Having problems with your Powerwasher 2400psi 2.0gpm Pw2420 Gas Powered Pressure Washer 4 ?

Spark plug for honda pw2420

\015 What spark plug do i need\015

Answers :

Repair Help & Product Troubleshooting for Powerwasher 2400psi 2.0gpm Pw2420 Gas Powered Pressure Washer 4

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

11 hp honda pressure washer engine won't start. No spark at the pkug, bought a new coil and still no spark. This sysem only has a coil off the fly wheel and the spark plug. I even changed spark plug. Use the unit the other day, shut it down and on restart it won't start. Also, I disconnected the kill switch and the il lvel sensor so nothing was going to ground.


If you replaced the coil,check the wire and boot,check with meter for continuity.could be loose connection to spark plug ... Honda Pressure Washer PSI 3000

Troy built pressure washer won't start. It has a Honda 160 CVG motor. I used it for about a year and then it stopped working. I've replaced fuel and spark plug. Spark plug is soaked every


... Karcher 2500 PSI Pressure Washer

I have a Troy Built 2500 PSI pressure washer with Honda 160 CVG motor. It won't start. I've replaced the gas and spark plug. Every time I pull the spark plug out it's soaked. Not sure


... Pressure Washers

Changing Honda HS621 spark plug?


... Honda 4 Hs621 Hs 621 Snowblower Spark Plugs Bpr6es

Whats spark plug gap honda 6 hp gc190 - Honda Pressure Washers


... Honda Pressure Washers

Honda gx240 spark plug resistor - Honda 8 HP Engine


... Honda 8 HP Engine

Honda 215 lawn mower spark plug gap setting - Honda Lawnmower Hrr216 Hrs216 Hrb216 Recoil Starter


... Honda Lawnmower Hrr216 Hrs216 Hrb216 Recoil Starter

Honda gx160 wont pull start with spark plug in.


... Honda Pressure Washers

Honda GX340 engine will start, but will not continue to run. Checked fuel and spark plug.


... Honda Pressure Washers

My 6 hp honda motor has become very hard to pull. It is on a pressure washer. I even removed the pump but still pulls hard.it runs if you can get it started but dosnt seem to be running at full power.I pulled the spark plug and it spins easily. Help!


When you remove the spark plug and it turns easily that means that the valves aren't opening properly. When the spark plug is installed and its hard to turn over, its because the valves (possibly just the exhaust valve) are sticking shut and the pre ... Pressure Washers

Can't start the Honda GX160 5.5 HP Electric motor on my Chore Master 2400psi Pressure Washer. Got gas (checked through feed line), new spark plug, switch on, gas, choke ok, throttle a bit funky (about 12 years old on loan from a friend unused for 5+ years, no manuals). Recoil string sounds close to kicking over, but pretty half-heartedly ...


Is there an oil sensor unit if it is going bad it tells the engine the oil low and engine wont start. I had same problem with my pressure washer, i just unplugged the sensor unit and it started fine ever since ... Pressure Washers

Honda 13 hp will not start, will run on starting spary, new spark plug, has knocing noise before stopping


Hello,If this machine has been sitting for an extended period of time it is likely that you have a couple of things going on. First you should drain the fuel from the gas tank. Next remove the bowl from the carb and using a flat head scre ... Honda Landa PG 3500 PSI Pressure Washer

I have a Husky 2600 PSI power washer with the Honda GCV160 engine that I can't get to start. It was okay when I purchased it from Home Depot last spring but now I've tried putting new gas in it, spraying carb cleaner, new spark plug, and it still won't start. I only ran it for about 30 minutes when I first purchased it. The guy at the service desk at Home Depot told me that the water hose should be attached and turned on while trying to start. Is this true or would this be starting the motor und


You can eliminate the motor by unbolting the pump from it and then if it will start the problem is with the pump or the unloading valve.If it does not start with the pump removed then you check for spark and get the carb cleaned or have a kit put in ... Karcher 2500 PSI Pressure Washer

Honda mower is not starting. Changed filter, spark plug, oil, and gas.


... Honda Lawnmower Hrr216 Hrs216 Hrb216 Recoil Starter

What is the spark plug number for a karcher honda 5hp 2500psi pressure cleaner


... Karcher 2500 PSI Pressure Washer

My Honda 2600 psi power washer will not pull to start. It was running great then I allowed the neighbor to borrow it. He ran the washer till it was out of gas and proceeded to refuel and at this point it would no longer start. The pull cord is out about 4-6 inches out and I am concerned about taking the casing off myself. Fearing that it may throw more off on the unit. If i take the casing off are there any spring loaded parts that will dismount? What should I do? Spark Plug? Turn


You should be fine to take the recoil off, there shouldn't be anything that shoots out at you. You might want to check the oil level on the engine, many of the Honda engines won't start unless there is enough oil in them. If your oil level is fine, c ... Honda Pressure Washer PSI 3000

Honda GX340 engine will start, but will not continue to run. Checked fuel and spark plug.


... Honda 8 HP Engine

Magneto on pump engine is not sparking plug - Honda 8 HP Engine


Has it got plenty of oil ?un plug the low oil senser wire as they do give abit of trouble and tryit then ,if still no spark you may have to lift the fly wheek and get the ignition module checked "youdoit" ... Honda 8 HP Engine

Spark plug gap - Global Industrial 2700 Psi Pressure Washer With 6 Hp Honda Engine


... Global Industrial 2700 Psi Pressure Washer With 6 Hp Honda Engine

I have a troy built power washer powered by honda. It runs for 10 - 15 minutes and then dies. I have replacced the ignition coil, spark plug, rebuilt the carburetor, checked fuel flow and placed the unloader valve and it still dies. Once it dies and the pressure is released it repeats the problem. Any suggestions?


... Honda Pressure Washer PSI 3000

Hello i have a Honda GX160 and the engine will only run on choke if i close it the engine just splutters and thats it. it wont run at the norm i have replaced the carb the tank the air filter and the spark plug and know luck i have no more ideas as to what the problem really is thanks jord


Ii know you must have replaced the fuel filter. Did you replace the fuel line? It is obvious it is not betting enough fuel or it is out of time. Have you tried adjusting the jets on the carb? Have you checked the timing? There is a crankshaft key-way ... Honda Pressure Washer PSI 3000

Honda GX340 pressure washer won't start has oil spark plugs look good and has gas.


... Pressure Washers

Honda GC190 no start. Unit has been sitting for 2 years. Drained old gas, cleaned the carb. No go. New plug gapped to 0.030in. Still nothing. spark seems good. Cleaned the fuel strainer and there IS a bit of vacuum at the fuel pump when cranking. Poured a dab of gas into combustion chamber.. Still won't "talk to me" AT ALL. Removed valve cover and checked the valves.. within specs and nothing sticking or hanging up. Timing belt and cam looks good. Took a peak at the coil.. air gap in specs. 1ohm


... Karcher 2500 PSI Pressure Washer

My porter cable 2400 psi pressure washer will not start. has honda engine gc160. pulled plug and put up against frame and it has spark. It's full of oil.


... Porter Cable Cable Commercial Pressure Washer PCH3200
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0364 seconds