Having problems with your Siemens Dishwashers ?

HI I have a extraklasse SE24A230GB/17 - it won't stop washing - I've tried to reset , checked filters are clean, checked no blockage in out pipe but it won't drain or stop washing . Can you advise please ? thank you Karen


Answers :

Sorry to tell you, but the board will need to be replaced.The micoM.(processor )is corrupt.
The water inlet valve is stuck open, you will have to replace it, or if your a DIY unplug washer, turn water off, both valves,
pull washer out, theres plastic valve with wires running to it.
and a hose, [where the water hoses hook up to washer, ] remove the valve, remove the screws that hold the top barrel on to the val;ve, clean valve seat , check fo wear, theres a little round slug that has a seat on it, and is spring loaded, see that it moves freely into coil housing, put it back together,
\015\012\015\012\015\012
\015\012Also have look at this post below, although NOT your exact model, they are all similar and this most likely apply as well.\015\012
\015\012http://www.selfhelpforums.com/archive/index.php/t-5111.html\015\012
\015\012\015\012
  • Check and make sure that the washer is plugged in. I know that sounds stupid, but washers move and it has happened before.
  • \015\012
  • Check and see if the washer works during the rinse cycle. if the motor moves then skip to step 3 If the motor does not turn then you need to test the power outlet. use a small hand held appliance like a hand mixer to make sure the outlet has power. If the outlet has no power you need to check your breakers. If the outlet has power you need to call a repairman for your washer.
  • \015\012
  • Good news because your washer works on the rinse cycle your problem may not be that severe. First check to make sure your lid switch is working. The lid switch is a safety device that ensures that the lid is closed before the machine will begin the spin cycle. to check the lid switch simply close and open the lid several times. each time you close the lid you should here a distinctive click. if there is no click then you need to replace the lid switch. if the is a click continue to step 4
  • \015\012
  • Ok you have power and you lid switch is working that means you have one of two things going on. 1. you have clog in the line or 2. your pump is burnt out. To check for a clog start at the back of the washer and remove the drain hose. Be ready for water! It may come pouring out. if water does come pouring out then you need to check the drain hose for a clog. If there is no clog in the drain hose then you have a bad pump and it will have to be replaced. If water does not come out when you remove the drain hose then you have a clog. the clog is either in the pump or in the upper hose that runs from the tank to pump.


  • \015\012
    \015\012
    Repair Help & Product Troubleshooting for Siemens Dishwashers

    Tips for a great answer:

    - Provide details, support with references or personal experience .
    - If you need clarification, ask it in the comment box .
    - It's 100% free, no registration required.

    Suggested Questions/Answers :

    HI I have a extraklasse SE24A230GB/17 - it won't stop washing - I've tried to reset , checked filters are clean, checked no blockage in out pipe but it won't drain or stop washing . Can you advise please ? thank you Karen


    Sorry to tell you, but the board will need to be replaced.The micoM.(processor )is corrupt. ... Siemens Dishwashers

    Candy washing machine runs through programme and stops at the point where it drains the drum to start the spin. Have switched it off and turned timer to correct position and it drains and spins OK (1200 spin) Tried other programmes on timer but same thing, stopping at point where the pump drains and the spin starts. Have checked the pump and is OK any ideas please, I am quite capable of taking the machine apart for repair. Thanks in anticipation Pete


    ... Dishwashers

    My bosch excell dishwasher won't drain it stops during the wash and won't restart until I have emptied the water then it will wash ok until it gets to the drain part of the programme then it stops again. The red warning light comes on for check the water


    A clog in the drain line or air gap (if there is one) is the usual\015\012reason that a dishwasher won't drain. Often the problem is at the point\015\012where the drain line attaches to the garbage disposer or household\015\012drain line. If you remo ... Bosch Dishwashers

    Bosch dishwasher won't drain...it washes the dishes great but there is water remaining in the bottom after the wash cycle is finished. I have done the following with no results: 1. checked drain hose to sink and it was clear of debris 2.removed filter and cleared it out as well as removed the bottom cover and checked there...looked clear. please help


