Having problems with your Tappan 18 in. MDR251RE Built-in Dishwasher ?

I have a problem for a refregirator GE modle GTS18KBMCRWW double doors top freezer .There are icicles on roof of the freezer. I checked everything and it is fine. I think it might be the gasket of the freezer door.


Answers :

Hi,
\015\012You are right, it probably is the seal around the door...
\015\012Get a piece of paper or a CC and slide it around the seal to see if it goes hard the whole way around... if it slides very easy at points then the seal is not tight enough and should be replaced.
\015\012
\015\012heatman101
Repair Help & Product Troubleshooting for Tappan 18 in. MDR251RE Built-in Dishwasher

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a problem for a refregirator GE modle GTS18KBMCRWW double doors top freezer .There are icicles on roof of the freezer. I checked everything and it is fine. I think it might be the gasket of the freezer door.


Hi,\015\012You are right, it probably is the seal around the door...\015\012Get a piece of paper or a CC and slide it around the seal to see if it goes hard the whole way around... if it slides very easy at points then the seal is not tig ... Tappan 18 in. MDR251RE Built-in Dishwasher

We have a leak around the door. It looks like it is around the bottom of the door. We can not find any reason for this. We have checked seals and everything else we can think off at no avaiel. Model 15919. We have found pieces of black stuff on the floor like maybe a protective cover that is deteriorateing . Other then that, everything else is fine. Thanks Dan


... Kenmore 15919 Built-in Dishwasher

My Kitchenaid dishwasher Model KUDPO1FLSS3 stopped working. The electrical works, as we checked the breaker and the little lights on the panel turn on, but the machine will not start. We're thinking there might be a problem with the connection where the door closes. We've checked out everything we can think of, but no luck. The plastic panel is worn away in places, so some of the buttons are exposed-can't imagine that matters, though. Help!


... KitchenAid Dishwashers

Water leak have the Ge triton dishwasher (Model # GSD5320D02BB, bought it n 2001) and currently have very small amount of water leaking out of the door during a run cycle. I did check levels when running and that seems to be fine......meaning the dishwasher is level and not an over-flow problem. My next thought is maybe it is a faulty door gasket. So my question is, where is the door gasket located and how do I replace it? (and where do I order this part from?). Looked for diagrams to follow and


They are in the bottom left and right of the door opening. GE likes to use L-shaped, molded and ribbed seals on most of their models - hopefully also on yours. Typically these can be removed by hand and easily replaced without taking anything apart. ... GE Tritonr XL GSD6260JCC Dishwasher

Kitchenaid (KUDM01TJWH0) Shortly aftter starting my kitchenaid (KUDM01tJWH0) dishwasher, smoke began coming out of the door. I opened the door and smelled a strong electrical smell. It is now completely dead. I drained the water out of the water line, thinking it might be plugged, but still nothing. What should my first move be to determine the cause? Breakers are fine. I think it is was purchased approximately 2001. Thank you!


Wires where thy bend at bottom of door and heating element....water in motor ... KitchenAid 24 in. KUDM01TJ - Multiple Color Built-in Dishwasher

We keep getting the message that the wash arm is blocked (Heavy/Rinse), yet the arm is free. We have replaced everything in the drawer that might impede the arm. We have checked the arm for food blockage, but there is none. Moved the rotors around to different drawers. We have replaced the rotor and the pump motor. Still get the message. It is annoying to receive the message four or five times a cycle. I think it is whatever is sensing the arm block, but have no idea what that might be. Af


Access the rotor, remove it, clean it and put it back in place.The rotor is part 5 in the diagram below. Click on the picture to enlarge: ... KitchenAid KUDD01DSSS Built-in Dishwasher

Wont start I've had the washer for many years with minimal problem. Yesterday when I closed the door no light went on and the washer would not start.  After 20 minutes or so it suddenly went on and worked fine.  I thought that it might have not completed its last cycle. Today, however, I had the same problem and it's been over an hour and still hasn't started. (I checked the circuit breaker and it's fine)


