Having problems with your Smeg 24 in. DWF1 2 Free-standing Dishwasher ?

Why does the door on my smeg diswasher not shut completely when there doesnt seem to be anything i.e dishes preventing it from closing?


Answers :

Repair Help & Product Troubleshooting for Smeg 24 in. DWF1 2 Free-standing Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Why does the door on my smeg diswasher not shut completely when there doesnt seem to be anything i.e dishes preventing it from closing?


... Smeg 24 in. DWF1 2 Free-standing Dishwasher

Hi, The machine will not complete a cycle. I think it may have started when the power was turned off at the mains during a cycle. Symptoms are : - You can turn machine on, select a program, press start button, close door, machine appears to begin cycle as normal, water seems to load, then 2 minutes later drains, and 1 minute or so after that the machine beeps 3 times to indicate cycle is finished. Dishwasher tablet door never opens, dishes not cleaned. Have tried : - cleaning filters; - turn


It is likely the dishwasher is locked in some diagnostic program.\015\012If you provide the dishwasher model no. then I can try to find out the keys you need to press to get it out from it. ... Whirlpool Dishwashers

My Kenmore ultra wash quiet guard doesn't seem to be doing a very good job washing dishes, especially anything on the top shelf such as glasses. Sometimes after a whole cycle, their are still fingerprints on the glasses and scum on the bottom of coffee cups. Also it doesn't seem to use much of the detergent. I fll the dispenser about half full with liqid Cascade Complete and most of it is still there after the cycle is done. The inside of the door is also stained and dirty. I have looked at the


... Kenmore Dishwashers

ETNA ENF 18500A/5 type: 3.E1.181213221110 36 VLENNL 5 Dishwasher lights are on, and set for running, but the dishwasher does not do anything. Sometimes it makes a slight hum when closing the door, but most of the time, nothing. It stopped running after standard dish washing liquid was put into the machine by mistake. At that time, the machine started and ran through part of the cycle, but did not complete, and did not drain the water. Since then it has not started again. I have remo


... Dishwashers

Whirlpool ADG993, door fault: Hi, a few weeks ago soemthing broke on the door to my diswasher and it falls open wide with no stopping half way as usual. That was fine as the machine could still work, but now the door won't close. All seems fine until you get all but closed and then the door raises slightly from the bottom right corner, preventing it from closing. It looks like something may be jammed in there which pushes the door up at the last minute. There's a man coming out on Friday,


... Whirlpool Dishwashers

The latch won't engage, so the door won't close. Obviously, this means the machine won't operate. We have removed the racks, checked the hinges to see if anything is lodged there and looked to see if anything is in the unit preventing the door from closing. Could the latch be broken? If so, what is involved in the repair?


... Bosch 24 in. SHV57C03UC Built-in Dishwasher

The detergent dispenser [Main Wash] door doesn't stay closed. It seems like there is something wrong with the latch, but we can't what. We've cleaned it, but don't know what else to try. There don't seem to be pieces missing or broken. But no matter what, when we put in the detergent [we use the cubes] the door always just pops open and the detergent ends up falling to the bottom on the dishwasher. The dishes are still getting relatively clean, but we want to solve the problem with the door


... Frigidaire FDB1200RG 24 in. Built-in Dishwasher

I have a Maytag MDB8951bws and I have noticed that the dishes at the end of the cycle do not feel hot but mildly warm and not completely dry. I also noticed that when I select the ''Sanitize'' option the light that tells you the dishes have completed being sanitized does not come on after the cycles are completely finished (the ''clean'' light does come on). One last note I will throw in is that the high temp wash seems to work quite well as a lot of steam is expelled when the door is opened dur


... Maytag MDB8951BW Dishwasher

I heard metal drop sound when dish easer door was open in down position. Seems that door does not close same way- it there a spring on door to help close that could have broke? Y I have the kitchen aid - kud102frsso. Thanks


... KitchenAid 24 in. KUDI02FR Built-in Dishwasher

Ariston dishwasher as 150 opened door during cycle to put a dish in closed door washcontinued but water came out since then cant seem to get any water in macine seems to start wash but no water and first lihgt flashes


... Dishwashers

I have a Kenmore dishwasher model 66574362K2. It has worked fine until tonight. I opened the door before the end of a cycle, closed the door, and pushed the cancel drain button. There was still water in the bottom but the dishes were basicly finished. Now I can not seem to get the dishwasher to come back on. The lock button seems to be on and it usually is not on. The manual says to push and hold the button for 4 seconds to turn it off. I did that. But now it is flashing between the Heate


Can you press the drain button to drain the water, then shut the unit off and restart??? I have exhausted all my resources to help, thought this may work. ... Kenmore Dishwashers

I have a Maytag MDB7600AWB dish washer. I have a door leak, dripping from the right side. I can not see anything that would allow it. It seems like it could be coming from the inside of the door. Also, there is heat and condensation on at the top of the door, above the leak. It could be that steam is coming from the top right and dripping down the door. Could you give me some idea about fixing the problem.


HI,Check for the following troubleshooting steps:Some leaking around-under-from the door on dishwashers can be traced back to a split in the spray arm. If the lower spray arm develops a split in it, the spray arm can turn too ... Maytag 24 in. MDB7600A Jetclean® II Built-in Dishwasher

When we open the dishwasher door, it produces a very loud metalicsqueeking sound- like something is rubbing or binding. The door is not catching on anything externally, and there doesn't seem to be resistance to opening or closing. I have lubricated all the external parts- pully, cable, etc, with silicon spray, but the sound continues. It is difficult to pinpoint the exact location- obviously at the bottom of door. What must I do to correct the squeeky noise? Thanks for your help!


