Having problems with your Simpson MegaShot 3100 PSI Gas Powered Pressure Washer - Pressure Washers ?

Cant fined model SHW 2030


Answers :

Repair Help & Product Troubleshooting for Simpson MegaShot 3100 PSI Gas Powered Pressure Washer - Pressure Washers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Model 01902 2350 psi . engine runs fine , sprays out nozzle but lower pressure and water sprays out plastic elbow on relief valve , that is supose to **** in soap if used , cant hold finger over spray from elbow , high pressure , took apart relief valve and plastic valves all orings are ok , brass pump seals look ok , all back together , still blows out elbow . ?? plastic spools were out by somebody else , not sure if they are in right , cant find picture to compare .


It sounds as if the non return valve in the elbow is the wrong way around .The o-ring normally goes in first then the ball then the spring. Try it and good luck. ... Pressure Washers

Model IGV 659.1 Dishwasher When switched on the 'time display' takes longer than 2 minutes to display the planned wash duration. The display works fine to set a delayed start. After cycling the start delay round to 0, or after RESET (buttons A and C pressed) the unit is then 'nudged' into displaying a time. After, at last, a time is displayed the unit works fine.


... Kuppersbusch Dishwashers

I HAVE A MAYTAG MODEL MDBTT59AWQ DISHWASHER THAT WILL NOT START UP. LIGHT ON CONTROL PANAL FOR HEAVY AND LIGHT LOAD LIGHTS, DELAY ONE DOESNT AND THE START/CANCEL ONE DOESN'T LIGHT EITHER. WORKED FINE A COUPLE DAYS AGO. TRYING TO FIND A MANUAL OR PARTS BREAK DOWN BUT CANT SEEM TO FIND ONE FOR THAT MODEL.


... Maytag Dishwasher

My Whiripool gold (Model Number)gu1200xtkso Does not drain - Everything else works fine but when the cycle is over the water is still Present. I dont know how to unscrew anything. I cant seem to find what to take off.. seems in possible to even check help....


... Dishwashers

The ge profile dishwasher model PDW8280J10SS was purchased about 2 yrs ago. It was working fine up until Jan. 2009. It ran fine but the water stopped draining. I read were you should run the garbage disposal prior to running the dishwasher. I drained the water and did this. It worked fine for a while then the problem was back. Once again, Drained all the water, sucked it out with a turkey baister, moved the dishwasher and checked hoses etc. Once again, it worked fine for about 10-14 runs. It now


It is probably clogged at the pump or before. See if you can get outlet hose off the bottom before the pump. ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

Water from my disposal backs up into my hotpoint ($300-model) dishwasher. The dishwasher works fine otherwise. Is there a one way valve in the diswasher that is suppose to prevent reverse flow and/or is there other dishwasher motor problems which could cause this. Actually the Hotpoint Model number is HDA3600N00BB but this website did not recognize that model number so I put in the closest model number closest to mine.


If it's what I think, it's a simple fix. Does your dishwasher drain run along the floor of the cabinet, then up to the disposal? (my guess is yes). There should be an "air gap" between the disposal and dishwasher, this means when it comes out of th ... Hotpoint 24 in. HDA3400G Built-in Dishwasher

My dishwasher is a Smeg model STA 6143, and the door won't close. It seems fine until the last few centimeters, then it jams and won't close easily. If you press hard, it'll shut but not latch. Nothing appears to be stuck anywhere. We've tried jiggling the door but it seems somehow to be misaligned, although there's no reason why it should all of a sudden appear to be so. The electronics work fine, the racks fit fine (we also removed them, and the door still won't close), and nothing appear


... Dishwashers

I own 2 model KUDS01FLSS1 KitchenAid Superba Dishwashers. The first unit had the clean light blinking so I read the post below and reset it. I thought everything was fine but half way during the cyc


... KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher

Hi kenmore model 587.15102800 dishwasher not getting any power breaker is fine . dishwasher is on its own circuit, is there a fuse in this model


If the breaker is fine then the next check will be the terminal box on dishwasher. usually that is where you would find your problem. let me know if this helps and if it did help me by sending a 4 thumbs up post Thanks! ... Kenmore Dishwashers

I have a dishlex global 270 i cant find a model no i only have a serial and manufacturers no. What i wanted to find out is does this model have an element that heats the water. I only have one hose and when i used it with cold water it didnt heat up so i am using hot water.


