Having problems with your Northstar Pressure Washers ?

I picked up my NorthStar 157892A Powerwasher from a family member, they lost the manual and its tune-up time. How can I get a replacement manual?


Answers :

I would recommend that you call northern tool at 1-800-270-0810 and let them know what you need. I have found them to be very helpful and knowledgeable.Hope this helps you. Thank you.
Repair Help & Product Troubleshooting for Northstar Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I picked up my NorthStar 157892A Powerwasher from a family member, they lost the manual and its tune-up time. How can I get a replacement manual?


I would recommend that you call northern tool at 1-800-270-0810 and let them know what you need. I have found them to be very helpful and knowledgeable.Hope this helps you. Thank you. ... Northstar Pressure Washers

We have run our dish washer several times, however, the dishes are not getting cleaned. We first ran it on "normal wash." The second and third time we ran it on "pots and pans." Not only are the dishes not getting cleaned, but the soap is hardly getting dissolved. We use liquid dish soap too. I noticed this last time, at the end of the wash, the soap was getting built up on the front-right (when facing the machine) and had turned into a solid clump; almost like plaster. I don't have a manual so


First idea goto your local home depot they make a product called AFFRESH for front load washing machines and dishwashers run this tablet inside your dishwasher with no dishes on the inside on the hotest setting this usually takes out all build up wit ... Dishwashers

My kitchen aid dishwasher will not start I replaced the interface control board thinking that was the obvious problem. When you go to set the dishwasher to start some of the settings don't always light up then when you push the start button the lights will flash then start but it's not flashing and won't start. I get lucky once in a while and get it to flash then start. I don't know where else to look. I don't want to start replacing parts one at a time till I get lucky. My model # is KUDIO1F


Check all cables especially the ribbon cables from the user interface to the electronic control assembly as steam from dishwashings will create small amounts of corrosion and inhibit signals to and from these 2 components,unplug each,inspect,and reco ... KitchenAid Dishwashers

Blowing fuse... We've replaced the overheating fuse located in the control board area about 5 times. It has just blown again after using the dishwaser one time--before it would go about a month before blowing the fuse. It seems to get about a few minutes away from completing the wash cycle and does not complete the draining process. Help!! We don't know what to do next--replacing the fuse is costing about $15 each time, before you know it we could have bought a new one! Thanks for the help. Ti


Tim, this blown fuse issue was pretty common on this model. Whirlpool, which made this model came out with a fuse kit that included a terminal and heavier guage wire to eliminate this problem. It just splices right into the control board, easy job. T ... Kenmore 17024 Built-in Dishwasher

The spring or balance in the door on my dishwasher Zanussi DW917 is no longer working, so that the door just drops unless held manually. How do I get to it to replace or where can I get a service manual with this information please?


... Dishwashers

I am trying to install a new Maytag MDBH945AWB Dishwasher and have to run the drain hose under the machine in order to get it to the sink. Each time I try to use the hose that comes with the machine it snaps in two and breaks. I have tried to look for a replacement hose that would stand up to the abuse but all I can find is the original. Is there a replacement I can get that is more flexible than the one that comes with it? At this point I am rather embarrased about going back to Home Depot


Hi...home depot sells clear PVC hoses, They come in various lengths up to 100 ft. You can use hose clamps to connect it to the T-fitting. ... Dishwashers

We keep getting the message that the wash arm is blocked (Heavy/Rinse), yet the arm is free. We have replaced everything in the drawer that might impede the arm. We have checked the arm for food blockage, but there is none. Moved the rotors around to different drawers. We have replaced the rotor and the pump motor. Still get the message. It is annoying to receive the message four or five times a cycle. I think it is whatever is sensing the arm block, but have no idea what that might be. Af


Access the rotor, remove it, clean it and put it back in place.The rotor is part 5 in the diagram below. Click on the picture to enlarge: ... KitchenAid KUDD01DSSS Built-in Dishwasher

Our Bosch SGS 53E02 AU/30 Dishwasher has the Tap Light on all the time while the Dishwasher is filling up. It appears as though water cannot get through and takes a long time to fill. It also does not allow the wash cycle to start and the powder door does not open. Can you also get any Service manuals for this model?