    Hi\015\012\015\012There are a few things to check with this problem on Bosch Dishwashers. \015\012\015\012As always for safety reasons disconnect the dishwasher from the mains supply before carrying out these checks.\015 ... Bosch Dishwashers

    Currently the only setting that is working is Sani Wash. If I use any of the other settings the Intake Drain light comes on and everythig stops. How can the Sani Wash cycle work fine and no Intake Drain light when all other cycles trigger the Intake Drain light and won't continue to wash? Thanks,Karen


    I decided I'd wait for the repairman; I don't want to have to pay additional money. ... Dishwashers

    Miele g7859 will rinse and drain on programme but wont run through a wash programme and drain its stops after about 30 secs was working on a wash programme till it went to drain f a fault code would come up tipped machine on its side then it would rinse and drain it would not do that before


    ... Miele G7859 Thermal Disinfection Dishwasher

    I have a new FDB520RHS2A Frigidaire dishwasher which remains in the wash cycle after I've started it. It sounds as if it is changing cycles but the wash light stays lit and never switches to rinse. The machine continues to run for hours if I don't stop it. We've checked the drain to the garbage disposal and it is clear. the water temp seems to be hot enough but how do I check that? Any ideas on what we should check before we bring it back to the store? Your help is much appreciated. Thanks!


    ... Dishwashers

    Miele g7859 will rinse and drain on programme but wont run through a wash programme and drain its stops after about 30 secs was working on a wash programme till it went to drain f a fault code would


    ... Miele G7859 Thermal Disinfection Dishwasher

    My whirlpool dishwasher gu2300 wont drain. I checked all the hoses, and i checked the basin and cleaned it out. and it still wont empty please some one help.


    ... Whirlpool GU2300XTV Dishwasher

    Hello My zanussi diva edw1500 stopped working half way through a wash and there is i30 flashing. According to the manual this is some protection against flooding. I thought it was my external drain was blocked and this was stopping the water from being pumped out of the machine. The drains have now been unblocked but when I tried to resume the dishwasher cycle ther same error appears. Please can you advise? Many thanks. Kind regards Jo


    ... Zanussi Dishwashers

    Have GE Dishwasher model GLD6700N20WW,unit has stopped draining! Took apart and pump was running when check, but no water coming out. Checked drain line and pulled apart pump housing, all clear. Thought maybe pump has a silinoid built inside of it and was stuck shut, so bought new pump and same thing, no water will go thru! Please help me? Is it control module, or turbitity sensor possibly?


    ... GE Profile PDW8600J Built-in Dishwasher

    I have a MDB4630AWS1 series dishwasher that is only a couple of weeks old. Suddenly, it now starts the wash cycle but then the Cancel/Drain light turns red, and it drains and stops the cycle. Check for items blocking the sprayers and looked for anything clogging the interior. It does this with all the settings. Seems to work for a few minutes, but then it just drains and stops. Any help would be greatly appreciated.


    ... Maytag MDB4630AWS Dishwasher

    Hotpoint dishwasher FDL570G.R is filling with water but wont wash the dishes,we've checked pipes,cleaned filters etc. but still wont work.It makes noise like its heating but wont do anything after that,it will just drain when we turn it off. It is only 4 months old.


    ... Dishwashers

    Hi, I have a Siemens SE44 dishwasher with Aquastop, which I bought recently. It was doing great for first 3-4 wash cycles and then it stopped functioning :( Now all it does is let the water in, and then drains it out- it doesnt do anything else. I can hear the water going in and then the machine drains the water,and this repeats. I tired resetting the dishwasher, checked the drain pipe, aquastop etc, and all seem to be in order to me. Any suggestions? Many thanks, stonerockyy


    ... Dishwashers

    My Kenmore Dishwasher Model # 665.13832K601, wont change from wash cycle to dry cycle. It stays on wash until you stop the cycle and drain the water


    ... Dishwashers

    Hi, I have a Neff S5457XOGB dish washer. The unit is programmed to start - but the pump just keeps empying water, even when the door is open. After approx 5 mins this can stop and thedishwasher enters its normal cycle - however there is no water. I have checked and clean the pump assembly I have filled the base with water - and the pump successfully empties the into the drain I have checked the filter that conects directly to the cold feed. - Any advice please? Many thanks.


