Having problems with your Roper 24 in. RUD1000DB Built-in Dishwasher ?

MY Roper WU0800x1 dishwasher does not spin the washing arm. In fact, water just bubbles from the center. I don't know if I need a new water pump or if there are parts missing; the unit was in my RV when I purchased it used. Does anyone have a schematic of the internal parts?


Answers :

Repair Help & Product Troubleshooting for Roper 24 in. RUD1000DB Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

MY Roper WU0800x1 dishwasher does not spin the washing arm. In fact, water just bubbles from the center. I don't know if I need a new water pump or if there are parts missing; the unit was in my RV when I purchased it used. Does anyone have a schematic of the internal parts?


... Roper 24 in. RUD1000DB Built-in Dishwasher

GU2700 Whirlpool - Does NOT FILL 2 Gallons on INITAL FILL - unit has new parts FILL VALVE IS NEW OVER FILL SWITCH IS NEW while filling if you reach under the unit and push the over fill float up it turns off the fill cycle - if you let go - unit keeps filling - but does not add the correct 2 gallons - water is not even close to the heating element - does not have enough water to come out of the TOP SPRAY Arm


... Whirlpool Dishwashers

Ge model # gsc3200j01ww dishwasher. when the door latch is closed, nothing happens. motor does not start. if the timer is advanced to the next part of the cycle, water will spray into unit until float valve is triggered. water will not pump out, motor does not start. bailed out water, checked for stuck float valve-ok. removed drain screens and filters, cleaned. no motor, drain, or start. what parts should i check? always rinsed dishes before putting in washer. unit is portable or undercounter


... GE 25 in. GSC3200J Built-in Dishwasher

Magic Chef DU55CA-01 unit runs but when pump kicks on for discharge cyle water leaks on the floor from the what appears to be the solenoid part. The leaking stops as soon as the pump turns off. What part needs to be replaced? The unit was in storage for some time would this just be an issue with it sitting for some time? What is the best way to determine the real cause of the leak?


Leaking from drain valve shaft seal. If you just replace the seal it may still leak. Replacing the pump is a lot of work and not really worth it to cure a small leak. ... Magic Chef 24 in. DU6550 Built-in Dishwasher

I have purchased a repalcement detergent dispenser-assembly and do not know how to take old one out and relpace with new part. The new part has a face plate that snaps on to the screw mounted base plate assembly which attaches to the door. I need to know how to remove the old dispenser and install the new dispenser without breaking parts and scratching the door. Is there a schematic or exploded repair view I can check out or even written directions?


Hello\015\012& Welcome to FixYa\015\012\015\012To replace the detergent\015\012dispenser you can check this video. The video gives you step by step\015\012instructions:\015\012\015 ... KitchenAid 24 in. KUDP02FRSS Stainless Steel Built-in Dishwasher

My plumber just installed a new water supply line for my dishwasher. Now the pump comes on but no water fills up in the machine. If I fill the bottom of the unit with water, it works just fine. Even though the water supply is ON, it does not pump water into the 'box'. Thanks, Art


You don't know how many times I've heard and found the shutoff valve off or partly turned off. Water entering DW is from line pressure not pumping. Items to suspect (again) the water supply valve (would'nt be the first time a new valve is bad). The ... Whirlpool 24 in. DU915QW Built-in Dishwasher

Kenmore (Whirlpool) 655 1589910 Dishwasher. Fills with water, motor makes horrible noise (buzzing / loud hum). Dishes do not wash and there is no evidence that any water pumped up to the spray arms. Spray arms are not clogged. We have a fully functioning water softener so it is not a hard water issue. Unit does drain normally. Either filter is badly clogged or pump is bad. How do I get to these parts to check them out?


You need to clean/ check the chopper. sounds like you have a bad motor. about 2-300 dollars for the part ... Kenmore 15899 Built-in Dishwasher

Have GE Dishwasher model GLD6700N20WW,unit has stopped draining! Took apart and pump was running when check, but no water coming out. Checked drain line and pulled apart pump housing, all clear. Thought maybe pump has a silinoid built inside of it and was stuck shut, so bought new pump and same thing, no water will go thru! Please help me? Is it control module, or turbitity sensor possibly?


... GE Profile PDW8600J Built-in Dishwasher

Miele G575 has suddenly stopped pumping out water after a cycle. I've tried cleaning parts - could it need a new pump? Thanks


... Miele 24 in. G881SCI Built-in Dishwasher

EDW5500DSS wont completely drain water Okay so now that my dishwasher runs, when it finishes a cycle it has a nice puddle of water at the bottom that never drains completely out. I am assuming its a relay or something because I looked for a floating switch (did not find), I can hear a pump sound as if it wants to pump the remaining water out, but, it doesn't. I really want to solve this problem soon so I can order the new door seal and needed part together. Checked the line out and of course i


The srainer over the pump could be clogged not letting the water drain quick enough. Be sure the screen is cleane out. I believe you would have already checked and cleaned this. I believe it is the impeller on the pump that pumps the water that is ei ... Dishwashers

How do I reinstall the pump seal? I have old KitchenAid KDS-16 dishwasher. The drain impeller failed and I purchased a new kit. Disassembled the pump. Installed the new pump seal but it does not hold water.


You may have tilted the seal when installing so take it apart again and make sure it is all the way down in its bed and it streight to the shaft . and looks centered then reinstall all other parts and try again .. mm h ... KitchenAid Dishwashers

Plastic Pieces We purchased our ASKO 1385 dishwasher 7-8 years ago. Over the years, I have found "small square, thin, pieces of gray plastic" inside. Where are these coming from? Also, we have replaced the drain pump 2 years ago and looks like we'll be replaced the main pump within the next few days as no water is going through. We are looking at paying big $$$ for that pump. Almost half as much as purchasing a new dishwasher. Is this a common problem?


