Having problems with your SMEs SA622X dishwasher. ?

How do I select a wash setting.

How do I select a wash programme.

Answers :

Repair Help & Product Troubleshooting for SMEs SA622X dishwasher.

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Several people have posted this problem with the Frigidaire Ultra Quiet 111, but I have seen no solutions. When it is set to wash without extra heat, it cycles normally. But when the extra-heat wash and extra-heat rinse are selected, then it gets stuck first mid-wash at the 7 o'clock position, and if it is manually advanced then it gets stuck again during the rinse cycle just before the 9 o'clock drying position. Both the wash and rinse thermostats have been replaced without solving the problem.


Hi,\015\012\015\012I know that you are going to think that this is dumb... but the only thing that it can really be is the timer....\015\012\015\012 ... Frigidaire 25 in. FDP750RC Free-standing Dishwasher

Washes for 5 seconds then stops, then starts again intermittently First the heating element started to turn on during the cycle. I never used it before. I changed the setting to unselect Hi Temp Wash but don't remember if it was selected before. The next day the dishwasher filled as usual, washing started for about 4 seconds, then stopped for aroud 10 seconds. The start/stop cycle repeated about 4 times, then all lights went off and nothing more happened.


Bought a new dishwasher... ... Maytag 24 in. MDB7650AW Built-in Dishwasher

My frigidaire dishwahser was set to run a normal wash cycle and heat dry. It never ran, the soap is still in the holder and the lock beneath the heat dry option is lit. I'm unable to cancel or select any other options. I cannot get the dishwasher to run. Do you have a solution? I have tried holding down a number of the buttons in different combonations but still can't get the light to go out or start a wash cycle.


Looks like a number of things are happening.\015\012\015\012It would be easier if you can provide the model no. of your frigidaire dishwasher.\015\012\015\012I am assuming you have turned the mains power off and on. ... Frigidaire Dishwashers

My Kenmore ULTRA WASH dishwasher model #1603* does not respond to any command. When I select a desired washing I only get a blinking light on my selection and nothing else. If I select ''Cancel/Drain'' it blinks as well. I receive no response at all if I select ''Start/Resume''. To stop the blinking I must turn off the circuit breaker. When I restore the power, the control board is not lit, however, selecting any of the wash cycles and the blinking starts once again. The manual refers to a blink


Replace timer/program module\015\012Vitally ... Kenmore Dishwashers

Cannot select any wash cycle but quick wash. No other wash cycles will light up when selected. If you select the start button, the quick wash lights and the dishwasher starts (even with door open).


I had this same problem and being an electrical engineer, I decided to see what I could fix before replacing the board. The symptoms were the only cycle I could run was the QUICK WASH - no other cycle buttons responded.\015\012\015\012I took t ... Jenn-Air 24 in. JDB1080AWS Built-in Dishwasher

The dishwasher seems to be making excessive noise prior to commencing wash cycle.the eco setting is not functioning but the 65 degree wash setting is. sometimes the wash cycle just doesn't start and all of the wash program setting lights flash repeatedly.


... Smeg 24 in. DWD612SS Built-in Dishwasher

Dishwasher runs for appx 14 min & stops washing half way thru wash cycle. Timer contunies to run. No drain pump out (nothing). Let dishwasher set idle for appx 1 hour and it will re-set. Set timer forward to end of wash cycle and it will complete rinse and final rinse. Then go to dry. Timer works ok.


This sounds like something is stuck in the drain pump. You can remove the inner cover to look for obstructions. You have a dual purpose motor it does the both circulating and draining. The blockage is causing it to overheat and trip the thermal prote ... Whirlpool DU840CWD Dishwasher

"Quick Rinse" light blinks constantly, unable to select "start" unable to select "normal wash" sometimes can select "pots and pans" but still not able to start. Was working normally, when it stopped at end or pre-rinse to start the main washing cycle, the "quick rinse" light came on blinking, and no other button works except as described above. Thanks,


Hi,\015\012 \015\012Check out the console assembly. take off the inside cover and the plastic over the electronics, just remove the two screws holding down the circuit board, pull it to the side, then blow ... Dishwashers

My Candy DFI 45 DISHWASHER WILL NOT RESTART AFTER POWER CUT, THE SELECT TYPE OF WASH BUTTON IS LIT UP BUT WHEN i PUSH IT TO SELECT NO LIGHT SHOWS ON THE SELECTED WASH


It sounds like you req a new pcb assy ..it could of blew it with a power surge :( 01179512835 ... Candy DFI Plan Built-In Dishwasher

Currently the only setting that is working is Sani Wash. If I use any of the other settings the Intake Drain light comes on and everythig stops. How can the Sani Wash cycle work fine and no Intake Drain light when all other cycles trigger the Intake Drain light and won't continue to wash? Thanks,Karen


I decided I'd wait for the repairman; I don't want to have to pay additional money. ... Dishwashers

Kenmore model # 587.15103801 - I select wash cycle , heat dry button and select start all buttons i selected flash and machine wont start wash?


