Having problems with your Powerhorse OHV Horizontal Engine - 414cc, 1in. dia. x 3 1/3in.L Shaft ?

414cc powerhorse spark issues

\015 Replaced coil and spark plug still no spark, removed wire from coil so no ground to frame\015

Answers :

Repair Help & Product Troubleshooting for Powerhorse OHV Horizontal Engine - 414cc, 1in. dia. x 3 1/3in.L Shaft

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

11 hp honda pressure washer engine won't start. No spark at the pkug, bought a new coil and still no spark. This sysem only has a coil off the fly wheel and the spark plug. I even changed spark plug. Use the unit the other day, shut it down and on restart it won't start. Also, I disconnected the kill switch and the il lvel sensor so nothing was going to ground.


If you replaced the coil,check the wire and boot,check with meter for continuity.could be loose connection to spark plug ... Honda Pressure Washer PSI 3000

No spark we had a gas leakand it ran down to the coil and flywheel. The engine quit and wouldn 't restart. no spark. I replaced the coil and still no spark. the insulation on the magnet appears to be good .I need help please.


Here are a few pointers from a former pressure pump tech. Usually no spark is caused by the low oil safety system or spark plug wire shorted. This system will prevent the engine from starting if the oil is dirty or contaminated with gas. Try disconn ... Pressure Washers

Washer won't start tried everything , I could think of changed spark plug tried new gas , Two things that bother me are . if i take out the spark plug and put my thumb over the spark plug hole theres no pressure and the wire that comes from the coil to shut off the pw it has continunity from the coil to the pin that sticks up to shut off the pw but it also has continuity from the coil to all parts of motor.


... Pressure Washers

I HAVE A NEW CRAFTSMAN PRESSURE WASHER WITH KEY START. I HAVE USED IT ONCE AND WHEN I TRIED TO START IT IT WAS HARD TO START HAD TO PULL START IT. NOW IT WONT START. LET PRESSURE OUT HAVE HOSE OH AND RUNNING, NEW SPARK PLUG HAS OIL, GAS FILTER FINE.HAS GOOD COMPRESSION, BUT WILL NOT FIRE GET SOME RECOIL. GETTING GAS TO SPARK PLUG AND GETTING SPARK. IM LOST PLEASE HELP.


... Pressure Washers

Dishwasher Issues My dishwasher is not properly dispensing the dishwasher soap. The flap on the soap container seems to be opening, but the soap is always caked in there after the cycle is finished. I have tried leaving the soap flap open, but that just seems to deposit soap particles on the dishes in the front of the bottom rack. Also, there is often a greasy film left on many of my dishes. Is this a soap issue or a water issue? I am very frustrated! Can you help?


I would try using a different soap or less of your current soap. ... Maytag 24 in. MDB4100 Built-in Dishwasher

Dishwasher issues dishwasher runs but water does not get hot and wash cycle continues endlessly until stopped or rest. Do I have a water heating element issue or a controlling PCB issue?


You should always turn the hot water faucet at the kitchen sink first before starting dishwasher. If you don't your entire wash is cold water. This will also cause the water temp mode to take forever to heat the water to the 140 that is factory set. ... Dishwashers

Troy built pressure washer won't start. It has a Honda 160 CVG motor. I used it for about a year and then it stopped working. I've replaced fuel and spark plug. Spark plug is soaked every


... Karcher 2500 PSI Pressure Washer

Pressure washer pressure issue - spill valve issue?


... Dewalt DXPW3835 - 3800 PSI Professional Gas-Cold Water Pressure

Hi my scorpion squirt pressure washer won't start spark but no fuel at spark plug fuel is going into the carby


... Pressure Washers

Got spark, no fire. Dipped plug in gas. Not ENOUGH spark?


Ok lets assume for a moment that it does not even fire with gas inserted into the spark plug hole. Given that we have to assume there may not be any compression. Have you tested the compression? \015\012\015\012Just for girns lets do s ... Briggs & Stratton 020324 3700 PSI Pro Series Pressure Washer

Hard starting 6hp Briggs and Stratton power washer engine. I poured a teaspoon of gas into the cylinder; reinserted the spark plug and with one pull in ran fine. This is a choke start engine and it may take 12 to 15 pulls to start on a cold engine. The unit is clean. The air cleaner is new. The spark plug is new. The unit is 2 years old with very little use.


Hello. I have this same machine. Go to the auto parts store and get an aerosol can of starter fluid. Have a helper squirt some into the air intake while you start it. Then continue to squirt a little starter fluid as it runs for the first two mi ... Campbell Hausfeld Pressure Washers

Dishwasher fills with water and then stops. No lights are on at all. I cked wiring and circuit breaker and no issues there. I then flipped off circuit breaker over night. Got up next morning and flipped breaker back on. Dishwasher lights were on and when I pushed Start button, it ran fine. Now it is doing same thing except circuit breaker trick dont work like last time. THERE is NO issues with wiring or connections to dishwasher.


