Having problems with your Samsung 24 in. DB5710DT Stainless Steel Built-in Dishwasher ?

HI.. I purchased a drm57 washer from Futureshop and within 2 weeks the letters were wearing off the control panel. http://www.thebuckleycrew.com/downloads/dw.jpg Future shop replaced it yesterday and now if i rub the letters on the new one, i see ink smearing on it also. obviously it's going to look the same. any advice? thx Eric


Answers :

Samsung changed the way they seal the lettering now. You need another brand new control panel
Repair Help & Product Troubleshooting for Samsung 24 in. DB5710DT Stainless Steel Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

HI.. I purchased a drm57 washer from Futureshop and within 2 weeks the letters were wearing off the control panel. http://www.thebuckleycrew.com/downloads/dw.jpg Future shop replaced it yesterday and now if i rub the letters on the new one, i see ink smearing on it also. obviously it's going to look the same. any advice? thx Eric


Samsung changed the way they seal the lettering now. You need another brand new control panel ... Samsung 24 in. DB5710DT Stainless Steel Built-in Dishwasher

I have an Ariston LS245 dishwasher, have just had the pump replaced, as it had shorted out, due to water in the bottom tray where the water detection float is, also a new drain hose fitted. Have just run a wash and after running a while, presumably to the end of the rinse, wash and dry cycle, then one of the cycle phase lights, the one for 'soak' blinks constantly. I switched the machine off and had a look to see if a wash had been done, the dishes look clean. In the book it says that if one


... Ariston Technologies Dishwashers

Hi - I've been all over your web site and keep getting rejected - alas. I have one of those wonderful Fisher Paykell double drawer dishwasher unit Model # 88445 (I think but also see another number LIM725367) I bought in new in 2007 worked fantastic but tore down my b ungalow now have a new kitchen ready for it. Carol 303 320 1697 [email protected] May 6 2011 11:30 AM MDT I would like to obtain an installation manual so I can make sure I packed all the parts and then put it in m


Hello Carol - \015\012\015\012\015\012The full model number for future reference is DD603-88445. I've uploaded the installation manual for all Fisher & Paykel DD603 double-drawer dishwashers to Rapidshare. Please follow the instruc ... Dishwashers

Hi my nearly 9yr old neff S5555 integrated dishwasher has problems on the control panel the program times come up with the completely the wrong times for the wash ie the 150 one comes up saying 32minutes on a quick wash it gets stuck at 1 minute left and keeps going on, also the delay timer timer is not working ( I have been told this could be a problem with the programmer) . Is it cost effective to get the progammer changed plus engineers cost or shall l look for a new dishwasher? Thanks Su


... Dishwashers

Hi my nearly 9yr old neff S5555XOGB/40 integrated dishwasher has problems on the control panel the program times come up with the completely the wrong times for the wash ie the 150 one comes up saying 32minutes on a quick wash it gets stuck at 1 minute left and keeps going on, also the delay timer timer is not working ( I have been told this could be a problem with the programmer) . Is it cost effective to get the progammer changed plus engineers cost or shall l look for a new dishwasher? Th


... Neff 24 in. S5543X2 Built-in Dishwasher

About a 3 year old maytag stainless steel inside dishwasher, not cleaning, often soap resdue on dishes or silverware, I use fresh new cascade, checked to see if washer fills with hot water, seems to up to the bottom of the door when I open durning cycle, arms go around, no obvious plugging of the screens, no junk in the foot chopper propeller, no paper or plastic or food in the jets of the arms. Motor went out on it 9 month ago and I had it replaced by appliance repair station here in Missoul


Water must be 130 Deg F to wash properly. ... Maytag Dishwashers

I have a Delonghi DW67S dishwasher which I have been using for about 2 months now. It has been 3 washes now that the dispenser hasn't opened while washing leaving the detergent still in the dispenser. I have replaced the detergent with a new one from a different batch but the same problem. I have also chosen a different washing cycle to see if it was that particular cycle I was using but still the same problem.


