Having problems with your Smeg 24 in. DWD1SSE-1 Built-in Dishwasher ?

Smeg ST663 gets stuck onwash cycle

\015 I have a smeg ST663 which gets to the first wash cycle and just on going and going I suspect that the water isn't heating. I have tried resetting but it doesn't work\015

Answers :

I have the same problem. If anyone has an answer I would be most greatfull.
Repair Help & Product Troubleshooting for Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Smeg ST663 gets stuck onwash cycle


I have the same problem. If anyone has an answer I would be most greatfull. ... Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

Hi Our Smeg dishwasher model ST 663-1 is not finishing a cycle. It beeps intermitently towrds the end and won't drain (stuck that part of the cycle). I have checked the filter and the drain hose isn't kinked.


... Dishwashers

Smeg Allegra We start our Smeg Allegra with a 'dial' control. It has started to get stuck, and unless nudged forward, will stay on the same wash cycle permanently. never switching itself off. Is there an easy remedy to this, or do we have to bin it and buy a new one?


... Smeg 24 in. DWF1 2 Free-standing Dishwasher

My smeg dishwasher is stuck on soak doesn't matter what cycle I try it goes back to soak there is no water in the dishwasher tho


... Dishwashers

HELP!!. Have an old smeg dishwasher - SNZ10. We turn it on, and it goes, but the dial never moves on through the cycles - it just stays stuck wherever you have turned it to. Does seem to be heating and water coming in. Husband grumpily doing dishes by hand! HELP!!


After a while thje dial on Dish Washers, wear out and jam, It sounds like it needs a new Timer, However if it's old, I would replace the Dish Washer. ... Smeg CSU2001 Built-in Dishwasher

Help i have a smeg dishwasher, which until recently has been perfect,it seems to be stuck on its cycle and is making all the noises of working, but nothing is happening, then the panel says E 1. any ideas what is wrong and what can i do? thanks to anyone that can help


We have a Smeg SA8605W which has had a similar problem 3 times in its short 3 month life. The problem with ours is that the control panel on the front pushes against a very brittle plastic frame to activate the micro switches. Because of the brittle ... Smeg CSU2001 Built-in Dishwasher

My smeg dwf 64 sse blew the main fuse yesterday. The machine was up to its rise stage on program 8 then the breaker went. Every time I switch the main back on it blew. I have managed to stop it blowing the panel but now it seem to be stuck mid-cycle and won't complete. There a re all sorts of noises and the 1st led stays on then the 3rd one illuminate. Any ideas?


Your element was initially short circuit, which caused circuit breaker trip. It is now open circuit and timer will not advance because water has not reched required temperature, recommend thermostat replacement also. ... Dishwashers

I have a Jade RJDW2470A dishwasher which was re-branded Jade. (It is a Maytag product.) It get's stuck between cycles and will run forever unless I manually advance the dial to the next cycle. It seems to get stuck around the "rinse" cycle and the soap door does not open until after I advance it past that cycle.


... Jade RJDW2470A Free-standing Dishwasher

Fisher & Paykel single SS Dishdrawer. Cycle's stuck. Normally sticks at 137mins and 33 mins, has stuck on other times too but it's always on those times. Have tried pausing and opeiong the drawer int he hope to kick it back into working but doesn't help. A normal cycle of 151mins is taking 4 hours.rnI normally have to let the cycle run till it sticks on 33 mins then I trun it off letting the dishdrawer empty and kick into dry mode. I hate to see my next electricity bill, its been a month n


My dd603 takes 3 hrs to do a 55 minute cycle-who can help me ... Fisher and Paykel 23 in. DS603H W Built-in Dishwasher

I have a SHU3032UC BOSH Dishwasher for a couple of years now. Always worked as expected. Latetly, the dishwasher never stops. It looks stuck on an "unknown cycle"... The cycle dial stays at the "bottom" cycle (there's nothing written). If I turn it 1-2 "clicks", the dishwasher continues its work and ultimatly finishes with very good cleaning results. Once, I open the dishwasher when it was stuck in the "bottom" position, and there was hot watter at the bottom. Here's what I've tried so


Hello, welcome to FixYa.\015\012\015\012Based on you description of the timer not advancing I suspect the thermostat isn't satisfied when heating the water.\015\012\015\012The SHU 30** unit`s with a mechanical timer have very few if any, issues with ... Dishwashers

BF41 Dishwasher with a leak stuck in mid cycle Hi, I have a 'general domestic Appliance Ltd' BF41 (95+G709394) dishwasher which recently started leaking at the door. After replacing the seal the problem seemed to ease, then recently the problem started all over again and the leaking got worse. A couple of day ago I couldn't stop it leaking and now it's stuck in mid cycle and even though the water is washing inside the machine it never gets hot inside or finishes the cycle. Ive tried stopping and


... Dishwashers

I have a Frigidaire Ultra Quiet II dishwasher that gets stuck in the 6:00 position (between light wash and drying) during the cycle. It also gets stuck right before the drying cycle. It will proceed with the cycle if I manually move the dial. The heated drying feature is also not working as well. Do you have any suggestions? Thank you for you time, for it is appreciated. Best Regards, Scott G.