... Bosch Dishwashers

I need to get a manual and a power washer hose. I have a blue max washer and I have lost the manual ,I need a manual and a powerwasher hose. It has a 2.4 horse power OHV enginStock #PW2200/03435 Hongcheng water cleaning hose 150bar [15 mpa] Thank you for your help. Marty


... Psi Blue Max 2200 High Pressure Gas Power Washer

Amana dishwasher, model adb2200aws, ser #, 26650464e. history: quit running, no lights, nothing. replaced the door switch, ran for three days, replaced the switches on both sides of door switch, ran three days, quit. replaced the circuit panel , ran one time, quit. not lights, nothing. when I take it apart sometimes, that is take off inside cover on door, it might run or not. seems like the current isn't getting in as no lights will come one.


I have the same problem with mine as well but I found out that if you take a space heater to it and warm the control panel up for about 5 minutes, everything works great. This model of dishwasher seems to be problematic in any environment under 70-75 ... Amana Dishwashers

I have a Karcher 330 electric power washer. When connected and set to highest pressure (on variable wand) I get no motor action unless I reduce wand setting, then I get a little boost but not much. If I use high pressure conical wand I get high pressure sometimes, other times motor does not go and no pressure is delivered. I have replaced the high pressure hose.


Just wondering. have you tried it without an attachment to see what kind of pressure you get ... Karcher K2.26 Electric Power Washer

My dishwasher is beeping 5 times with a pause in between, I can't get it to do anything now, each time I switch it on it just beeps at me. In the manual it says that the 'flood switch' has been activated, I' not sure why, or even what this is, but I'd really like to deactivate it.


It would help to know the make and model number of the dishwasher.\015\012\015\012Flood switch can be at different locations depending on the model.\015\012Are there any lights flashing on the panel as well? ... Dishwashers

How do I get the nozzle to spray detergent out of it? The high pressure works great but I can't get the detergent part to work. I lost the owners manual and now I'm confused about it. Any help will be appreciated. Thank You , Mad Max


Go to this LINK and find the part/diagram that can help you. ... Karcher FactoryReconditioned K240R 1400 PSI 13 GPM Electric Pressure Was

Hotpoint hda 3420 dishwaher. when turning, on the motor hums and doesn't kick in like usual. manual says caused by non use. "must keep the seal moist" put water in the unit, thinking it might get the seal moist. bottom filled and unit has not worked for days. assuming it's this seal: where is it? how do i get at it? what is replacement difiiculty? how much is the part? thanx ron [email protected] or [email protected]


Hi,Before thinking about replacement... pour a couple of cups of water in the dishwasher and let them soak the seal for overnight...Then if it don't go give the motor a spin...just to make sure it will go...if that don't work ... Dishwashers

Just bought a new house and the old owners have installed a Technika Bellissimo dishwasher. I managed to get the first load done, now it doesn't start the cycle and beeps five times pause, then five times, nothing about five beeps in the manual! It also has the end light on, confused?


Hi\015\012\015\012This beep issue is caused when the control board goes bad and needs to be replaced. You can also use a hair dryer to blow air on the control before replacing it. After this if the issue remains then replacing it is recom ... Dishwashers

I have a Candy CD650 dishwasher which is not washing properly. Basically, the detergent tablets seem to be getting stuck in the tray. Most times I open the door, the tablet is a pile of mush inside the tray. Other times it is on the bottom of the dishwasher - again a pile of mush! Sometimes, it starts the program & sounds like it's about to start a wash cycle, but then gives up! it gives one short woosh, the stops again. Any ideas how to fix this? I don't have a manual so can't look there.


