Having problems with your Smeg CSU2001 Built-in Dishwasher ?

Where do you put the salt - Smeg CSU2001 Built-in Dishwasher


Answers :

Repair Help & Product Troubleshooting for Smeg CSU2001 Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Where do you put the salt - Smeg CSU2001 Built-in Dishwasher


... Smeg CSU2001 Built-in Dishwasher

Dishwasher will not drain - Smeg CSU2001 Built-in Dishwasher


First check for blockage then listen for humming sound when its suppose to be emptying, the drain pump may be blocked or may have died. ... Smeg CSU2001 Built-in Dishwasher

I cannot get my smeg dishwasher to programme the salt container light is on i have put salt in the dispenser but it is not full will that stop it from working


It is possible that water has gone into the salt container or the salt container sensor is faulty.\015\012It might help find a possible cause if you proivde the full model number of dishwasher ... Dishwashers

Where do i put the salt in the dishwasher - Hotpoint 24 in. DWF34 Built-in Dishwasher


... Hotpoint 24 in. DWF34 Built-in Dishwasher

How to remove waste hose from machine? - Smeg CSU2001 Built-in Dishwasher


1\012Turn off the circuit breaker that controls the dishwasher.\012\0122\012Open the dishwasher door. Locate the two small screws holding the bottom valance trim piece. Remove the screws and the valance, revealing the lower pump a ... Smeg CSU2001 Built-in Dishwasher

I have a whirlpool for Ikea dishwasher that is built in and I put it on the normal 30 minute cycle before I went to bed and 8 hours later it was still going. I opened the door and machine was full of suds. It is like it gets stuck and can't move on to the next part of the cycle. I have checked the filter in the bottom of the machine and checked the salt and rinse aid levels.


It could be waiting for the temperature to reach the required level.\012\012Sounds like the heater element has died. ... Whirlpool Dishwashers

Hi, I just put normal table salt in my dishwasher and have now realised this was a mistake. Will it damage my machine? Should I try and get it out? Or should I put proper dishwasher salt on top; the lite is still red despite me putting in 500gms of table salt.


... Danby DDW1805W Designer Series Free-Standing Dishwasher

My whirlpool dishwasher adp4407 is not washing properly when i open the door thinking its finished a wash the soap tablet has not dissolved and is on the bottom of the dishwasher and sometimes its not emptied the water also the red light is constantly on i did not know you had to put salt in a compartment on the bottom of the dishwasher how much salt are you suppoosed to put in this compartment.


... Dishwashers

Hi just had new dishwasher put in its a diplomat intergrated dishwasher aca9102, only used it once and started beeping towards the end of the cycle. thought it might be coz i didn't put salt in it, and had tablets instead of detergent so put salt in and detergent in but couldn't get rinse aid. started the program on normal wash but started beeping 10 beeps straight away and the first three lights out of 6 are flashing on the control panel. could it be coz theres no rinse aid in it? please someon


Dear tracy83, \015\012\015\012we have an aca9102 diplomat dishwasher since april 08. we now have a fault with dishwasher but cannot locate our manual. could we arrange rto have a copy of your manual? sorry for being up front but cannot ob ... Dishwashers

My Kenwood dishwasher KDW24FI/B has worked fine for approx 2 years. But now when I put my dishwasher on, the cycle never seems to end. After a few hours of running I opened the door to find the tablet hadn't dissolved but lots of steam coming out. I tried 2 more times and the same thing happened. The pump is working and everything seems ok. After reading the manual I have noticed the salt and rinse aid lights are iluminated. I have never put salt or rinse aid in since I had the dishwasher so thi


Lol is it a stereo or a kenmore, dishwashers dont use salt, but water softeners do ... Dishwashers

My dishwasher is flashing for salt it is a Miele and i want to know what kind of salt to put in and how much - i have the plastic bowl thing to put it in the dishwasher


Use the salt supplied by your service provider. Or try in a super market.Ask for dish washer salt. If a plastic funnel is supplied use it to fill the salt compartment. The quantity as it holds. Do not fill kitchen salt used for food ... Dishwashers

Miele G893 i cant find where to put the salt on our new house's miele 893 dishwasher. the previous owner left salt for us, and the dishwasher smells horrible (like stale water) when you try to run it without salt. (only tried that once though)