... Dishwashers

I have a new Frigidaire FDB1050RE diswasher. I ran it for the first time set on normal wash and pressing both the Hi-temp wash and heat dry button. This cycle is supposed to take a total of 89 minutes to complete including the drying cycle. After 89 minutes it was still in the wash cycle so I cancelled it to preserve sanity. In the instruction manual it states that the water temperature must be above 120°F. Our building's water heating unit is set at 110°F. Why there is a lower temperature


It should still work pretty well but you probably can't use the high temp wash because it will take too long for the dishwasher to heat up the water enough to satisfy the high temp washer thermostat. If the thermostat's calibrated closing temperature ... Frigidaire Dishwashers

I have a technika diswasher,not sure of the model, is approx 3 years old and has a big dial on the left hand side with 7 wash functuions and the power button is smaller and is on the RHS. I cant remember how to reset the wash settings. I thought that by pushing in the large dial this set the wash cycle but a technician told be that you have to hold your finger on the start/pause button until the green light flashes, and turn the dishwasher off then back on. Can you please give me a step by ste


I have the same model. You just turn the dial to the setting you want, push the dial back in, turn the (right) power button on then turn the smaller start button on. I use different cycles all of the time depending on whats in the load and this works ... Dishwashers

FDW60 AQJarius freestanding,When set, 2 lights stay on fast and delecate wash.


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

AEG Favorit 80820 dishwasher tablet door opens as soon as switched on and door closed. When you put the power on and select a wash and then close the door the small grey dishwasher tablet inside the door can be heard to open as soon as the door is closed. Normally this door remains closed until asked to opened automatically by the dishwasher at the correct point in the selected wash program.


... AEG 24 in. Favorit 80820 Free-standing Dishwasher

Bosch Dishwasher sgs55e02au Showing tap/faucet symbol when setting to wash cycle


... Dishwashers

ADP6000WH/ADP6000IX Whirlpool Dishwasher. The controls are not working correctly. When I select the top two (Strong and Normal) settings I hit the start button the dishwasher will not run. When I select the other four (Economy, Rinse, glass and soak) settings the machine works fine. Thanks MB


... Whirlpool Dishwashers

Our office has a new Asko d3112 dishwasher and maybe its just "user error" but we set it to wash and it stayed on for 3hrs? How do we set it to a normal wash? Simple question but for busy accountants we could use some help! Thank You


This is probably not 'user error'. No machine has a 3 hour wash cycle. The timer will not advance if the water is not up to the proper temp. A severely extended wash cycle is usually caused by a faulty heating element.\015\012I assume the wa ... Asko 24 in. D3112 Free-Standing Dishwasher

My smeg dwi 710 dishwasher keeps flashing on the diplay panel and won't change to another wash selection. it wont close and wont start. the light is stuck on the heaviest wash selection and just keeps flashing on and off and on and off. i have tried turning it off, keeping buttons held down and nothing seems to work. there is nothing in the manual that says what the flashing means so i dont know how to fix it.


... Smeg Dishwashers

Rotary switch selection of washing program.Whichever one selected - machine sounds to start up, whether or not the start button is pressed. However no sound of washing kicks in as was usual and eventually the light over the start button starts blinking and all noise ceases - blinking continues.


Found a local man on the internet, who popped in and leant the machine forward then backwards and then flushed out the system, explaining that the program cycle had gone awry and there was water where there should have been air and so microswitches h ... Dishwashers

The touchpad buttons no longer work to select a wash cycle. When I push "Start" the light above "Smart Wash" comes on and the dishwasher operates normally, but I cannot select any other cycles and the light only comes on after pressing "Start", not before. Also, the Options buttons seem to work normally but the delay button doesn't scroll through 2-4-6, it only toggles the light on and off above "4". The item is 15 months old. Thank you.


... Kenmore 13743 Staimless Steel Built-in Dishwasher

Our Whirlpool ADP 6515 has a delay button. When the button is pressed and activated for a 3 hour, 6 hour or 9 hour delay, if we change our minds and want to wash immediately, we cannot disable the button!! How can we deactivate the delay setting to wash immediately? We have pushed the delay button over and over to turn it off but it will remain on the 9 hour delay setting. We are very frustrated. Please help.


Try switching the power off at the wall switch for a minute, then switch back on, to clear the memory. ... Whirlpool Dishwashers

All the sequence lights flash simultaneously when I set to wash


... Miele G880 Dishwasher

KUDU03STSS2 The dishwasher won't start and you cannot select a cycle. Hiting cancel twice will turn a small steady light on in the time window were the spining light normally is before a cycle starts, at which time closing the door will drain the dishwasher. Tried using the reset combos: hot wash, heat dry, hot wash, heat dry - all lights came on but nothing reset. Also tried same sequence doubling the heat dry. Unpluged for ten minutes, still nothing. Can select rinse, but unit does not start,


... KitchenAid Dishwashers

Westinghouse undercounter dishwasher. after shutting door with latch, comes on when dial knob turned to selected wash. was taken out to redo floor underneath. after being placed back in position, did at least 2 loads fine. now after dial knob gets to selected wash, dishwasher light comes on and i can hear the motor try but then starts clicking. there is also water at the bottom inside the dishwasher


This seems to be a drainage problem, obviously. There may be some food debris in the drain tube where it connects to the drain pipe. It would be easy to detach and do a visual check, and see if you can clear the clog. Also, try to s ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0958 seconds