Having problems with your Northstar Pressure Washers ?

What type of oil goes in the pump, i notice that the sightglass is alittle low.


Answers :

You can top up the pump with hydraulic oil.
Repair Help & Product Troubleshooting for Northstar Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

What type of oil goes in the pump, i notice that the sightglass is alittle low.


You can top up the pump with hydraulic oil. ... Northstar Pressure Washers

Honda 11 hp, model GX340, Cat pump model 5DX40GL; Low on hydrolic oil need to know what type of hydrolic oil to use.


... Honda Pressure Washer PSI 3000

I have a coleman pressure washer model # PW0912500 - What type of oil goes into the pump housing , how much goes in, and how often does it need to be changed ?


... Pressure Washers

What type of oil goes in the pump, and is the tube that comes out of it on the top of the pump supposed to be open or a covered vent??


Hello 10W30 is OK but it must be NON DETERGENT. Be sure you only fill the reservoir 1/3 to 1/2 full. Thee should be a cap on top. ... Coleman Pressure Washers

What type oil goes in a honda 6hp gc190 pressure washer pump


... Honda Pressure Washers

What type of oil goes in a comet axd 3020 pressure washer pump?


You should use what the pump manufacturer recommends. Typically a 30wt non-detergent (non foaming) oil. Do not over fill. If there is a sight glass half way is normal. Or if it has a dip stick follow the mark there. Here is a great link for pre ... Comet GXD2527G Pressure Washer Pump

What type of oil goes into the pump - Honda Pressure Washer PSI 3000


YOU NEED AN OIL THAT IS THIN & CAN COPE WITH HIGH TEMPERATURES.\015\012I USE & RECOMMEND HYDRAULIC OIL ... Honda Pressure Washer PSI 3000

What type of oil goes into the pressure washer pump...3600psi


I would recommend pump oil for this particular application because it contains special components in the oil but you can substitute as I have done many times with hydraulic fluid.You need to change your pump oil every 50 hours. ... DeVilbiss Pressure Washers

My Troy Bilt power washer (using Honda GCV160 engine) has no pressure coming from the pump. I checked the water flow, everything seems fine. I believe the pump needs oil added, however, I can't seem to firgure it out (how to add oil to the pump). I did notice that previously, I used to see drops of oil coming from under the pump. I I have a bad seal, can I add oil and test the pressure before I change the seal? Please advise.


I had a similar problem. Turns out I had left the hose disconnected and some sort of wasp built a paper type nest inside the washer tube that the hose connects to. I had to take the pump off and take apart and then cleaned it out with a screw driver. ... Honda Black Max 2600 PSI Pressure Washer

I have a sears pressure washer, model 580752300. The pump on the underside vibrated lose and broke a couple screws. It came off and the oil drained out. I replaced the screws and it's ready to go except I can't find out how much replacement oil to put back in. Sears has larger containers but won't tell you how much oil to put in. However, there's a pricey pre-measured container they want to make you buy. Anybody know how much oil goes in that pump?


... FAIP Non Marking Pressure Washer Hose 4000 Psi, 50ft. Length

What type oil for Karcher K 2400 HH pump end?


... Karcher 2500 PSI Pressure Washer

No pressure Gas powered pump is a radial type from DeVilbiss. There is very low pressure, although there is some pulsing from the pumping action. There are no leaks and the supply pressure is good. Pump pistons are in good condition. They seem to be pumping when I had it disassembled and operated by hand. I suspect it is something in the bypass or unloader. Or it may be in the ''easy start'' assembly which I assume reduces backpressure on the pump when starting the engine. Pump has a temperatu


... Pressure Washers

No water pressure coming out while ingine is running. hoses/ attachments not clog. Pulled and opened pump, didn't see anything broken although noticed pump was filled with oil/lubricant but about 1/4" below top surface. Is it suppose to be filled to the top? What kind of oil is used on the pump? And how come there's no water pressure coming out while the motor is running and handle trigger engaged?