... Candy 24 in. CD650 Free-standing Dishwasher

Bosch Dishwasher I have just moved into my flat where there is a Bosch dishwaher installed in the kitchen. I have tried on a number of times to get the dishwasher to start a programme but for some reason it fails to start. It does switch on but I dont know how to operate it. I dont have a manual for it so have not a clue what to press to get the programmes running. I would be grateful if you could help. Bosch Dishwasher logixx Model Number SGS6952GB/13 Installed 2001


Dear Saps,\015\012Go to https://portal.bsh-partner.com/portal(bD1kZSZjPTAwOQ==)/PORTALFRAME.HTM for a pdf download for an Intr ... Dishwashers

The count down timer gets to 1 stays there a long time, then resets to 23 or so, gets to 0 in about 3 hours or so. What do I need to replace? Thanks for your help.


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012Based on your description I'd say the issue is with the control. Bosch has had a history of this exact problem I'm about to lay out for you and this is the fi ... Bosch 24 in. SHU43 Built-in Dishwasher

I have a Frigidaire Ultra Quiet II dishwasher that gets stuck in the 6:00 position (between light wash and drying) during the cycle. It also gets stuck right before the drying cycle. It will proceed with the cycle if I manually move the dial. The heated drying feature is also not working as well. Do you have any suggestions? Thank you for you time, for it is appreciated. Best Regards, Scott G.


... Dishwashers

Hi i have a Candy CDI 1012/B Intergrated dishwasher and 4 lights are flashing during the first programme then system drains and stops showing four lights lit. We have no instruction manual or service manual this would be good to get hold of as we have serveral of these machines. any idea what the problem is to save us time investigating it. Thanks Paul


Hi. The four leds flashing quickly at start of the cycle means that there is an inlet problem. Check that the inlet hose is not bent, blocked or kinked, ensure that water has sufficient pressure. The inlet valve can be tested reading Ohms at valve te ... Dishwashers

I have a Danby Dishwasher model # 67638 18052. There is a slight crack in one of the parts underneath that is allowing water to leak out. The part is located in the back corner and it is a pale yellowish elbow shaped connector. Can I get some some kind of glue to seal it, or do I need to get it replaced? It that going to cost a lot? Is it going to be worth it?Thank you for your time.


... Danby DDW1805W Designer Series Free-Standing Dishwasher

MDB8750AWS I had to replace my board 3 times this year. Once the board is replace the dishwasher will work for 4 months. Can you please let me know what is the problem, because changing the board is getting very expensive.


Do you have alot of electrical storms, install surge protectors on all electronic appliances.\015\012was the board and the person installing the part grounded. static can make those parts fail within a few months. ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

How can I shut off the water supply to the dishwasher? It fills slowly with water from the top (while not running), and then water spills out over the kitchen floor. By pressing the 'Drain' button, the water will drain out, but I have to get to it before it floods. It takes about 4 hours for it to get to the overflow stage. It is a Jennair model, about 9 years old. We have a lot of limescale, it is probably time to replace it, but for the moment my main concern is to stop the leak. Thank you for


Most water supply lines are attached to the hot water supply under the kitchen sink. If not it may be accessible from the basement somewhere under where the dishwasher is located. Regarding the issue with the dishwasher, the inlet water v ... Sears 24 in. 14181 Built-in Dishwasher

An electrical panel breaker switch was replaced after the microwave and dishwasher both lost power. The microwave works after replacing the main panel breaker. However the dishwasher will not show any power. Checked the internal circuit board, no burned areas, cannot find an internal GFI reset, what can I do to get power restored to the main control panel or even the unit itself? Rick C


1)check any fuse in the circut board.(blown off)\015\0122)check any loose connection of neutral (or)phase wire to the machine(or)in the switch. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a G E Nautilus dishwasher that has been in storage for 2 years. Every thing works but the Drain. When the cycles are finished I' m left with a dishwasher full of water and it dont drain. I checked the bottom as u said in a previos question I see not obstacles, trash etc. How else4 can I get it to unplug? Also where can I get a owners manual? I can be contacted at [email protected] if needed. Thanks ahead of time for the help.


Hello. Here is the link to a free manual http://kitchen.manualsonline.com/manuals/mfg/ge_appliances/ge_ap ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1555 seconds