    ... Neff 24 in. S5457X0GB Built-in Dishwasher

    We have a Maytag MDW700EDWG washing machine and it has stopped working. The display window is showing F2 and will not go to the time lenght of any program. I am unable to switch it off at the Start button. It is making a noise as if it is trying to do something - but then stops. I have cleaned the filters, checked water supply but still have F2 showing. Please can you shead any light or let me knoiw what to do Many thanks Emma


    Is it the salt reservoir that is empty?\015\012Did you solve it already...mine has the exact same issue now ... Maytag Dishwashers

    ASKO dishwasher D3122 drain pump wont stop pumping and the machine wont respond when we press any of the program or start/stop buttons. the program light is flashing. We can turn the power off with the main switch on top of the door but when turning it back on the pump starts pumping again. please tell me how to fix this problem so we can get it up and running again.


    ... Asko D3122XLSS Stainless Steel Dishwasher

    This is a past problem posted that I am now experiencing with my Kenmore Elite Model 655.17489300 dishwasher. Looking for any suggested solutions, Rick Past Problem: I have the same problem with my 2004 Ultra Wash Model 665...fills with water, sensing light comes, then stops for a second. Then you can hear another pump kick in (it hums) and just runs continuously but no water is spraying through the arms. When you cancel the wash, it drains perfectly. I've checked the filters, all is c


    The symptoms you have mentioned could be linked to the soil sensor which some models come with. The purpose is to run the drain pump and let more water flow through inlet valve if during wash cycle the dishwasher detects soil collection in the accumu ... Kenmore 24 in. 16539 Built-in Dishwasher

    Stopped half way through a wash it stops and beeps for me to open it but when I do it hasnt drained. we checked all the pipes but it wasnt5 blocked so now we've pulled it completely out


    This is a typical Anti Flood system activation. This system activates when water leaks onto the floor of the machiene due to a leak fault (pipe/hose clamp/ partly blocked pipe). The machiene automatically switches to pump out mode and stops water inl ... Baumatic 23 in. BDW13 Built-in Dishwasher

    We have a Beko DWD5410W dishwasher that has worked fine...until today - the 'wash' light is on but it is not wasing. I have pressed in the 'start' button and held for 5 seconds to reset and it then springs to life draining out or whatever that noise is, and then if I turn the dial to a setting (even the cold prewash) and press 'start' again it starts whirring away, then after about 10 seconds just stops, with the 'wash' light staying on. Not blocked, I have checked - this likely to be a frozen p


    ... Dishwashers

    My miele wont wash it starts up then stops an wont drain out then the water intake light comes on


    Hi If appliance fills then starts to wash then stops and starts. Then most likely cause is debris in circulation motor. This will require appliance and motor to be removed ... Miele 24 in. G643Vi Plus Built-In Dishwasher

    De3861fw Hi, the machine stays on the same cycle time(cycle wash 5-84min; cycle wash 6-93min) The machine is on and sounds like it is running, but no water is entering, have checked the obviuos of water being turned on and also draining properly, but to no availe. Please help! Cheers


    ... Beko Dishwashers

    Electrolux dishwasher wont stop draining


    ... Electrolux Dishwashers

    Smeg DF612S All starts well but after 40 minutes stops with a beep and will not progress to the main wash cycle. Instead all programme lights come on (located on the left), along with the first 2 phase lights (the first two of the lights on the right hand panel). This indicates error code 3 (cannot pump out water), but water is entering and draining perfectly. Please advise.


    Check to make sure there r no kinks’ in the drain line or\015\012that it is not clogged it sounds like the sensor is tripping because there is\015\012too much strain on the pump just like a breaker. ... Smeg 24 in. DWI612 Built-in Dishwasher
    • Start your question with What, Why, How, When, etc. and end with a "?"
    • Be clear and specific
    • Use proper spelling and grammar
    all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
    Load time: 0.1722 seconds