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

When starting a wash cycle it pumps out the remaining water as usual. It fills normally but does not pump/wash the dishes. It continues to heat and when first noticed it seemed to have gone through the complete cycle but didn't wash. The detergent door had opened and the soap pack dropped out but it never dissolved. The dishes were extremely hot too. Is the same pump used to both drain the washer and wash the dishes?


Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... Asko 24 in. 1805 Built-in Dishwasher

Dishwasher seems to run but does not wash dishes. Recently had to take the door apart to fix the latch that was stuck in the closed position, causing the door not to lock.


I've got the same problem and will watch for your answer. My landlord says "its fine." However, my dishes are not clean. ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

Detergent dispenser door Whirlpool DU7400 won't open. I tested 300109 ACTUATOR resistance and it is closed. I ran washer and saw the actuator receives a current several times during the complete wash cycle. How else can I test? I notice the lever on the Acutator is quite floppy. Should it be stiff? Also the dispenser door does pop open if pushed from behind so that seems OK? Does anyone have the actual testing procedure for this problem? Thanks for anyone's help!


... Whirlpool 300109 ACTUATOR

Our dishwasher doesnt seem to be cleaaning the dishes properly. After the cycle soap residue remains on the door and bottom of the unit and the dishes are not getting clean. I have checked the supply line and discharge for blokage but both are clear. what should I be looking for?


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... LG 24 in. LDF 7811 Stainless Steel Built-in Dishwasher

Drying problem Hi Our 3-day old LG dishwasher is not able to dry our dishes. After the cycle is finished 2 hours later, I open the door to find that water is everywhere. As if the washer is skipping the dry sequence completely. The "vent" on the inside of the door doesn't seem to have an outlet--why is this a vent if nothing can escape? The owner's manual says to use a rinse aid to help drying. I don't believe in using band-aid's; something else is wrong. Any help/advice is appreciated. Thanks,


Hi,\015\012\015\012As I had the same problem, I worked on my machine and found out the heater unit was not working (it is a brand new machine ! - remark : as I moved overseas, LG did not cover it with their warranty).\015\012\015\012But b ... LG LDF6810ST Stainless Steel Built-in Dishwasher

I am not happy with the racks in my new Bosch dishwasher! The bottom rack is not right! The silverware basket is in the back right corner and the silverware catches on the seal on door and it is hard to get to. The tongs are two close together and point the wrong way? The upper rack's tongs are also to close together also. I don't seem to be able to get larger dishes in with these tongs in the way. Having never used the mdl 9000359119 Rev B I had no idea. Buying a Bosch ment quality to me


... Bosch Dishwashers

Our KitchenAid Superba model KUDS01DJss0 ( about 7 years old and has always worked fine) I think is not heating . . the dishes come out wet and don't seem very clean if they had especially if they have a small a bit of something like peanut butter on them when loaded ( so lately I've been dong a pre-wash by hand). Unit doesn't seem to get very "hot" during the wash/dry and steam does not billow out when I open the door soon after the cycle completes like it used to. It does feel warm to the


Hello. The new heating element will come with a new control board. There are no tricks to the change actually, the easiest way to change the heating element is to unhook the plumbing, electrical, and drain hose then pull it out and get to the back ... Dishwashers

GU2400 whirlpool gold quiet partner iii. Won't clean dishes. Dishes don't get wet. Water seems to accumulate at the bottom but no spraying sound during cycle. Cancel causes the system to drain completely. Possibly plastic utensil under the filter screen at bottom. Can't figure out how to remove it or the filter screen. Might be preventing impeller blades from rotating.


... Whirlpool GU2400XTP Built-in Dishwasher

Middle and top spinners do not spin The pump is pushing water up the back delivery tube. There are no dishes in the unit and I was able to trick the door into thinking it was closed so I could watch what was happening. Or Not Happening The spinners are completely free of calcium or soap build up and both top and middle are easily spun with a finger. While the pump and bottom spinner were working, I pulled the top drawer out partially and there appeared to be a good flow of water coming out of


Hi,\015\012 Remove each spray arm and check it is clear of food particlesat the jets. The next problem may occour at the rotating joint . If the seal is not good, you can loose a lot of water out of this point.. If both of these seem reasonable ... Dishwashers

Door will close but not lock in place preventing me starting a wash cycle on the dish washer


Check to see if your dish racks are in properly or take them out and then try the door. ... Dishwashers

I have an older under the counter high temp dish washer not sure the model number but it has the three switches on the lower left, has both upper and lower wands and it is high temp. Not for sure but it seem like the homing cam switch is not working you can manually turn the came to get machine working but when it shuts off it wont restart when you close and latch the door could you please help!


The cam switch may be faulty and may be available for replacement.\015\012\015\012Hard to find replacement without model no. but for the current model it is available ... Moyer Diebel Dishwashers

The some dispenser and the rinse aid dispenser seem to be "stuck", soap door doesnt open and dishes appear streaky from no rinse aid. this happened after I cleaned the deposits from under the screen in the bottom of the dishwasher. how do I clean the dispensers?


There is a solenoid which pops open the soap lid after the initial rinse.\015\012\015\012If the solenoid or soap lid latch is faulty, you will need to replace it. In the interim just poar your soap in the bottom of the dishwasher tray bef ... Bosch Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1068 seconds