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Wont start acts like no spark but is getting spark


Same problem happened to me after starting it on the 1st pull used it \012and put it away for months.The carb.has a single jet which is a very \012small hole that gets gummed up when its not ran for awhile due to the \012Ethanol that they put in gas. ... Karcher G3025OH Pressure Washer

I have the E3 error on my Smeg DWI614 dishwasher which would indicate a heater error, however it is heating the water in the bottom of the machine but it seems to time out. The main issue seems to be that the recirc. pump is not running during the heating phase. I have taken the pump out, checked the connections etc. twice now and everything seems fine (the motor runs when tested). When I have done this (both times) the dishwasher has started again and run for 20+ cycles fine, then the issue com


... Smeg DWI614 Built-in Dishwasher

I have an Excell VR2500 pressure washer with B & S 6.5 HP engine. It was running fine, but then stalled out and now will not start. Has clean gas and full oil. I pulled the spark plug it is producing a sufficient spark when starter cord is pulled. Any ideas what might be causing the problem? Please help.


The key things to check are the spark plug, the air filter, the fuel. If those are all new and in good shape then you probably have gum in the carburator. Get a can of starter fluid and a helper. One person squirt the starter fluid into the air in ... Briggs & Stratton Pressure Washers

Won't start I have checked the spark plug and I have good saprk. I have checked the fuel sysstem and the primer bulb injects fuel. I have removed the head and cjecked for engine damage and all cycle correctly. Vaves opne on time piston shows no dmagae. side walls are smooth and not damaged. This engine was working fine but the pressure washer needed some O rings replaced. I have tried to start it with and without the pump attahced. Evrything on the engine looks fine. I removed the spark plug and


... Briggs & Stratton Briggs Stratton 2550 Psigaspressure Washer

GE dishwasher GLDL500N10BB (2 year old)began to run eratically 2 months ago. Would run a cycle then restart and continue like that for hours. Sometimes it would run a partiaal cycle and stop. Finally no start at all. Have dor off and no visible wiring issues, water, or other obvious issues


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If the cycle doesn't\015\012complete, then the first thing ... GE Dishwashers

I have a mid 60's 6 hp Tecumseh engine on a Troybilt tiller. I used it to till my front yard and it ran fine. I let a friend use and it quit on him after a few minutes. It will not start. It has spark at the spark plug. I have thoroughly cleaned the carburetor by taking it apart, soaking it in cleaner, blowing out all holes and passages. I made sure the tiny holes in the power valve at the bottom of the fuel bowl are open. I have taken this carburetor apart five or six times over the years an


... Karcher 2500 PSI Pressure Washer

On 2/18/09, I had a part replaced (due to a recent recall issue) on our Bosch dishwasher, SHU43C06UC. I had not had any problems with my dishwasher - ever - and, since the replacement, my dishes are not being properly cleaned. The Sears repairman who replaced the part tells me that the part he replaced has nothing to do with my present issue and, because my DW is no longer under warranty, I would have to pay for any further services he may provide. 1) What do I need to do to troubleshoot this di


Http://www.boschappliances.com/safetyrecall/dishwasher/default.aspx?pid=BCH0905OIQ001 ... Bosch 24 in. SHU43 Built-in Dishwasher

Dishwasher makes grinding noise during wash cycle (after pre-wash). noise persists for 15-20 minutes. It seems as though the inlet valve doesn't open during this phase of the cycle. adding water to the dishwasher manually eliminates the noise and water circulates through the wash arms. I'm trying to determine if this is a controller issue or a valve/pump issue.


Water-inlet valve\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012\015\012\011\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\01 ... KitchenAid Dishwashers

First we had drain issue with Bosch Integra® 500 SHX55M05UC Built-in Dishwasher ECO cycle. It stopped after a while. I thought it may be because last cycle might not be finished well. When we ran again ECO cycle with no drain issues but cycle did not finished as it used to be. I am sure because cycle countdown were not zero and because infra red light was off which is sing of complete cycle.


... Bosch Integra® 500 SHX55M05UC Built-in Dishwasher

My maytag dishwasher has water in the basin and won't drain. We had a plumber out, thinking it was a drain issue, but it's not. He thinks it's a dishwasher issue, but he does not work do dishwasher repair. What should I do?


... Maytag Dishwashers

Even after ensuring that really hot water is coming from the faucet and placing the unit on the Delicate/Econo setting we consistently get a 2 HR reading. We have also had it where the unit gets stuck on Cycle 1 and we have to reset to go to CL and clear the system of its waste water. Is this a mechanical issue or a circuit board issue.


Did you discover the source of the 2HR reading? Mine's doing the same thing, except the drain pump keeps running and running as well...\015\012Any ideas?\015\012I can't imagine it's anything but the circuit board (for the third time in t ... Bosch SHU5316UC Dishwasher

Whirlpool ADG993 Hi -Had several issues with the door similar to those posted, coming away at the hinge, not sitting flush so wont close. New issue - the latch has given way, it sounds like it works but the catch is not holding, the door then falls to the floor. Any suggestions for making the latch hold the door closed? - thanks..


Dear friend,\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012\015\012ngfam at you service!\015\012\015\012If its new your warranty is for 12 months!If the dishwasher is 10 years or older its not worth inve ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0270 seconds