Having problems with your Smeg Dishwashers ?

Water comes in for the first part of the cycle then it empties and motor runs but no more water comes in


Answers :

You are leaking ,,,,,,,,,,, *********** TURN MACHINE OF AND TAKE PANELS OFF *********** you should see were its leaking ..what you can hear is drain pump running more likely....
Repair Help & Product Troubleshooting for Smeg Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Water comes in for the first part of the cycle then it empties and motor runs but no more water comes in


You are leaking ,,,,,,,,,,, *********** TURN MACHINE OF AND TAKE PANELS OFF *********** you should see were its leaking ..what you can hear is drain pump running more likely.... ... Smeg Dishwashers

Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w


Most common d/w power is 120 volts, check for 120 volts with a  ... Dishwashers

I have a De Dietrich DV640JE1 built in 45cm Dishwasher, working fine for over 3 years. After replacing the connection under the sink to fix a leak it has stopped working. But I dont think this is related. I run a cycle and it fills water in the bottom of the machine, it drains it out in the end but the 2 arms are not rotating and no water comes out. I checked the arms and they are not blocked. A faint clunking sound can be heard at some part of the cycle. I did also run a cycle with the dr


Hello Benny,\015\012\015\012It's highly unlikely that replacing the connection under the sink is related to this problem.\015\012\015\012From the symptoms you describe, it's almost certain that the circulation pump motor has f ... Dishwashers

Had a clogged garbage disposal, once fixed, the dishwasher stopped getting water to it, sounds like its running, but no water coming to the cycle, Its a bosch dishwasher, motor seems to run, drain working,but no water to it.


If you didn't do the disposal fix yourself then there's a possibility that whoever did it closed the water valve to the dishwasher although there is no good reason to do that...\015\012\015\012I would check the valve then make sure that a ... Bosch 24 in. SHU43 Built-in Dishwasher

My Kenmore built-in dishwasher is running its cycles normally, but no water is coming into the machine so it runs the cycles dry (even a rinse cycle). Can you advise? If a part is needed, is it an expensive one? Thank you!!


Sound like the inlet water valve is to blame here - or else the main controller board relay is not telling it to open. Further testing will be necessary to determine which is the cause.If it is the board - you are better off getting a new ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

I have a CDA CW494 dishwasher, which is a rebadged Whirlpool. The pump has been changed by a service engineer, using a Whirlpool part instead of the original, apparently it is superior. It seemed to work OK, but now the main jets only squirt for a short burst when the motor stops or starts. The rest of the time the motor can be heard running, but no water comes from the jets. Could the motor be running in reverse?


I would check to see if there is any blockage in the area of the dishwasher where the water collects to be recirculated through the pump back into the washer. It sounds as though the water isn't being allowed into the pump enough to continue the was ... Dishwashers

Fagor Dishwasher My Fagor DW suddenly has no water coming in but the motor is running. The cycle starts for about 3 mins then sounds a bit painful followed by all the warning lights coming on and beeping. I live in Spain and am not good with the lingo so am worried about calling anyone out. I've checked the water in pipe which is OK. Help!!!!!!!!!!!! (Please)


Ok if you have a volt meter then remove the bottom kick-plate locate the water valve take the connector off the valve set the meter to ac volts plug the leads into the connector turn the timer to fill if y ... Frigidaire 24 in. FDB126RB Built-in Dishwasher

Kenmore Elite dishwasher Model #665 1597 2992 Machine fills with water but thereafter it neither washes nor drains. Machine will not drain when I advance the cycle by pressing the Cancel/Drain button. There was a report that there was some noise when the machine first failed. I do not hear anything when I try to run a cycle. What might the problem be? How does one turn the motor manually to see if it is bound up by something? If it is the motor do I want to pay an extra $70 to $100 and


... Dishwashers

Normal wash cycle- tub fills (?), then comes a loud hummmm and nothing happens. I noticed water level didn't reach heater coil and added water until limiter switch clicked. Still just a loud hummmm. Machine was well into its regular cycle when this first occurred, but now, won't even get past initial fill. Pushing the "Cancel/drain" button activates motor and pump: they work fine.


You are an expert enough reading this. But with a terrible complicated dishwasher. First clear the waterlevel problem.\015\012Rest is a result. You do not need me, join us. Next time buy something more plain. ... Dishwashers

The water is pumped out after the rinse cycle then it continues to run and make an unusual noise but nothing happens. The noise is almost a grinding sound. There is also a smell like some part may be hot or the wiring may be hot. I can reset the dishwasher and re-run the cycle up until that same point and it does the same thing again. I have had a repairman out twice in the last six months. The first time he could find nothing wrong because the problem was intermittent and he couldn't see anythi


Timer \015\012\015\012or\015\012\015\012 ... Bosch Dishwashers

Bosch shu8806 Hello, I aquired a shu8806 recently and it doesn't work. It has power and water. I push wash cycle, indicator light comes on, shut door and nothing happens.  So the door switch seemed like a good place to start. Since I am an electrician I thought I would give it a shot. When plugged in, the wire from the motor is 120V but when jumpered to the neutral(common on the door switch), motor doesn't operate. Although, I have heard the motor turn over momentarialy when trying to run unit e


The pump may be clogged, or the motor start capacitor may be bad or some units have a fill switch wired inline with the motor so it won't start unless the unit is full ... Bosch 23 in. SHU 8805 Built-in Dishwasher

Frigidaire Dishwasher runs, but no water after first cycle or two


Http://frigidaireservicetips.com/pdfs/486_5.pdf\015\012\015\012Above is y ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Hello, I have a Kitchen Aid (model # KUDMO1T JWHO) dishwasher that runs the motor in all cycles, with water fill & drain working fine, but the pump is not pumping water during any cycle, as the spinners and the inside of the washer are dry when I open the door, except for the water sitting in the bottom. Also, no normal swishing sound of water when the motor runs in any cycle. Looks to me like a mechanical break in the pump drive. How do I check the pump drive on this model? Do you have any