Hi\015\012\015\012\015\012Thanks for using FixYa. I hope you understand that no one can tell you what are the specifications of the product until you provide the model no# however, dishlex usually have element in their dishwa ... Dishwashers

Hi there, Ok, i think i'mHi there, Ok, i think i'm getting close to solving this problem. I have an LG dishwasher- Model # LDS 5811ST. I have stripped it down and clean all hoses etc. It is running fine through all the cycles. The only problem is that it has no water pressure. In other words water is pumping into the More Hi there, Ok, i think i'm getting close to solving this problem. I have an LG dishwasher- Model # LDS 5811ST. I have stripped it down and clean all hoses etc. It is running fi


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. In\015\012this case you’ll need to check the water inlet valve. Disconnect the power\015\012source to dis ... Dishwashers

I HAVE AN EXCELL PRESSURE WASHER-MODEL EXPRO 2530-HONDA ENGINE GX200QX2-IT HAS A CAT PUMP MODEL#2SFX30GZ1. IT IS VERY HARD TO CRANK UNLESS YOU DEPRESS THE HANDLE ON THE SPRAY WAND WHILE CRANKING.ONCE STARTED IT WORKS FINE UNTIL YOU RELEASE THE HANDLE AND THEN THE ENGINE QUITS.IT DOES NOT GO INTO BYPASS MODE.


... Caterpillar Cat Pump Pressure Washer Pump 3SP30G11

Whirlpool Model DU8770XY purchased new in 1992 has just started to overflow through the air gap kit 300096. This unit has been working fine for the past 18 years. I checked the unit and drain tail section under the sink along with the P-trap and the water flows through them just fine. The kit is clean with no visible obstruction.


... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

Have a lg model lds 5811st model dish washer for a little over 2 years and had the le error button .called technican replaced the motor now 4 weeks later the same error button.and the cancel button wont release the water standing in the bottom.also cant get repair man to garanty his work or parts.


Take off the door cover and you will find the wires melted into a black blown in insulation. Carefully free the wires and run a quick check to see if any of the wires are broken. If they are cut them and splice them back together. It takes a while ... LG LDF6810 Built-in Dishwasher

I have a Kenmore model 587.1610 dishwasher that doesn't fill all the way when starting a load. I checked the float switch and it is working fine. The fill soleniod is also working fine and is clean. It just seems to time out before it fills all the way.also to compound the problem it doesn't seem to want to start all the wash cycle even after I have re-started the machine and it has filled to capacity. please help thanks Danny


... Dishwashers

Just installed fisher paykel model 88270 dishwasher, bottom drawer has no power,and top drawer does not fully drain. Cant find another power cord, is there a second one? Cant locate the manual.


... Fisher Dishwashers

Amana softsound 111 dishwasher, model adw750eaw - The dishwasher fills with water fine and drains water fine, but will not circulate water during the wash and rinse cycles. Any advice?


... Amana Dishwashers

Whirlpool Model GU1500XTKQ0..top washer arm not rotating..bottom arm fine...draining fine..


... Whirlpool Dishwashers

I'm not sure exactly what has happened, I washed a load of dishesand everything seemed fine, but when I went to wash a load yesterday, my Kenmore Ultra Wash III, Model # 1677990simply would not turn on and I found water in the bottom. I checked the house circut breaker and it is fine, is there a fuse or breaker on the machine somewhere? Please help!!!


... Kenmore 24 in. 15932 Built-in Dishwasher

Whirlpool Quiet Wash Plus dishwasher Model DU920PFGZ3. Worked fine until I replaced the insinkerator and forgot to punch the drain plug leaving water standing on the bottom of the machine. I punched the drain opening, and pushed the cancel/drain cycle button. It drained fine but since no water comes from the spray arms. I have removed the arm all the way down..NOTHING!! Some research indicated it could be the water inlet valve. When the buttons are pushed, it cycles but no spray or water.


... Dishwashers

I have a Karcher G2600 OR Pressure Washer, 2600 psi, 2.5 gpm. PN 1.194 506 0. gas engine works fine and water flows fine but pump is not adding pressure to stream. Checked and cleaned inlet water filter.


... Pressure Washers

Troy Bilt pressure washer model 020209 will not build pressure-have checked all screens and intake in pressure hose and garden hose from house to pump. water leaks at gun handle- took it apart and oiled piston- was ''grabby'' but now snappy but still leaks. Engine starts fine and runs fine. Please help.


A leaking gun will kill all the pressure. You may need to repair or replace the gun ... Briggs & Stratton Pressure Washers

In our church one of our dishwashers is a model WM5H. Sometimes it will work fine. Other times the light never comes on. I have had two service calls and it works fine while they are there.


The door switch, by door hinge, resets the timer for the next cycle. The door needs to stay open for about 8 seconds to complete the reset. \015\012\015\012There is also a switch inside the door at the handle. This can cause a similar ... Dishwashers

Two days ago my LG dishwasher model lDF 7810BB worked fine. Yesterday I loaded it and the display panel will not light nor show any sign of power. I check the circuit breaker several times and all other electrical items work fine in the kitchen. The 2 year warranty expired 9/08/08


Check for voltage with a multimeter at the wires very near the front, just behind the kick plate. Follow the incoming electrical wire in and remove the little plate the covers the wires/wire nuts. I have seen wires that appear to be connected prope ... LG 24 in. LDF7810 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1049 seconds