Having problems with your Smeg Dishwashers ?

Smeg dwa157 x will not drain

\015 Dwa157 x\015

Answers :

Repair Help & Product Troubleshooting for Smeg Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Smeg dwa157 x will not drain


... Smeg Dishwashers

Smeg Dishwasher Hello I have a smeg dishwasher - built in, push button. It has stopped working - the program start and you hear it drain but that's as far as it gets, no water appears to be getting in. A couple of times the last 2 program buttons flash or the rinse light is on when we open it. let me know if you have any thoughts on this - I'd really appreciate it. thanks Diane


Replace the timer/control board ... Dishwashers

Hi Our Smeg dishwasher model ST 663-1 is not finishing a cycle. It beeps intermitently towrds the end and won't drain (stuck that part of the cycle). I have checked the filter and the drain hose isn't kinked.


... Dishwashers

I have a water leak on my smeg di612ca - i have replaced the drain pump with a new one as i thought this was the culprit but it still appears to be leaking water from the inlet of the drain pump into the base - any ideas? many thanks


... Smeg Dishwashers

Smeg dishwasher model DI 612 C type 12053 good morning After selecting a program and shutting the door the drain pump starts and runs for 2 seconds then stops. The machine makes a bleep noise then the drain pump starts again running for 2 seconds then stops again and the cutting in and out process continues and the machine never reaches its selcted cycle. No alarm lights are displayed. I have filled the machine with water so that the filter is submerged and the level is


... Smeg Dishwashers

Smeg dishwasher not draining - Smeg 24 in. STX2 Built-in Dishwasher


... Smeg 24 in. STX2 Built-in Dishwasher

Smeg Dwi409c dishwasher is stopping 3 minutes into cycle with no fault lights or anything, I hear it fill with water but then stops, but I do notice the water is not draining which I assume is why it is stopping, correct me if I am wrong. Have removed the filter but still not draining. Any ideas?


... Smeg Repair Pcb / Module Dwi409c

Smeg DWI612C Pulsing drain pump..


... Dishwashers

Smeg Allegra NZL750 drains water after wash but then it fills up bottom with water


... Smeg CSU2001 Built-in Dishwasher

Smeg DF612SE drain problem


... Smeg Dishwashers

Smeg dishwasher Beeps when trying to drain...seems to wash ok but


Thanks for the above. I solved the problem by cleaning ALL of the drainage pipes--removing them and thoroughly cleaning in detergent and bleach--the small diameter outlet from the dishwasher WAS partially blocked. More to the point I connected from ... Smeg 24 in. DWI612 Built-in Dishwasher

Smeg dishwasher not draining


... Smeg Dishwashers

Smeg df612sdx dishwasher wont drain


It is a common fault that the drain fails to work in\012most machines in a period of time and is the most problematic fault in a\012washing machine. In all occasions it is important that your observation is most\012important and so is vital ... Smeg Dishwashers

Smeg dishwasher won't drain


... Smeg Dishwashers

Smeg df612sdx wont drain


Its clog up take a clothes hanger an clean the drainage ... Smeg Dishwashers

HOW DO I DRAIN WATER FROM MY SMEG DISHWASHER


There is a screen filter at the bottom of most dish washers, if the screen gets dirty it probly won't drain properly. Check the screen and clean if neccesary. If not that, then pump may be getting weak. ... Smeg Dishwashers

I have a Diplomat ADP 8520 dishwasher (possibly SMEG manufacture) which will not stop trying to empty. There are 4 leds lit reading left to right and it beeps. I have read on some forums about pressing the programme button 4 times or holding it down for ten seconds to clear the fault but neither of these solutions work. I thought maybe that the drain was blocked but I put the pipe directly into the sink and it empties ok, problem is, it does not stop.


Fault is probably water in the bottom tray operating the anti-flood device. take bottom front panel off and mop out the water and it will work. if fault reoccurs then you have a leak ... Dishwashers

Smeg dishwasher, not draining properly. It overflows lot of water to the kitchen floor, when the cycle is on.


... Smeg Dishwashers

BUILT IN SMEG DISH WASHER ADP8132 FILLS WITH WATER THEN DRAINS AND CUTS OUT. TRYED NEW MOTOR AND PCB NO BLOCKAGE NO LEAKS PLEASE HELP


Does the water just disappear down the drain as fast as it fills, with no obvious pumping sounds?\015\012\015\012If so, it might just be that the waste hose is routed wrong after it comes out the back of the dishwasher. It needs to loop ... Dishwashers

I have a smeg st663 that has the delicate and normal wash buttons illuminated and the intensive button flashing after the last wash. Some water failed to drain and I can,t reset it. Any suggestions.


Hi.Try first to reset the error follow the procedures below.1:\015\012\015\012Hold down program selection button for up to ten seconds\015\012Close the door.\0 ... Smeg Dishwashers

Water will not drain from smeg dishwasher. No blockage in pipes.


... Smeg 24 in. DWF1 2 Free-standing Dishwasher

Dishwasher will not drain - Smeg CSU2001 Built-in Dishwasher


First check for blockage then listen for humming sound when its suppose to be emptying, the drain pump may be blocked or may have died. ... Smeg CSU2001 Built-in Dishwasher

I have a smeg d1612cah intergrated dishwasher I am trying to find a reset button as it is not getting anywater into it, It happened after a plumber called to fi a problem with a radiator and drained the whole system and turned off the power.


... Dishwashers

I have a DWI 612C Smeg dishwasher I have an error code of the 2 right hand LED's flashing Have tried to reset the programmer (turn off, on then press program 4 times in 2 secs, wait 15 secs and turn off) This enables me to select a programme, but when the programme starts, after five mins it beeps and carries on making the draining pump noise and the programme never starts When I turn it off and back on I get the far 2 red lights flashing again Have looked for signs of blockages and can


... Smeg 24 in. DWI612 Built-in Dishwasher

Smeg DF612S All starts well but after 40 minutes stops with a beep and will not progress to the main wash cycle. Instead all programme lights come on (located on the left), along with the first 2 phase lights (the first two of the lights on the right hand panel). This indicates error code 3 (cannot pump out water), but water is entering and draining perfectly. Please advise.


Check to make sure there r no kinks’ in the drain line or\015\012that it is not clogged it sounds like the sensor is tripping because there is\015\012too much strain on the pump just like a breaker. ... Smeg 24 in. DWI612 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0934 seconds