\015\012\015\012I'm more than happy to give step-by-step instructions for replacing the detergent dispenser, however it's not cheap (about \302\24350) and it probably doesn't need to be replaced. Some of the smaller component ... Bosch Dishwashers

I need the diagram for the door pulley system so I can make sure I am hooking it up right. The original door chord/pulley assembly broke. I ordered new parts, Now I want to make sure I am putting it back together the right way. The edge of the screw- on floor panel is pushing the plastic hook off of the door hook when you shut the dishwasher door.


... KitchenAid Dishwashers

My Siemens dishwasher SL34A sometimes makes loud vibration noises from the supply line at the water pump connection. I can turn off the water and back on it will quit, but sometimes starts again. And it does not matter how open or closed the supply line valve is either. I'm told it is likely the water pump, but this model has a combination water pump/motor assembly and I do not care to put another $230 into it. thx, TS.


... Siemens 24 in. SL34A006UC Built-in Dishwasher

The connector on the hose for my powerwasher blew off how do i put it back on


... Pressure Washers

Whirlpool dishwasher DU1145XTPQA. I removed the lower arm etc and cleaned debris from my chopper/pump area. went through steps in reverse to reassemble it all BUT when I put the lower spray arm back on and tighten its VERY wobbly...I am not doing something correct in the last few steps...nut, plastic washer, feed tube cap & wash arm...please help


I did the same exact thing, and ended up with the same result, A very wobbly lower spray arm. Despite it wobbling and hitting the feeder tube to the upper spray arm, it works.... somehow.... ... Dishwashers

I have a several year old honda gx240 engine. It has never been teched and now, all of a sudden it hardly works. Before this it would occassionally backfire but now I cant put any load on the engine or get any rpm's out of it. It was literally a overnight thing. Worked perfectly the other night and now it hardly runs. Any ideas? Anyway to adjust/clean the carb?


It sounds l may need a digapham or bowl cleaning ike a carborater problem it ... Honda 8 HP Engine

We have a KitchenAid KEBC147KSDS06 24" conv. oven. After putting it through a clean cycle, I tried to preheat it to conv, bake @ 350 deg. The display comes up normally and the fan runs, but after 5 sec. the temp disappears from the display and 'Lo' appears in its place. The conv. fan continues to run but neither upper nor lower element heats. Following a suggestion, I tried to reset the oven by turning off its circuit breaker and powering back up, but it did not correct the problem.


It depends how long you had the self-clean function running. The oven is known to overheat and damage the thermostat during self-clean.\015\012\015\012See postings on some user forums.\015\012\015\012 ... KitchenAid 24 in. KUDS02SRSS Stainless Steel Built-in Dishwasher

Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking


You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer

My dishwasher does not sound correct (lack of spraying action sound) and this last time when I opened the door the soap had not disolved and the dishes where still dirty. I have taken apart the bottom arm before for a cleaning but it was only a couple of weeks ago. Could it clog up again so fast even when the type of dishes remain the same? Did I put it back together wrong? Maytag EQ Plus


DEAR FRIEND,\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012ngfam1 here for you!\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\0 ... Dishwashers

The cover of the detergent dispenser does not latch properly and will flip open. The dishwasher is 6 years old and I think we need to replace the dispenser assembly but don't know how to take it off the door and put it back. The model number is GU1500XTKB0 Thank you for your help.


I've posted this before. The latch just needs a good cleaning. In the past, something placed in the washer kept the door from opening properly, which caused detergent to dry under the latch. This has happen several times until I figured it out. Don't ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

When I turn on the power washer, it turns on but it shuts back down. It sounds like it wants to turn on but it doesnt.PLease help. Its my friends powerwasher he uses at work. I cant get the exact model.


Some washers turn themselves off when low on oil, check the oil level ... Pressure Washers

Panel door to integrated prima dishwasher has fallen off. Cant find instructions to put it back. It only has 4 shortish screws straight into panel and 2 strips of Velcro-is this right


... Dishwashers

I have a 7 hp B&G craftsman Pressure washer , if I place an air filter on it ,it wound't start or run , if I remove the air filter it would run like a champ, but after 10 mints , oil would shoot out off the carb like a running faucet , why is it not running with the filter on,.Now am not so sure if the air filter is the correct size , because when I put it on it seem to be a bit on the taller size rather than a perfect fit, thanks for your help , in Hollywood , Reinaldo Roman .


First,It sounds like the air filter is full of dirt preventing air from flowing through, starving the engine of air.As for the oil shooting through, are you certain the oil is coming from teh carb?. Makes no sense the engine w ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

I go to pull start it and it fires up but then it dies so i cleaned the carb out took it all apart and cleaned and put it back together and still same problem


Usually there is both a choke and fuel shut off lever on the engine with the choke being gray and the fuel lever being black. With the fuel line disconnected from the carb., move the lever back and forth while using a catch container and ... Pressure Washers

Carburator is gummed up I can remove the carburator but after that im lost I removed the screw from the bottom of the cup drained the old gas shot some carb cleaner in there opened the gas line put the screw back in numerous times wont start regapped the spark plug and cleaned it won't start only has been used about five hours my buddy didn,t run the old gas out of it two years ago before winter it's a type 5 manual choke/fixed throttle


... Karcher 2500 PSI Pressure Washer

Normal cycle light blinking, won't turn on MDB7609AWW1. Was told it was micro computer. Replaced it....same problem..Put old micro computer back in.. wife secured all wires and banged the machine and it started working tfor a few Days.. stopped with same old symptoms..I'm sure guru is correct and it is the touchpad, but his facing appears to be glued on,I don't wan't to ruin the front of the console , and I've not been able to find a touchpad part on the schematic or online. Help???


... Maytag MDB7609AW Builtin Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0847 seconds