Yes, I have the same problem and it is the upper bearing rack, not the pump impeller. The new bearing kit is $30.00 (another is available for $123.00-the same!!). ... Asko 1385 Dishwasher

FDW70 dishwasher, starts to fill with water, shows pre wash on control panel, then pumps out within about 2-3 minutes, but has vertualy no water in it. Puts up code A10 on control panel, can still hear the pump going even when l open the door. Have replaced a burnt out heater tube with a new genuine unit, also have removed & checked fill valve & this works fine.


Hi,Try this few steps;Turn off the water supply to the dishwasher and remove the hose, turn\015\012on the machine for a couple of minutes in a fill position then turn off\015\012the machine, reconnect the hose, turn the ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Pressurized water sprays out bottom of pump but no visible cracks, seals or washers maybe? Are these parts available, I only see a replacement pump complete unit... Unit has less than 10 hrs use.


... Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer

Eaton viking i have an old eaton viking dishwasher. model# DC392W149 the seal in the pump for diverting water to the top spinner bar is worn out. i cannot seem to find parts anywhere. should i try to find a new pump assembly or break down and buy a new dishwasher?


... Viking Dishwashers

E1 fault code Dishwasher runs for about 5 minutes. Water fills up at bottom of unit and then machine seems to pause then fault code E1 appears then water is pumped out from bottom of machine. There are no leaking pipes and drain is installed correctly. I installed a new wash pump and fault still appears.


Hi,\015\012I think both the heater and thermostat / trip switches need to be checked.\015\012If water is going in and out ok, then it seems to be waiting to heat the water. It sees a fault - so just clears out.\015\012Heating elemen ... Dishwashers

During wash cycle water leak appears on the floor at the left side of the unit. this is a new unit model #Kuds301vwh #FO1114221 purchased and then installed on 3/25/10. Gasket was replaced on door by factory repair man and leak continues. unit appears to be level.Unit is covered under warrantee.


... KitchenAid KUDS30IV Builtin Dishwasher

I have a Maytag dishwasher (MDB600AWA) and it does not pump the water out. The pump motor doesn't seem to be coming on or trying to pump. I've never had any other trouble with this. It was purchased new in '99, but not installed until 2001 (long story) Can you help?


Ive found miriad things in dishwasher pumps...watch,bullets,underwear,money,chicken bones. i would first suspect the pump of being plugged or stopped up with something. if you are handy with tools you could remove the pump to check. if not call a rep ... Maytag MDB9600A Jetclean II Built-in Dishwasher

My Karcher K3.48M pressure washer remains in the low pressure mode even when I return the pressure nozzle to the high pressure position. How can this be corrected. The pump seems to build up the pressure because when I release the handle the pump motor stops. This is a fairly new pump which was purchased in the latter part of last year(2010). Could this have been caused by the detergent I have been using which is an automotive shampoo? Please help I love this washer and for the times that I u


... Karcher PSI Electric Pressure Washer

Trying to connect Sears Dishwasher model 110733500 Iknow where the water goes in, but can't figure out where the water goes out I see where there is an outlet that might be it but I must be missing a part for it this is a used dishwasher and I don't have the schematic for it. Thanks, Richard


In the space below the door, look on the left side and you will see 2 almost clear drain hoses. One goes to a loop up the side of the dishwasher, the other is tucked into the left frame just for shipping. Gently pull it out and connect to the suppl ... Kenmore Dishwashers

New SHE4AM16UC, professionally installed eight months ago. Worked fine with very light usage until now. Dishwasher starts normally but stops and signals "clean" after less than five minutes on any cycle. One inch of water in bottom that (I think) drains when a new cycle starts. Soap tablets are not ejected from compartment. Bosch authorized repairman says he now has two client dishwashers with identical symptoms and is asking Bosch support for ideas (he's changed pump, control unit, and float sw


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the clean light flashes, pauses, and then repeats.\015\012When the dishwasher doesn't sense a water t ... Bosch SHE4AM16UC 24 in. Built-in Dishwasher

My washer will not drain the water I think that the pump has gone out in it is it going to be cost efective to put a new pump in it or should i just replace the entire unit


You could just need to clean out the sump if the drain pump impeller is jammed. Below is a link to a video you can download that will show you how to repair a Bosch Dishwasher that isn't draining. ... Bosch 24 in. SHU43 Built-in Dishwasher

I removed an old dishwasher and replaced it with this GE 24" Profile GSD533ODO1WW unit. It seems to run through the cycles like it should but it doesn't seem to run any water for some reason. I hooked up a new water line to it and turned it on. There where no leaks that I could see. Is there any installation manual that you could send me to make sure that I didn't miss anything or is there anything that you can tell me that I should look for? Thanks, Jesse


... Dishwashers

Hi I am in an emergency situation with an ikea whirlpool dishwasher. I have no idea what model it is since it's built in and I can't find the manual in my rental apartment. The machine works normally until the part where it's supposed to pump the water out after rinsing. At this point it starts to beep, once, and then 3 times. On and on and on. If I open it, there is water stagnated there. If I try to turn it off and back in, it will go through a whole new program and then I get the same problem


Can you feel the pump operate during the last wash cycles? if not either theres a bad pump motor or lack of power to the pump during that cycle,if this is ok,then remove the drain hose to the main drain to see if this is plugged up with food debris ... Whirlpool GU2400XTP Built-in Dishwasher

Missing "turnscrew" I just purchased this as a floor model from Olum's in Vestal, NY. I brought the unit home and the "turnscrew" that fastens down the lower spray arm is missing. Please email me the part # so that I can have them secure one for me and I can start using my dishwasher! Thanks. Joe Roma


... Whirlpool DP940PWSQ Free-Standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1813 seconds