Having problems with your Samsung Dishwashers ?

A little smiling man symbol appears on the front panel. It has blocked out the ability to run a new lead of wash. what does the man mean, and what do I do to fix it?


Answers :

Repair Help & Product Troubleshooting for Samsung Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

A little smiling man symbol appears on the front panel. It has blocked out the ability to run a new lead of wash. what does the man mean, and what do I do to fix it?


... Samsung Dishwashers

Dishwasher I am getting a run around with getting my LG dishwasher fixed properly. We had a tech more than once come in and look at our dishwasher. It has not been fixed and never dried the dishes properly. It is now leaking and going to a "del" level when we attempt to wash the dishes. It is also leaking on our fairly new tiled floor and under our new kitchen cabinet. Your tech stated the dishwasher was not installed properly. The installation dept , Francine stated it is not their problem


Not sure what you mean by a "del" level, but as far a drying issues:\015\012\015\012LG chose to use a very energy efficient drying method which relies on the residual heat of the dishes to help dry them rather than many manufacturer ... LG LDF6810 Built-in Dishwasher

I have a new Bosch Dishwasher.I just turned the Unit on and 10 Minutes into the Wash Cycle it comes up with Error Code E 16. There is no information in the Operating instructions about what this means or how to fix it. I have been on the phone for 1 hours on hold listening to elevator music after ringing BSH Home Appliances Pty Ltd Customer Care I just install in using the Installation Guide. I have 20 years experiance in Appliance Repairs. Does anyone know what E 16 means and what is the fix.


... Bosch Dishwashers

I have a De Dietrich DV640JE1 built in 45cm Dishwasher, working fine for over 3 years. After replacing the connection under the sink to fix a leak it has stopped working. But I dont think this is related. I run a cycle and it fills water in the bottom of the machine, it drains it out in the end but the 2 arms are not rotating and no water comes out. I checked the arms and they are not blocked. A faint clunking sound can be heard at some part of the cycle. I did also run a cycle with the dr


Hello Benny,\015\012\015\012It's highly unlikely that replacing the connection under the sink is related to this problem.\015\012\015\012From the symptoms you describe, it's almost certain that the circulation pump motor has f ... Dishwashers

We had a problem with our garbage disposal and it resulted with water leaking from our dishwasher. The disposal is fixed, I removed the excess water from the dishwasher. I tried to run the dishwasher empty to clean it. It runs but then the E-2 alert shows on the control panel meaning high water level. I read in the book that I may have to have a service person do some sort of a reset. Is this correct?


Contacted the company and they e-mailed instructions to fix problem ... Asko 24 in. 1895 Built-in Dishwasher

Kenmore model#587(Frigidaire) leaks under door. New install. Had machine for a year plus before install. took off front panel- can see water squirting past lower door gasket as wash arms rotate. cause is water running down door during wash cycle piles up in the channels molded into the lower left & right side of the wash tub and pushes out the sides of the lower gasket. looks like a design issue- called SEARS, they just want to sell me a new gasket! go figure. any ideas on a fix?


It does sound like an inner door seal ,however If you get upset at Sears and complain they may help you as they say the squeaky hinge gets the oil..And with Sears the more you squeak the better your chances of results ...Good Luck ... Dishwashers

My 2008 frigidaire 24" dishwasher model #FDB1050REC is not washing during the cycle. I have run the test cycle and the tub is filling up and draining but no washing is taking place during the wash cycle. The dishwasher has an electronic control board and therfore no mechanical timer. I put test leads to check for voltage on the power leads to the main washing pump, which I have already replaced with a new one, and I'm only registering a low voltage of around 10 or 11 VAC. With the cycle off I'm


If you have replace the motor and this did not fix your problem then yes replace the control board ... Dishwashers

E4 error light comes on, dishwasher won't run, this apparently means water is on a sensor, have removed water from collection tray in bottom, tilted machine backward to dry out sensor, left for 24 hours, machine still won't run. Currently a very small new counter top but a useless dishwasher.


The problem is related to the floater assembly inside the dishwasher. It is filling up with gunk and stop working properly. I found out the hard way after a good spill. The solution is easy but takes a bit of time.1. Unplug the power and water h ... Danby DDW497W 22 in. Countertop Dishwasher

Bosch Dishwasher has error code e24, I checked the line, replaced with new pump, new control unit and call repair man no luck. It works on and off. I get it run then next cyle nothing. Heelp!


... Dishwashers

Model 587784100 My 18inch Kenmore apartment-sized portable dishwasher leaks when running and needs a new main rubber gasket (where the door seals the washer), and a new collar of some sort of white hard plastic collar at the very bottom of the spinning washer arm (which I believe helps make it spin more freely and not "chatter"?) My question is: Is it possible foe a handy person to replace these parts (looks fairly easy), or should I get a proper Kenmore/Sears repairman to fix it?


If you think you can do it then do it. it is normally not any harder than it looks. now because i work there i would say call them :) but you can change those parts fairly easily ... Kenmore Dishwashers

The slide on the upper basket keeps falling out. It's been fixed twice but doesn't hold. The second repair man who put the slide back in the rollers said he couldn't see anything wrong with it, but it still didn't hold, so he called your tech dept. who said they had roller and slide kits at a total cost of $66 for this model. The slide kit had a new part number but the tech department didn't tell the repair man why they'd changed the part. The roller kit was one for dishwashers the sides o


One option is installing stainless steel washers on the rack supports that screw into the side of the tub. The rack falls down because there is too much "slop" with the rack...a couple small washers to space them tighter normally does the trick. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

WHEN YOU PLUG THE UNIT IN , YOU HAVE TO HIT THE RESET TO MAKE OT RUN. tHEN WHEN IT START IS RUNS SHUTS OFF AND YOU AGAIN HAVE TO HIT THE RESET. THIS HAPPENS OVER AND OVER. iT ALSO LEAKS, i HAVE HAD THIS FOR LITTLE OVER A YEAR AND REALLY DECIDED ITS A PIECE OF JUNK. iT APPEARS FIORM THE SERVICE CENTER I TALKED TO, ITS COST MORE TO FIX IT THAN A NEW ONE. WHAT A RACKET.


