Having problems with your Ridgid 3300 Psi / 3.0 Gpm Gas Pressure Washer 40678 ?

Stuck unloader valve - Ridgid 3300 Psi / 3.0 Gpm Gas Pressure Washer 40678


Answers :

Repair Help & Product Troubleshooting for Ridgid 3300 Psi / 3.0 Gpm Gas Pressure Washer 40678

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Stuck unloader valve - Ridgid 3300 Psi / 3.0 Gpm Gas Pressure Washer 40678


... Ridgid 3300 Psi / 3.0 Gpm Gas Pressure Washer 40678

I was given a low hour, 10 year old, CH PW205002LE 6.5 HP gas vertical shaft 2000 PSI/2.5 GPM pressure washer with a Lavor pump. It did not work - no pressure. I found a broken o-ring on the brass unloader valve and replaced it with a ring as close in size as I could find as the part break down doesn't state size. Everything was very clean. I coated everything with silicine grease and reassembled, seating the brass piston? as deep as it would go. I had to press the trigger in order to get the mo


My personal experience is that 40% of all the sellers I dealt with on e*** exaggerated their products or worse. If you decide to go the e*** way be sure you put it on a good credit card so you can get your money back if it's a bust. Don't use your ba ... Campbell Hausfeld Pressure Washers

I have a Karcher G2600 OR Pressure Washer, 2600 psi, 2.5 gpm. PN 1.194 506 0. gas engine works fine and water flows fine but pump is not adding pressure to stream. Checked and cleaned inlet water filter.


... Pressure Washers

I have a 4,000 psi, 4.5 gpm 45G cat pump powered by a 13 hp honda engine I can not seem to be able to adjust the unloader valve to give me pressure over 950 psi and even at lower pressures, the pump will not deliver consistant pressure without bouncing off to the relief stage and back into the tank Are unloader valves worth repairing, or should i look at just buying a new one my current thought is to buy an EZ start Pulsar


I would just purchase a new unloader valve, they usually aren't worth rebuilding. I would like to have a picture of the set up that you have, if you can send me a picture of the unloader region of the pump I can get you are price on a new one. email ... Honda Pressure Washer PSI 3000

What valve lash should me GX 390 be set at? - Simpson Taskmaster Industrial Gas Powered Pressure Washer 4000 PSI @ 3.5 GPM Honda GX390 Engine And 50' Non-Marring Hose #TM4000BD


Inlet .006 exhaust .008 ... Simpson Taskmaster Industrial Gas Powered Pressure Washer 4000 PSI @ 3.5 GPM Honda GX390 Engine And 50' Non-Marring Hose #TM4000BD

Unable to start gas engine on a NorthStar pressure washer


Disassemble and clean the carb. If it ran briefly with the starer fluid then gasoline is not coming through the carb. ... Northstar Pressure Washers

Owners manual Homelite pressure washer - Homelite Pressure Washer. Honda 2700 psi 2.4 GPM Gas Pressure Washer


... Homelite Pressure Washer. Honda 2700 psi 2.4 GPM Gas Pressure Washer

I have a G2500VH pressure washer that has started to pulse when the trigger is squeezed. This happens if I use the 0,25, and 40 degree nozzles BUT if I use the one for low pressure(detergent use) it will hold pressure fine. I have changed the unloader valve, checked all the valves and seals ad they seem to be fine. What could be the problem?


Do you mean pressure on and off with the hp tips and smooth and steady with chemical tip? ... Pressure Washers

Where to you hook up soap line - Homelite Pressure Washer. 2600 psi 2.3 GPM Gas Pressure Washer UT80522


... Homelite Pressure Washer. 2600 psi 2.3 GPM Gas Pressure Washer UT80522

Pressure washer surges - Generac 2700 PSI 2.3 GPM Gas Pressure Washer Non CA


This could be your unloader valve taking in account the engine isn't surging. Does the engine run smooth? Do you have at least 50 psi water pressure feeding the pump? Inlet screen clogged? ALL tips act same way or no change? ... Generac 2700 PSI 2.3 GPM Gas Pressure Washer Non CA

Looking for user manual for pressure washer - Husqvarna 3100 PSI 2.8 GPM Gas Pressure Washer 020490