If you can find the model # then you can call tech support for free advise.\0121-888-279-9274 ... Karcher Pressure Washers

I bought a troybuilt pressure washer used and i changed the motor oil and ran it maybe 5 minutes. later i checked the oil level again and it shot out the cap and i noticed the pump oil level is also almost to the top of sight glass. Does anyone know whats wrong?


If you left it sit for a while & did not turn the fuel tap off,it may have flooded and therefore the oil level would have risen causing the oil to over flow.\015\012\015\012always turn the fuel tap off when not using your pressure wahser. ... Honda Pressure Washer PSI 3000

I have a Coleman powermate clean machine pressure washer 2500 psi 2.36gpm and has a 6x200 honda 6.5 horse motor. I just bought at a garage sale.It started just fine when I got home and in less that 2 minutes quit. It says the engine will stop automatically when low on oil. what kind of oil should I use and for the pump what kind of oil do you use?


... Coleman Pressure Washer PW0881800

I have the John Deer 3800 psi from lowes. The machine is in great running order it just seems to be losing psi as I use it. Also checking the oil in the Honda 13hp motor and in the pump. Do you take the dipstick out and then insert it Not screw it back in to check the oil? The motor has 2 places for oil 1 on each side?


Thread the dip stip back in to get a true reading of the oil level. Either oil filler may be used to top off the crank case. There is only one crank case - the oil on one side is the same oil seen in the other filler. ... Briggs & Stratton Pressure Washers

Do you have to use oil in the pump and if so type,how often.


Water pumps doesn't require oil in the pump; but your engine does require. if the water pump is of "self priming" type, fill the pump casing with water before starting the machine to avoid damage to the water seals. ... Campbell Hausfeld PW1750 Electric Pressure Washer

What type of oil does the pump use? how much?


8.5 oz. to the red dot on the site glass.SAE 30 / 30 wt Non Detergent Oil from your local auto parts house. ... Caterpillar Cat Pump Pressure Washer Pump 2.5 Gpm, 2750 Psi, 5 Hp To 6.5 Hp Required, ModelNo. 3DX25GSI

Type of oil for pressure washer pump.


Any anti foaming oil ,you can use multi grade but it goes milky with minute air bubbles and gives the appearance of getting water in.most manufacturers recommend anti-foaming oil ... Campbell Hausfeld PW2102 Gas Pressure Washer

I have a Karcher model G 2401 HB and need to know what type of oil to use in pump ?


I fixed mine works good too, watch my video step by step i put it on youtube ... Karcher 2500 PSI Pressure Washer

What type of oil is used in a simpson power washer,the pump not the engine


... Simpson Pressure Washers

Smeg dishwasher model dw1612c type 12043 seems to be stuck. program lights 4 & 5 are lit up solid and theres also a beep beep audio warning.it will not reset this is with the door open wen you close door the pump goes on and off / on and off have checked all pumps pipes and motor there are no blockages and everything is turning freely. can it be fixed. ?


... Smeg DWD612C Built-in Dishwasher

Type- KEW Hobby waterblaster- requires addition pump oil. What kind of oil does it take.


Pump oil is 20 or 30 weight non-detergent motor oil. SAE20 or SAE30.Pump oil fills about half-way up inside pump. Look for fill mark or read manual. Of course you saved the manual, right? So you're not in line at fixya wanting a manual fo ... Pressure Washers

Starts but does not keep running. checked oil & its full. do you need water pressure at the pump? I know it has a low oil pressure cut off.


First: check and change the spark plug and do a oil change (OIL IS NOT THE PROBLEM BUT IS GOOD TO DO IT) then do a test with fresh gasoline.\012Second:check all fuel components (LINES,CARB,ETC...)\012Third:if any of this fix the problem ... Dewalt DPD3100 Gas Pressure Washer

I have a GENERAC brand pressure washer.I am not familure with these.I have no manual.So,what my question is....Do the pumps require oil or not?If mine does,where in the heck do you put it?And what type is it of oil is it?I need to know! THANKS!


I would love to help you ,but unless we can get an idea what size it is how much pressure it does etc its abit hard ,it will reqire oil, non foaming oil.my suggestionwould be to go to a shop that deals in these things and see if you can see one like ... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0754 seconds