Hello Dennis,You are looking at 2 possible causes for the resets. First is that the GFI adapter has become defective, or water has found its way inside. Either way, it will need to be replaced if it defective. Second, the GFI may be do ... Karcher PSI Electric Pressure Washer

Hi, I have a whirlpool ADG 7340 dishwasher and it's failing to run a full cycle (it just starts beeping constantly about half way through). The light is flashing 4 times so I guess that means it's fault number 4 but I have no idea what fault 4 means & how it would need to be fixed.


... Whirlpool Dishwashers

I have a new Bosch SHE4AM06UC dishwasher that won't run. It sounds like it is starting, says active, then immediately goes to clean without ever running. What is the fix.?


... Bosch SHE4AM06UC 24 in. Built-in Dishwasher

We have a kitchenaid dishwasher, kudi22ot3, installed in 1992. It is not cleaning dishes even thought the tub is getting water, and we've run dishwasher magic through it a couple of times. The dishes will get clean for a few runs, and then will stop getting clean. Is it time for a new dishwasher or can this one be fixed? Thank you.


Hi,There are 6 major reasons that could affect the cleaning.A nice guide you could follow is :-http://www.partselect.com/dishwasher+dishes-not-clean+repair.htmOther than this, you need to check the pump. Make sure ... KitchenAid Dishwashers

Dw44zp fithe bottom was full of water and would not drain, fixed the drain issue with new hose and clan out of basin. Next I restart the dishwasher to see it run and NOW the drain pump runs forever and wont go thru the cycles ??rst


... Thermador DW44Z Built-in Dishwasher

My Kenmore 16533 dishwasher all of sudden started running really loud on the wash cycle. I stopped the cycle, drained the unit, and looked for something obstructing--found nothing. Started it up, and the problem persists. The dishes do come out clean, however. The dishwasher is 6 yrs old. Is this a problem I could fix, or do I need a repairman? Is it worth the expense of a repairman, or is it time for a new unit?


... Kenmore 24 in. 16533 Stainless Steel Built-in Dishwasher

My maytag dishwasher door will not latch shut, and all of the lights keep flashing. What does this mean and how can I fix it? or will I have to buy a new one....?


Hi- Yes, these can be a problem. It is most likely the latch assembly as long as you don't see any obstructions and the racks are going all the way back. Sometimes you can carefully bend the strike (the part that sticks out from the frame) and get ... KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher

My eurotech dishwasher comes up with an error code E1 after running what does this mean and where can i order parts to fix.


... Dishwashers

G851 SC Plus started to trip GFI plug. Called Miele and they said there was nothing wrong with the dishwasher and the GFI was faulty. Unplugged from GFI and plugged into regular plug and it worked for a few days. Eventually stopped running. How wrong Miele was, it had everything to do with the dishwasher and not the GFI. It was only warning me a problem was coming. Appliance man came out, noticed water in bottom pan and order new pump, said seal probably gone. Came back, replaced the pump, put d


... Miele 24 in. Novotronic G851SC Plus Built-In Dishwasher

Frigidaire dishwasher PLD2855RFC rinse aid leaks around cap. How to fix? New cap? Is this a recurring problem? I have found rinse aid on door below cap (residue) plus have found rinse aid itself on dish below dispenser. I have to refill the rinse aid reservoir about every 7 or 8 wash loads. Also, the dishwasher is very noisy when running (should be quieter). Not very happy with this model ...


... Frigidaire PLD2855RFC Dishwasher

My Bosch shu 5315uc does not advance to rinse or dry. Machine just keeps running. Dishes are dirty and smelly. Manuel says to check if water line is closed or inlet filter blocked. Have no idea how to do these. It is out of warrantee. Should I bother to pay for repair and parts, or would you just invest in a new one. Please help!


The waste pipe may be blocked or partly blocke. Is this connected with another appliance under the sink?( T junction?.\015\012It may be blocked or partly blocked. ... Bosch SHU5315UC Dishwasher

My elecrolux dishwasher gives me error code 11. What do I do? I have the manual, which says that it timed out before it could establish a drain... but there is no info on how to fix it. The dishwasher is new, but it has run 6 or 7 times with no problems.


... Electrolux EWDW6505GS Fully Integrated Dishwasher with 9 Wash Cycles, Nylon Racks, Wave-Touch Contro... 24 in. Built-in Dishwasher

When I switch my karcher k4.97 washer on it just sits and pulsates(on off on off etc.)When I squeeze the trigger it runs perfect,but emits a very low pressure.Then when I release the trigger it reverts back to pulsating. I have tried the popular fixes like cleaning lances,filters,making sure its not airlocked etc.I have even fitted new parts(seals to the pump etc).There are no leaks what so ever.


You have an internal crack in the out let head of the machine very comon in thease machine and not expencive to fix ... Alfred Karcher K 5.93 M Electric Pressure Washer

The electronic panel on the top of the door doesnt light up anymore and is unresponsive, when the power is turned on, the machine makes a sound like its running or draining or something, but nothing is happening. This all started after a potential electrical disruption following a power outage. Perhaps there is a fuse or some relatively easy way to fix this? or am I screwed and should just call a repair man. Thanks for your suggestions, Brodie


... Bosch 24 in. SHX56B05 Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1427 seconds