You should have a dispenser on the door to add salt,regardless get c.l.r. calcium lime rust remover from a supermarket,lowes,home depot.put a cup in the unit ,run for 15 minutes and then put a cup in again.let the unit complete its cycle.if you still ... Miele Touchtronic G892 Built-in Dishwasher

I have a DS605 and DD605, F1 fault comes up everytime I try to cut the dishwasher on also water will emerge in it and the impleller floats up under the rack on the top dishwasher. Both dishwasher comes on the same time and make noise and the F1 with a little rench shows up. They said when the red light comes on the salt reservoir is empty. What kind of salt do I put in.Please advise


... Fisher and Paykel DD605HSS 23 in. Built-in Dishwasher

Dishwasher is showing low dishwasher salt soon after putting dishwasher salt. why?


Do not bother. Continue using the m/c. If the inlet water quality is good do not worry. This is a sensor sensing fault, even if the salt is fully loaded. If the wash quality is good without salt continue.Otherwise add salt at ... Indesit 24 in. D63 Free-standing Dishwasher

E8 error code on smeg dishwasher - Smeg 24 in. DWD1SSE-1 Built-in Dishwasher


Thanks to hijoloo for pointing me in the right direction. The offending part is the diverter valve, a paddle inside blocks one of two outlets in turn actuated by a micro switch, a motor and reduction gears. Check switch for continuity with multimeter ... Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

Smeg dishwasher door wont open - Smeg DWI614 Built-in Dishwasher


... Smeg DWI614 Built-in Dishwasher

How much salt do i put in my bosch classicxx dishwasher have put salt in but light still on


... Bosch 24 in. SRS43C12 Classixx Slim-Line Free-standing Dishwasher

Smeg Dishwasher SA945X-3 manual - Smeg 18 in. STX45-1 Stainless Steel Built-in Dishwasher


... Smeg 18 in. STX45-1 Stainless Steel Built-in Dishwasher

Smeg dishwasher e1 fault code - Smeg 24 in. DWD1SSE-1 Built-in Dishwasher


... Smeg 24 in. DWD1SSE-1 Built-in Dishwasher

Smeg Dishwasher Hello I have a smeg dishwasher - built in, push button. It has stopped working - the program start and you hear it drain but that's as far as it gets, no water appears to be getting in. A couple of times the last 2 program buttons flash or the rinse light is on when we open it. let me know if you have any thoughts on this - I'd really appreciate it. thanks Diane


Replace the timer/control board ... Dishwashers

Our church has a Vulcan Autosan built in Dishwasher, comercial style. The cable broke that raises and lifts the door. Here is the model numbers found on our dishwasher. R-16 BTF 81-07-1828-H If you have any idea where we could get this cable and how to put it on, we would appreciate it very much. My name is Donna Woods and I will put in my email address. Thank You, Donna


Hi Donna.Unfortunately the model number did not return anything after been entered in the online search box.The model name of this machine should be Vulcan R-16 ELT.Here the contact for Vulcan Hart parts distributors, call the ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

I did not put salt in my new dishwasher just used a tablet. DIshwasher started up and then stopped saying water flow problem was this my fault? Rang service desk who were very rude and made a big thing about the salt which I did not think was a big thing since live in softw ater area.


Absolutly not your fault robert. nothing to do with salt atal. if its water flow problem could be a faulty flow meter in which case if ur dishwasher is under 28 days u can refuse a repair and demand a replacement.\015\012\015\012hotpoint ... Hotpoint Dishwashers

Require manual for Smeg DWI409C dishwasher - Smeg DWI409C Slim-Line Built-in Dishwasher


... Smeg DWI409C Slim-Line Built-in Dishwasher

Smeg dishwasher not draining - Smeg 24 in. STX2 Built-in Dishwasher


... Smeg 24 in. STX2 Built-in Dishwasher

Dishwasher problem i have been having problems with my dishwasher,it does not clean properly,i got fed up so i brought another dishwasher,i wash brilliant for about a week now it is also not cleaning,i have cleaned filters,put salt into it,what am i missing,2 dishwashers,same problem. Thanks dee


If you have 2 units with the same problem i would check the water line/hose,they have screens in them and they could be obstructed.I would also see if the water pressure isnt too low.Also the line from the dishwasher to the drain i would check for ob ... Bosch 24 in. SHU5305UC Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1933 seconds