... KitchenAid Dishwashers

I just installed my whirl pool dish washer , it filled with water , i can hear the timer going on the knob but the motor is not coming on the wash cycle or any other cycles are not running i.e. no washing draining or rinsing? what do i do or what could be wrong


... Whirlpool GU2300XTS 24 in Builtin Dishwasher

Motor problems? I have a fisher paykel DS6031SS -top drawer dishwasher that the motor makes a loud sound when cycle first starts. Sound seems to be coming from the front of the dishwasher. It is 7 years old. Anyone else have this problem? I llive in a small town in Washington state (Lacey) and have been told the closest place to get parts is Seattle! Thanks.


... Fisher and Paykel DS603SS Stainless Steel Built-in Dishwasher

My Tecknika Bellissimo dishwasher in wash mode the motor comes on and off rather than run continuously as it used to. So it runs for two seconds, cuts out for two seconds and then repeats this. Other parts of the cycle are normal.


... Dishwashers

Our Asko D1716 dishwasher functions to fill and empty but the pump which causes the sprayers to rotate and distribute the water does not function. The local appliance repairman diagnosed the problem as a bad pump (he called it a motor). Since the pump is a $400 part plus labor, is it possible that the problem is something else like a bad motor capacitor or relay? When the cycle calls for the pump to come on, there is no sound except for a very soft hum.


Hi ! \015\012\015\012Got a D1706 ( in 2002 ) paid $1000 and as os April 2010...same problem as yours, I will trow it away ( dishwasher ) and will never buy at such cost. I'll get a GE or LG. \015\012\015\012Stupid Sweden dish ... Asko D1716 Built-in Dishwasher

Incomplete cycle My Miele dishwasher (3 to 4 years old) finishes, leaving the dishes dirty and wet. It seems that it may only be running through part of the cycle - I'm not sure but from the time I set it going to the time it switches off, it seems shorter than usual. The dishwasher is not emptying as it has a pool of water in the bottom. I have tried various settings and have the same problem. the inlet/drain light DOES NOT come on. I have soaked up all the residue on the bottom and cleaned out


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

Avanti dishwasher stopped working. I have checked breakers-the dishwasher lights do come on-it will not cycle. When it first stopped working, the motor was working, but the dial would not move. I tried to cycle it to drain the water, but then nothing more happened.


... Avanti 18 in. DW19PSS Platinium Built-in Dishwasher

Ice maker cannot eject cubes. I took off the front cover and found several contact points for checking the motor, water valve, thermostat, mold heater. There is also a line voltage and neutral contact. Are these contacts live only during certain parts of the cycle? I suspect the heater isnt working to loosen the cubes so they cant be ejected. The motor sounds lilke its running but the ejector is not moving nor is the Gear on the front of the unit. Can someone give me a full description of this t


I usually replace icemakers as a unit. It sounds like the mold heater is out. The system cycles like this: Fill, freeze, mold heat, eject, and start over. The mold heater not working will prevent ejection. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a new Ariston LKF720 dishwasher. In part of its wash cycle it is very noisy - not water noise, but a grating motor-like noise. Is there anything I can do? Is there anywhere I can watch a dishwasher do a run and listen to its noise, Ariston or other brand? We bought the present one off the floor and did not expect any problem, having had other dishwashers for years, they being quiet. The poor technician already changed the motor, but it is still just as noisy. I am even considering sellin


... Ariston Technologies L63 Free-Standing Dishwasher

Hello, I have a Neff Dishwasher S5453X1GB/74 and it's not draining the water out at the end of the cycle. I have unscrewed the filter and released the impeller. I have also cleared the waste pipe that runs to the sink waste and put loads of cleaner in the dishwasher. The pipes seem to be clear as water goes somewhere during the cycle but backs up at the end. A few times when I started a cycle the water did not spray out but I could here the drainer or motor? running. I jetted water through th


... Neff 24 in. S5453X1 Built-in Dishwasher

I have a Maytag MDBH945AWS dishwasher that makes loud noises when running through the wash cycle. When first purchased the DW was whisper quiet. At about 6 months it was noticeably louder. Then just recently it alternates between clicking (sounds like the soft food disposer), loud vibrating hum, and the medium loud hum that has been steadily increasing. I've disassembled it down to the motor and haven't found the problem. No obvious abrasion from parts interference. Nothing in the pump ass


... Maytag Jetclean II MDBH945AWS Stainless Steel Built-in Dishwasher

I tried the steps listed at this website for the same issue I am having. http://www.fixya.com/support/t273954-kenmore_elite_dishwasher The steps worked to get the dishwasher to "reset" with all the lights coming on. The problem I am having now is that after the "reset" the dishwasher starts to run a small cycle for about 5 minutes. Upon opening the washer, nothing has happened inside (no water, no visible movement of parts, no soap container opening). Upon closing the dishwasher and trying


I think think the water fill is ok and the drain is ok as it uses a seperate drain motor . but what is not working is the main wash motor . so no water is moving and the wash arms are not going around and the lights ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Miele Dishwasher Model G1040, Type HG03, NR: 32/65143704 The machine is three years old. The cycle reaches almost to the end, then all three LEDs merge together, and the pump runs continuously, even with the master switch off. I have taken the machine out and removed the base plate. When I first took the machine out of its position, I tipped it backwards and water came out of the bottom. All hoses and parts in the bottom section seem perfect in every way but the inside of the bottom plate indica


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1902 seconds