... Dishwashers

My 12 yr old KitchenAid -Sculptura-Model KUDR24SE starts to fills with water and then does nothing else. It will eventually go through the cycles on the panel, but nothing is happening inside. End result is still dirty dishes with water sitting in the bottom that has to be baled out. Cups on top rack don't have any water on the indentations, so it's obvious that the thing filled with water and that's it. I had the motor replaced (supposedly with a new) one 2 years ago so I find it hard to bel


... Dishwashers

Hello I have a built in DCS dishwasher - width 24" heigh 35". It started smoking out the front and the repair man said it needs a new control board. Is that possible or should I buy a new one. IT is not a dishdrawer its a full dishwasher. the top rack is also broken. If I need to buy a new one - where from - new jersey area


Http://www.thefind.com/appliances/browse-dcs-single-dishwasheryou can purchase online from here... ... Dishwashers

Bad i bought the 1800 psi washer 2 years ago the head on the hose blew off you sent me a new hose it did the same thing. you sent me anouther hose and it blew off too. finaliy you sent me a hole new washer because of a recall. i didnt get to use the first one all year and now i was going to use the new one the other day 3-28-09 and it is the same washer i had and the head blew off so now i have two washers with no hose, that i can not use. so what do i do now ?


... McCulloch FHH18A Electric Pressure Washer

On our Hobart Dishwaher, Model AM15T, S/N-23-1000-664 won't start with message wrench & P2. The Thermistor is not open or shorted with resistance reading of 64 Kilo-ohms. I suspect that the Relay Board P/N- 892934-2F is not good. I installed the New spare board P/N 892934-1 Rev.F, but no display at all. Is this the correct PCB? Also the Thermistor is on one assembly with float switc. The new spare we had is only a Thermistor P/N F370609. I also checked the 3- Thermostat on the Tank and they are


... Hobart Dishwashers

I have got a problem with my circuit board on my homark dw45bi any ideas where i can get a new one or fix the old one there is power going into 1 side and coming out of it but not going into the other side any ideas???


... Dishwashers

It has stopped working, There is power going into te machine. An engineer from Repaircare said it was the programmer, ordered a new on vcame to fit it said it was te wrong one. Ordered anoter one Whirlopool saaid it was out of stock, on back order. Waited 3 weeks engineer came with new programmer, fitted it it didnt work. Said maybe they can't fix it. Thew nachine is only two years old and a popular make. WHAT CAN I DO???


Hi,I am sorry to hear regarding the problem. You need to have some patience in order to find what's actually work with the Dishwasher. I cannot jump to the conclusion as there might be "N" number of reasons.Now, Fi ... Whirlpool Dishwashers

Maytag dishwasher MDB8951BWB not drying dishes throughly. Have had several Maytag authorized technicians looking at the dishwasher and saying it is operating normal. That because of the mandated energy saving requirements newer dishwashers do not dry dishes like the old ones. In addition, our older set of stainless steel silverware rusted out, my wife bought a brand new fairly expensive set and the new ones are starting to rust. After going through a wash cycle there is a foul smell similar


... Dishwashers

Hi I have a Nemo Dishwasher and the top spray arm is not turning. The bottom one is going fine and there is certainly plenty of water getting into the washer as I opened the door with the washer going and it flood me. I can see the water getting into both spray arms - the bottom one has a excellent upward spray and turns - the upper spray arm has water getting into it but it will not turn. I have cleaned the dishwasher out and any internal parts that I could find so it is spotless - this is so f


... Fisher and Paykel DS602 Dishwasher

Bosch SHU 3300. Soap dispenser not opening during cycle--and this is a brand new soap dispenser (old one would not stay closed in the beginning of cycle). Also had control panel replaced because old one started smoking.