... Dishwashers

Dishwasher is making a loud grinding noise when it's started. Doesn't matter the cycle choice; the cycle starts as normal then once started up starts making a sort of grinding noise as the water is pulsing, like something is stuck or blocking the "push" of water. I couldn't see anything stuck in the bottom - any thoughts before I call a repair person? I've never owned a dishwasher before - maybe there's a basic drain/blockage thing I should check out first? And, any recommendations for repair


... Maytag 24 in. MDBH970AW Built-in Dishwasher

Smeg Dishwasher DWD 63.1 SS, not heating; I have Smeg dishwasher that is sticking in its cycle (wash phase), water was cold, so I assumed the element had failed (or tank termostat), so I have replaced both element and tank thermostat in turn. No change, water still cold and dishwasher sticks in the wash cycle. Any ideas? (Note, no diagnostic leds on this model)


... Dishwashers

Gets to the end of the cycle (1 minute left on countdown) and just keeps running, does not start the "dry" mode. will run until i open it and when i shut it it goes 13 minutes left on the countdown but then gets stuck at 1 minute again. does not drain. has been doing this awhile, but until now it would simply finish the cycle when i opened, closed and reset it. now it just gets stuck again.


Hello,Welcome to FixYa.Based on your description ... Bosch SHU5315UC Dishwasher

After running our dishes through a wash cycle we noticed there was still a lot of food stuck on the plates & glasses etc. We cleaned out the trap but due to the murky water in the well, we also pulled out the racks & removed the bottom plate. The underside was greasy and had a lot of grim stuck to it as well as the bottom of the drawer itself. We washed the filter trap, swing arm and plate in the sink. We loaded it with the dishes that previously did not come clean and ran a full cycle. The


Hi,\012\012\012\012\012I\012have an older dishwasher also and recently my wife also complained\012about it not cleaning right... so me being the man I am tried in vain\012to clean the things... Bought new ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

HI our Indesit IDE 750 dishwasher gets stuck on the first cycle and the timer doesn't count down. Switching it off and restarting drains the water, but it gets stuck at the same point in the cycle


This sounds like a heating element issue, If the water doesn't get warm it just keeps trying to heat but won't advance past this point until it has reached a set temperature. You dishwasher may or may not be fitted with a thermal overload that may ha ... Dishwashers

It sounds like drain cycle is stuck. Is there some type of reset button? I tried unplugging the washer but when I plug it back in the drain cycle is stuck


Hello,Welcome to FixYa.Based on your description " It sounds like drain cycle is stuck. Is there some type of reset button? " , the good news...It is likely noth ... Asko D1796FI Built-in Dishwasher

Dishwater cycle gets stuck at 27 minutes and doesn't go beyond but continues to run, staying at 27 minutes. timing mechanism gets stuck in all cycles.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If the cycle doesn't\015\012complete, then the first thing ... Dishwashers

Time to go, and washing cycle, stuck at 36 minutes. Switching off/on makes no difference. The cycle is stuck at 36 minutes to go


Replace the module ... Dishwashers

Several people have posted this problem with the Frigidaire Ultra Quiet 111, but I have seen no solutions. When it is set to wash without extra heat, it cycles normally. But when the extra-heat wash and extra-heat rinse are selected, then it gets stuck first mid-wash at the 7 o'clock position, and if it is manually advanced then it gets stuck again during the rinse cycle just before the 9 o'clock drying position. Both the wash and rinse thermostats have been replaced without solving the problem.


Hi,\015\012\015\012I know that you are going to think that this is dumb... but the only thing that it can really be is the timer....\015\012\015\012 ... Frigidaire 25 in. FDP750RC Free-standing Dishwasher

Bosch SHU43C My Bosch SHU43C is stuck with the drain pump running. I ran the self-test and it gave me the fault code 4 wich indicates a filling fault. The washer is empty and all wash cycles display the correct number of minutes for the cycle. It counts down to 0, but the pump continues to run. Does this indicate a stuck float, or is the problem with the control board? Where is the float located? Are diagrams/pictures available on-line anywhere? I've done some searching, but haven't found any. R


My SHU43C is just over 3 years old. I had a similar problem recently. First, there were a few floods. Then, the Bosch only drained non-stop. Even when I used the Cancel Drain buttons the drain pump would run without stopping. When I ... Bosch 24 in. SHU43 Built-in Dishwasher

My Bosch SHU 3030 gets stuck during the washing cycle and will continue to run indefinately until the wash cycle knob is rotated a little bit, then it will work fine for a few more minutes until the knob gets stuck again. Whats my solution?


... Bosch Dishwashers

Hi, My haier dishwasher is getting stuck mid cycle. Could you tell me why this keeps happening. It gets stuck mid cycle after the wash and rinse and then it wont drain or dry dishes properly. It has never been used before. Please help. Kind regard Katie Hopkins.


... Haier Dishwashers

My dishwasher is starting it's cycle, then running for a minute or 2, then it stops and drains itself, then starts the cycle over and repeats this. It won't continue it's cycle and it seems to be stuck in a certian cycle


You seem to be stuck in a 'quick rinse' cycle. double check your buttons as well as your timer/dial to see if you are using the normal wash cycle. especially check the buttons. good luck ... Frigidaire Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2061 seconds