... Husqvarna 3100 PSI 2.8 GPM Gas Pressure Washer 020490

Parts diagram for ProForce pressure washer - ProForce Gas Pressure Washer: 2000 psi 1.5 GPM PWF0102000.03


... ProForce Gas Pressure Washer: 2000 psi 1.5 GPM PWF0102000.03

2500 PSI 2.3 GPM Gas Pressure Washer - Troy-Bilt Pressure Washers


... Troy-Bilt Pressure Washers

North Star Model 157597 Pressure Washer from Norther Tool calims to have adjustable pressure. There is nothing in the manual about how to adjust the pressure and I have received two statements from them on how to adjust the pressure: 1. Adjust the pressure at the unloader valve 2. Run the motor at reduced speeds. Which, if either is correct?


... Pressure Washers

Hi ..I have an Excell gas pressure washer model no. Exwgv2121-3 with Faip 2100 psi 2 gpm vertical shaft pump..the problem is that there is water leaking from every weep hole at the bottom of the pump when running. Oddly enough,the pump still puts out significant pressure but less than it should due to the leaking water. What is the most likely cause of this?..is it the high pressure water seal(s)? If so,how do I repair it?


... Pressure Washers

Gas leaking out of carbuerator - Troy-Bilt 2700 PSI 2.3 GPM Gas Pressure Washer CARB 020487


... Troy-Bilt 2700 PSI 2.3 GPM Gas Pressure Washer CARB 020487

Need fuel cap for ridgid power washer - Ridgid Rd80702 3300 Psi 3.0 Gpm 7 Hp Subaru Ex21fi Ohc Gas Powered


... Ridgid Rd80702 3300 Psi 3.0 Gpm 7 Hp Subaru Ex21fi Ohc Gas Powered

Do i need to put something in the gas - Dewalt DS3532 3,500 PSI 3.2 GPM Gas Pressure Washer with Subaru Engine


... Dewalt DS3532 3,500 PSI 3.2 GPM Gas Pressure Washer with Subaru Engine

I have a Husky 2600 Psi 2.3 GPM Honda powered gas pressure washer. When i turn it on the motor runs fine, But when i squeeze the trigger the water is not pressurized when it comes out. How do i fix this problem?


... Honda Pressure Washers

I have a Karcher 2,600 PSI 2.3 GPM Gas Pressure Washer G 2600 VHR that I have used once last summer. I have stored the PW in my basement with no fuel in the gas tank. The PW was never exposed to freezing temps. I cannot get the PW to start. I put new fuel into the tank, the oil is good, I drained the carburetor, and the spark plug works (tested it). I pull the cord and the engine doesn't turn. Fuel value is on, choke is pulled, and the starter switch is turned on. System is practically brand new


Hi I have a similar pressure washer from Kartcher and the same scenario as yours I have owned it for about 2 years and noticed that it was getting harder and harder to start with each time I use it which is months. If your pw has a honda engine on i ... Karcher G 2600 VH Gas Pressure Washer

I have a 4000psi @ 4gpm gas pressure washer, when in bypass mode the psi gauge on discharge outlet says 3200psi but when i pull the trigger the psi drops to 1000psi and stays there. I tried to turn the unloader and nothing happens. thanks Collin


... Karcher Pressure Washers

Black max pressure washer 2600 psi 2.3 gph honda unloader valve stuck


... Honda Black Max 2600 PSI Pressure Washer

Troy-bilt pressure washer 3000 max psi 2.7 gpm not getting gas


The carburetor ports and jets are likely clogged with gum from fuel that contains Ethanol. Avoid using any gasoline that contains Ethanol in small engines. Use only 100% gasoline. You can try the simple method first by adding some Lucas to the gasol ... Briggs & Stratton Pressure Washers

Northstar Hot Water Pressure Washer (model #157322) While using the pressure washer the safety relief valve activated venting steam and hot water from it... I immediately shut it down and let it cool down. After it was cool, I turned on the water supply again and the relief valve was still spewing water from it. My neighbor said it was probably the "unloader" valve was stuck or damaged. I called around my area and it seems as though no one services my pressure washer.. Is there a manu


... Pressure Washers

Troy-Bilt XP 3000 PSI 2.7 GPM Gas Pressure Washer


... Honda Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0843 seconds