Give it a firm push over the door latch once you've closed the door..it might be the door switch not activating. oops.... first and formost isolate from power for 5-10mins and try ... Bosch 24 in. SHU43 Built-in Dishwasher

Model KUDI24SEWH2 - the dishwasher was operating, I opened the door to add another dish. When I closed the door, there was a small click and nothing happened. The lights indicated to me there was rinsing and drying going on, but in reality, nothing happened.rn We were told it might be the thermal fuse, but have just check that and it is fine. It will fill, just not pump or drain. Any help?


... KitchenAid Dishwashers

No voltage to water inlet valve, overfill switch seems ok and door switch seems ok. I am thinking the timer, but everything else seems to work fine is there something i am overlooking?


\015\012Verify wire harness connections to inlet valves, pressure switch, flow meter, and Central Control Unit (CCU).\015\012Check all hoses for possible leaks.\015\012 ... Roper Dishwashers

Broken dishwasher idl350 dishwasher fitted a new element but it still wont heat the water what coud the problem be. have checked on everything i can think of but it stil wont work. would it be eney broken wires it the door?


IF your dishwasher is a 220 volt unit find and reset BOTH breakers for it. Also make sure someone hasn't inadvertantly hit the"heat dry" button to off. ... Dishwashers

I have a "Crosley" portable dishwasher, Mod#DC24J6A, Serial # 0176983 1089. Everything about it is fine EXCEPT it started with a slow leak at the front door, which has become a raging kitchen-flooding torrent. I do not see any gasket breaks. Gotta clue?


... Dishwashers

I have power to the unit and the door switches or working fine but nothing will work ?? i think it might be the touch pad or the circut board . can you confirm ?


... Maytag MDB8851AWS Stainless Steel 24 in Builtin Dishwasher

Kenmore we have a kenmore 665.1376 that is just over a year old. last night after about 15-30 min it shut down. there is water standing in the bottom but i don't think the float shut it off. checked the power breaker and everything seems fine there.


... Kenmore 15073 Stainless Steel Built-in Dishwasher

Bosch SHY66C My Bosch dishwasher won't fill with water.  All electrical connections are fine and I can hear it make a sound as if it is trying to start about every 2 minutes.  There was water in the bottom so I used a shop vac and pulled it all out but it still won't start and is doing the same thing.  I checked the solenoid with a multi-meter and it appears to be working.  My power went out last night for about two hours and that's all I can think of that might have affected it.  The dishwasher


I'm a novice on this question, but i agree with the above statement about check the stuck float switch or check for a bad safety switch or lockout switch of some sort. I would suspect something is definately faulty in that area. Will the dishwasher r ... Dishwashers

We have a Kenmore portable Dishwasher one and a half years old. It ran fine for about 6 months then we saw a water leak from the lower right hand corner of the door. I cleaned the door gasket. It stop leaking for a while. It started leaking again. Cleaned and rest the door gasket again. It is still leaking. Unit drains fine and all other functions are correct. What is the fix?


... Kenmore Dishwashers

Kenmore dishwasher I have a kenmore dishwasher and in the middle of a cycle all my front panel lights went off. I have checked the power going into the dishwasher it is fine. I also checked the door latch it is fine. Not sure what else to check? Same exact problem model number 665.15934 We have had nothing but problems with all of our sears products - highly suggest to SHOP SOME WHERE ELSE before you get stuck too.


Check the continuity of the thermal fuse (part # 8193762). It's clipped onto the electronic control inside the console.Let me know if you need more help. ... Kenmore Dishwashers

Model- kudm25shwh1 leaking under door when draining. I have replaced the gasket-for the tub, door seal, tub spacer. checked the top vent (cleaned the gunk out). checked the screws on the main sprayer. unit is 9 yrs old. is it time to replace?


... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Electrolux ESL 63010 dishwasher. This worked fine until the door catch broke. I replaced the catch but could not remember which way round the two electrical leads went (red and black). I tried both ways with the same result. The lights come on the control panel and I can change the programme, but on closing the door the house fuses blow. I have checked the earth cable is fine. Any ideas?


Red - is active powerblack - ground or neutral ... Electrolux Dishwashers

New LG 2131sh dishwasher, have it for 2 weeks, worked twice and now when pushing power lights come on, and when selecting program(eg intensive) it does not start. Water checked at it is fine. Checked door, closing fine.


I would call where you purchased it. There should be a one year warranty on the dishwasher and they should send someone out at no charge to repair it. ... Dishwashers

Dishes on top rack are not getting clean. the spray arm does rotate when I spin it by hand, but not sure it is spinning when door is closed. Water is present on the spray arm when I open the door to check. Can you suggest things I might check or tell me what may be occurring?


Remove the spray arm and clean each nozzle then fixed it back and test but be sure that the wash pump is working. ... KitchenAid Dishwashers

My dishwasher emits a dead animal smell immediately after filling. I have a 20-year-old KitchenAid KUDS220T3 dishwasher. The racks are a little corroded, but it still cleans dishes just fine. About two months ago, it started smelling like a dead animal immediately after the dishwasher fills with hot water, during the time the water is being heated, but before agitation begins. The smell appears to be coming from around the door. If I open the door, everything inside the dishwasher smells fine.


This vent that you are describing is to allow air to flow in for the heat/dry cycle. Some times little creatures want to "mark" their territory by "spraying". Spray some type of cleaner like ammonia into it and **** it out with vacuum a few times. Mo ... KitchenAid Dishwashers

I have a Maytag DWU8250BAX and the thing leaks like crazy. I just replaced the door gasket, but that is not the problem. When I took a closer look at the door it seems as though the water is getting up and into the door through a space in the bottom of the door. It seems to me like there should be another door seal to fill a gap that sits between the door hinges. If anyone knows if there should be a seal here and then what the part number might be that would be great. Thanks!


There is an airgap under the door..it should spray up and run down the door not spray up under it..look for crack or hole in spray arm..if there is the wrong soap in it it will flood out with lots of bubbles..just have to flush it out. lastly, if you ... Dishwashers

Door leak I have a small leak between the bottom of the dishwasher door the lower service panel on the dishwashere. I did replace the seal on the inside bottom of the door along with the other parts that come with the door seal. Could there be a gasket leak around the detergent dispenser or the vent at the top of the inside of the door. I did not check the water lever as was mentioned in a previous question on water level, but the float does move up and down quite freely. Any suggestions as to w


I had my dishwasher leaking alot at the bottom of the doo,r and found out that the steam vent was very cloged with gunk. After taking the vent cover off on the inside of the door and cleaning, then putting the vent cover back on NO MORE leaking. Th ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

GE Dishwasher - front door assembly - GSD5420G00WW - Took the front door apart to check the wiring as d/w was acting erractically (not draining fully, not obeying pushbutton commands every time). Everything seem OK, but now not sure how the detergent latch lever and the sequence switch lever fit together to reassemble the door. Help, please. Rick


... GE Dishwashers

When my dishwasher completes its cycle, there is powdered detergent left in the dispenser and the dishes aren't as clean as they use to be. This started happening after I ran a HI TEMP WASH with a SANI RINSE cycle. I'm thinking that either the detergent dispenser door is opening late or the water is not getting hot enough. To check the dispenser door, I left the door open and just poured powder into the dispenser compartment. This did not improve the cleaning.


Hi\015\012 \015\012Dishwashers use Bi-Metal strip to allow the dispenser to open/close. This strip when heat up causes the soap door spring to open up the dispenser. If this strip is not heated doesn't allo ... Kenmore 16372 / 16374 / 16379 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1407 seconds