... Bosch Dishwashers

Dishwasher I am getting a run around with getting my LG dishwasher fixed properly. We had a tech more than once come in and look at our dishwasher. It has not been fixed and never dried the dishes properly. It is now leaking and going to a "del" level when we attempt to wash the dishes. It is also leaking on our fairly new tiled floor and under our new kitchen cabinet. Your tech stated the dishwasher was not installed properly. The installation dept , Francine stated it is not their problem


Not sure what you mean by a "del" level, but as far a drying issues:\015\012\015\012LG chose to use a very energy efficient drying method which relies on the residual heat of the dishes to help dry them rather than many manufacturer ... LG LDF6810 Built-in Dishwasher

I have a Whirlpool Quiet Partner 3. It sat up for a few months because the control panel went out and it took a while to save up and order a new one. Now it blew the thermal fuse. I put a 15amp automotive fuse in it to try it, and it runs until it fills up and blows the fuse again. I am trying to figure out how to test the motor and the heating element to see if they are shorted. My local repair shop told me that they want to replace my new panel with their panel first, and that after that


A 15amp automotive fuse is rated for a 12VDC system in an automobile, not a 125VAC houshold electrical system in an appliance. I don't think your automotive fuse can handle the start current being drawn by the main wash pump as the dishwasher starts ... Dishwashers

Part missing, don"t know which one. need to see service manuel for 5hp model xr 2600-1 ser.no. 2551347902 don"t have one to go to.


... Honda Pressure Washers

We've just installed a new to us dishwasher. We've not had one previously so all of the plumming is new for that. When I turn on the dishwasher it seems as if the water is only trickles and it's obvious by the sound that the jet are not turning. What are some things I can check before I have to call out a professional?


The water-inlet valve lets water enter the machine. First Check to see if the valve is getting water. Make sure it's not clogged. There is a screen on the inside of the valve, this sometimes gets clogged up with debris. Check to see if you g ... Kenmore Dishwashers

Classique Dishwasher I have classique dishwasher its the biggest load of rubbish i have ever used - i have had 2 new ones due to buying new houses - they dont wash properly and the tablets either stay in the dispenser or smear everywhere - cant wait to get rid of it


... Jenn-Air 24 in. JDB8910 Built-in Dishwasher

The circuit board on our Miele G646 dishwasher has failed. do we 1) see if we can get another one second hand and in which case what other models have a compatible circuit board 2) try and get the board repaired and who do you recommend 3) bite the bullet and pay an exorbitant amount for a new board or 4) give up and just buy a new machine Thanks


What is the dwasher doing or not doing and how do you know it's the board. More information required please. ... Dishwashers

Hello, My husband bumped into our Bosch dishwasher door when it was open. It won't close now, one side is about an inch higher than the other. Also the inside of the door (not the hinge) looks bent. What can we do? Can a repairman fix the door or do we need to get a new one?


THE DOOR NEEDS TO BE RESET IN ITS POSITION.THAT A REPAIR MAN CAN DO BEST YOU GET THE AXPERT IN TO ASSIST YOU.\015\012\015\012GOODLUCK.\015\012\015\012MOHAMED ... Bosch Dishwashers

My dish washer is not draining the water, I have a garbage disposal but its junk I am going to get a new one in a month or so it has a hole in it, I took the line going to the disposal off it had a lot of stuff in it but no water was coming out, I then took a vaccum and some water started coming out but did not continue any guesses?


If there is no blockage then the pump impeller or the motor has failed. Only disassembly will locate the real issue.Eric ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

Dishwasher problem Our Asko 1353 dishwasher stops halfway through its's wash cycle. I suspected the thermostat, as it seemed loose in it's holder and not tight against the tub. After I tightened the holder the problem is still the same. Also, the on/off switch (pressure switch?) does not stay in the on position and when I looked it over I found one of the crimp on terminals had melted. Short circuit? Too much resistance from bad thermostat? How do I check the thermostat before I order a new one?


I think your switch may just be bad,but to check the t-stat remove both wires and use a multimeter,set the meter to ohms and connect the two leads to the terminals on the t-stat.with the t-stat to off you should read an (ol) open condition,when you t ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0834 seconds